The following data was obtained from a field study to determine how a toxic pollutant reacts. Determine the order reaction and the rate constant, with proper units. day time (d) 0.25 0.5 1 2 2.5 3 3.5 concentration (mg/L) Ct (mg/L) 15 12 10 8 3 1 0.5 0.02

The following data was obtained from a field study to determine how a toxic pollutant reacts. Determine the order reaction and the rate constant, with proper units. day time (d) 0.25 0.5 1 2 2.5 3 3.5 concentration (mg/L) Ct (mg/L) 15 12 10 8 3 1 0.5 0.02

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: A funnel in the shape of a cone having an area of base 0.093 sq. m and an altitude of 0.30 m, has a ...

A: To determine the: downward force required to fold the inverted cone down least scale reading Giv...

Q: The thin-walled tube is used as a beam to support the uniformly distributed load of intensity wo. (a...

Q: SN kN/m EN kN/m www AL D 20.9m 20.1m 50.74m 30.56m 30.89m

Q: MA

Q: Draw the shear and moment diagram using the long method. Check your answer using the area moment met...

A: Area of loading diagram gives shear force. Area of shear force diagram gives bending moment.

Q: The following are OSnaps except: O Quadrant O Farthest O Parallel Insertion

Q: he acceleration of a particle as it moves along a straight line is given by a = (2t - 1) m/s², where...

A: This question is related to the Vector Mechanics from Mechanics Engineering.

Q: Three equal wheel loads of 50 kN each, separated by 3 m between each load, roll as a unit across a 1...

Q: The same torque is applied to two tubes with identical metal sheets, determine the ratio of Tsquare/...

Q: The cantilever beam carries a combination of a uniformly distributed load and a trapezoidal loading ...

Q: 2.5 cm 7.5 cm- -5 cm- 66 C 370 C- Concrete cInder block k = 0.76 W/m.C = 0.11 W/m.C aujd

A: Given, Concrete cinder block=0.76 W/m°C Building brick=0.69 W/m °C Yellow pine=0.147 W/m°C

Q: 4. Given the forces shown, determine the resultant moment about point A. 2 lb A 1' 3 lb l' 1 lb

Q: 1. Find the magnitude and direction of the resultant of the forces acting on the bracket as shown. F...

Q: The hydraulic conductivity (K) of a homogeneous sandy clay mix aquifer is 2x10-3 cm/sec. The hy...

Q: Prob 01: The rigid bar ABC in figure below is hinged at A and supported by a steel rod at B. Determi...

Q: 35% d) What is the internal angle of friction for these two conjugate faults? 120° Figure 6

Q: qual wheel loads ted by 3 m betw ross a 10-m. De SS

Q: 3. An aluminum shaft with a constant diameter of 50 mm is loaded by torques applied to gears attache...

A: Given data in question Diameter Length Modulus of rigidity Torque To find out Angle of twist of ...

Q: A steel tube is 5 millimeters thick and has an outside diameter of 60 millimeters. It is being used ...

Q: 3) The masses of the person and the diving board are 54 kg and 36 kg, respectively. Assume they are ...

Q: Design the T beam for the floor system when subjected to an ultimate moment of 300 kN-m. Beam span i...

A: Given data: Ultimate Moment M = 300 Kn-m web width (bw) = 300 mm slab thickness (hf) = 100 mm effect...

Q: Two tangents intersecting at V with azimuths of 255⁰12’ and 281⁰24’ respectively are joined by a 4⁰ ...

A: Calculate the intersection angle as below Vertex angle (I) = 281°24' - 255°12' = 26°12' Radius of cu...

Q: Determine the reactions at the following: A (Normal) - Blank 1 kN B (Horizontal ) - Blank 2...

Q: Two processes can be used for producing a new engine. Process A will have a first cost of P750,000, ...

Q: In the MIPS instruction "jr $1", what information does register $1 contain? the address of the...

Q: A 50 m run of core drilled horizontally from an underground drift allowed to recover 42 m of rock co...

A: Step 1: Rock Quality Designation: L- 50 m run of core drilled horizontally from Length recovered- 38...

Q: Calculate the variations of o, u, and o' at points A, B, and C, and how high should the groundwater ...

Q: g Classification/Category: Section 103 Table 103-1 2. Basic Wind Speed: Figure 207A.5-1A,B,C 3. Expo...

Q: LEIS company is planning to borrow P10.5M for a company expansion and is not sure what the interest ...

Q: in bullet form list structural work of beam

A: Structural work of beam

Q: Situation 1: Starting from rest with the position shown. Neglect the mass of the pulley and assume a...

Q: The kinetic energy of a 4.0 kg object moving at 3.0 m/s is:

A: Given data : The velocity of moving object=V V=3 m/s The mass of moving object=m m=4 kg To find : ...

Q: The figure shown is a cross section of a concrete column that is loaded uniformly in compression. De...

A: Given data in question Load Dimensions To find out Stress Co ordinates which will produce uniform...

Q: Determine the moment of inertia about j- axis of the built-up section made up of 2 back to back chan...

Q: How do I calculate the apparent molecular weight of gas, gas density at reservoir condition and flow...

A: Reservoir engineering is a field of petroleum engineering which applies scientific principles to the...

Q: Employ stiffness matrix approach for the simply supported beam as shown in the figure to calculate u...

Q: A bolted connection between a vertical column and a diagonal brace is shown in the figure below. The...

A: Average shear stress = VA a. Find Shear force in one bolt ; V = 13 * P2 P = 6 k So, V = 1 k b. Find ...

Q: Given the fence 20 meters long and 3 meters high, determine the total number of pieces of 10mm diame...

Q: What is the advantage of the four-quadrant streaking method?

A: There are various advantage of four - quadrant striking method one of the main advantage is given be...

Q: (Ex) Design a singly reinforced concrete beam. f = 3 ksi, fy = 60 ksi, P, = 10k, P, = 8*, W = 1.0 k/...

Q: Three wheel loads rolls as a unit across a 12-m span. The loads are A = 15 kN; B = 25 kN, 2 m to the...

Q: u. Water has to be supplied to a town with one lakh population at the rate of 150 litres per capita ...

A: Given Data: The population of the town is 100000. The consumption per capita per day is 150 litres. ...

Q: The ball at A is kicked with a speed of (24 + 0.XY) m/s at an angle 0 = (25 + X.Y)°. Determine the p...

Q: in bullet form list structural work of roof truss

A: Roof Truss- A roof truss is a prefabricated wooden or steel framework that supports the roof and tie...

Q: The following are the result of shrinkage limit test. Vo (Saturated State) 25.4 cm3 Vf (Dry State) 1...

A: Given data - Vo ( saturated state ) = 25.4 cm3 Vf (Dry State) = 16.1 cm3 mo (Saturated State) = 4...

Q: The same torque is applied to two tubes with identical metal sheets, determine the ratio of square c...

Q: Three wheel loads rolls as a unit across a 12-m span. The loads are A = 15 kN; B =25 kN, %3D %3D 2 m...

A: Moment at C is,

Q: Given the following data using Thornthwaite method: Month Jan Feb Mar Apr May Jun Jul Aug Sep Oct No...

Q: For the built-up section shown, determine the following: a. Centroid of the Area, b. Moment of Inert...

Q: pts What is the location of the Maximum moment from A in meters. Given: w 17, a 3, b 5, and c 1. w k...

Concept explainers

Storm Sewers and Detention

The storm drains system transports rainwater or stormwater and other runoff from roads, parking lots, and roof downpipes directly to nearby creeks, rivers, or the sea without any treatment.

