The 700-N flat-bottom container in is 700 mm wide and 900 mm long. Determine the depth the container will float in the water (a) when it carries the 200-N steel block, and (b) when the block is suspended directly beneath the container, Take Yst = 77.0 kN/m3.

The 700-N flat-bottom container in is 700 mm wide and 900 mm long. Determine the depth the container will float in the water (a) when it carries the 200-N steel block, and (b) when the block is suspended directly beneath the container, Take Yst = 77.0 kN/m3.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Rx P2 2 F 150 mmø 300 mmø

Q: A 1.24 meter high cylindrical water tank is used in lifting oil to the top of the building. The…

A: Given data in question Pressure Height Density To find out Maximum vertical acceleration while…

Q: An open vessel of water accelerates up a 30° plane at 2 m/s. Determine: a. Horizontal component of…

A: open vessel water accelerates up 30° plate at 2 m/s3θ= angle made by liquid surface with…

Q: The tank shown has one curved surface restraining a body of static fluid, with the following…

A: To determine the magnitude of the resultant force on the curved surface. Given, Width of the tank…

Q: sample: The water tank in Fig. 5-B is being filled through section 1 at 6 m/s and through section 3…

Q: At two points 1 and 2 in a pipeline the velocities are Vand 2V, respectively. Both the points are at…

A: applying Bernoulli's theorem

Q: A block weighing 100 N is placed on an inclined plane of slope angle 30 degrees and is connected to…

Q: Problem 2 A 7-kg block is released from rest at A and slides down the smooth circular surface from A…

A: Given:- The mass of the block = 7 kg The radius of the smooth circular surface = r = 4 m The angle…

Q: Q54. A 1:10 scale model of a sub far below the surface of wate water tunnel. If the speed of th m/s,…

Q: The pressure of a fluid at rest has higher value in the deeper location. o True o False • Gage…

A: Brief concept introduction- Pressure- It is defined as the force acting on a body per unit area of…

Q: For a fully developed laminar flow of water (dynamic viscosity 0.001 Pa-s) through a pipe of radius…

A: Given data- dynamic viscosity μ=0.001 Pa-sRadius R=5 cmpressure gradient ∂P∂x=-10 Pa/mradial…

Q: The conveyor belt shown in (Figure 1) delivers each 12-kg crate to the ramp at A such that the…

A: Sketch the free body diagram of the crate as follows; Calculate the normal force using equilibrium…

Q: An open rectangular tank mounted on a truck is 5 meters long and 1 meters wide. It is filled with…

Q: The 40-kg crate is placed on the top of the step of an escalator. If the static coefficient of…

A: Given:- The mass of the crate = 40 kg The static coefficient of friction between the crate and step…

Q: A cylindrical water tank used in lifting water to the top of a tower is 1.3m high. If the pressure…

A: From the given information, we can solve the problem by applying the given equation: null The…

Q: A gas with density 1.25kg/m and dynamic viscosity Aair 1.1 x 10-5Pa, s flows past a flat plate of…

Q: Co e- 30 A sphere of weight W is released with no initial velocity and rolls without slipping on the…

Q: 100-lb block is initially at rest and is placed along the inclined plane making an angle of 60° with…

A: Given- M=100 lb F=90lb, μs=0.20, μk=0.16 The diagram is given as-

Q: Determine the upward thrust F on .5 the semi-cylindrical top of the container shown below. The…

Q: A cylindrical vessel with closed bottom and open top is 0.9 m in diameter. What is the rotational…

A: Given- Dia of open top=0.9 mrise=0.5 mbottom dia=0.4 mg=10 m/s2 Rotational speed needs to be find…

Q: PROBLEM 5 Determine the Wmin for the cylindrical weight for which the system is in equilibrium. The…

A: Given:- Mass of the block = 100 lb Coefficient of friction between block and the incline = 0.20…

Q: Q6) A hydraulic system is shown in figure Q6. Assume the system is in equilibrium state (There is no…

