The data field of a UDP datagram is 8192 bytes. Use Ethernet to transmit. How many datagrams will be divided in the IP layer

Q: Consider the figure below. Cabling between interconnection (router (switch) to switch or WAP)…

A: Given that, In the given cabling interconnection, there full duplex between Router, switches and…

Q: It is said that IPsec may not work with Network Address Translation (NAT) (RFC 1631). However,…

A:

Q: Suppose a wireless router is purchased and connected to your cable modem. Even imagine your ISP can…

A: Clients are assigned IP addresses by the DHCP (Dynamic Host Configuration Protocol) server. In most…

Q: onsider the bandwidth of the line is 1.2 Mbps, packet size is 1 KB and round-trip time is 50 msec.…

A: In Stop and wait only one frame sends at a time and stop sending further and wait for…

Q: What role does IP addressing play in BGP routing? Second, what role does physical topology play in…

A: Introduction: The process of establishing the path for data to take in order to move from one…

Q: Question 2: An end system sends 50 packets per second using the User Datagram Protocol (UDP) over a…

A: An end system sends 50 packets per second using the User Datagram Protocol (UDP) over a full duplex…

Q: You have been asked to bond/aggregate 4 of the gigabit ethernet connections between two switches to…

A: B) LACP

Q: 78. What is the meaning of Bandwidth in Network? a. Transmission capacity of a communication…

A: Answer :

Q: the Interframe gap, calculate the maximum data utilisation of SLTP/UDP/IPv6 packets over a 100 Mbps…

A: It is defined as a type of communication protocol which connects computers on a network over a wired…

Q: like for crt ans   dislike for wrong ans Apply DSA lifecycle to the following: Router (Layer 3)…

A: (i) The matlab code for the series + + + + + انت 302 + 101 5 9 is as follows : numerator = 5;   %…

Q: In which protocol the packets you send will be received in the same order or different order in…

A: In TCP the packets you send will be received in the same order in which network protocol were sent…

Q: Perform subnetting on the IP prefix 47.1.59.0/24 to divide the network into 6 subnets with at least…

A: in the IP address 47.1.59.0/24, 24 bits are allotted to the Network id part. So, 8 bits are remained…

Q: Locate the DNS query and response messages in the packet capture (hint, type "dns" in the display…

A: 1) DNS has two types of messages: query and response. Both types have the same format. The query…

Q: From the above scenario, RIP and internal EIGRP routing protocols were configured on the same…

A: As the routers connect to a total of 4 hosts so the network is small, EIGRP is used for medium to…

Q: While designing your network’s VLAN topology, your team has decided to use a centrally managed DHCP…

A: DHCP Relay Agents: - It is a host that forward DHCP data packets between clients and servers. DHCP…

Q: We want to utransmit Data using the following Network via packet switching Conditions: Maximum…

A: Packet Switching: Convert the packet is the transfer between various networks of small parts of…

Q: What is the difference between forwarding and routing? Who is responsible to add entries in the…

A: Forwarding refers to a device sending a datagram to the next device in the path to the destination.…

Q: 155. Interconnected networks need communication processors such as switches, routers, hubs, and…

A: Interconnected networks need communication processors such as switches, routers, hubs, and gateways.…

Q: Your company has 2 routers. One router has 15 NICs and the other has 3. One network is shared…

A: IP Address: 128.0.0.0 Network Address: 128.0.0.0 Usable Host IP Range: 128.0.0.1 - 128.0.0.2…

Q: Suppose  your network is connected to another network via a router. Network layer  OSI  model layer…

A: Routing information by Network layer in OSI model

Q: If the size of an IP packet handed down to Ethernet is 7000 Bytes, how many fram are required to…

A: It is defined as the small units of data transmission which helps to identify the data packets used…

Q: What is the network-layer protocol used to perform the DNS requests and responses?   A. ICMP   B.…

A: Given: What protocol is utilized to execute DNS queries and answers at the network layer?

