The Bluetooth device has a limitation of devices connecting to a network. How to increase the network size of a BT network?
Q: Refer to the exhibit. The network topology is provided and we are using Distance Vector Routing…
A: Hey there, I am writing the required solution of the questin mentioned above. Please do find the…
Q: Consider a network connecting two systems located 4000 kilometers apart. The bandwidth of the…
A: The solution of the above problem is as follows:-
Q: b) The distance between a sender and a receiver of a data communication system is 1400 km and the…
A: Go-Back-N ARQ is a specific instance of the automatic repeat request protocol in which the sending…
Q: a) You have been hired by a startup company to design, plan, and implement an Ethernet network. The…
A: Given: You have been hired by a startup company to design, plan, and implement an Ethernet network.…
Q: 192.168.10.1 192.168.100.1 a. Consider A, B, C, D, E, F are Routers, and link cost are given. Find…
A: The given question is based on the routing of nodes (in this case routers ) in the network. The…
Q: 3. Suppose several network users share a 1 Mbps link. Also, suppose each user requires 250 kbps when…
A: Suppose several network users share a 1 Mbps link. Also, suppose each user requires 250 kbps when…
Q: Perform a Traceroute between source and destination on the same continent at three different hours…
A: for_windows use "tracert www.targethost.com"//any address_we_can_mention_that_you_need. here,…
Q: For each of the following four networks, discuss with the aid of diagrams the consequences if a…
A: five devices arranged in a mesh topology: In mesh topology If any link goes down from them so it…
Q: Apply fixed routing Algorithm to the network showing in the following graph and create router's D…
A: Fixed routing algorithm is a static routing algorithm. In this algorithm, a route is selected for…
Q: What is the total delay of the new packet in arriving at Router B, i.e., how long does it take the…
A: Given: Length of packet (L)=15,000 Transmission rate (R)= 0.05 mbps Number of packet per wave (N)=…
Q: an implementable routing and bridging solution for the network. Your solution must address the…
A: It is defined as Network-to-network connections are what make the Internet possible. The "network…
Q: factor in the delay of a store-and-forward packet-switching system is how long it takes to store and…
A:
Q: nsider two LANS interconnccted by thrce routers, as shown in Figure (1). Use the sociated table and…
A: Hi and thanks for your question! Unfortunately it looks incomplete. Please resubmit the question…
Q: Five devices arranged in a mesh topology
A: *Multiple questions* as per our guidelines we are supposed to answer only one question. Kindly…
Q: Exercise (3): Use (1) Timing Diagram Method (2) Formulas Method Consider three intermediate nodes…
A: Dear Student, In packet switching a message is divided into packets then a packet is sent one by…
Q: 15. An entry in the switching table of a virtual-circuit network is normally created during the…
A: Solution:
Q: 13. Suppose a 1-Gbps point-to-point link is being set up between th Earth and a new lunar colony.…
A:
Q: Consider two nodes, A and B are attached to opposite ends of an 1200 meter cable with signal…
A: introduction :
Q: b. C. Derive the initial routing table for all the routers. In the next time slot, router t receives…
A: Routing:- Routing is the process of forwarding packets from the source machine to the destination…
Q: 1. Two TCP entities communicate across a reliable network. Let the normalized time to transmit a…
A: Two TCP entities communicate across a reliable network. Let the normalized time to transmit a fixed…
Q: Problem 5 Imagine that client A needs to send 4 messages reliably to a server B over an unreliable…
A: There is a two systems one is client A and another one is server B, these two are communicating over…
Q: Consider a channel with spectrum between 4 MHz and 6 MHz and SNRdB = 20. Using Shannon’s formula,…
A: The maximum capacity of the channel
Q: Find the 1*, 2nd and 3rd short path for the below network problem. 12 19 12 11
A: Given graph contains, 6 vertices= {1, 2, 3, 4, 5, 6} Edges weights are, 11, 12, 1, 12, 11, 7, 19, 4
Q: COMPUTER NETWORKS: Please answer fast and show how to get the answer. An application message is…
A: Number of packets=20 Length of the packet size= 4000 bytes Band width= 1 Mbps Total distance= 2000…
Q: 1. Answer the following questions with respect to “Link state Routing Protocol". 5 2 192.168.10.1…
A: Link state routing is one network where routers share knowledge to its neighbors.
Q: QUESTION 9: Assume the usage of Go-Back-7 (N = 7) ARQ sliding window protocol for flow and error…
A: Here in this multiple question we have given a sliding window (GB7) .and we have asked to find no of…
Q: INCREASING TWO POT IN NETWORK THERE ARE DELAYS. WHY ? a. NAME( 5) DEFACTOR STANDARD OF…
A: According to the question we need to answer: INCREASING TWO POT IN NETWORK THERE ARE DELAYS. WHY ?a.…
Q: Suppose a system has 50 MB data to send on a network and transmit the data in burst at 8 Mbps, the…
A: introduction :
Q: By using distance vector routing protocol, complete all the five tables for routers A, B, C, D and E…
A:
Q: Answer the following questions with respect to "Link state Routing Protocol". 192.168.10.1…
A: Link state routing protocol is a dynamic routing protocol which is used to find the routing distance…
Q: QUESTION 16 Select the correct statement(s) regarding Frame Relay (FR). a. FR is a connectionless…
A: Frame Relay is a highly efficient WAN protocol that operates on physical and data interface layers…
Q: 13. Suppose a 1-Gbps point-to-point link is being set up between the Earth and a new lunar colony.…
A: RTT is the term in milliseconds (ms) it takes for an organization solicitation to go from a…
Q: Consider the following network. A. Display router forwarding table A. such that all traffic for…
A: Forwarding table and explanation
Q: Question 2 a) Describe the signal pattern produced on the medium by the Manchester-encoded preamble…
A: please see the next step for solution
Q: Q1. (i) Differentiate between Go-Back-N ARQ and Selective Repeat ARQ methods. Explain with example.…
A: Introduction Q1. (i) Differentiate between Go-Back-N ARQ and Selective Repeat ARQ methods. Explain…
Q: A=32, B=33, C=34, D=35 x1, y1, z1 are the interfaces for the router gateway, while x2, x3, y2, y3,…
A: Here i am writing below(step 2) the required solution for the above stated question.
