The inductance per unit length of a coaxial cable with inner radius 3 mm and outer radius 7 mm is (Assume µ, = 1)

Q: In a series L-C circuit, the inductance and capacitance are 5 H and 2 μF respectively. of the…

A: Given: Inductance, L= 5H Capacitance, C= 2×10-6F

Q: Describe the basic principles of the ultrasonic testing technique;

A: Ultrasonic testing is a non-destructive testing technique that uses high-frequency sound waves to…

Q: The current at the terminals of the element in (Figure 1) is i = 0, t = 0; i=22e-7000t A, t≥0.

A: Note: i=dqdtQ=∫dq=∫i dt

Q: 5. Determine the output waveform simulation shown in Figure (1-12). 0 0 Figure (1-12) <D00

A:

Q: 26. An unbalanced star-connected load is supplied from a symmetrical 400-V, three-phase, three-wire…

A:

Q: Q 2. For the overhead line of configuration shown in Fig. 2, operating at 60 Hz, and a conductor…

A:

Q: Q5: Let us consider a complex signal Is it power or energy signal? x(t)= Ae

A: Note: A periodic signal can not be an energy signal A signal to be an energy signal it's values…

Q: In the circuit shown in the right figure, find the resistance R and the emf &. 8.0V R E m 2.0A 3.0Ω…

A: Given: A circuit, To find: EMF ε,

Q: Load Flow Methods A 4-pole, 50 Hz, 11 KV turbo generator has a rating of 40 MW. Power factor 0.8…

A: Given- 4-pole, 50 Hz, 11 kV turbo generator, 40 MW rating, Power factor pf=0.8 lagging, Moment of…

Q: Which design is preferred in n-bit adder? a) many pass transistors in series b) many pass…

A: Which design is preferred in n-bit adder? a) many pass transistors in series b) many pass…

Q: what are the Motor control techniques can be used and the Suitable Microcontroller for above design…

A: Closed Loop Motor control techniques is very important in industrial applications such as running a…

Q: It is known that the different equations of a system are as follows: 3y[n - 2] - 2y[n - 1] - 2y[n] =…

A:

Q: A simple band-pass filter can be designed by cascading one-pole high-pass and one-pole low-pass…

A:

Q: A certain JFET data sheet gives VGS = -6V and loss = 12mA. When VGS=OV, what is the lo for the…

A:

Q: 2. Determine the relative permittivity of dielectric for a square plate capacitor of 2.5 m² area and…

A: As per company guidelines,when multiple questions are posted,the first question needed to be…

Q: A 400-km, 500-kV, 60-Hz uncompensated three-phase line has a positive-sequence series impedance z =…

A:

Q: digitizer is a physical device used to convert analogue information into its digital representation.…

A: Digitizer is a device used to change the given information into digital form. Generally a digitizer…

Q: Question- A 3- phase alternator is wound with 60° phase - spread armature windings and develops 300…

A: Given- 3-phase alternator wound with 60o phase-spread armature windings, 300 kVA, Phase spread=180o,…

Q: 3. The input to the circuit shown in Figure 3 is the voltage of the voltage source v.. The output of…

A: Given: A network, To find: Network function,  Hω=V0(ω)Vs(ω),

Q: Q21. In the circuit shown below, find vx (t). 4 cos 500t 000 R₁ 10 mH 3 cos (500t + 40°) R₂ 1mF

A:

Q: What is the difference between AM-DSB and AM-VSB.

