Answered: The Doppler radar shown below is…

The Doppler radar shown below is operating at 10 GHz and intended to detect target velocities ranging from 5 to 50 m/sec. What is the required bandwidth of the Doppler filter?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: 2. At a certain time, the MUF for transmissions at an angle of incidence of 750 is 17 MHz. what the…

Q: A lossless resonant dipole antenna, has the pattern of the antenna is given approximately by U=Bo…

Q: 2. Compute for the EIRP for a transmitting power of 30W and an antenna gain of 45 dB.

Q: Q5] Answer the following: a) Increasing the transmitter power of a radar by a factor of 5 will…

A: a) increasing the transmitter power of a radar by a factor of 5 will increase the maximum range by…

Q: The current design of a spacecraft transmitter has the following characteristics: f= 3 Ghz, P₁ = 5…

Q: (a) Describe isotropic, directional and omnidirectional antenna patterns.

A: Since you have asked a multipart question, and questions are interconnected. hence we will solve the…

Q: A doppler radar is working at 9GHZ, determine: a) The measured frequency shift when observing a car…

A: Given data:

Q: :Design an antenna with omnidirectional amplitude pattern with half-power beamwidth of 900 with…

A: Since the half-power bandwidth is 90° the angle at which the half-power period occurs is θ = 45°

Q: What is the distance to the radio horizon for an antenna that is 40 m above the top of a 4000 m…

A: Given: Mountain height h1=4000 m Antenna height from mountain h2=40 m

Q: ****** Calculate the minimum value of the transmitted power of a pulsed radar signal in order to…

Q: 4. A coherent ground-based radar system has a pulse length of 1 microsecond, a PRF of 8 kHz, and an…

Q: Evaluate the width of the frequency band around fo=29 GHz within which the reflectance of the radome…

A: General introduction of Radome and Reflectance. Radome is basically defined as the protective…

Q: Skample 1: Consider an antenna transmitting a power of low at goOMHz. Calculate the received signal…

Q: The maximum radar cross section for a resonant half-wave length dipole is 0.85A2. the frequency is…

A: Given, Frequency, f=10 GHz Distance, R=1000 m Gain of the transmitter, Gt=20 dB Gain of the…

Q: A radar antenna used for both transmitting and receiving has a gain of 200 at its operating…

Q: 1GHz satellite antenna has an E-plane beam-width of 12º and on H-plane beam-width of 10°. The…

A: SOLUTION GIVEN--> Frequency f=1GHz…

Q: 1. A radar has a pulse length of r = 10 µs, an azimuth beamwidth 0, = 3°, and an elevation beamwidth…

A: Given, Pulse length (τ) = 10μsAzimuth beamwidth(θ3) = 3°Elevation beamwidth (ϕ3)=3°and…

Q: How much error in the vertical position occurs if the GNSS antenna is mounted on a 2.25-m pole that…

A: Antenna: It is a device that used to transmit or receive radio or television signals. GNSS…

Q: 6. Consider a directional antenna that has a gain of 10 dB and radiates 20 Watts. How much power an…

A: EIRP is used to measure the effective power in one direction from an ideal isotropic source. The…

Q: Find the maximum range of a tropospheric transmission for which the transmitting åntenna height is…

A: Given information: Height of the transmitting antenna is Ht=100 ft Height of the receiving antenna…

Q: In a Long range microwave communication system operating at a 12GHz, the transmitting and receiving…

A: According to question, we have to calculate gains (in dB) of transmittingand receiving antennas be…

Q: 4/ Calculate the minimum value of the transmitted power of a pulsed radar signal to detect a target…

A: It is given that: Cross-sectional area=σ=10 m2Distance=D=120 km=120×103 mFrequency=ν=35 GHz=35×109…

Q: Q3/ Consider a radar system with P, -1,000,000 W GANT = 28 dB 1= 100 us Te - 200 K f= 10 GHz What is…

A: The unwanted part of signal is called noise. Noise is equal to standard deviation of signal.…

Q: Consider a lossless antenna with a directive gain of +6 dB. If 1 mW of power is fed to it the total…

A: Solution Lossless antenna with directive gain of +6dB = 100.6 =4 (In linear) Input power to antenna…

