Answered: The mass specific gravity of a soil is…

The mass specific gravity of a soil is 1.95, while the specific gravity of soil solids is 2.7. If the moisture content of the soil be 22%. Determine the porosity. a.86 b.41 c.20 d.15.97

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: The plate as shown weighing 25 kN is raised by a cable sling. The cable sling has the identical clev...

Q: 65. In some cases of repairs of girders damaged by collision, the damage is severe what is used? A. ...

Q: 5. A contractor has decided to use a hydraulic backhoe to excavate a 24-inch wide trench for the con...

Q: 36. In a white wash, after how many hours is dissolved gum added to the solution? A. O 24 hours В. 1...

A: Answer: A Explanation: White wash is actually prepared from a fat lime. The Fat lime is dissolved in...

Q: What is the physical layout of an EnCase evidence file?

A: Physical layout of the EnCase evidence file:- The header appears at the front of the file and it wa...

Q: 7. As shown in the figure below, a pump lifts water through a 100-mm diameter ductile iron pipe (fri...

Q: What is Porosity?

A: ENGINEERING GEOLOGY:

Q: Why is the rate of water-flow into soils of importance in irrigation practice?

A: The rate at which the water flows into the soil is called infiltration rate. It's very importance fr...

Q: Determine the annual cost of a structure that requires an initial investment of F 1,500,000 and an a...

A: This question is related to the Estimation costing and valuation engineering. There is Option B is c...

Q: For the following data, compute the horizontal distance for a recorded slope distance AB, a) AB = 38...

Q: 39. paint gets deteriorated when exposed to sun. A. O Asbestos B. O Bituminous С. C. O Oil O Oil D. ...

A: Bituminous Paint- This paint provides waterproofing and resistance with the corrosion. Oil Paint- It...

Q: You measure a brick of nickel and find it has a depth of 75.0 cm and a width of 75.0 cm. The distanc...

A: To determine the distance the top of the nickel brick moves, relative to the bottom. Given, Width ...

Q: The result No of blows(N) and water content in % (w) of liquid limit tests are given as follows: Tri...

Q: 38. A paint normally consists of components. A. O 3 В. О 5 С. О 4 D. О6

Q: The equation of the effective stress failure envelope for a slightly over-consolidated clay is 7, = ...

A: Pole Method The Pole method is used in mohr's circle to find the stresses along the plane. The Pole ...

Q: Given that all main factors remain unchanged, using the Theory of Buckling by Euler’s Formula. What ...

Q: An overflowing dam is shown in Figure 4a. If there is no uplift pressure, determine the location of ...

Q: A 6-in-diameter pipe (reentrant entrance, f = 0.028) 475+(Reg.No/100) ft long can deliver water from...

Q: An orifice of 0.1-meter-diameter is installed in a pipe having a diameter equal to 0.3 meters as sho...

Q: 38. A paint normally consists of components. А. ОЗ В. О 5 С. О 4 D. O 6

A: Paint consist of components that comprise base, vehicle, solvent, pigment, filler and drier.

Q: A fully saturated soil sample has a volume of 28 cc. The sample was dried in oven and the weight of ...

A: Given data- A fully saturated soil sample-Total Volume of soil VT=28 ccWeight of dry soil Wd=48.76 g...

Q: 1. From the floor system shown, determine the moment capacity of the beam along column A / row 1-2, ...

Q: rength (OMn). Does the beam satisfy ent? Given: f'.= 6.000 psi, A. = 4 #10

A: tensile force = compression force AS. fy =0.85 fc' . Ac 460 = 0.85 5. Ac Ac = 56.47 in2 depth of ...

Q: 8. A differential leveling loop started and closed on BM Juno, elevation 2485.19 ft. The plus sight ...

A: Given:- A differential leveling loop started and closed on BM Juno The elevation of the BM = 2485.1...

Q: The bending moment M of a beam is given by dM = −ω(l−x), where ω and l are constants. Determine dx (...

A: Given data - M = 12 WL2/2 WHEN X = 0

Q: The laundry uses 1000 n in laundering oerpations. Mg2+ at 2 meq/L. Their goal is to reduce total har...

A: STEP 1 Qreq = 1000m3/daycolumn = 200mg/l as caco3magnesium =100 mg/l as caco3absolute hardness ought...

Q: sand cone in place unit test was conducted on the field during the construction of the embanklment i...

Q: A built up beam is made up of 1250 mm x 9 mm web section and two flange sections of 620 x 20 mm pla...

A: As per bartleby guidelines, only 1st 3 parts among multiple parts questions need to be solved. That'...

Q: A fully saturated soil sample has a volume of 28 cc. The sample was dried in oven and the weight of ...

Q: Find the present worth of perpetuity of P 8,000 annually with an interest rate of 10% annually. O P ...

A: This question is related to the Estimation , costing and valuation. There is Option D is correct ans...

Q: The rigid bar ABCD supports point loads at A and D and is being supported by two bars at B and C. De...

Q: 4. Using the figure below, find the time it takes for tank 2 to increase water level by 2m. (C = 0.6...

Q: 2. Given the figure below, solve for flow rate in the venturi meter. (C = 0.984) 2 (Ø - 250mm) oil (...

Q: 65. In some cases of repairs of girders damaged by collision, the damage is severe what is used? A. ...

A: Answer : option (c) links and dowels is correct option. More explanation is given below

Q: Determine the moment equation for segment A-B. Determine the moment segment at F-G. Determine the ve...

Q: In the cash flow diagram, it is one wherein the cash flow changes by the same amount in each cash fl...

A: This question is related to the Estimation valuation and costing.

Q: Determine the reactions at support A. A=375 lb F= 500 lb B. 05 ft 8 ft 6 ft 5 t- 30 F= 160 lb

A: A loaded beam is given and it has been asked to determine the support reactions. please refer step 2...