Q: 16. Find the transfer function, G(s) = V.(s)/V;(s), for each network shown in Figure P2.3. [Section:…
A:
Q: b. Why Cyclic Redundancy Check (CRC) technique is used in the world of networking? Also show the CRC…
A: Why CRC is used:- It is a error detecting algorithm which is used to find whether error in data is…
Q: COMPUTER NETWORKS: Please solve with solutions and provide correct answer An application message…
A: Given Data : Number of packets (n) = 20 Packet size (p) = 1000 bytes Bit rate (b) = 1 Mbps…
Q: 59. Consider the network in Figure 3.56, using link-state routing. Suppose the B-F link fails, and…
A:
Q: A TCP connection is established through 10 wireless hops in an acoustic underwater ad hoc network.…
A: Answer: I have given answered in the handwritten format.
Q: 1) Consider a packet of length 1200 bytes begins at end system 'A' and travels over three links to…
A: Given that, Length of the packet= 1200 bytes queuing delay= 0 propagation delay= 2.5*108m/s Band…
Q: Computer A is sending a 100 kByte long file to Computer B via packet-switching over two consecutive…
A: Answer: Given File size=100 kByte Rate =10Mbps Distance =1000km Speed=2.5 x 108 m/s
Q: Computer Science Which of the following statement is true for Path term in SDH Network?
A: Option d Points where Multiplexing/Demultiplexing of signal occurs.
Q: The practical network shown below is a WAN consisting of seven routers A through G interconnecting…
A: Dijkstra's algorithm is a single source shortest path algorithm. In which initially select a source…
Q: 1) How long does it take a packet of length 1,000 bytes to propagate over a link of distance 5,000…
A: The given data is: The length of the packet is 1,000 bytes.Here, the length is given in bytes first…
Q: 233. The transmission media that handle the communication between offices is called a. local…
A: Answer : - option B) Trunks
Q: Suppose that a router interconnects three subnets, where all the interfaces of the subnets must have…
A:
Q: The following figure shows that, using relays can extend communication distances. Assume the…
A: This is due to the reason that throughout with fixed relays at different distances through the graph…
|
3. |
(a) |
The Bluetooth device has a limitation of devices connecting to a network. How to increase the network size of a BT network? |
|
|
(b) |
In the illustration, the J router updates its routing. Do you know how? If another new router is added to the same network named X and delay from G, H and D is 6, 12,18 respectively. Show the routing table of X. |
Step by step
Solved in 2 steps
- The source outputs 0 or 1 in sequences of various lengths. The following is an example: 11111111111111111000000000000000000111111111111111111; Model the source, so you can reduce the total number of bits per sequence. Discuss the condition for the bit rate reduction. Apply your model to the above sequence. Calculate the compression ratioWhat bit patterns are represented by the following hexadecimal patterns? a. 0x5FD97 b. 0x610A c. 0xABCD d. 0x01001) In a 6-bit two's complement system, A=010110, B=001100, when perform X=A - B, which of following statement is true? Hint: perform C= NEGATE B, then perform X = A+C Question options: a. X is 001010, NZCV=0011 b. X is 001010, NZCV=0010 c. X is 101010, NZCV=0011 d. X is 101010, NZCV=0010 e. X is 001010, NZCV=0001
- Decode the following messages that encounter noises in the channel where the channel encoding uses repetition code where k=3. 1.) 101101011100110 2.) 010010001010011 3.) 111110110010100 4.) 100100001010010Compute the Hamming distance of the following code words: 0011010010111100 0000011100001111 0010110110101101 0101011010011110 Please show all working understandable. THANK YOU VERY MUCHDetermine the “M” value and number of data bits that can be represented by a single symbol using OOK where the possible amplitude values per symbol can be {-1v, 0v}. a. M=2, N=1 bit per symbol b. M=4, N=2 bit per symbol c. M=6, N=3 bit per symbol d. M=8, N=3 bit per symbol
- For 7 bits floating point representation using: seeefff, what is the decimal value 0 111 100 Question 82 options: A. +NAN B. 36 C. 3 D. 1/16 E. 1/8 36. Using a 6-bit cell to store integers in 2's complement, NOT 0 0 0 1 1 0 = ______? A. 0 0 1 0 1 1 B. 0 1 0 1 0 0 C. 1 0 1 0 1 1 D. 0 0 1 1 0 0 E. 1 1 1 0 0 1Suppose you want to send a BCD number "(100100110101)BCD" to your friend and the sending device has an odd parity bit generator that can process a single BCD digit. Design an odd parity bit generator to send BCD digit and find out parity bit for given number.Separate the bit sequence into appropriate sized chuncks for each of the following domains. (You do NOT have to decode this bit sequence.) 1. Octal String: 010 110 101 010 101 111 010 111 111 101 011 011 011 011 010 1001. Hex String:1. Base64 String:
- Suppose the binary data stream 000011110011 is differentially encoded and then transmitted sketch each of the following codes Unipolar NRZ Polar RZ AMI (Alternate Mark Inversion) ManchesterThe data word 10101110001101 is given for transmission. Draw the following encoding formats. NRZ-L NRZ-I Bi-phase Manchester RZ Differential Manchester158400= (DL) + (DL x 1.5)