the frequency that is injected into an AM modulator is 100Mhz and it is combined with another injected signal of 10Khz, we can say that the combination is:

Q: 22 25 V 123 3 V

A: The given figure is shown below:

Q: Simplify the following expressions 1. А[В + C (АВ + АC)] 2. А + B[AC + (В + C)DI 3. (А + (ВC)) (АВ' ...

A:

Q: AC-DC power supply circuits are one of the most common circuit configurations in electronic systems....

A: Electronic system: This system deals with devices in which light current is used and this system is ...

Q: R1 10k V1 Ovdc R5 100k U1 Vout OUT R3 10k OPAMP R2 V2 100k Ovdc

A:

Q: The diode current is 1.6 mA when the applied voltage is 180 mV, and 34 mA when the applied voltage i...

A: Diode current, I=IoeqVηkT-11.6×10-3=IoeqVηkT-1=IoeqVηkT              =Ioe18018η=Ioe10η.....(1)34×10-...

Q: 1-7. A 208-V, two-pole, 60-Hz, Y-connected wound-rotor induction motor is rated at I5 hp. Its equiva...

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts fo...

Q: For the network of Figure Vcc = 16 V a. Determine re b. Calculate Zi and Zo C. Find Av 3.9 k2 d. Rep...

A:

Q: How ring main distribution network is different than radial systems?

A:

Q: Q1/A-What is the total cost of using the following at 4c per kilowatthour? a) 600 W air conditioner ...

A: we have given  a) 600 W air conditioner for 8 h  b) 2800 W clothes dryer for 45 min c) 850 W coffee ...

Q: 4.59. A half-wavelength dipole is placed vertically on an infinite electric ground plane. Assuming t...

A: Given that, A half-wavelength dipole is placed vertically on an infinite electric ground plane. Cons...

Q: A half-wavelength (1 = ^/2) dipole, positioned symmetrically about the origin along the z- axis, is ...

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you ar...

Q: in the series combination of 300 ohm resistor, 0.25H inductor and a 1 microfarad capacitor, find the...

A:

Q: What are the circumstances in which a Kalman filter should be employed?

A: Kalman filter is designed in order to determine the future states of a given system by using the pre...

Q: Sketch the output waveform of the given circuit, assuming that the voltage of the battery is 1V and ...

A:

Q: Find vi and v3 in the circuit below 14 2 ww + 40 V 10 E Kt

A:

Q: 4.70 An automobile battery, when connected to a car radio, provides 12.5 V to the radio. When connec...

A:

Q: Problem 1. Suppose the body electrode of a MOSFET with a p-Si body is at ground potential, and the g...

A: Generally the body of mosfet is p type material it means that mosfet is of the N- type mosfet.  Gene...

Q: The basic principle of ultrasound imaging works by measuring the time of flight required for a sound...

A:

Q: A 3 phase transmission line is supplying 8 kV to an 800 kVA, 0.85 pf lagging load. The resistance an...

A: For a 3-ϕ transmission line - PL=800kVAVS=8kVPF=0.85 (lagging)The resistance and reactancec per kilo...

Q: 1.Using the simulator of your choice simulate and screenshot the output voltage wave form for each c...

A: The circuit diagram The input and output simulation result

Q: find the minimum SOP with Laws and Theorems of Boolean Algebra and then draw the logic diagram using...

A:  

Q: 3) Solve the problems in this section with the circuit given below when, w = 1000 rad/s. 2.5 k2 1.25...

A:

Q: Convert the point P(3,4,5) from cartesian to spherical co-ordinates

A:

Q: Power of imaginary i What is (i raised to 254) + 3(i raised to 33) + 5(i raised to 10

A:

Q: 5.10 The boost regulator in Figure 5.18a has an input voltage V, 6V. The average out- put voltage V,...

A:

Q: 40 kM 10 kN 20 kN 02 A 100 V 4 V 80 kN

A: the total number of nodes is only 1, which is ground node. For node identification in circuit please...

Q: 2. Find the voltage across 10A resistor and currant through 12 a resistor in the tollowing circuit. ...

