The length of chain measured with a chain was found to be 250 m. If the length of chain was measured with 30 m chain and the chain was 10 cm too short, the true length of the line will be
Q: 6. Find the effective net area A, for the L6 x 4 x 1/2 angle shown below with 15/16 in. diameter…
A: Answer We know that effective Net area is given by Ae = An*U An = Net section area U = shear lag…
Q: 4. What does the analytical scale read? (Ans: 1.550 g) 5. What is the concentration of the Total…
A: Given, Flow rate (Q) = 20 mgd Volume (V) = 90 ml or 0.09 L
Q: β = 0.2 and α = 6.3
A: Given:- The increase in speed from rest to 50 mph in 3.8 sec The increase in speed from rest to 65…
Q: Consider a point in a structural member that is subjected to plane stress. Normal and shear stresses…
A: Answer Given data: Normal stress in x- direction σx = 30 Mpa Normal stress in y-vertical direction…
Q: The saturated NC clay is 8 meters deep. The moisture content is 40% and the specific gravity is 2.5.…
A: Given The saturated NC clay H = 8 m Moisture content = 40% Specific gravity = 2.5 Cc=0.2; Cs =0.05…
Q: Identify and compare all relevant advances and developments of engineering draughting techniques and…
A: Engineering draughting techniques have undergone several advancements and developments over the…
Q: Q3 A simply supported beam ABCDEF of 5 m length and loaded as shown in Fig. Q3. Find the deflection…
A:
Q: An aluminum [E = 8600 ksi] bar is bonded to a steel [E = 30150 ksi] bar to form a composite beam as…
A:
Q: 4. What are the fields of Environmental Engineering? 5. What is Environmental Resource? Give atleast…
A: To Determine: 4 .What are the fields of Environmental Engineering? 5 .What is Environmental…
Q: Eight kilometers below the surface of the ocean the pressure is 81.4 MPa. Determine the density of…
A: Given- Depth h=8 km=8000 m Pressure P=81.4 MPa, B=2.87 GPa It is needed to find the density of sea…
Q: Q.4 A non-Newtonian fluid is flowing in a floor having height 5mm and with a free stream velocity of…
A: Given data- Non-Newtonian fluid- height h=5 mm, Free stream velocity=0.5 m/s, Yield stress=38 MPa,…
Q: What are the types of pavement line and markings? a. Longitudinal Lines, Transverse Lines, Center…
A: What are the types of pavement line and markings?
Q: A pollutant entered into a confined aquifer of 5 m thick and porosity 25%. If the seepage discharge…
A:
Q: The engine hoist is used to support the 200 kg engine. Determine the magnitude of the force acting…
A:
Q: Simply supported beam of span length 75mm dia. carries a uniformly distributed load of 1.5 kN/m - if…
A: Given data. For the given simply supported beam of, span length, l= 75 mm Dia. d= 75 mm It carries…
Q: Probem-4, A rectangular open channel has a width of 10 m and a bed slope of 0.002. For a uniform…
A:
Q: The strength of a sample of fully matured concrete is found to be 50 MPa. Find the strength of…
A:
Q: In a hydraulic jump occurring in a horizontal channel, the Froude's number before the jump is 10.0…
A: Froude number before the jump F1 = 10 Energy loss is EL = 3.2 m Y1 = depth before the hydraulic…
Q: The annual maximum flood magnitude in a river shows a mean of 170 m³/s and a standard deviation of…
A:
Q: Two pipes, A and B, contain a fluid flowing under pressure and are connected by a differential gage…
A: Pressure at A =10psi To find pressure at B
Q: The shear stress distribution for a circular section of diameter 'd' under the action of shear force…
A: Given:- The shear stress distribution for a circular section of diameter 'd' under the action of…
Q: The total rainfall in a catchment of area 1000 km², during a 6 h storm, is 19 cm. The surface runoff…
A: Given that :- Surface runoff = 1×108 m3 Catchment area = 1000 km2 Storm duration = 6 hr To find the…
Q: 3- A torque of 2000 N-m is applied on a steel circular shaft with a diameter of 50 mm. The shaft has…
A: Objective: To determine the maximum shearing and the angle of twist for the given circular shaft.…
Q: Consider a point in a structural member that is subjected to plane stress. Normal and shear stresses…
A: Given data:σx= - 4 ksiσy= 18 ksiτ= 15 ksi
Q: Directions: Check the safety of the typical reinforced concrete tee beam used to support the…
A:
Q: An intermediate beam is carried by a girder at its midspan. The intermediate beam has a dimension of…
A: Answer Let us first draw the shear force diagram P = factored Load from intermediate beam…
Q: A square pile of section 30 cm x 30 cm and length 10 m penetrates a deposit of clay having c = 50…
A: Given: A square pile of section 30 cm × 30 cm B = 0.3 m Length, L = 10 m A deposit of clay having c…
Q: The absolute minimum radius of curve for safe operation, for a speed of 110 kmph is (a) 110 m (b)…
A:
Q: A catchment area is estimated to have a curve number of 80. Determine the fraction of the catchment…
A: Given that :- Total rainfall = 14 cm catchment area is estimated to have a curve number of 80 To…
Q: A tank contains gasoline sp. gr. = 0.90, oil sp. gr. = 0.8, and sea water sp. gr. = 1.03. If the…
A:
Q: 2. The allowable bending stress in this beam is 160 MPa. (Hint: Start by listing down potential…
A: Given data, Span of simply supported beam= 5 m Uniform distributed load = 12kn/m Allowable…
Q: The shear stress distribution for a circular section of diameter 'd' under the action of shear force…
A: Given: A circular section of diameter 'd'. In under the action of shear force 'S'.