A: Using Hydraulic press principle one can get Solution for the given parts.fa=FAf=Small weight lifted…

Q: If the velocity profile of a fluid over a plate is parabolic with free stream velocity of 120 cm/…

A: Given data in question Free stream velocity Distances Viscosity To find out Velocity gradients…

Q: The 25-kg package is thrown with a speed of 7 m/s onto the cart having a mass of 14 kg. If it slides…

A: Given: The mass of the package is 25 kg. The thrown speed of the package is 7 m/s. The mass of the…

Q: A pipe of 0.7 m diameter has a length of 6 km and connects two reservoirs A and B. The Ans water…

Q: In the Figure 3, if m=15 kg and 0-30°, then the weight component normal to the inclined surface is…

A: Given: mass Angle To find: Weight component normal ho inclined surface.

Q: An square open tank with base length of 1.8 meters contains 0.9 m of water. It is translated…

A: Given: The base length is 1.8 m. The depth of water is 0.9 m. The horizontal acceleration is 4…

Q: A closed oil tanker 2.5m deep * 2m wide * 4m long has been filled with an oil of sp. gr 0.85 up to a…

Q: Problem No. 1 An open rectangular tank 3. 8m high, 2. 5m wide and 6m long is filled with water at a…

A: Given data in question Dimensions of vessel Angle of slope Acceleration To find out Acceleration…

Q: Problem 2. Reynolds Transport Theorem. kir with a density of 0.0644 Ib.-m./cu. ft is flowing upward…

A: We knowP1-P2γm=ΔhP1-P2=Δhγmso,v1A1=v2A2v2=2v1v1=80ftsV2=160fts

Q: 200kg • A rectangular boat with additional load at the center of 1200 kg is submerged in water by…

A: Given data, Load = 1200kg Length = 8m Width = 6m Height = 2.4m

Q: Two plates each having and area of 5m^2 and and 37 mm apart. The plate on top is fixed while the…

Q: The spring is fixed to block A and block B is pressed against the spring. If the spring is…

Q: A cylindrical caisson having an outside diameter of 10m floats in sea water with its axis vertical…

Q: An open rectangular tank, 9.62 ft. high, 11.29 ft. long, and 5.19 ft. wide, has liquid (SG = 0.53)…

A: Consider the following figure.

Q: A box with a mass of 5 kg is moving down the inclined plane at a constant speed of 6 m/s. The…

A: The values and diagram given in the question are as follows: Mass of block(m)= 5 kg Constant…

Q: A 15-kg solid cylinder rolls without slipping down the incline (30° with the horizontal). Determine…

Q: An open cylindrical tank is 1.20 m in diameter and 2.10 m high, is 2/3 full of water. Compute the…

Q: Two blocks are connected by a rope attached to each block with frictionless pulley as shown. If the…

Q: A 285-lb cylindrical tank is at rest as shown. Determine force P required to move the tank up the…

A: This is the problem involving rotational equilibrium. The drum will start rotating about A when the…

Q: If 250-N force is applied to the lower piston (D1 = 4 cm), what is the magnitude of the force F2…

Q: An open rectangular tank mounted on a truck is 5 m long, 2 m wide and 2.5 m high is filled with…

A: We will use formula of angle.

Q: A rectangular, fully enclosed tank 2.85m long, 1.85m wide and 0.8m high is constructed of sheet…

Q: For a fully developed laminar flow of water (dynamic viscosity 0.001 Pa-s) through a pipe of radius…

Q: 3 m water 8 m d Peoncrete = 2200kgm* 6 m The dam shown in the figure is built of concrete having a…

A: To determine the minimum coefficient of friction to prevent sliding of the dam. Given, Depth water…

Q: QI. A closed cylindrical tank of diameter 2.0tn, height 1.2 m and weighing 20 KN is floating with…

Q: The small 0.6-kg block slides with a small amount of friction on the circular path of radius 3 m in…