Q: Determine the maximum axial compressive service load that can be supported if the live load is twice...

Q: 2.00 1.00 2.00 1.00 PRELIM EXAM 10 KN/m 1. If the allowable axial stress of steel cable is 5 KN/m A ...

Q: Bronze A = 300mm? 2.00 m E = 83 GPa Steel 1.00 m A = 600mm? E = 200 GPa A В 0.60m 1.00 m 1.00m MN kN

Q: The weight and volume of a fully saturated soil sample were 55.4 g and 29. 2 cm3 respectively. After...

Q: having a slope of 3% and a sandy loam soil has four gauging stations. Dete ation requirement in m if...

A: According to given data A catchment area which is having a slope of 3% and a sandy soil has four ...

Q: If the flow rate is measured in Liters/day, the flow rate is The largest form of water flowing natur...

A: 1. It is called as Volumetric flow rate. 2. Rivers.

Q: 4)On a map drawn to scale of 1cm = 20 m,the horizontal map distance between 1/2 m contours on a unif...

Q: Select all true statements regarding the volume factor, Cy, used to adjust the design bending stress...

A: This question is related to the timber from Building Material.

Q: An undisturbed specimen of soil has a volume of 300 cm3 and weighs 498 g. After over drying for 24 h...

Q: At the beginning of each month, P 200 is deposited into a retirement fund. The fund earns 6% compoun...

Q: 1. Apparent Specific Gravity 2. Soil Structure

A: As per ASTM 1) Apparent specific gravity According to the principle of buoyancy, the apparent mass ...

Q: The volume and weight of a partially saturated clay sample are 185 cm3 and 362 g respectively. After...

Q: Find the ventical movement og Pif P is 120 kN Stee Aluminum 4m 3m 3m Im 8. P= 120 kN Aluminum Steel ...

Concept explainers

Weight-Volume relationships

Weight is defined as the quantity of matter contained in a body. Weight can also be defined as the force acting on a body due to gravity. Mathematically, weight can be defined as-

Question

The mass specific gravity of a soil is 1.95, while the specific gravity of soil solids is 2.7. If the moisture content of the soil be 22%. Determine the porosity.

a.86

b.41

c.20

d.15.97

With FBD if necessary

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

The wet mass of 0.1 m3of soil is 12.5 kg. If the moisture content is 14% and the specific gravity of soil solids is 2.71and the specific gravity of soil solids is 2.71, determine the following:(a) Dry unit weightb) Void ratioc) Porosityd) Degree of saturatione) Volume occupied by water
Q5: The moist weight of 0.1 ft3 of soil is 12.2 lb. If the moisture content is 12% and the specific gravity of the soil solids is 2.72, find the following: 1. Moist unit weight. 2. Dry unit weight. 3. Void ratio. 4. Porosity. 5. Degree of saturation. 6. Volume occupied by water.
The mass specific gravity of a soil is 1.95, while the specific gravity of soil solids is 2.7. If the moisture content of the soil be 22%. Determine the dry unit weight in kN/m3.
The moist unit weights and degrees of saturation of a soil are given in the following table: Unit Weight (pcf) 119.04 123.86 S (%) 65 85 Determine the specific gravity of the soil solids. Determine the porosity of the soil in percent. Determine the void ratio of the soil in percent. Please answer this asap. For upvote. Thank you very much
The moist weight of 0.2 ft3 of a soil is 23 lb. The moisture content and the specific gravity of the soil solids are determined in the laboratory to be 11% and 2.7, respectively. Calculate the following:a. Moist unit weight (lb/ft3)b. Dry unit weight (lb/ft3)c. Void ratiod. Porositye. Degree of saturation (%)f. Volume occupied by water (ft3)
The mass of the wet sample of the soil and its container is 14.5 kg. The drymass of the soil and its container is 12.5 kg. The mass of the container is 0.5 kg, and its volume is 7.5 x 10-3 m3. The specific gravity of the soil is 2.67. Calculate the: a) porosity, nb ) How much air void is in the soil?c) Determine the weight of water required to saturate 1 m3 of this soil.
The moist mass of 0.1 ft^3 of soil is 12.5 lb. If the moisture content is 14% and the specific gravity of soil solids is 2.71, determine the following: a. Moist unit weight b. Dry unit weight c. Void ratio d. Porosity e. Degree of saturation f. Volume occupied by water
The moist weight of 5.66 x 10^-3 m^3 of a soil is 102.3 x 10^-3 kN. The moisture content and the specific gravity of the solid soil are determined in laboratory to be 11% and 2.7, respectively. Calculate the following: i)Moisture unit weight (kN/m^3)ii)Dry unit weight (kN/m^3)iii)Void ratioiv)Porosityv)Degree of saturationvi)Volume occupied by water (m^3)
The moist weight of 0.0057 m3 of a soil is 102.6 N. The moisture content and the specific gravity of soil solids are determined in the laboratory to be 11% and 2.7 respectively. Calculate the following: Moist unit weight Dry unit weight Void ratio Porosity Degree of saturation
Dry soil is mixed with 16.50% by mass with water and then compacted. The moist soil has a volume of 0.001m3 and a mass of 1.80 kg. The specific gravity of soil solids is 2.70. 7. Which of the following most nearly gives the dry unit weight of the soil?
The mass specific gravity of a soil is 1.95, while the specific gravity of soil solids is 2.7. If the moisture content of the soil be 22%. Determine the porosity.
A150-cm3 sample of wet soil has a mass of 250 g when 100 % saturated. When oven-dried, the mass is 162 g. Calculate the dry density, dry unit weight, water content, void ratio, and Gs.