Q: Find the far field distance for an antenna with maximum dimension of 2 m and operating frequency of…

A: For an antenna having a maximum dimension d, the far-field distance can be expressed as

Q: An L band pulse radas has Common transmi tHting and receiving antenna. The antenna havi ng…

A: Radar is used to detect object and its location. It work on electromagnetic wave . Radar is used in…

Q: The radiation intensity pattern expression for an antenna is given by: F(0) 0 elsewhere Determine:…

A: This is a basic problem of antenna characteristics The formula and calculation is given below

Q: Design a horn antenna to be working on 14 GHz with 10°of half power beam angle of E-plane, H-plane…

A: According to question: The wavelength at 14GHz is calculated as ∵λ=cf⇒λ=3×10814×109⇒λ=0.0214m Let…

Q: Estimate the diameter of a paraboloidal reflector antenna required to produce null beamwidth of 10o…

A: In this case, the frequency of operation is 3 GHz. So, the value of the corresponding wavelength…

Q: Calculate the power gain of a horn antenna of square aperture with the aperture area of 100 times…

A: The power gain of a horn antenna can be expressed as In this problem, the aperture area is given as…

Q: 9. Ferromagnetic sphere with saturation magnetization M;=0.6 is placed in resonant cavity tuned to…

A: Given: Saturation magnetization of a Ferromagnetic sphere=0.6 Field at which resonant absorption is…

Q: A radar antenna, used for both transmitting and receiving, has a gain of 150 (dimensionless) at its…

Q: Define the following terms: Radiation resistance, Bandwidth, Antenna effective aperture,…

A: Radiation resistance The radiation resistance of a receiving antenna depicts the antenna's source…

Q: termine the radio horizon for a transmit antenna that is 100 ft high and a receiving antenna that is…

Q: At 20 GHz, the gain of a parabolic dish antenna of I meter diameter and 70% efficiency is-------

A: The gain for the parabolic dish antenna is given by:

Q: 9. Ferromagnetic sphere with saturation magnetization M;-0.6 is placed in resonant cavity tuned to…

A: For an anisotropically magnetized medium, the anisotropy constant is a measure of how divergent the…

Q: 3.4 A DBS-TV receiving antenna has a circular aperture with a diameter of 0.6 m and operates at a…

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost other…

Q: 1. Determine the following; (a) What is the wavelength of an 800-MHz signal? (b) What is the…

Q: 12.4. A coherent ground-based radar system has a pulse length of 1 microsecond, a PRF of 8 kHz, and…

A: Radar : Radar is a detecting technique that employs radio signals to calculate distance, velocity…

Q: A pyramidal horn antenna with aperture dimensions of 9 ×8 cm and operating at 5 GHz. What will be…

A: The directivity of a pyramidal horn antenna can be expressed as

Q: Q₁: Answer the following sentences with (True) or (False) then correct the false sentences: 1- 2 3-…

A: We need to tell about whether the given statement is true or false .

Q: 3.8 An earth station antenna has a circular aperture with a diameter of 6.5 m and an aperture…

Q: Directivity of antenna radiating at 15 MHz is 2.5 dB. What will be effective aperture of the…

A: Write the expression for effective aperture of the antenna.

Q: A bistatic radar system is operating at 4 GHz. GT = 30 dB and GR = 15 dB, The Tx - Rx antennas of…

A: Given, A bistatic radar system is operating at frequency, f = 4 GHz Gt =30 dB = 103 Gr =15 dB =…

Q: An L-band pulse radar nas transmitting and receiving antenna. The antenna having directive gain of…

A: Radar is used to detect object and its location. It work on electromagnetic wave . Radar is used in…

Question

The Doppler radar shown below
is operating at 10 GHz and
intended to detect target
velocities ranging from 5 to 50
m/sec. What is the required
bandwidth of the Doppler filter?
so
Antenna
Circulator
fま。
fo土
Display
Doppler Filter Amplifier
0.3 kHz
3 kHz
300 kHz
30 kHz

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step by step

Solved in 5 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Types of Waveguide and Its Characteristics