A: Solution; We obtain the normal force by summing forces in the n-direction, which is the direction of…

Q: An open rectangular tank mounted on a truck is 5 meters long and 1 meters wide, It is filled with…

Q: Situation 22: The 125-kg concrete block A is released from rest in the position shown and pulls the…

A: When force is acting on the system or any structural element the two types of reaction are…

Question

The 700-N flat-bottom container in is 700 mm wide and 900 mm long. Determine the depth the container will float in the water
(a) when it carries the 200-N steel block, and
(b) when the block is suspended directly beneath the container,
Take Yst = 77.0 kN/m3.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

The container is partially filled with oil. Water and air as shown. Determine the pressure at A, B and C assuming Pwater=1000kg/m^3 and Poil=830 kg/m^3
An open rectangular tank mounted on a truck is 5 m long, 2 m wide and 2.5 m high is filled with water to a depth of 2 a.) What final velocity in kph can the truck achieve if it accelerated in 10 s so that the tank will not spill any water? b.) What is the maximum pressure experienced by the truck?
8. A tank has a length of 2.5 m and width of 2.0 m and contains water at a depth of 1.15 m. If the tank is subjected to an linear acceleration of 4.25 m/s-2 parallel to the length of the tank, determine the height of the sides such that no water will be spilled.
A tank is accelerating up an incline plane at an angle 10°.The inclination of the water level with respect to the horizontal is 15°. Find the acceleration in m/s2 of the tank when the motion is downwards.
An open rectangular tank 3.8m high, 2.5m wide and 6m long is filled with water at a depth of 2.2m. If it is accelerated at 2.3 m/s^2 and is moving at a plane inclined 15 degrees from the horizontal, determine the following: a. acceleration of the vessel along the horizontal; and b. angle of fluid inclination. Note: Use density of water as 1000kg/m3 and specific weight as 9.81kN/m3.
A tank containing water moves horizontally (parallel to length) with a constant linear acceleration of 3 m/s2 . The tank is 3 m long and the depth of water when the tank is at rest is 1.5 m. FIND THE FOLLOWING: A. what angle (degrees) does the water make during acceleration? B. what is the minimum height of the vessel for no spilling of water? C. what is the maximum pressure head? (m)
A rectangular, fully enclosed tank 2.85m long, 1.85m wide and 0.8m high is constructed of sheet metal weighing 340N/m2. The tank floats in sea water of density 1025kg/m3 with its 0.8m sides vertical. If the centre of gravity is at the geometric centre of the vessel, calculate the metacentric height and comment on the stability of the tank.
A tank containing water moves horizontally (parallel to length) with a constant linear acceleration of 3 m/s2 . The tank is 3 m long and the depth of water when the tank is at rest is 1.5 m. (a) What angle (degrees) does the water make during acceleration? (b) What is the minimum height of the vessel for no spilling of water? (c) What is the maximum pressure head (m)?
A cylindrical vessel 15 cm diameter and 40 cm long is completely filled with water. The vessel is open at the top. Find the quantity of water left in the vessel in cm^3, when it is rotated about its vertical axis with a speed of 300 rpm.
an open rectangular tank mounted on atruck is 8 m long and 1 m. wide. it is filled with water to a depth of 3.69 meters. if it is accelerated at 10.16 m/s^2 along its length, determine the required height (in meters) of the tank to prevent any water from spiling.
A rectangular dam having a width of 15 m has a height of 24 m. The depth of the water on one side of the dam is 22 m. If the coefficient of friction between the dam and the foundation is 0.85. Compute the factor of safety for sliding if its density of concrete is 2310 kg/m^3. CHOICES: a.) 0.29 b.) 2.29 c.) 2.92 d.) 9.22
An open horizontal tank 2 m high, 2 m wide and 4m. long is full of water. a) How much water is spilled out when the tank is accelerated horizontally at 2.45 misec in a direction parallel with its longest side? b.) What is the porce acting on the side with the greatest depth? c.) Compute the required accelerating force.