The drift velocity is given as V=µE Sketch the graph between V and E

Q: Find Z for the maximum average Power transfer to the Lead for the circuits Shown below. JIr

A:

Q: After MOV AL, 0BCH           DAA                                                AL=______________

A: AL = 22

Q: Determine V. for each network shown. Sketch the output waveform. 12 V Si 22 kO 1.8 LQ 12V

A: we need to determine V0 and sketch output waveform.

Q: A B QA find Q using Bolenn algebera 1 1

A: Any Boolean function can be expressed either in its sum-of-product (SOP) or the product-of-sum (POS)…

Q: The factor that can worsen the transfer of energy from the transmitter to * the antenna is mismatch…

A: In order to deliver energy faithfully from transmitter to receiver following should be followed by…

Q: The angle at which a wind turbine generator rotates is called its pitch. Select one: True False

A: In this question we need to verify the given statement is true or false

Q: Find the average value of the voltage signal v(t), such that Vm = 4.5 V and time period T = 3.2 s.…

A: Given, Voltage signal, Vm=4.5 VT=3.2 s

Q: (e) Which of these frequencies has the long period? 1- 25 rad/s 2- 50 Hz

A:

Q: The power radiated by an AM transmitter for 100% modulation is 900 W. Find the power radiated by the…

A: Given, For 100% modulation, μ1=1 Total radiated power, Pt1=900 W For 70.7 % modulation, μ2=0.707 The…

Q: In a certain media with ̟µ = µ0. plan wave electric field is given by E(z,t) = 50 cos (10*t + 2z )a,…

A: Ez,t = 50 Cos108t + 2zay V/m ---------- 1) E = E0 Coswt + βz ayV/m ----------- 2) On comparing…

Q: 12. The normalized impedance zL=0.2-j0.2 lies on O the open circuit location O None of them O the…

A: The location of Point in the Smith chart can be found by comparing the given normalized impedance…

Q: 12. The normalized impedance zL=0.2-j0.2 lies on the open circuit location the horizontal line of…

A: The location of the given Point can be found on the Smith chart by comparing the given normalized…

Q: The angular velocity is 5 rad/sec. What will be the change in power angle after 0.2 sec for a…

A: Given that  ω=5 rad/sect=0.2 sec

Q: Two identical waves travel in the same direction, each with a wavelength = 0.5 m and speed v = 20…

A: NOTE :- We’ll answer the first question since the exact one wasn’t specified. Please submit a new…

Q: ! Required information Consider the following signals. x (t) = 8 (t – 2) Graph the magnitude and the…

A:

Q: What is the corner frequency for: 200 T (s) = s+10 Owc = 200 (rad/s) Wc = 20 (rad/s) Owc 0.05…

A: The transfer function is given as: Ts=200s+10 The above transfer function represents the TF of the…

Q: Find the root for the following equation that lies within the period [-1,0] using the Regula Falsi…

A:

Q: Q2: Determine the magnitude and phase for three-point moving average system y(n) = 1/3 [ x(n+1) +…

A:

Q: Calculate and sketch the magnitude and the phase of H(w) for: y(n) = x(n) + x(n - 3) %3D

A:

Q: Question 5 Given V, = 20 sin(@t + 60°) and V, = 60 cos(wt – 10°). What is the phase angle between…

A:

Q: the

A: In this question, induction machine frequency given and speed of machine given..We have to find out…

Q: The amplitude of the AC voltage at home electrical outlet is 120 V. Select one: True False

A: The electricity is available at the at 240 V in from the service main to the house. The power supply…

Q: 6. A voltage has a frequency of 150 Hz. what is the angular velocity? 16.67 ms .667 ms 157 rad/s 942…

A: To calculate the angular velocity

Q: An alternating voltage is given by v 261.03cos341t V. Find the frequency

A:

Q: Example In the following cases, the x-axis carries a scale of t in milliseconds. (a) у 4 (b) (c)…

A: Time period: Time period is known as the time taken for one complete oscillation to occur. It is…

Q: Sketch the following signals: a) 26 (п) + 36 (п + 1) + 16 (п — 1) b) и (п) + 26 (п — 2) с) 2…

A:

Q: Average value is always measured over half a cycle. Select one: O True O False

A: Given:  Brief description: In the above given question they want to know the concept of average…

Q: Calculate the skin depth (in microns) for bronze ( = frequency f= 100 MHz $) a S.) m 107 S at a

A: Given data, For bronze Conductivity, σ=107 S/m Frequency, f=100 MHz

Q: 7. For the signal, x(t)= log(cos(a*pi*t+d)) for a = 25 Hz, what is the time period of the signal, if…

A:

Q: 1.Find a b if lal =26 ahd Ibl =17 and the angle between them is 60°.

A:

Q: Problem: At 8:00AM a lighthouse is north of a ship. Thirty minutes later the lighthouse bears N…

A: θ=40°45'  =40°+4560°  =40°+34°  =40.75°

Q: What impedance vector (0- j15) Ohms represents:

A:

Q: The carrier phase's relative angular displacement (shift) in radians with regard to the reference is…

A: The carrier phase's relative angular displacement (shift) in radians with regard to the reference is…

Q: Q30. The angle between El and the normal to the surface of Q27 23.4 27.5 None of these

A:

Q: Problem 16: Find the frequency and period of sine waves having an angular velocity of: a. 754 rad/s…

A:

Q: Find the average voltage value for the signal shown below for t=0 to10 (ms): V (V) 25

A:

Q: What is the frequency in hertz if the period is 15ms? 66.67 33.33 60.00 O 99.99

A: Given, Time period, T = 15 ms = 15×10-3 sec

Q: The Amplitude of waves  can be defined as

A: given wave

Q: (a) 8 12 8 (a) (b) 12 12 Determine the average power in the first four harmonics of each signal…

A: (a) For the first signal, lets find the Fourier series:

Q: . Sketch 5 sin 754t with the abscissa:

A: Equation of line with slope is- y=(y2 -y1  )/(x2-x1) x+C

Q: Obtain the following a.) exponential frequency b.) rise time c.) time constant d.) settling time.…

A:

Q: The electric field intensity is Ē(:.1) =(2à, – jà,)e* in a non-magnetic medium. The intrinsic…

A: The angular frequency is 108  rad/sec. And angular frequency w= 2πf So f=w2π Putting the values we…

Q: Determine  period or aperiod , if it is periodic find the fundamental period.

A:

Q: C) For an AM Radio, the message Root Mean Square is 1.5vZ. Plot the AM signals using the following…

A: Vrms = 1.5 √2 Vmax  = √2 × Vrms  = 3

Q: The voltage between lines in a transmission line is the maximum value of the sine waveform. Select…

A: The voltage between lines in transmission is maximum value of the sine waveform?  True or false…

Q: Q1/ For the below system, if you know that the input is (t) = A sin(wt), explain and draw the…

A:

Q: The voltage between lines in a transmission line is the maximum value of the sine waveform. Select…

A: The voltage between lines in the transmission line is maximum value of the sine waveform

Q: 1) Sketch the following signals: a) 26 (п) + 36 (n + 1) + 16 (п — 1) b) и (п) + 26 (п - 2) с) 2…

A:

Q: Maxwell's bridge is accurate for the measuremen coil inductance in milli Henry to several Henry…

A: Maxwell bridge is accurate for the measurement coil inductance in mili Henry to several Henry range?…