The bridge deck represented by a beam element shown is to be designed to support a 60 kN concentrated live load, a uniform live load of 20 kN/m and a uniform dead load of 10 kN/m. Construct the influence lines for the following responses and determine the maximum response due to the prescribed loadings. You may use any method in constructing the influence lines.

The bridge deck represented by a beam element shown is to be designed to support a 60 kN concentrated live load, a uniform live load of 20 kN/m and a uniform dead load of 10 kN/m. Construct the influence lines for the following responses and determine the maximum response due to the prescribed loadings. You may use any method in constructing the influence lines.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

1. The boom of the wall crane 4m long is held at right angles to the wall by a wire that is attached to the wall 3m above the foot of the boom. If the load lifted is 45000N, find the tension in the wire and the compression force in the boom Neglect the weight of the boom. Draw the FBD
Answer is 1,726. No other answer thanks From the given beam in the figure, compute the maximum moment (kN-m, magnitude only) at C due to a uniform dead load of 14 kN/m, uniform live load of 14 kN/m and a concentrated load of 93 kN by influence lines. Use a = 4 m., and b = 11 m.
force@ D=40kips. I have provided the reactions. Pls continue Asap. Thanks
Determine the moments at all supports. Answer key: MBA = 2 kN-m; MBC = -2 kN-m; MCB = 4.46 kN-m; MCD = -4.46 kN-m; MDC = 0.66 kN-m; MDE = -0.66 kN-m; MED = 3.27 kN-m
Determine the reactions at a and b for the beam subjected to the concentrated loads Ay= ? (Not 8.77 or 4.85 previous failed attempts on my behalf) bx = 7.2 Ax = ? (Not 1.9 or -.3365)
6.D1 A large tower is to be supported by a series of steel wires; it is estimated that the load on each wire will be 13,300 N (3000 Ib). Determine the minimum required wire diameter,assuming a factor of safety of 2 and a yield strength of 860 MPa (125,000 psi) for the steel.
Draw the free-body diagram for the following problem. The boom shown.
Draw the free-body diagram for the following problem.The boom shown.
A 300 mm x 300 mm concrete column which is pin connected at both ends has an unsupported length of 4.6 meters. The column is carry a total factored axial load Pu = 300 kN and a lateral concentrated load of 90 kN acting at the mid-height of the column. Assume fc’ = 21 MPa and Bdns = 0.15. Compute the total moment including the secondary moment due to lateral deflection.a. 75.852 kN.m. c. 124.614 kN.m.b. 635.785 kN.m. d. 90.872 kN.m
Required: Maximum positive And negative moment for 2nd-floor BEAMS DISTRIBUTION METHOD 5 cycles.
Draw the Influence Line Diagram for involving a moving unit load 1 unit. VD = f (x)AV = f (x)RB = f (x)
The steel framework is used to support the 4-in. reinforced stone concrete slab that carries a uniform liveloading of 500 lb/ft^2. Determine the reaction at point E in kips. b = 10 ft and a = 7.5 ft