the current and voltage are 64 deg out of phase in an rc series circuit. the apparent power is 260 VA. what is the true power in the circuit?

Q: 4. Calculate the size of the filter capacitor needed to obtain a filtered voltage with 7% ripple at…

A:

Q: Referring to Figure Q2, determine; i) ii) V₁, V2, la and the power delivered by the independent…

A:

Q: 3. Calculate the size of the filter capacitor needed to obtain a filtered voltage with 7% ripple at…

A: We need to find out the capacitor value for given ripple .

Q: Determine the currents I1 and I2 for the network in Fig 3

A: The required current can be calculated by using the ohm's law and the Kirchhoff's current law to the…

Q: A 100 kVA, 230V load operates at 0.80 lagging power factor. The power factor is to be improved to…

A:

Q: Question 3 The system L in the figure is known to be linear. Show are three output signals yı(n),…

A: LTI SYSTEMS A system is referred to as a linear time-invariant system, or LTI system if it possesses…

Q: A 36, 460 V, 100 hp, 60 Hz, six-pole induction machine operates at 3% slip (positive) at full load.…

A: Given that  In a 3-phase induction machine Power=100hp Voltage=460V frequency(f)=60Hz No.of poles =6…

Q: Form the truth table for an 8-to-3 priority encoder. Use w7 W6 W5 W4 W3 W2 W₁ Wo as inputs and and…

A: To do: we have to derive the simplified boolean expression for outputs of 8:3 priority encoder.

Q: 8.6 Given that B = 6xa, - 9ya, + 3za. Wb/m², find the total force experienced by the rec- tangular…

A: Given: In this question, the given details are, The given equation is,  B=6xax-9yay+3zaz Wb/m2 To…

Q: c) Determine the speed of the startor field.

A: We need to find out the speed of stator for given motor .

Q: Using Kirchoff's Laws, determine the values of V and I. Show your step-by-step solution and…

A: We need to find out the current and voltage for given circuit.

Q: The argument of 15cos(12t +30°)

A:

Q: Find the discrete-time equivalent of a double integrator using a ZOH as D/A. 1 2 S G(s) =

A: Given ,              Gs = 1s2Concept:    →        For discrete -time equivalent, s=2TZ-1Z+1    →…

Q: An analog voltage in the range 0 to 10.8 V is divided in 16 equal intervals for conversion to 4-bit…

A: We need to find out the maximum quantization error for given quantization.

Q: 2) In a step-by-step solution, find the current in each resistor using: A. Kirchhoff's Laws. B.…

A: As per our guidelines we are supposed to answer only one question at a time. As you post the…

Q: The source voltage phasor is given by V = 10V at the frequency of 1GHz. The load impedance is Z₁ =…

A: Given data: The source voltage,Vg=10 V Frequency of the source voltage,f=1 GHz Source…

Q: term Phojas slepsiesentation NE) = cos (3wot +30°) + sin(juot-60°) v(t) = (as( swot +30°) + sin…

A:

Q: 3. Find the following (b) V (c) Frequency (d) Period (e) Angular Velocity (f) Phase angle (g)…

A:

Q: A 3-phase, 2-pole, 60 Hz, induction motor operates at 3546 rpm while delivering 20 kW to a load.…

A: Given: In this question, the given details are, A three-phase , 2-pole, and 60 Hz frequency,…

Q: a. In an RC circuit supplied with AC power, a 500 ohm resistor is used to create a system with a…

A:

Q: 24. A sinusoidal voltage is applied to the resistive circuit in Figure 11-80. Determine the…

A: As per the guidelines of Bartley we supposed to answer first time subpart only for solution of…

Q: Your turn: Determine V3 employing voltage division 6 Volt (+ S www 10 202. + V3 +51 402 20 V₂

A: We need to find out the voltage for given circuit by voltage division rule .

Q: Which of the following is/are true for ASK, QAM, and PSK? Select one or more: All these schemes can…

A: Given: Four options about modulation  techniques. To do: We have to select one or more suitable…

Q: For the circuit shown below, thevenin voltage at terminals a-bis 50 www 0.51, 1A 50² ba ob 10 V

A: Given circuit-     To find- Thevenin voltage.

