The maximum peak to peak value of an AM wave is 43 volts and its frequency is 25000000. The peak to peak value of the modulating signal is 21volts and its frequency is 16000. If it is transmitted through an antenna with an internal resistance of 49ohms, 5. Carrier power Pc 6. Power in side bands Psb 7. Power in upper side band Pusb wwwn 8. Total transmitted current It

The maximum peak to peak value of an AM wave is 43 volts and its frequency is 25000000. The peak to peak value of the modulating signal is 21volts and its frequency is 16000. If it is transmitted through an antenna with an internal resistance of 49ohms, 5. Carrier power Pc 6. Power in side bands Psb 7. Power in upper side band Pusb wwwn 8. Total transmitted current It

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Please answer completely what are being asked and please write neatly. Thanks! A 75 MHz carrier having an amplitude of 50 V is modulated by a 3 kHz audio signal that has an amplitude of 20 V. d. Determine the modulation factor. e. What frequencies would show up in a spectrum analysis of the modulated wave? f. Write trigonometric equations for the carrier and the modulating waves.
1. A 1500-kHz carrier and kHz intelligence signal are combined in a nonlin-ear device. List all the frequency components produced. *2. If a 1500-kHz radio wave is modulated by a 2-kHz sine-wave tone, what frequencies are contained in the modulated wave (the actual AM signal)? *3. If a carrier is amplitude-modulated, what causes the sideband frequencies? *4. What determines the bandwidth of emission for an AM transmission? *10. What are some of the possible results of overmodulation? *11. An unmodulated carrier is 300 V p-p. Calculate %m when its maximum p-p value reaches 400, 500, and 600 V. (33.3%, 66.7%, 100%) 12. If V and V as shown in Figure 8, determine %m. (53.85%) 13. Determine and from Problem 12. ( Vpk, Vpk)
Write three important factors which justify the need of modulating a message signal. Show diagrammatically how an amplitude modulated wave is obtained when a modulating signal is superimposed on a carrier wave.
A carrier wave of 100 MHz frequency is modulated in phase by a sine wave of 10 KHz frequency and maximum phase shift of 100 radians. i) Determine approximately the Band necessary for the transmission of the signal in modulated phase, assuming that the modulation signal has unity amplitude. ii) What would the approximate Band be if the amplitude of the modulation signal were doubled? iii) What would be the required band if the frequency of the modulation signal were also doubled? ..
Calculate the frequency deviation and the carrier swing of a frequency- modulated wave which was produced by modulating a 50.4 MHz carrier. The highest frequency reached by the FM wave is 50.415 MHz. Then calculate the lowest frequency reached by the FM wave. If the frequency of the modulating signal is 5 KHz, what is the bandwidth of the FM wave?
Q1) The maximum peak to peak value of an AM wave is 52 volts and its frequency is 58000000. The peak to peak value of the modulating signal is 13volts and its frequency is 21000. If it is transmitted through an antenna with an internal resistance of 93ohms, Find the following: 1. modulation index m 2. percentage modulation %m 3. Amplitude of carrier Vc 4. Total power Pt 5. Carrier power Pc 6. Power in side bands Psb 7. Power in upper side band Pusb 8. Total transmitted current It 9. Carrier current Ic I want to solve Question 6, 7, 8 and 9
If a carrier signal vc(t) = 9 cos(2 pi 3000t) Volts is modulated by a sine wave vm(t) =7 cos(2 pi 440t) V, what is the percentage modulation of the resulting AM signal?
a) If the carrier signal is 10V 100kHZ, the information signal is 5V 3kHZ, an AM Modulator is passed through a filter with Fr=100kHZ and Q=10, what is the sending status of the carrier lower and upper sidebands? b) Draw the AM modulator output envelope? c) Calculate the Modulation index and the sideband and total power to be sent in the transmitter according to the 50 Ohm transmitter output impedance? d) Draw the frequency spectrum? Calculate the antenna length in the transmitter?
Discuss the importance of "LOS (Line of Sight)" in microwave communication and its role in signal propagation.
Suppose the spectrum of the channel is between 5 MHz and 6 MHz. If the signal to noise ratio is found to be 24dB, Find the maximum channel capacity. Also find the maximum number of signal levels in the transmitted signal?
Which mode of propagation is used by short wave broadcast services having frequency range from a few MHz upto 30 MHz? Explain diagrammatically how long distance communication can be achieved by this mode. Why is there an upper limit to frequency of waves used in this mode?
d) How many AM broadcast stations can be accommodated in a 100 KHz bandwidth if the highest frequency modulating a carrier fmax is 5 KHz?e) The total power content of an AM signal is 1000 W. Determine the carrier power PC and the sideband power Ps and power efficiency when the modulation index is 0.5?f) An amplitude modulated wave has a power at its carrier frequency (PC) of 800 W. determine the sideband power Ps and total power when the modulation factor is 0.8?