I need the answer quickly stion 1The micrometer reading of the following figure is:yetveredked out of1015 20lag question-45Select one:О а. 21.49O b. 21.51О с. 20.49O d. 20.51O e. None of them

Explanation: In above micrometer readingThe main scale on sleeve contains positions of 0.5mm ,…

Answered: The micrometer reading of the following…

The micrometer reading of the following figure is: 10 5 15 20 -45 Select one: O a. 21.49 O b. 21.51 O c. 20.49 O d. 20.51 O e. None of them

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Q2. Consider an LTI system with the frequency response shown in figure Q2. Find the output for the…

Q: 10-14. The following noise record was obtained in the front yard of a home. Is this a relatively…

Q: 3. A water jet that comes out of a pipe, exits into the air and strikes a plate. If the force is…

Q: Incandescent CFL LED Watts 60 14 7 kW 0.06 0.014 7 Hours 25000 25000 0.007 Quantity 20 3 25000 Cost…

Q: A differential manometer is connected to two water tanks initially filled up to same level and open…

Q: 9. Connected to an 18-inch water line is a 6-inch horizontal Venturi meter, with a meter coeficient…

A: Given data in question Diameter of pipe line Diameter of Venturimeter Coefficient of discharge…

Q: langulation): Two stations B and C were observed from a theodolite set up at station A and following…

Q: 1. COMPUTE FOR SPACING BETWEEN LIGHTING UNITS TO PRODUCE AVERAGE LUX STREET WIDTH = 15M %3D MOUNTING…

Q: A bubble tube of a level has a sensitiveness of 20" per 2 mm division. The error in the reading on…

Q: 10-1. A building located near a road is 6.92 m high. How high is the building in terms of…

Q: Q#15: The following is the data relative to observed stations made on vertically held staff with a…

A: The distance equation, that is the horizontal distance between the axis and the staff is given as:…

Q: 13. The following table gives two-way travel-times of seismic waves reflected from different…

Q: A PIPE 2.95m Long+ DETERMINE THE FREQUENCIES OF THE FIRST THREE HARMONICS IF THE PIPE IS OPEN AT…

Q: Problem 5.10 A calibration was made to evaluate the constant of a transit with a focusing interval…

A: NOTE :- As per our guidelines we are supposed to answer first question only. So please repost other…

Q: What is the estimated error of an EDM instruments having specified errors of ±(7 ?mm + 6 ppm) in…

Q: Calculate for the moment of inertia about the vertical centroidal axis for the region shown below: y…

Q: Q#15: The following is the data relative to observed stations made on vertically held staff with a…

A: Constant of instrument = 100

Q: Determine the deflection at point D of the beam shown in Fig. 7.13(a) by the virtual work method

A: Virtual work method: In the virtual work method, the law of conservation of energy is used to…

Q: 4. TITI 10' 20 kips 10' 1 max = Ama Max =

A: Given data:-

Q: In an external focussing tacheometer, the fixed interval between stadia hairs is 5 mm, the focal…

Q: Q1). The following consecutive readings were taken along a straight line from station (11+090) to…

Q: Calculate the y-coordinate of the centroid of the shaded area. 12" 55°55 11" 2" 12" 12"- Answer: Y =…

Q: Q2) determine the normalized average power in frequency domain of f(t)= 4cosa00r +30°)+2cos(200…

Q: A stone is dropped from the deck of a bridge. The sound of the splash reached the deck 3 secs later.…

A: If the initial velocity is straight down, then it is one and the same. If it is straight-up and…

Q: A tacheometer is setup at station A and the staff is held vertical at a point B. The telescope…

Q: hat is the estimated error of an EDM instruments having specified errors of ( 4 mm + 4 ppm) in…

A: Given : Specified errors = ±(4mm+4ppm) Distance = 7.1754 km = 7175.4 m

Q: A stone is dropped with zero initial velocity into a well. The sound of the splash is heard 3.63 s…

A: To find the distance-

Q: What is the estimated error of an EDM instruments having specified errors of ±( 4 mm + 2 ppm) in…

A: Given : Ec=4mmD = 8.0752km⇒8075.2m

Q: Calculato the angle of incidence of beam radiation on a surface located at Glasgow. Scotland if the…

A: Given; Latitude=ϕ=56oN Day = 1st February 'n' denotes the day number since there are 31 days in…

Q: Calculate the moment of inertia of the shaded area about the x-axis. ... 95 mm 28 mm 49 mm t49 mm -…

Q: The following measurements were taken using a theodolite that was not moved. Calculate the…

Q: What is the estimated error of an EDM instruments having specified errors of + ( 5 mm + 2 ppm ) in…

A: Estimated Error in Distance is Given as : Error =Ec2+el2+ec2+(ppm ×D)2Where : Ec & ei…

Q: If an EDM instrument has a purported accuracy capability of ± (11.5 mm + 2ppm2), what error can be…

A: To find error in measured distance

Q: BACKSIGHT FORESIGHT DE im) ELEVATION (m) STA RR (m) VD (m) RR (m) VD (m) (m) (m) BM- I01.245-4° 25'…

Q: Determine the gage reading of the manometer system below air 20 ст water 3 m gage mercury

Q: Determine the moment of inertia Ix of the shaded area about the y axis. as the following procedure:…

Q: Question 01: A Tacheometer was set up at point P and two readings were taken from two station A and…