Q: P 1 m W = X N 1 ms = 0.4 5. Determine the normal force between the crate and the surface 6.…
A:
Q: 6-2, 6-3, 6-4, and 6-5 Compute $V for the cross sections shown in Figs. P6-2, P6-3, P6-4, and P6-5.…
A:
Q: Convert 150kph to mi/hr, m/s and ft/s
A:
Q: A - 6 м О 1.2 kN/m В
A:
Q: 1. Rigid member ABC is connected to two elastic bars, as shown in the figure. Bar AD is heated by…
A: Given:- Properties of copper bar areA=700 mm2E=90 GPaαT=20×10-6/oCProperties of steel bar areA=500…
Q: Determine the location and magnitude of maximum deflection and rotation at both supports in degrees…
A: Solution: Compute the support reactions: Ay+By=10×4+20+15=75 kN Take moment about A:…
Q: Soil Mechanics A timber pile of length 8m and diameter of 0.2m is driven with a 20 kN drop hammer,…
A: Given Length L=8 m diameter d=0.2 m 20 N dop hammer height h=1.5 m Safe load carrying capacity=?
Q: Situation 2: A hollow steel tube has an outer diameter of 90 mm and a thickness of 14 mm. Determine…
A: The basic concept of stress is ; Stress = Force Area σ = FA In terms of force it can be rearranged…
Q: When do traffic monitoring and warning systems become useful?
A: Traffic monitoring system Traffic monitoring systems are the system of sensors which are installed…
Q: what are some past and current wastewater treatment methods in Singapore? (please mention pro and…
A: Given, * Singapore has a long history of implementing innovative and effective waste water treatment…
Q: . If a soil sample has a dry unit weight of 19.5 KN/m3, moisture content of 8%and a specific gravity…
A:
Q: 3. If the pressure at A is 137.20 kPa, what is the pressure at B when x=20 cm. OR (0.8) 30 am tater.…
A: Given Pressure at A = 137.20 kPa x= 20 cm specific gravity of fluid = 0.8 To find Pressure at B
Q: 11. The tank in the adjoining figure contains oil of specific gravity of 0.75. Determine the reading…
A: Given data in question Specific gravity 0.7 Depth 3 m and 22 cm Air To find out Reading at A
Q: A wooden buoy (s.g. = 0.62) is 70mm by 70mm by 26.5m long is made to float in sea water…
A:
Q: 7. Determine the effective net area of the 12.5 mm thick plate shown below using the NSCP 2015…
A: Given Plate thickness = 12.5 mm Diameter of bolts = 20 mm To find The effective net area
Q: Delineation is generally provided using the following devices: i. Pavement Markings ii. Signs iii.…
A: Explanation: Delineation of the road is done to provide visual assistance to the road users via…
Q: an 8 lane bfs in rolling terrain has a lanr width of 12 ft right shoulder width of 8 ft one…
A: BFFS = 70 mph (Standard value taken) Lane width = W = 12 ft.Total no of lanes = 8Right shoulder…
Q: a Y Ь C d e F X
A:
Chainage.
Step by step
Solved in 2 steps
- If the actual length of a 20 m chain is found to be19.8 m, then the actual length of a line measured as 100 m with that chain will be.A tape 100m long, it's cross sectional area in 0.0585 cm', the apparent length of which was found to be 1500m. The tape was Standardized under a pull of 6.75kg but after the line was measured, it was Found that the pull actually used during the measurement was = 7.75 kg. what Was the true length of the line if the tape was standardized & used on the flat? Take young modulus, E = 2,000,000 kg/cm²A distance of 1300 m was measured by a 40 m chain. Later on, it was detected that the chain was 0.1 m too long. Another 400 m was measured and it was detected that the chain was 0.15 m too long. Determine the exact length (m) that was measured. Express your answer in 3 decimal places.
- SHOW COMPLETE ILLUSTRATION & SOLUTION A line 50m long was paced by a civil engineer three times and recorded the following results, 58, 60 and 61. He also paced another line three times and obtained the following results: 231, 236 and 227. Determine the length of the line.Answer the following problem. Show complete solution and illustration. Two parallel sides of a rectangle are being lengthened at the rate of 20 mm/sec, while the other two sides are shortened in such a way that the figure remains a rectangle with a constant area of 5000 sq mm. What is the rate of change of the perimeter P when the length of the increasing side is 50 mm?A line of true length 398 m when measured by a chain of 20 m chain is recorded to be 400 m. What is the actual length of the chain (in m)?
- Determine the centroid of the area shown in the figure in reference with the X and Y axes. (bar x, bar y) Select the correct answer: 0.517,0.04 0.04, 0.571 0.571,-0.571 -0.571,0.571A 100 meter tape weighing 5.08 kilograms was used to measure a line. It was supported at the end points and on its midpoint having a 60 newton applied tension. If the total measured distance is 2345.76 meters, what is the correct distance of the line?A hemispherical tank of diameter 4 m contains water up to a height of 2.0 m. An orifice of diameter 50 mm is provided at the bottom. Find the time required by water to fall from 2.0m to 1.0m. Take Cd=0.60. include your free body diagram a. 2582 seconds b. 1814 seconds c. 3600 seconds d. 3179 seconds
- A hemispherical tank of diameter 4 m contains water up to a height of 2.0 m. An orifice of diameter 50 mm is provided at the bottom. Find the time required by water to fall from 2.0m to 1.0m. Take Cd=0.60. a.3179 seconds b.2582 seconds c.1814 seconds d.3600 secondsInvestigate the diameter of the electrical wire used in your home. How thick are theinterstate transmission lines,and what is their cross-sectional areaA distance of 1500 m was measured with a 20 m chain. After the measurement chain was found to be 80 mm longer. If the length of chain was perfectly correct while starting measurement, what is the true length of the line measured? Solution: Average correction per chain length