A: In the given questions we need to provide difference between Amplitude modulation based on Double…

Q: Solve for I1 using Superposition Theorem. Show complete and detailed solutions

A: It is given that:

Q: Signal

A: Given: Maximum frequency of baseband signal is : fm=46.4 KHz

Q: draw the small signal model of this circuit

A:

Q: 30 V | +1 4Ω 2Ω 8 Ω 4Α 6Ω ΜΕ M 3 Ω 1Ω

A:

Q: A 2300 V 400 Hp 60 Hz eight-pole Y connected synchronous motor has a rated factor of 0.85 leading.…

A:

Q: 2. The z-transform of the system impulse response is described below. n-1 24 h(n) = (-)¹-¹ u(n-1) -…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: . (10%) For the circuit shown in Figure P4, find the current i 10Ω IA Μ • 20 Ω Μ 1/₂ ΕΣΩ |24

A: Circuit is given as:

Q: Explain the working of the Zener diode in detail. I just need explantion so i will undersatnd.

A: We will refer the concept of zener diode equivalent circuit for better understanding.

Q: +5V W 2 ΚΩ -0 V₂ -O V₁ (2 mA –5V

A:

Q: d) Determine the total inductance for the connection shown in Figure 5.1 below.

A: The total inductance of the circuit can be calculated by reducing the parallel connection and then…

Q: jur 13 j32 sh 12 232 jun Il 65 S-2) 11, 12, ve 13 akımlarını bulunuz. Joou ef.

A:

Q: A Rochelle salt crystal, having a voltage sensitivity of 0.098 V-m/N and thickness 2 mm, produced an…

A:

Q: (b) The voltage v(t) = 2t (v) for t>0 v(t) (+ 8Ω 2F (b) Circuit B i(t) (4) What is the current of…

A:

Q: a second-order process is controlled using a P controller with a feedback closed-loop control…

A: Given information about a second-order process control system is written below. The applied step…

Q: Dc Calculate the voltages and Current Of The resistors CRI, B92, R3) for figure 4.5 Да, Ammeter…

A: In this question We need to determine the voltage across the resistances and current in the…

Q: (c) Find the Thevenin equivalent of the following circuit: 60 101 I 20 mm 202 ww 10.20

A:

Q: The finite sheet 0≤x≤ 1, and 0 ≤ y ≤ 1 on the z = 0 has a charge density Ps xy(x² + y² +25) 3/2…

A:

Q: For a transmission line, L=1.8mh/m C=0.01pF/m, then the phase velocity of the line is O a. 2.3X108 O…

A: Given data, For a transmission line, Inductance, L=1.8 mH/m. Capacitance, C=0.01 pF/m.

Q: Q4/ calculate The angle betweeh The Two Vector A, B That make the relationship. AXBI A-B - 3 4

A: Given: Expression: A→.B→=34A→×B→

Q: Write Define A,B,C,D

A:

Q: Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and…

A: Clipper Circuits:- A clipper circuit is used to clip the input voltage at a fixed higher and lower…

Q: The cube has sides of L-10cm. The electric field is uniform, has a magnitude of 500V/m and directed…

A: Given data, Electric field E = 500 V/m. Length of cube l = 10 cm = 0.1 m.

Q: 4, Assume a sequence x(n) is real. And the 7-point DFT is the X(k). The value of DFT even points are…

A: The given problem is from Discrete Fourier Transform (DFT).

Q: 7.1 Given g(s) = s+2 / (s^2-1)(s+2) 7.2   Find an uncontrollable and unobservable realization for…

A: Given data g(s) = s+2 / (s^2-1)(s+2)

Q: 1.2 For the circuits of Figure 1.2 sketch von 10 V 12 V -10 V 1-12 V f = 1kHz (a) 10x0 m 5.3 V с It…

A: Given data, 1.2) a) b)

Q: 3. For the 64-point Decimation-in-Time FFT Algorithm with Radix-2 requires a total of complex…

A:

Q: uction: Compute for the values of currents using Kirchhoff’s Current Law to complete the table…

A:

Q: If_x₁(n)={2,3,1,-3,-1}, x₂(n)={-2,-1,1,2}, calculate the linear convolution, 6-point circular…

A:

Q: Question No.23 The active power in a delta connected system of 440V with a balanced load of…

A: Given- A delta connected system with, Line voltage = phase voltage , Vph=440 V Inductive reactance,…