Q: w/ For the wave form shown in fig. below find KF. in 20 10 Y И 8 12 16 20 t

A:

Q: A signal with bandwidth B is naturally sampled using a sampling frequency of fs > 2B. What is the…

A: Given, A signal with bandwidth= B It is naturally sampled with sampling frequency, fs > 2B. We…

Q: The NMOS and PMOS transistors in the circuit below are matched with kn' (WnLn) = kp' (Wp/Lp) = 1 mA/…

A:

Q: Exercise. There is a system that works with a sampling rate of 48 kpsp and requires a bandpass…

A: According to the question, there is a system that works with a sampling rate of 48 kbps and requires…

Q: G₁: T₁: T₂: G₂: Line: Load: G₁ 90 MVA 80 MVA 80 MVA 90 MVA 20 kV 20/200 kV 200/20 kV 18 KV 200 kV…

A:

Q: Consider the given digital system shown in fig. 1; if T-50 ns, a=1 ms, t=1 ns, T₁ = 1 ns, MTBF 8…

A: Given: In this question, the given details are, Here, the given digital system is, The given values…

Q: THEVENIN'S THEOREM  2   find Vth , Rth , IL

A: The thevenin's equivalent circuit can be calculated by calculating the open circuit voltage and…

Q: Why is low-frequency operation the most reliable for TRIACs?

A: TRIAC is a type of thyristor . TRIAC is capable to conduct in both direction.

Q: answer the following questions. Note that M₁ and M₂ have the following parameters: VTH = 0.5v, k =…

A:

Q: What is the firing angle in Problem 1 if all the facts are the same except that the UJT fails and is…

A: Note: Here data from problem 1 is required but problem 1 is not defined. However, problem 1 was…

Q: I tried graphing this transfer function to matlab, are my inputs correct? (bode plot)

A: The given transfer function should be expanded to get the numerator and denominator terms and the…

Q: The plane wave E(r, t) = 2 x cos(wt + Bx) is incident on a planar interface located at x=0. The…

A:

Q: vdc + G C₂ pics vice R 51 Mmm Drive D Vo (de) 2 52 Vocrimis) + VSI + VS₂

A:

Q: Explain the circuit below

A: The given circuit is an astable multivibrator that produces a pulse with a certain duty cycle based…

Q: 12. Using branch-current analysis, find the magnitude and direction of the current through each…

A: (a) The circuit is shown below:  Applying K.C.L at node a,…

Q: Solve the heat equation using the Fourier transform of the squ to solve for the coefficients in the…

A:

Q: Find the expression for the voltage and current of the capacitor as a function of time for the…

A: The voltage and current across the capacitor in the given circuit can be obtained by analysing the…

Q: b) Using mesh analysis, solve the voltage V₁ in the circuit of Figure Q2b. ist 2002 ww 1052 M 1052…

A:

Q: Find the Norton equivalent at terminals a-b of the circuit.

A: The norton's equivalent resistance circuit can be removing the independent sources and then reduce…

Q: Explain each circuit on how it works and its output

A: We have to explain the given circuit. The given circuit is drawn in Proteus software.

Q: Given the following circuit, find Thevenin's equivalent circuit at terminals A-B.

A: The thevenin's equivalent voltage can be obtained by calculating the open circuit voltage and the…

Q: 6. Figure 6 shows a DC resistive circuit. (a) When the switch SW is opened, calculate the current…

A: Given data: The voltage source,V=100 V The resistance connected in the series with the source is 5…

Q: Explain each circuit on how it works and its output

A: According to the question, we need to explain the working of the circuit as shown below

Q: Εγ = 10 V <0° E, = 4 V –—– Figure 1 + I R₁ Xc² Μ HI 6Ω 2 Ω XL voo 4Ω R₂ Μ 8 Ω

A:

Q: Q.8 Load Flow Methods A 3-phase overhead line has reactance of 20 Q. The load at receiving end is 30…

A: Given- 3-phase overhead line, Reactance = 20 ohm, Load at receiving end = 30 MW at 0.85 pf lagging…

Q: 3)A 50hp, pf 1.60 Hz, star-connected synchronous motor has a current induction rating of 108A and…

A: