The irreversible reaction A - B was carried out in a batch reactor and the following concentration- time data were obtained as follows: to tz t3 ty Time (min) CA(mol/dm) 4 If the rate equation is expressed as : analysis to determine the kinetic constants k and 'n. 10 15 20 0.008 - rA=kC"A . Apply the differential method of 2.25 1 0.25

Q: A CSTR is used to carry out liquid-phase reactions as described below. 2A + B -> 3C + D          ...

A:

Q: An ideal gas at 300 K and 10 bar enters an apparatus, which is thermally and mechanically insulated ...

A:

Q: A nuclear power plant generates 750 MW, the reactor temperature is 588.15 K and a river with water t...

A: Work done by nuclear power plant W = 750 MW Reactor Temperature TH = 588.15 K River water Temperatur...

Q: why chemistry is reliable, testable, and flexible?

A:

Q: In the burning of pyrite containing 92% FeS2 and 8% gangue, 13% of the FeS2 charged is lost in the c...

A: Pyrite analysis: 92% FeS2 and 8% gangue The percentage of this charged FeS2 lost in cinder is 13%. P...

Q: The vapor pressure of mercury at 160 ° C is 4.14 mmHg. Calculate the Gibbs energy in calories of 1 m...

A: The equilibrium relation between mercury vapor and liquid is written as:   Temperature of analysis ...

Q: a) Use a mole balance for A to derive a differential equation for the concentration of A as a functi...

A: The schematic diagram given for the 1st order reaction taking place in a CSTR with 1 inflow and 1 ou...

Q: chlorine consists of the following isotopes:  WHAT IS THE ATOMIC MASS OF CHLORINE?   ISOTOPIC FRA...

A: The atomic mass of chlorine-35 and chlorine-37 is denoted by M35  and M37 , respectively. The abunda...

Q: What is the entropy change of the gas, heated in a steady flow process at approximately atmospheric ...

A: Initial temperature of ethylene=473.15 K Amount of heat supplied to 10 moles ethylene=800 KJ From li...

Q: 0.07 kg of propane is contained in a piston-cylinder assembly at a constant pressure of 2.7 bar. Hea...

A:

Q: Starting from Σ Gia = > x;G; + RT x; In xị (10.79) %3! Show that uia = Gjd = G;(T,P) + RT In x¡ (10....

A: The equation for the Gibbs free energy for an ideal solution is given as:

Q: Determine the expressions for GR, HR and SR implied by the van der Waals equation of state.

A:

Q: 1500 kg solution containing 20% Na 2 SO 4 and 80% H 2 O by weight is subjected to evaporative coolin...

A: given that, weight of feed solution containing 20% Na2SO4 and 80% H2O = 1500 Kg 20% of the original ...

Q: 6.9

A:

Q: 3. Write a balanced nuclear equation for each reaction. a. B- decay of "Rb b. B* decay of Mg c. a de...

A: In nuclear reactions, an alpha(α) decay reduces mass number by 4 units and atomic number by 2 units....

Q: Calculate the change in enthalpy and the change in entropy using Lee/Kessler generalized correlation...

A: Given information:   The gas to be expanded isothermally is CO2. Initial temperature of the gas, T1 ...

Q: Two large fixed parallel plates are 12 mm apart. The space between the surfaces is filled with oil o...

A: Since you have posted multiple questions and have not specified which question is to be solved. we w...

Q: In the picture, at which pH is the hydrolysis of p-nitrophenyal phosphate fastest? Please explain th...

A:

Q: Heat Transfer Question

A: Given: Steam at temperature Ts = 400°F Steel pipe conductivity ks = 8.7 Btu/hr.ft.°F Pipe inner diam...

Q: What is the difference between permeability and permeance?How are they analogous to diffusivity and ...

A: The difference between the permeability and the permeance is to be mentioned along with the relation...

Q: Decomposition of sulfuryl chloride The reaction shown below is first order with regards to SO2Cl2 ...

A: The given reaction is:   SO2Cl2 → SO2 + Cl2   The reaction id first order with respect to SO2Cl2. At...

Q: 6.19 If the pressure inside a pressure cooker is 200 kPa, what is the boiling point of water inside ...

A: Given: The pressure inside the pressure cooker P = 200 kPa Normal Boiling Point of water Tn =373 K T...

Q: Blowdown Lost steam Ikg lag+sy3.5x10° kg H,O(v) Heat Process fluid. T Boiler feedwater Steam HEAT DE...

A: Note: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question...

Q: Show that for any gas whose volume varies linearly with temperature at a given pressure, the Joule–T...

A:

Q: 2. Coal with a heating value of 13,900 BTU/lb is found to have the following analysis: 27.13% VCM, 6...

A: NOTE: We are authorized to answer three subparts at a time, since you have not mentioned which part ...

Q: A sulfur burner, burning sulfur of 98% purity with dry air, discharged gas at 1300°F containing 16% ...

A: Raw sulfur with 98% purity is burned with dry air to produce discharge gas. Let the basis of the cal...

Q: Kayla began a science experiment with 18 grams of an unknown solid. During the experiment, the chang...

A: Given data: Initial mass of unknown solid = 18 g Change in the mass of the solid during the experime...

Q: 4.87. A fuel gas produced by gasifying coal is to be burned with 20% excess air. The gas contains 50...

A:

Q: Under what conditions is a cascade of mixer-settler units probably the best choice of extraction equ...

A: The condition at which the mixer-settler is the best choice for the extraction process is to be ment...

Q: A mixture of ethyl benzene (15 wt%), ortho-xylene (20 wt%), meta-xylene (30 wt%), and para-xylene (3...

A:

Q: The reactor feed (not the fresh feed from the process) contains 3 moles of ethylene per mole of oxyg...

A: Given data: Single pass conversion of ethylene = 20 % Number of moles of ethylene per mole of oxygen...

Q: a) Ts=21.111°C b)Ts=440.168°C C)Ts=47.77°C Solve d), e), f) g), h) and i)

A: Hello. Since your question has multiple sub-parts, we will solve the first three of the requested su...

Q: The Tait equation for liquids is written for an isotherm as: ̄V= ̄V0(1− AP/B+P) where ̄Vis the molar...

A: Given that The Tait equation for liquids: V = Vo 1 - APB + P where, V is the molar volume Vo is the ...

Q: An environmentally toxic radioactive chemical is continually released at a constant rate of 1 (mg pe...

A: We know that Conservation law is as follows                                       ….1 In our system ...

Q: 75% pure raw sulfur is burned in excess air supplied at the rate of 4.75m3/kg of raw sulfur at 28°C,...

A: The basis of the calculation is taken as 1 kg of raw sulfur fed to the burner.   The purity of raw s...

Q: Heat Transfer Question

A: Given data: Velocity of air = 20 m/s Temperature of air = 29 0C Diameter of pipe = 30 cm Surface tem...

Q: Transfer Phenomena Question

A: The following equation is used to calculate the frictional loss: g∆z+∆Pρ+12∆V2=Ws-∑F      ...(1)

Q: ring Chemical EngineeringQ&A LibraryAn effluent gas from a food processing industry with a flow ...

A: hi and thanks for the question, but you have posted multiple subparts, so we will answer the first 3...

Q: 75% pure raw sulfur is burned in excess air supplied at the rate of 4.75m3/kg of raw sulfur at 28°C,...

A:

Q: 2) Copper reacts with iodine in a similar reaction from what was done in lab to produce copper(I) i...

A: Given data: Copper reacts with iodine to produce copper iodide. The balanced reaction is given the p...

Q: (2) ¿Ghä Which of the following sentence * ? is correct Terminating a chain polymerization reaction ...

A: The correct statement out of the given options is to be chosen.

Q: please help meeee

A: 2.10 solution: Anion is the ion with a negative charge. In the given compound, perbromic acid HBrO4,...

Q: 2. You are working for a power plant that makes use of coal tar, a type of liquid fuel as its raw ma...

A:

Q: 1. The molar enthalpy of vaporization of benzene at its boiling point of 353.25 K is 30.8 kJ mol-1. ...

A: Given that molar enthalpy of vaporization of benzene ∆H= 30.8 kJ/mol =30800 J/mol Boiling point T= 3...

Q: A stream of hydrocarbon (Cp= 2.2 kJ/kg.K) is cooled at a rate of 720 kg/hr from 150°C to 40°C in the...

A: Hi and thanks for the question, but you have posted multiple subparts, so we will answer the first 3...

Q: A pipeline laid cross country carries oil at the rate of Q = 795 m³/d. The pressure of the oil is P1...

A:

Q: Q-5) Complete the following table for H20 Phase T(°C) P (kPa) h (kJ/kg) u (kJ/kg) v (m³/kg) descript...

A:

Q: 1.

A:

Q: Heat-Transfer Coefficient in Single-Effect Evaporator. A feed of 4535 kg/h of a 2.0 wt % salt soluti...

A: