The elements of a wheel-height adjuster for a lawn mower are shown. The wheel (partial outline shown dashed for clarity) bolts through the hole at A, which goes through the bracket but not the housing H. A pin fixed to the back of the bracket at B fits into one of the seven elongated holes of the housing. For the position shown, determine the magnitude of the force at the pin B and the magnitude of the reaction at the pivot O. The wheel supports a force of magnitude W/4, where W is the weight of the entire mower.

The elements of a wheel-height adjuster for a lawn mower are shown. The wheel (partial outline shown dashed for clarity) bolts through the hole at A, which goes through the bracket but not the housing H. A pin fixed to the back of the bracket at B fits into one of the seven elongated holes of the housing. For the position shown, determine the magnitude of the force at the pin B and the magnitude of the reaction at the pivot O. The wheel supports a force of magnitude W/4, where W is the weight of the entire mower.

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter2: Basic Operations With Force Systems

Section: Chapter Questions

Problem 2.80P: The figure shows one-half of a universal coupling known as the Hooke's joint. The coupling is acted...

See similar textbooks

Similar questions

The homogeneous bar AB weighs 25 lb. Determine the magnitudes of the forces acting on the bar at A and B. Neglect friction.
The center of gravity of the 3000-lb car is at G. The car is parked on an incline with the parking brake engaged, which locks the rear wheels. Find (a) the normal forces (perpendicular to the incline) acting under the front and rear pairs of wheels; and (b) the friction force (parallel to the incline) under the rear pair of wheels.
What is the ratio L/R for which the uniform wire figure can be balanced in the position shown?
The uniform 240-lb bar AB is held in the position shown by the cable AC. Compute the tension in the cable.
The figure models the handle of the water cock described in Prob. 4.9. Draw the FBD of the handle, neglecting its weight. Count the unknowns.
The figure shows one-half of a universal coupling known as the Hooke's joint. The coupling is acted on by the three couples shown: (a) the input couple consisting of forces of magnitude P, (b) the output couple C0, and (c) the couple formed by bearing reactions of magnitude R. If the resultant of these couples is zero, compute R and C0 for P=750lb.
The 12-lb force is applied to the handle of the toggle cutter. Determine the force exerted by the cutting blade CB on the workpiece E.
SITUATION 1. The quarter circular plate is subjected to forces as shown. If the plate weighs 50 kg, and assuming equilibrium
Practice Problem 2.4.16: The couple acts on the handlesof a steering mechanism. In the position shown, themoment applied by the couple about the z-axis is zero.Determine the distance b.Use F = 200i − 110j − 80k kN.
For the system shown (for the extension strokes of the cylinders), what pump pressure is required if the cylinder loads are 12000 lb each and cylinder 1 has a piston diameter of 6in?
The cable spool shown at the right has a weight of 50 lbs and has a moment of inertia of .28 slug-ft^2. Assume the spool rolls without slipping when we apply a 50-lb tension in the cable. Find: friction force between the spool and the ground.
The hydraulic cylinder shown exerts a force of 3 kN directed to the right on point B and to the left on point E . Determine the magnitude of the couple M required to rotate the drum clockwise at a constant speed.