H1 is root It means find root and than match options...is the h1 .. 10. The characteristic equation for a system is given by A= 83+10s2 + 11s +6. Using Continued FractionExpansion, determine the h₁ coefficient?(a) 10(b) 1.73(c) 0.96(d) 0.1(e) None of the above

The Given equation is ∆=s3+10s2+11s+6 To determine the h1 coefficient by using continued fraction.

Answered: The characteristic equation for a…

The characteristic equation for a system is given by A=8³+10s² +118 +6. Using Continued Fraction Expansion, determine the h₁ coefficient? (a) 10 (b) 1.73 (c) 0.96 (d) 0.1 (e) None of the above

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter17: Resistive-inductive Series Circuits

Section: Chapter Questions

Problem 2PP: Assume that the voltage drop across the resistor, ER, is 78 V, that the voltage drop across the...

See similar textbooks

Related questions

Q: The sensitivity of a PMMC instrument is 10k /V. If this instrument is used in a rectifier type…

A: Given, For a PMMC instrument Sensitivity, Sdc = 10 kΩV

Q: Consider the root locus of a unity feedback system with loop transfer function L(s) = Ge(s)G(s) =…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: sketch the root locus for the system above. Hand written plzz D(S) 2) 2(s) K 547 C(s) (533) 5 G,(s)…

Q: A 2002 load receives power from parallel-connected battery cells, as shown in the figure below.…

Q: +IVo +5vo K 2 +5V • 2 ΚΩ OV

A: In this question we need to find a voltage V for the given circuit.

Q: Q1: For the circuit shown below; find i(t) for t > 0 3 A 292 ww 2u(t) V(!) ,i(1) IH

A: In this question we need to find a current i(t) for t>0

Q: Find the value of the following parameters if the E-MOSFET has VGS(TH) = 0.8Vand ID(on) = 1.8 MA and…

Q: O a m 5 ohms bo www 10 ohms www 15 ohms 20 ohms 25 ohms M 30 ohms d

Q: Discuss difference between instrument repeatability and instrument hysterises

A: Repeatability – It is a measure of the closeness of agreement between a number of readings (10 to…

Q: Express the function y = 27 cos(wt) + 364 sin(wt) as a single sine wave y = A sin(wt + ) for some…

Q: Find the z-parameters given below: 202 60 www 4Ω

A: In this question we need to find a z parameters of the given two Port network

Q: Q1: In a delta modulation process, the step size is 0.05 v and sampling rate is four times the…

A: We need to find out the amplitude of message signal to avoid slope over load error

Q: y(n) = h(n)) * x(n) where, A. h(n) = u(n − 1) and x(n) = u(n-5)

A: Use the property of unit step convolution i.e u(n-a) * u(n-b) = (n-a-b-1) u(n-b-a)

Q: A hybrid solar cell and diesel power distribution system has been proposed and tested. The system…

Q: Find current through R2 resistor. R1 5 R3 12 (+1 II V₁ 10 Select one: O a. 3.04 O b. 2.67 O c. 3.75…

A: Give, the circuit with the resistances and the voltage sources.

Q: An ideal shunt-shunt feedback amplifier has Rs =∞. If li= 100 microAmp, I fb = 99 microAmp and Vo =…

Q: When a current of 2.5 A passes through a circular loop, the magnetic field at the center is 125 µT.…

Q: Consider the circuit in the figure below: a) What are the benefites of using the transformer in this…

A: Cut in voltage of silicon diode is 0.7V and cut in voltage of germanium diode is 0.3V. During…

Q: Find current through R2 resistor. R3 10 12 PE 11 V1 10 Select one: O a. 3.04 O b. 2.67 O c. 3.75 O…

A: Given circuit,

Q: A three phase,Y connected, 215 V (line to line), 7.5 kW, 60 Hz, three pole IM has the following…

Q: Question 2 Consider transmission of a digitalised voltage signal. The analogue signal before…

A: Brief description: In the above given question they have mentioned a bandpass signal and we need to…

Q: Given two batteries: one with voltage V and internal resistance r₁; another with also voltage V and…

A: Brief description: Whenever two batteries are connected in series we need to calculate total voltage…

Q: Determine the equivalent resistance between terminals a and b. M 10 ohms 10 ohms 10 ohms M 10 ohms b…

A: In this question we need to find a equivalent resistance between terminal a and b

Q: A 12-bit ADC is connected to the positive reference voltage of 1.5V and negative reference voltage…

Q: In a delta modulation process, the step size is 0.05 v and sampling rate is four times the Nyquist…

Q: Which of the following integrals correctly solve for the magnetic flux passing through the surface…

Q: Determine the power absorbed by each of the resistors in the circuit shown in Fig. (3). 3 A 12 V 60…

Q: Compute for the voltage vab O-13.7037 V O-12.5784 V -13.3752 V a R5 2 Ohms V3 미다 10V V1 20V R6 ww 9…

A: Given

Q: Define Shift register and draw four-bit shift register using D-Flipflop.

A: Since these are two different questions, in the following section, the first question will be…

Q: The measured value of a voltmeter is 20V and the expected value of the voltage measurement was 25V.…

A: Given data: Voltmeter Measured value = 20 V Voltmeter True value = 25 V

Q: A boost converter is a dc-to-de switched power supply in which the voltage output is larger than the…

Q: Low Frequency Response: Compute for the following. b. Av

A: The required parameters can be calculated by using the DC analysis and AC analysis of the amplifier…

Q: 1. Consider an air-filled rectangular cavity resonator with dimensions of a = 2.286 cm, b = 1.016 cm…

A: It is given that: a=2.286 cmb=1.016 cmd=2 cmσ=3.816×107 S/m

Q: Q3: Determine the Nyquist rate of sampling required for the signal g(t)=e^(-2|t|) (Approximate the…

Q: Determine the equivalent resistance between terminals a and b. www 10 ohms 10 ohms 10 ohms ww 10…

A: We need to find out the equivalent resistance between a and b .

Q: Find the Norton circuit to the left of terminal A and B for the network shown below. Connect the…

A: Norton's circuit is an analytical circuit used to trade a complex circuit into an easy equal circuit…

Q: Q3: Determine the Nyquist rate of sampling required for the signal g(t)=e^(-2|t|) (Approximate the…

Q: Multiple Choice Initially, a circuit is composed of a DC source and two resistors, R1 and R2,…

Q: integrated circuit families (RTL, DTL, TTL, CMOS) 4. Let vx = vy = 0.1V (Logic 0), B = 25 Determine…

Q: Draw a circuit that implements a 3-bit Adder that takes two 3-bit numbers as input, each on 3 input…

A: We know that half adder is used to add two bits and produces corresponding Sum and Carry where as…

Q: a- b r1 5 Ohms V1 15 V www i1 r2 3 Ohms i2 V2 8 V 믐 R_LOAD ww 10 Ohms r3 3 Ohms i3 V3 + 믐 3 V

Q: iven the circuit below, determine the magnitude of the current through the 20-volt source.

Q: Find V, in the circuit below ww 4 ΚΩ 4 ΚΩ 6V (2mA 2 mA + (1) 2 ΚΩ 4 mA Σ2 ΚΩ Vo

A: This is a basic problem of circuits. The voltage Vo can be calculated by applying nodal analysis and…

Q: Find the Norton equivalents

Q: 1. Find VCE, VBE, and VCB in below circuits. 2. Determine if the transistor is saturated or not Rc…

Q: Select the size of the filter capacitor needed to obtain a filtered voltage with 10% ripple at a…

Q: The computation for the magnetic force due to a current carrying conductor requires the following…

A: We know Force on a current carrying conductor in the magnetic field is given by F= I.l×B Where B:…

Q: An antenna has a loss resistance, Re=10Ω and a radiation resistance of Rr=120Ω. Determine the…

Q: Given four resistors R1 = 100 ohms, R2=250 ohms, R3 = 350 ohms, and R4 = 200 ohms such that R1 and…

Q: Convert the following hexadecimal numbers to the decimal number system. please show all steps a. C…

A: This question belongs to digital electronics . It is based on the concept of conversion of…

Question

H1 is root It means find root and than match options...is the h1 ..