A: In this question we will find current through 12 ohm and voltage across 10 ohm..

Q: b) - the currents I, and I2 using node analysis 2A ( 9 9) 1A

A: We are authorized to answer one question at a time since you have not mentioned which question you a...

Q: A two-core feeder 184 kilo meter long supplies a maximum current of 153 A at 400 volts. The demand i...

A: For a two-core feeder -Imax=153AV=400 VThe resistance of conductor is,R=0.0101 ΩThe length of conduc...

Q: CONSIDERING THE CIRCUIT OF FIGURE 2. THE INPUT FUNCTION OF V(T) IS THE VOLTAGE PULSE SHOWN IN FIGURE...

A: First, let us convert the voltage source to current source using source transformation.             ...

Q: An amplifier has an open loop voltage gain of 1,00,000. With negative voltage feedback, the voltage ...

A: Given, an amplifier has An open loop voltage gain, Avf=1,00,000 Voltage gain with negative feedback,...

Q: Task 2: Your supervisor asked you to analyse the following signal processing system that exists in a...

A: i.roots of the equation are s = -1,-2,-3,-4,-5

Q: Problem: In electronics device laboratory, you need to use the function generator to use different t...

A: Answer-

Q: Find Xc, Z, I, VR,,VC and don’t forget to put their units. Source voltage 115∠60º

A:

Q: R1 GU2 20 V U2 25 2

A: We will solve the given question by nodal analysis. We will apply KCL at the top node and assume the...

Q: last four digits 4 3 2 { Your student IO → XX - -- fixed A = + 1| + 10 = 15 ニ Calaulate A ニ = Write ...

A: Let the complete student I'd is: 141332871

Q: Ifthe voltage gain of an amplifier without feedback is 20 and with negative feedback it is 12, then ...

A: Given, The voltage gain of an amplifier without feedback, Avf=100 The voltage gain of an amplifier w...

Q: 3. An essential part of an AC-DC power supply circuit is the filter, used to separate the residual A...

A:

Q: 2. Although not a popular design, some power supply circuits are transformer less. Direct rectificat...

A: Power supply -  A power supply is a device that provides electricity to a minimum single load. It of...

Q: For the network of Figure 1 a. Determine re Vcc = 20 V b. Calculate VB and VC c. Determine Zi and Av...

A:

Q: For the ROM memory chip shown, find the capacity (including units): . organization: is this memory v...

A: The ROM is a Non Volatile Memory.

Q: 2 H le 000 18 cos 21 VI IH

A:

Q: *6.1 The SPST switch in the circuit of Fig. P6.1 closes at i = 0 after it had been open for a long t...

A:

Q: Explain in sentence what is meant by effective current and effective voltage.

A:   Effective Current The value of an alternating or otherwise variable current in a circuit that prod...

Q: Essay 1. Discuss how electric circuits can be understood in relation to water flowing in pipes.

A: The electric circuit can be understood in relation to water flowing in pipes: The pump drives the wa...

Q: In the case of SSB, the efficiency of the power used by the transmitter to send the information is 5...

A: SSB is a method of amplitude modulation to reduce power usage by transmitting only the sidebands..  

Q: Two points A(2,2,1) and B(3,-4,2) are given in the cartesian system. Obtain the vector from A to B a...

A:

Q: Given the applied source and network below: a. Determine the sinusoidal expression for the source v...

A: The solution can be achieved as follows.

Q: Problem 2 A capacitor is used to correct the power factor of the load of the following figure. Deter...

A:

Q: here was basically no electricity 150 years ago. Tesla, Edison and Faraday were experimenting, and i...

A: The use of solar photovoltaic and wind energy leading technologies are the best renewable energy res...

Amplitude modulation

A radio signal can carry information in the form of sound or image for broadcasting or communication. For it to be sent to a greater distance, the signal must be changed or modulated in some way. One of the easiest way is to change the amplitude of the signal with variations of the video or the audio signal. This is called Amplitude Modulaton. In this modulation information of message is carried in amplitude of carrier signal.