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A mobile phone antenna with a gain of 2 dB transmits a 0.5 W signal to a base station with an antenna gain of 8 dB. Assume the minimum sensitivity of the receiving antenna to be Pr = -110 dBm. If the operating frequency is 700 MHz, what is the maximum allowed distance between the base station and the mobile phone?.
2.) The power density is 4 mW/m² at some distance R from an isotropic antenna. The isotropic antenna is replaced with a different antenna and the power density measured is now 60 mW/m² at the same distance R. What is the gain (in dB) of the second antenna? 3.) The received power at an airplane is calculated as Pr=-43 dBm at a range of 13 miles using free-space propagation. Determine the received power (in dBm) at a range of 52 miles.
Wirless communication Determine the carrier-to-noise density ratio for a receiver with a 70 dBW input carrier power,an equivalent noise temperature of 180 K, and a bandwidth of 20 MHz.
4. short answers a. What is the effective antenna area of an antenna at 2500 MHz, if the gain is 13 dBi. b. For a WCDMA handset with 7 dB noise figure and 5 MHz effective noise bandwidth, calculate the noise floor in dBm. c. An NBA basketball player is close to 2 meters tall, and an “Umpa-Lumpa” from the movie “Willie Wonka” is 0.5 meters tall. Assuming 2-ray propagation model, what is the ratio of the signal strength received by the two people? d. Consider a 12-km microwave link with 15 meter towers at both ends, calculate the minimum frequency in GHz, such the first Fresnel zone does not intersect the ground? Assume that the ground is flat between the towers.
Consider a receiving antenna with a ground value of 20 dB and an equivalent noise temperature of 12dBK, the G/T factor will be: Select one: A. The value is 32dB/K b. The value is 8dB/K c. None of the results is correct d The value is -8db/K
You have an FSK transmitter using a mark frequency of 500 kHz, a space frequency of 380 kHz, and sending 10 kbps. A) How much bandwidth do you need for your transmission? B) if you are to design the system with continuous phase shift keying in mind, what would be the value of the space frequency if the mark frequency remains the same?
Use the free space model and the following equation to compute the received power in dBm for a 900 MHz signal travelling to a receiver 200 meters away. Assume the transmitter antenna gain is 10 dB and the receiver antenna gain is 3 dB. Assume the power at the transmitter is 22 dBm. (Note: Pr dBm is the received power in dBm, Pt dBm is the transmitted power in dBm, PL dB is the free space path loss in dB, Gt dB and Gr dB are the antennas gains at the transmitter and receiver, expressed in dB, respectively) state the answer in the correct units and show all your computations to receive credit
In a certain cell of a cellular mobile communication system, the serving base station is located 4 Km from the mobile station. The base station and the mobile station antennas have gains of Gt=30 and Gr=20, respectively. The transmitted power from the base station is 100W with carrier frequency of 910 MHz. Assume free space propagation model, the received signal power in dB at the mobile station is approximately -56 dB -62 dB -36 dB -76 dB
A satellite in synchronous orbit is used to communicate with an earth station at a distance of 7.6 ×10^7 m. The satellite has an antenna with a gain of 15 dB and a transmitter power of 3 W. The earth station uses an antenna with gain 50 dB. The frequency band is at f = 9.8 GHz. What is the free space path loss in dB? Also, determine the received power level at the output of the receiver antenna in dBW.
In a broadcast superheterodyne receiver having no RF amplifier, the loaded Q of the antenna coupling circuit (at the input to the mixer) is 100. If the intermediate frequency is 455 kHz, calculate the image frequency and its rejection at 25 MHz.
A satellite transmitter operates at 4 GHz with an antenna gain of 40 dBi. The receiver 40,000 km away has a gain of 50 dBi. If the transmitter has a power 8 W, ignoring feedline losses and mismatch, find (a) the EIRP in dBW (b) the free space path loss, (c) the power delivered to the receiver in W and dBm
Q. A base stationcellular communicationsystems lossless antenna has a maximum gain of 16 dB (above isotropic) at 1,900 MHz. Assuming the input power to the antenna is 8 watts, what is the maximum radiated power density (in watts/cm2 ) at a distance of 100 meters? This will determine the safe level for human exposure to electromagnetic radiation.