I need the answer as soon as possible The consumption of tires leads to the emission.of particles of leadTrueFalse

Answered: The consumption of tires leads to the…

Engineering

Civil Engineering

The consumption of tires leads to the emission .of particles of lead

Materials Science And Engineering Properties

1st Edition

ISBN:9781111988609

Author:Charles Gilmore

Publisher:Charles Gilmore

Chapter8: Engineering Materials

Section: Chapter Questions

Problem 79CQ

See similar textbooks

Related questions

Q: In 100 yrs, 100mg of radium decomposes to 95mg. How many mg will be left after 200 yrs?

A: Let A0 be the initial amount of radium and A be the amount of radium left after t years of…

Q: It is found in a water sample that it has insufficient alkalinity and therefore soda ash (Na2CO3) is…

Q: A theodolite is a equipment used by engineers. Enumerate all metals and metal alloys present in it,…

A: Brief Introduction- Theodolite- Theodolite is an optical device that is used for the measurement of…

Q: The following information is given for cadmium at 1atm: boiling point = 765 °C Hvap(765 °C) = 100…

A: Given: Boiling point = 765°C Melting point = 321°C Specific heat solid= 0.230 J/g°C Specific heat…

Q: 9. Example of amorphous substance is a) Polymers b) Diamond c) Snowflakes d) Quartz

A: Example of an amorphous substance.

Q: An activated-carbon bed that is 12 ft x 6 ft x 2 ft deep is used in a benzene recovery system. The…

A: Solution; Given data; Depth of bed D = 2 ft Void fraction ε = 0.40 Gas viscosity µ = 0.047 lb/ft-hr…

Q: Aggregate is also used for filter systems, is the attached image of a filter system correct in…

A: The given figure is of Slow sand filter with mixed aggregates (FSG). The given arrangement of…

Q: mponent of the accelerat mponent of the accelerat

A: normal acceleration

Q: 3. Consider the following with regards to burning of clay bricks. 1. The clay loses its plasticity…

A: During dehydration

Q: (Lola) A Glycerin has a Mass(M)= 945 Kg. And a Volume (V)= 0.750 M3.---The Specific Weight .8 岛 :is…

A: Specific Weight is defined as weight per unit volume. Weight is a force. The unit for specific…

Q: The air in the San Francisco Bay Area has a mercury content of 2.1 mg/m3. This concentration should…

A: Given, mercury content=2.1 mg/m3 Temperature=20˚C=(20+273)K

Q: Which type of activated carbon is most suitable for gasoline vapor recovery?

A: The activated carbon is classified based on Characteristics of activated carbon Type of raw…

Q: A dose of 100 me/l of alum is used in coagulating a turbid raw water. Calculate the sum of amount of…

Q: Provide relevant information about the constituents of OPC in the blank cells of the following…

A: OPC- Ordinary Portland Cement The information about constituents of OPC is provided below-

Q: ple is pa content ty 2 gm particles

A: To find: void ratio, e

Q: Formaldehyde is commonly found in the indoor air of improperly designed and constructed buildings.…

Q: The mean indoor airborne chloroform (CHCI,) conc. in a room was detemined to be 0.4 ug/m3. Use the…

Q: a) Explain the functions of the following in particle removal during water filtration in granular…

A: Water filteration It is process of treatment of water under various phases which includes- Primary…

Q: The SOo concentration in a stack is 500 ppm, the stack diameter is 12 ft, and the stack gas velocity…

A: Calculate volume of the gas Q=AvVt=Av Q=VolumetimeV=AvtV=π4122×6524×3600V=635154636.6 ft3 Convert…

Q: A teapot with a surface area of 665 cm2 is to be plated with silver. It is attached to the negative…

A: Given:

Q: Calculate the dosage of activated carbon to reduce an influent (flowrate = 10 mgd) concentration of…

Q: The specific gravity of ethyl alcohol is 0.79. Calculate its specific weight in kN/m^3.

A: Given:- The specific gravity of ethyl alcohol is 0.79.

Q: Describe Fischer-Tropsch diesel production.

A: fischer tropsch diesel : Fischer–Tropsch Diesel is a brand of Fischer–Tropsch. F–T diesel, also…

Q: Assume that the NO2 concentration in a house with a gas stove is .150 pg/m3. Calculate the…

A: Solution: Given: NO2 = 150 micro grams/m3

Q: Silver nitrate is stored in a brown bottle

A: Silver nitrate stored in dark clour bottles:

Q: Determine the angle at which a particle in Jupiter's circular orbit experiences an attraction from…

A: MjLθ2=1.23MstarL2θ=MJ1.23Ms

Q: You are being consulted for the design of a coagulation-flocculation basin for a water treatment…

Q: ch question: 1. Activity of a gas in equilibrium with solution is ______? A. its partial pressure;…

A: 1.A For gas the activity means its partial pressure, so answer is partial pressure 2. B sorbate :…

Q: It is the decrease in value of physical properties with the passage of time and use. depletion…

A: This question is related to the Estimation costing and valuation.