Question

The following data was obtained from a field study to determine how a toxic pollutant
reacts. Determine the order reaction and the rate constant, with proper units.
day
time (d)
0.25
0.5
1
2
2.5
3.5
concentration (mg/L)
Ct (mg/L)
15
12
10
8.
3
1
0.5
0.02
3.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

in simple terms, explain how to use a lagoon and evapotranspiration in wastewater processing and disposal.
A lake is fed by a polluted stream and a sewage outfall. The stream and sewage wastes have a decay rate coefficient (k) of 0.9/day (1st order units). Assuming complete mixing and no other water losses or gains, what is the steady-state pollutant concentration as mg/L in the lake?Incoming Stream: C = 10 mg/L, Q = 90 m^3/sSewage Outfall: C = 300 ppm, Q = 0.5 m^3/sLake: V= 10,000 m^3
A two-pond system shown in the attached picture is fed by a stream with a flow rate of 1.0 million gallons per day (MGD) and a BOD (nonconservative pollutant) concentration of 20.0 mg/L. The rate of decay of BOD is 0.30/day. The volume of the first pond is 5.0 million gallons, and the volume of the second is 3.0 million gallons. Assuming complete mixing within each pond, find the BOD concentration leaving each pond.
(c) Calculate the size and number of slow sand filter units to serve a population of (432000) with an average water consumption of (960) lpcd. Adopt a filtration rate of 0.45 ft/hr. when the population increases at a geometric rate of 0.04 per year. The design period is (192) years.
Lake Taal has a volume of 458 cubic km, and its rate of inflow and outflow are both 175 cubic km/year. Suppose that the time t=0 (years), its pollutant concentration is 0.06 %, and that thereafter the concentration of pollutants in the inflowing water is 0.01 %. Assuming that the outflow is perfectly mixed lake water, find the initial-value problem and how long will it take to reduce the pollution concentration in the lake at 0.03 %? Show illustrations Use 3 decimals
An orifice meter was calibrated by the manufacturer for air at 25℃ and 1atm. It is installed in an air sampling system where it operates at 33℃, 0.9atm and reads a ΔP of 4.8″H2O. The calibration curve has the relationship Qi=41×(ΔP)1/2in slpm(liters per minute at 25℃, 1atm). What is the true gas flow rate in slpm?
Please answer 4 and 5 Consider the design of granular media filters for a water treatment plant with a design flow of 40 MGD. For a filtration hydraulic loading of 5 gpm/ft2 determine the total filter area required for filtration (in square ft). Next, select the number of parallel filters needed, and their length and width (even foot increments), if each filter is square with area of 400 square feet. You choose a filter consisting of 36 inches of sand with an ES of 0.55 mm. The porosity is 0.4. Determine the superficial filtration velocity and the pore velocities in the sand layer. Calculate the detention time (in minutes) through the entire depth of the filter Calculate the clean bed head loss (in feet) for the filter using the Carmen-Kozeny equation. Assume a water temperature of 68 ºF and the design hydraulic loading rate. Use the media effective size for media diameter in the calculation. Estimate the filtration efficiency for a particle that is 4 microns in diameter.
Determine the reference evapotranspiration for a given day using the Penman-Monteith method given the following data: Tmax = 33.5oC γ = 0.067 kPa/oC Tmin = 22.5oC Ra = 29.6 MJ/m2/day Tdew = 23.0oC N = 11.2 hours z = 75.0 m n = 5.4 hours Latitude = 16.0 oN G = 0 u2 = 11.0 km/day
To solve the question use table and equation on the photo. (Answers: 2.035*10^6 m^3 , 2.169*10^6 m^3) Evaporation
Compare the positive and negative effects of disinfection of wastewater effluents.
A tank has 40L of sewage runoff. It initially consists of 60% water and 40% pollutants. Another sewage runoff with 70% water and 30% pollutant is being added to the tank at a rate of 3L/min. As the tank is being filled, the solution is also being drained at a rate of 4L/min. How much pollutant is in the tank after 7 mins?
Consider a rectangular wastewater treatment pond having a length of 100 ft,width of 20 ft, and depth of 20 ft. Assume the discharge from a wastewater treatment plant has aflow of 30 MGD with a solids concentration of 5 mg/L.a) Determine the mass flow rate of solids discharged in ton per day?b) Calculate the residence time of the pond in minutes?