The bottles going to the heat based shrink system should be in upstanding situation and any fallen bottles should not be allowed to enter the grouping station (P3). They should be rejected at a location prior to the grouping station (say at rejection station). The system is illustrated in Fig.5.11. Assume P1 to be the detection location, P2 the rejection station, and the sensor LS1 generates 10 pulses when the conveyor travels from location P1 to P2, design the required control system.

The bottles going to the heat based shrink system should be in upstanding situation and any fallen bottles should not be allowed to enter the grouping station (P3). They should be rejected at a location prior to the grouping station (say at rejection station). The system is illustrated in Fig.5.11. Assume P1 to be the detection location, P2 the rejection station, and the sensor LS1 generates 10 pulses when the conveyor travels from location P1 to P2, design the required control system.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

5. Can an MCB provide personal protection from electrocution? Explain.
Explain this sma connector
Q.1) Assume that the control of a bottle filling system is performed with an 8051 microcontroller. • The start and stop of the conveyor is controlled by the P1.0 pin. • The bottles are moving on the conveyor and detected with a sensor. When they arrive at the filling place, they are detected with a logical "1" signal, otherwise they are detected with a "0" signal. • A valve connected to P1.1 turns on for 10 seconds to fill each bottle. • At every X bottles, the conveyor will stop for 8 minutes and then start again. The remaining time to restart in the waiting period is displayed in minutes on the 7-segment display. • Logic "1" is detected from P1.3 during the operation of the system. Logic '0' is detected from P1.3 at the end of the shift. • At the end of the shift, the number of the filled bottles will be determined and saved in a memory location as 2 bytes. Write the required program. (Crystal Frequency:12MHZ). NOTE: X number will be taken as the last 2 digits of 59
VI. FILL-IN QUESTIONS: 1. Before the TRIAC is triggered on, the voltage across its main terminals is equal to the voltage. 2. When the TRIAC is triggered on, the voltage across its main terminal is about V. 3. Once the TRIAC is conducting, the gate_control the current to flow through the TRIAC. 4. The TRIAC can be turned off by reducing the current through it below its The TRIAC can have_or__terminal voltage and be triggered on by_applied on the gate.
How does TP4056 works? What is the purpose of red and blue lights in the components?
how to implement this circut in tinkercad .
When the depletion region widens in the varactor diode, plate separation ____. a. will increase b. will decrease c. become infinite d. become zero
please send full calculation as step by step
Complete the wiring below, such that the two sensors are connected in series and capable of controlling the given load. SENSORS in SERIES ... Brown Brown 0-30 Vpc SUPPLY Black Black PNP PNP Blue Blue
the counter shown is best described as a ___ type counter decade ripple self-stopping synchronous.
a.What is an ROC? b.What is a cold site? c,What is fault tolerance?
Test the accuracy of the equation by applying the operation in Ampere law (del.)? If there is a mistake, correct this mistake.