The amount that the property would bring if sold or junk. Scrap value Depreciation Earning value Book value

Q: a) Design the rectangular beam to resist the applied moment. DL=20kN/m, LL=15kN/m. Use C25,S420;…

A: Answer (a)To design the rectangular beam based on the given data we need to calculate the Design…

Q: vs from A d loss is as B = 0.45 v St to

A: solution of above problem is below:

Q: Problem A spiral column 600 mm in diameter has an unsupported height of 2.4 m. The column is bent in…

A:

Q: m 2 ate for the support reactions of the following bea 60 KN 40 kN/m 120 kN m The 3 m D min

A:

Q: For the following beams, draw the simplified free-body diagram and below it the shear and bending…

A:

Q: Is strike fault affects and influence the tunnels?

A: Effect of strike fault on tunnel.

Q: 1. Determine the direct runoff hydrograph by separating the baseflow. 2. Derive the unit hydrograph…

A: 1- Determination of Direct Runoff hydrograbh and UNIT hydrograbh ###

Q: Calculate the area of the rectangle where the coordinates are given in meters as shown in Figure…

A:

Q: 2) Consider the statically indeterminate truss shown in figure. EA is constant. Select the member 3…

A:

Q: Find: 1. Total number of frequency 2. Size of the class interval 3. Q3 class 4. Class interval to…

A:

Q: SOLVE THE PROBLEM USING DOUBLE INTEGRATION METHOD Problem II. The midpoint B of the steel cantilever…

A:

Q: No. 3. Beam AC carries a concentrated load P at its midspan point B. Determine the depth of the beam…

A: Bending stress σmax=50MpaThe Maximum deflection σmax=10mmThe span L=4mE=200Gpa

Q: ure below, a fluid avity of 0.77 is w rate is recorder

A:

Q: Find the value of displacement if force applied is 12 N and work done is 63 i

A: Introduction : The given question is related with mechanics . In this question we are provided with…

Q: e reaction force of the joint of the serration in the figure below lies along the member A To bring…

A: given:

Q: If the soil sample is having a plastic limit of 28%, natural moisture content of 44% and a liquidity…

A: This question is related to the Soil Mechanics.

Q: A rectangular flume of smooth wood (n =0.011) slopes 5 m. per 3 km. The width and depth of the first…

A: By manning's Equation  Q=1nAR23S12 n=0.011 S= 5m per km= 5/1000= 0.005  A1= 6*3= 18 m2 A2 = 2*7=14…

Q: Find the value of potential energy Mass=2.4 kg h=0.8 m g=10 m/s2

A: Potential energy is the energy possessed by the body by virtue of it's position.

Q: B At a horizontal curve portion of a 4 lane undivided carriageway, a transition curve is to be…

A:

Q: Q2: A road embankment is 8 m wide and 200 m in length at the formation level, with a side slope of…

A: embankment : An embankment is a volume of earthen material that is put and compacted to raise the…

Q: An interior column is to be designed as a part of an unbraced frame system, located at ground floor.…

A: Le = kL = 1*3 = 3m = 3000 mm Pu = 1.2*300 + 1.6*350 = 920 KN For A36 fy = 250N/mm2

Q: Using Pappus Theorem, find the volume formed by revolving about the x-axis the area bounded in the…

A:

Q: One of the most common appliances used on a daily basis is the hair dryer. A hair dryer is basically…

A: Given :

Q: Using Conjugate Beam Method determine the deflection of the steel beam at point C. 8 KN с 9 m + 3 m

A:

Q: Find hydraulic radius Wetted area=13.32 m2 Wetted perimeter=11.33

A: Given that, A = 13.3m2 P = 11.33m  Hydraulic radius = R= A/P

Q: it is the depth difference between the waterlevel measured after some time during borehole pumping…

A: it is the depth difference between the waterlevel measured after some time during borehole pumping…

Q: with downstream sheet pile is shown in the figure below. The exit gradient as per Khosla's method is…

A:

Q: The specimen shown has been cut from a -in.-thick sheet o vinyl (E = 0.45 x 10 psi) and is subjected…

A:

Q: What are the basic formulas used in the Rotation of a fixed axis? Includes its definition per symbol…

A: Required: Basic formulas used in rotation of fixed axis and example of each formula.

Q: Flow The table below represents the vertical coordinates of the hydrograph of a rainstorm over a…

A: The basic assumptions made in defining moment the Unit hydrograph were that: a) the excess rain…

Q: A guided support as shown in the figure below is represented by three springs (horizontal, vertical…

A:

Q: The gradients of two intersected grade line are -3% and 3%, the radius of vertical curve is 3000m,…

A: Given:- The gradients of two intersected grade lines are:- g1 = -3% g2 = 3% The radius of the…

Q: While out on your boat you spot a spherical vessel (10 ft diameter) on the bottom of the ocean. The…

A: Density of water at 25°C = 997kg/m3  d (diameter of sphere) = 10feet = 3.048 m  So, r (radius) = d/2…

Q: Q2- Two reservoirs with a difference in elevation of 15 m are connected by the three pipes in…

A:

Q: - Two reservoirs with a difference in elevation of 15 m are connected by the three pipes in series.…

A: This question is related to the Fluid Mechanics.

Q: Q4: In a discharge through a Venturi meter, the actual discharge is 1.2 m/s and the theoretical…

A:

Q: Q.2) A state of stress is specified as shown in Figure (2), By using Mohr's circle determine the…

A: Radius of the circleR=(σx-σy2)2+τxy2R=(40+802)2+502R=78.1…

Q: Two of the discussed pollutions: Light Pollution Noise Pollution Are less known and are…

A:

Q: 7 A steel control rod is 5.5 ft long and must not stretch more than 0.04 in. when a 2-kip tensile…

A:

Q: MOHRS 10min зомра зопра 10 min 2

A:

Q: Q2) Water at 20°C flows at 30 m³/s in a rectangular channel that is 10 m wide. The flowing water…

A:

Q: -0.4 L 0.6b FIG. P2.94 6000 lb 4000 lb 7000 lb 5000 lb -SA- FIG.P2.95 2.96 The uniform beam of…

A:

Q: B At a horizontal curve portion of a 4 lane undivided carriageway, a transition curve is to be…

A:

Q: A weir on a permeable foundation with downstream sheet pile is shown in the figure below. The exit…

A:

Q: A barrel in the form of a frustum of a cone with a radius of 3m and 6m at the bottom and at the top…

A:

Q: Determine the distance H from the upper surface of the symmetric double-T beam cross section to the…

A:

Q: Determine the following of the truss shown using the method of consistent deformations: Answer:…

A:

Q: Q3/ Design a short-tied column to support a service dead load of 1600 kN and service live load of…

A:

Q: A- Proportional flow weir is used to keep constant horizontal velocity in: 1. Primary sedimentation…

A: Proportional flow weir is used to keep constant horizontal velocity in grit removal chamber.

Q: 2=38 N Find man k done

A: Force = 3.8N Distance = 1m   It has been asked in the question to determine the work done

Tax Significance of Depreciation

While calculating taxes, depreciation is the method used to allocate the cost of a tangible or immovable asset over the useful life of an asset. In other words, allocate part of that cost to the times when tangible assets help generate revenue or sales. By recording the depreciation of an asset, depreciation reduces the amount of taxes a company or business pays in tax deductions.