The device that is used to remove the unwanted components or features from the signal is DAQS Сарacitors Resistors

Q: The Auto transformers are used to provide a variable voltage output. Select one: O True O False

A:

Q: Ql: Use any analyzing method to obtain the value of I, 20 $/0° A -20= 20

A: The resistance of 2Ω and -j2Ω are in parallel. So, the equivalent of the two is:…

Q: Draw circuit for the following expression !(xz)+(!yz)+(xy!z) Remember, there are no 3-input circuit…

A: In this question there have mentioned the Boolean expression .   First of all we have to simplify…

Q: Use mesh analysis to wri quations in Figure shown E

A: Given network is shown below.

Q: It's a low-frequency oscillator circuit that's relatively stable and easy to tune, and it's often…

A: The solution is given below

Q: Find VTh j60 N 240/0° V(A 36 2

A:

Q: Using the sum series below, where R1 = 5K; R2= 20K; R3 = 10K; R4 = 20K. Determine the output voltage…

A:

Q: Q4: Draw the output voltage vs input voltage for the circuit below, if the input is (V= 3 sin400nt)

A:

Q: Chapter #3 Oscillators HW # 1 Find R and the frequency of operation [rad/sec] for the circuit below:…

A:

Q: Find this simple circuit configuration (Vth & Rth) seen from the output terminals

A:

Q: Find Do andk, by using nodal analysis. 20 40 V 50

A: According to question we have to find the value of Vo and Ix with the help of nodal apply to the…

Q: In the following JFET circuit, the source voltage is: VDD +15 V Ip 5 mA Rp 1.0 kN VG =0 V Rs 220 N…

A: We need to find out source voltage .

Q: 3V analog output is equivalent to diğital input word 011. Select one: True False

A:

Q: (За, х 4аф) х 2а,- Select one: O a. None of these O b. 2 O c.2 az O d.0

A:

Q: Example Sketch the root loci for the system. K(s+ 1) (s+3.6)

A: In this question,   We need to draw the root locus of the given system.

Q: The first stage of FM demodulation be implemented can by a) Converting WBFM to NBFM b) Converting…

A: The process of extracting a modulating signal from a modulated carrier is known as demodulation. The…

Q: circuit Select one: O True O False

A:

Q: The parameters that are mainly used in * electronics circuits are Z Parameters Y Parameters H…

A: About electronic circuit parameters

Q: Solve the approximate value of Rg of Figure 44. vc 12V |RC RB v.= 7.6V Beta = 80 V = 2.4V RE 1.2ka…

A: From given emitter voltage calculate emitter current and than find base current . Now using ohms law…

Q: QI) What range of output voltage is developed in the cireuit of figure below if the I= 0.066 mA, I=…

A:

Q: Discuss the system stability for all values of k. 54 +5³ +5² = -1-K₁s¹ ² 3 Q(s) = $¹4_

A:

Q: A standard second order system has 40% overshoot and settling time of 7 seconds. Determine w,, 5, T,…

A:

Q: QI\ An ac bridge has the following constants: arm AB, R=8002 in parallel with C=0.4µF; BC, R=5002 in…

A:

Q: Using simplified model, determine Vp. VR, and Ip +0.5 V Ip SiY VD R21.2 k2 VR

A: In this question we need to find a value of ID , VD and VR.

Q: 1) Consider the following cireuit: 12k? 5kN 8kN Vout.a E 72V 20k? Vout a) Find the Thévenin…

A:

Q: 3. Sketch the output V for the given network below. 0 V₁ 20 V 100 ΚΩ -20 V

A: In this question we will find output Vo for given circuit below-

Q: power sistems analysis

A:

Q: Working Standards: } Principal tools of measurement lab. Ex.: calibrating using standard resistor }…

A: Although there are four type of measurement standards 1-International 2-Primary 3-secondary…

Q: Employ A-Y conversion techniques as appropriate to determine Rin as labeled in the given circuit. In…

A: The given circuit diagram is shown below, Where, Rx = 14 ohm

Q: R-10 Km V input ww Ac Voutput source R-10 Am mux Hscope input 1/(Ts+1)

A:

Q: 1. Determine Vo and sketch output waveform. Determine v, for each network of Fig. 176 for the input…

A:

Q: ) Design an asynchronous Mod-N descending counter, where N=3+

A:

Q: Vs O Rs m +5V V₂

A:

Q: Autotransformer is used to increase the frequency in this lab experiment Select one: True False

A: Variable auto transformers are used in the laboratory and industry to provide a wide range of ac…

Q: What is Power Analysis

A: The solution is given below

Q: RJ 11 connector is larger in size than the RJ 45 connector. Select one: True False

A: The solution is given below . The statement is False

Q: Calculate the equivalent resistance Rab at terminals a-b in Figure Q12. 10Ω a 80 Ωξ 60 Ως 20 Ωξ $30…

A: we need to determine Rab.

Q: Given that V 15V, the value of I, is Is + Vs Vx 50 20 Ω

A:

Q: Ri 30 ko 10 k2 5 kQ Consider the following circuit and find Ri seen by the input voltage. S zelfon:…

A:

Q: - Interpret by drawing the output graph of the clipping circuit, whose input voltage and circuit…

A:

Q: Sketch V. and determine its values. 120 V Idenl A

A: Given : Brief description: In the given question they have mentioned positive clamper circuit.…

Q: AC is more conveniently distributed than DC. Select one: O True O False

A: Force is made by generators at power stations and a short time later passed on by an immense…

Q: If the output of a transistor amplifier is 13 V rms and the input is 186 mV rms, the voltage gain is…

A: Output voltage V0 = 13Vrms Input voltage Vin =  186 mV rms Voltage gain Av = ?

Q: Sketch the output voltage waveform vo(t) for the circuit shown and given the input voltage waveform…

A:

Q: 4. The output power for an audio amplifier is specified to be 38 dBm. Convert this value to (a)…

A: Given, The output power for an audio amplifier is specified to be 38 dBm.

Q: The standard Voltage and Select one: True False The property of storing ch Select one: True False

A:

Q: 1. Find I, VR and Vc. 20 N -j25 N VR 240/30° V

A:

Q: A digital instrument will have a graduated scale in its construction. Select one: True False

A:

Q: implement Z=A+B using NAND implimentation by converting it into its SOP form first.

A: SOP form of Z = A + B  And implementation using NAND gates

Q: Find Vo 125 N 75 N 50 N 40 V 300 N 25 N 500ia vo 200 N

A: Basic question on network analysis , there is one important thing in this that the current will flow…

Power Amplifier

The power amplifier is an electronic amplifier designed to maximize the signal strength of a given input. The input signal strength is enhanced to a high enough level to drive output devices such as speakers, headphones, RF (Radio frequency) transmitters, etc. Unlike voltage / current amplifiers, the power amplifier is designed to drive core loads directly and is used as a storage block in the amplifier series.

Maximum Efficiency Criterion

In every field of engineering, there is a tremendous use of the machine and all those machines are equipped for their popular work efficiency so it very much important for operation engineers to monitor the efficiency of the machine, planning engineers to check out the efficiency of the machine before installing the machine and design engineers to design machine for higher efficiency than and then the utility will procure their products that will ultimately lead to profit and loss of the company. It indicates the importance of efficiency right from the initial stage as manufacturing units, intermediate stage as planning coordinators, and end-users stage as a utility.