Q: Example: A product developer is interested in reducing the drying time of a primer paint. Two…

A: Given, n1=30n2=30x1=121x2=112 σ1=σ2=8 min Level of significance = 5 %

Q: e radius of cu wers limit their e lateral accele

Q: Select the correct FBD of particle A. 30° 40° 100 kg

A: Let us analyse the question in step 2.

Q: 1. The rate at which the particles of fluid can spread is called a) Surface tension b) Diffusivity…

Q: Calculate the amount of barium from Sodium sulphate in a liter. A 100 ml solution of sodium sulphate…

A: Given data There is 100 ml solution of Sodium sulphate is treated with solution of Barium chloride…

Q: Cesium decomposes approximately at a rate proportional to the amount present. If 80 g will be 76 g,…

Q: Kerosene has a specific weight of γk = 51.1 lb/ft3 and benzene has a specific weight of γb = 56.2…

Q: The chief engineer in charge of refinery operations was not satisfied with the preliminary design…

Q: A 325 L of carbon tetrachloride weighs 500 kg. a. Calculate its density. b. Calculate its specific…

Q: Organomercury compounds, such as MeHg*, are persistent pollutants which are extremely toxic to…

A: The toxicities of many metals, such as mercury and lead, are known to man since the dawn of…

Concept explainers

Asphalt Binders and Mixtures

Asphalt binders are subsidiary products procured during the refining process of petroleum while manufacturing gasoline, diesel, and similar petroleum products. Asphalt binders are obtained from the residue that remains after the distillation of petroleum, this residue is further subjected to steam distillation and oxidation to remove the traces of gas oil present in the residue. Certain additives or modifiers are also added to asphalt binders to alter them to suit different applications.

Question

I need the answer as soon as possible

The consumption of tires leads to the emission
.of particles of lead
True
False

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Aggregate is also used for filter systems, is the attached image of a filter system correct in regards to the arrangement of the particle size. explain your answer
The following information is given for cadmium at 1atm: boiling point = 765 °C Hvap(765 °C) = 100 kJ/mol melting point = 321 °C Hfus(321 °C) = 6.11 kJ/mol specific heat solid= 0.230 J/g°C specific heat liquid = 0.264 J/g°C __________kJ are required to melt a 31.0 g sample of solid cadmium, Cd, at its normal melting point.
The SOo concentration in a stack is 500 ppm, the stack diameter is 12 ft, and the stack gas velocity is 65 ft/secl The gas temperature and pressure are 390 °F ami 1 atm. Calculate the approximate SO2 mass emission rate in Ih/day. (The atomic weight of S - 32 and the atomic weight of O « 16)a. 12,300 Ih/dayb. 16,400 Ih/daye. 24,600 Ih/dayd. 32,800 Ib/day
A teapot with a surface area of 665 cm2 is to be plated with silver. It is attached to the negative electrode of an electrolytic cell containing silver nitrate (Ag+ NO3−). The cell is powered by a 12.0-V battery and has a resistance of 1.30 Ω. If the density of silver is 1.05 104 kg/m3, over what time interval does a 0.133-mm layer of silver build up on the teapot?
The specific gravity of ethyl alcohol is 0.79. Calculate its specific weight in kN/m^3.
Can you explain the how the distance for hb alcohol and ha alcohol
Lake Bonaventure is a lake fed by the Saint Croix River. The Acme smeting company discharges the heavy metal nickel into the lake. The easy way to model the concentration of nickel is to assume the lake is well mixed. It isn’t. The lake has a mean depth of 30m, and during the summer a surface epilimnion of 5m develops, which breaks down for the winter. (no calculations are required to answer the questions below) (A) Given what you know about the hydrology of lakes, what differences in concentration would there be if the smelter discharges at the surface or at a depth of 30m? (B) How would concentrations vary in the lake throughout the year? (C) What if you factor in the fact that the flow of the Saint Croix River is less during the winter?
ENVIRONMENTAL ENGINEERING: WATER POLLUTION For a solution containing 200 mg of glycine [CH2(NH2)COOH] whose oxidation can be represented as: 2 CH2(NH2)COOH + 3 O2 ---> 4 CO2 + 2 H2O + 2 NH3 NH3 + 2 O2 ---> NO3- +H+ + H2O FIND: The theoretical CBOD The untimate NBOD The total theoretical BOD.
Which type of activated carbon is most suitable for gasoline vapor recovery?
Aluminum pieces inadvertently collect on the filter. a. If left on the filter, will the percent yield of the alum be reported as too high or as too low? Explain. b. If the aluminum pieces are detected on the filter, what steps would be used to remedy the observation? Explain.
An activated-carbon bed that is 12 ft x 6 ft x 2 ft deep is used in a benzene recovery system. The system is on-line for one hour and is then regenerated for one hour.
1. Industrial representatives claim that the NAAQS for S02 is so low that one exceeds it if one strikes a simple woodenmatch in a modest-sized room. Is this true?(a) Calculate the concentration (in µg/m3) expected for striking such a match in a room that is 15 ft by 15 ft by 8 ft. A typical2-inch wooden match contains ≃ 2.5 mg of sulfur.