10. The characteristic equation for a system is given by A= 83+10s2 + 11s +6. Using Continued Fraction
Expansion, determine the h₁ coefficient?
(a) 10
(b) 1.73
(c) 0.96
(d) 0.1
(e) None of the above

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Different Types of System and Its Property

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

If the roots of the characteristic equation are -3,0 then the system is _________________________. Marginally stable Conditionally stable Stable Unstable
Write an expression for the output voltage for the circuit as shown if υ1 = 0.5 sin 2000πt, and υ2 is generated by the circuit as shown with υ3 = 0.5 sin 10,000πt? Assume VCC = −VEE = 10 V, IEE = 500 μA, R1 = R3 = 2 kΩ, and R = 10 kΩ.
A circuit is constructed with an AC generator, a resistor, capacitor and inductor as shown. The generator voltage varies in time as ε =Va - Vb = εmsinωt, where εm = 120 V and ω = 726 radians/second. The values for the remaining circuit components are: R = 62 Ω, L = 95.6 mH, and C = 13.8μF. 4) What is t1, the first time after t = 0 when the voltage across the inductor is zero? 6) What is VC = Vd - Va, the voltage across the capacitor, at time t = 0? Note that VC is a signed number.
The current in an L-R-C series circuit has amplitude 0.120 Aand angular frequency 8.00 * 103 rad/s, and it has its maximum positivevalue at t = 0. The resistance is 95.0 Ω, the inductance is 6.50 mH,and the capacitance is 0.440 mF. For the resistor, inductor, and capacitor,find (a) the voltage amplitudes and (b) the instantaneous voltages att = 0.305 ms.
A system has the following characteristic equation: s + s + 3 + 2s + 2 = 0 Using the Routh-Hurwitz method, check
A resistor of 100 Ω, a coil of 4.50 μH, and a capacitor of 220 pF are in parallel. What is the admittance vector at 6.50 MHz? Provide illustration of the circuit.
given that vc=q/C. derive the expression for q in terms of time t.
The voltage across the terminals of the 5μF capacitor is 30 cos (4000t + 25°) V. Calculate (a) the capacitive reactance; (b) the impedance of the capacitor; (c) the phasor current I; and (d) the steady-state expression for i (t). 5 μF + v i
H5. An RCL circuit connected in series has R = 180 ohms, C = 1/280 farad, L = 20 henries, and an applied voltage E(t) = 10 sin t. Assuming no initial charge on the capacitor, but an initial current of 1 ampere at t = 0 when the voltage is first applied, find the subsequent charge on the capacitor at t=0.5. Use 4 decimal places.
Set up a system of first-order differential equations for theindicated currents I1 and I2 in the electrical circuit ofFig. 4.1.14, which shows an inductor, two resistors, anda generator which supplies an alternating voltage drop ofE(t) = 100 sin 60t V in the direction of the current I1.
In the series circuit of Fig, the source has voltage amplitude 20.0 V and angular frequency 5.40 x 103 rad/s, the inductance is 6.50 mH, the capacitance is 0.600 µF, and the impedance is 474 Ω. Find (a) the resistance, (b) the current amplitude, (c) the resistor voltage amplitude, (d) the inductor voltage amplitude, and (e) the capacitor voltage amplitude
The terminal points determined by pi/2, pi, -pi/2, 2pi are __________, ________, ___________, and ___________, respectively.