Q: How to create subnet (5) in IPv6 network, using 2001:db8::132 host address

A: Create a VPC with a 10.0.0.0/16 CIDR block and associate an IPv6 CIDR block with the VPC.   aws…

Q: A _______ is a three-layer device that handles packets based on their logical addresses. a. repeater…

A: We are asked a question on a device which deals with logical addresses and is used to transfer the…

Q: use layer 3 information to forward packets in a network. Firewalls Switches Bridges Routers Which…

A: Please find the answer below :

Q: the minimum packet size for the IEEE 802.3 LAN standard is 64 bytes and the data rate of the…

A: Lets see the solution.

Q: In X.25 protocol, which of the following performs functions such as connection establishment,…

A: The following step provides the correct answer for the given question with an explanation.

Q: In an OSPF router how would you allot a Gigabit Ethernet interface a lower cost than a Fast Ethernet…

A: According to our company policy we can answer only one question if multiple questions are posted.…

Q: On Cisco Packet tracer, how do I get a Gigabit connection to carry only certain VLANs

A: Cisco suggests that you know about the data in this segment.   VLANs are a component to permit…

Q: ompare the UDP and TCP packages for sending 6000 bytes of the data on the Ethernet frame using ipv4…

A: According to the information given:- We have to Compare the UDP and TCP packages for sending 6000…

Q: Host A sends IP datagrams to host B and passes through five routers on the way. How many times did…

A: Given that, Host A is sending IP datagrams to the Host B. In between Host A and Host B, there are…

Q: In this Question, you have been given the network address 13.0.0.0/8 to subnet and provid the IP…

A: Network Address Block Subnet Mask 255.0.0.0/8 255.128.0.0/9 255.192.0.0/10 255.224.0.0/11…

Q: Data is grouped into packets in the ___ layer.   At which layer do router devices operate?

A: Note: we are only allowed to solve one question in one post. i have solved two for you.To get…

Q: Can you set your window to open several simutaneous Web site connections? What are the benefits and…

A: Ans --  Yes, you can configure your window to open several simultaneous connections to a website. It…

Q: If your router is facilitating a CSU/DSU, which of the following commands do you need to use to…

A: The required command is given below -

Q: Supposing you have a packet whose length is 1500 bytes,calculate the transmission delay for the…

A: In given question, we have to first check maximum transmission rate(i.e., Bandwidth) and then find…

Q: Consider a 10 km long broadcast LAN has 10^10 bps bandwidth and uses CSMA/CD. The signal travels…

A: Here in this question we have given Given --- Distance= 10 km  Bandwidth= 10^10 bps speed =2.5 *…

Q: Consider the figure below. Cabling between interconnection (router (switch) to switch or WAP)…

A: Given that, There is full duplex between the router, switches, and WAP in the supplied cabling…

Q: Two hosts simultaneously send data through the network with a capacity of 1 Mpbs. Host A uses UDP…

A: The reason why UDP is faster than TCP is due to the absence of an acknowledgement packet (ACK) that…

Q: 16) a layer 4 connection, what action should a system take if it receives a synchronize packet?…

A: In this question we need to find that if a system receives a synchronize packet in layer 4…

Q: Question 3: Consider a non-standard Ethernet segment. The maximum distance between the two computers…

A: Dear Student, To solve this problem we need bandwidth of signal as bandwidth of signal is not given…

Q: Question 3: Which one of the following statements is FALSE? 1. Packet switching leads to better…

A: Lets see the solution in the next steps

Q: yer    C) Application layer    D) Internet layer   Answer: iv) How many bits are used in the IP…

A: 1) Internet layer is for routing packets in TCP/IP architecture. Hence answer is d) 2)Internet…

Q: Question 3: a server and receives a corresponding reply also with 60 B of data. The client and…

A: Solution : Check the detailed solution below.

Q: Suppose you purchase a wireless router and connect it to your cable modem. Also suppose that your…

A: Actually, given information Suppose you purchase a wireless router and connect it to your cable…

Q: Which of the following device copies electrical signals from one Ethernet to another? a. hub b.…

A: Given that: Which of the following device copies electrical signals from one Ethernet to another.

Types Of Protocols

A network protocol is a collection of rules that governs the exchange of data between devices connected to the same network. In other words, network protocols are rules that specify how devices communicate or transfer data over a network. The sender and receiver systems must obey the standards to facilitate communication between them.