A: Since the Question number to be solved is not specified, the solution for Question No.01 is as…

Q: What is the estimated error of an EDM instruments having specified errors of ±( 8 mm + 4 ppm) in…

Q: Construct a rainfall hyetograph Question 1 above has the following temporal distri Table 1: Tem

Q: 225 P- 8 P;= 10 9;- 18 2 (m) 1 (m) 4.50 (m) 1.50 (m)

Q: 2. Assume the separation for A, B, and C. With the instrument midway between A and B the readings…

Q: What is the estimated error of an EDM instruments having specified errors of ±(2 ?mm + 6 ppm) in…

Q: Water is flowing. Calculate direction and aproximate magnitude of the manometer reading. 1Scm 15 m…

A: Fluid is an important part of the fluid mechanic's sector. Fluid can be compressible or…

Q: 16. For a gage reading of -17.1 kPa, determine the (a) elevation of the liquids in the open…

A: the gage reading (P) = -17.1 KpaTo Find: -A) the elevation of the liquid in the open pipe piezometer…

Q: What is the estimated error of an EDM instruments having specified errors of ±( 5 mm + 2 ppm) in…

Q: Given data : Initial velocity=20 m/s Final velocity=25 m/s time=D4 s

A: Given data : Initial velocity=U Final velocity=V Time=t To find : Acceleration

Q: Question 6 Q6) In an attempt to verify if this law is obeyed by the light from a source the above…

A: The given table is shown below:

Q: 2. Calculate area moment of inertia about the horizontal and vertical axis passing through centroid…

A: Let divide the entire area into 3 portion Area of portion 1 = A1 = (60 x 30) =1800 , A2 = (90 x 25)…

Concept explainers

Asphalt Binders and Mixtures

Asphalt binders are subsidiary products procured during the refining process of petroleum while manufacturing gasoline, diesel, and similar petroleum products. Asphalt binders are obtained from the residue that remains after the distillation of petroleum, this residue is further subjected to steam distillation and oxidation to remove the traces of gas oil present in the residue. Certain additives or modifiers are also added to asphalt binders to alter them to suit different applications.

Question

I need the answer quickly

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

ANSWER KEY: PROBLEM 5.10K1=102.2495mPROBLEM 5.11 D=150.7275m∆h= 33.8483m
Question: 1 To determine the elevation of station A, the following observation were taken, the rod held vertically. The instrument fitted with Anallatic lens and value of constant was 100. Inst. Station Height of instrument Staff Station Vertical angle Staff Reading Remarks O 1.440 B.M - 5o40’ 1.332 1.896 2.460 R.L of BM = 158.205 m B 1.440 C.P +8o 20’ 0.780 1.263 1.746 A 1.380 C.P -6o 24’ 1.158 1.617 2.076 subject: Engneering surveyin 1
Transit is set up at A observeda stadia intercept of 2.2 m at a verticalangle of +1823’. The stadia interval factor ofthe instrument used is 95.5 and stadiaconstant of 0.3 m. If the height of instrumentis 1.62 m, and the rod reading is 1.95 m.Determine the horizontal distance from thetransit set up A to the rod at point B. a. 201.44 m c. 198.45 b. 189.48 m d. 186.56 m
0 a 2178 kN O b. 3726 kN 1| select one: WG o weiox92
A tower is located on a hilltop at T. Angular readings are taken with a theodolitefrom two instrumentation stations A and B, which are 50 m apart. Given the followingdata, determine the R.L. of hilltop at T and the tower height. Height of instrument (R.L.of instrumental centre) = 10 m. Vertical angles from A to the top and bottom of thetower at T is 35° and 28°(upward) respectively. Whole circle bearing of line AT, ABand BTis 25°, 110°, 5° respectively.
Given:Upper reading = 1.64 mMiddle reading = 1.57 mLower reading = 1.51 mVertical Middle Angle = 10°32’00”Elev of point A = 333 mH of instrument = 1.2 mK = 100Stadia Constant = 0 Solve the ff.: A. Inclined, horizontal, and vertical distance B. Elevation of point B.
deg= 23.234 qo (kn/m) = 20.82
Whatisthehydraulicradiusofarectangularairduct300mmby 500mm?
A stone is dropped down a well with a velocity of 3.28 ft/s and 16.30seconds later thesound of the splash is heard. If the velocity of sound is 1130 feet per seconds. What isthe depth of the well?
From the given figure below, the engineer’s transit is set-up at point C. Calculate:a. Difference in elevation between A and Bb. Elevation of ATake note of the Values: RR @A = 91.296 mS between A and C = 111.296 mS between C and B = 211.296 mRR @ B = 11.296 mElevation @ B = 1511.296 m
A surveying student had recorded the following afterrepeated pacing:First distance = 200 m.No. of paces: 222.00, 231.10, 230.50, 210.20, 215.20, 211.80,221.00, 230.20, 220.90, 218.10, 211.50, 218.50, 212.20, 216.00and 215.80Determine the second distance if the no. of paces are: 570.10,572.20, 575.00, 571.20, 572.30, 570.00, 578.10, 569.90, 569.50,571.20, 573.30, 573.50, 570.40, 575.20 and 593.80. SEND SOLUTIONS
A tacheometer was set up at B.M and the following observations were made with a leveling staff held vertically at P and Q. Ins: Station Staff Station Vertical Angle Hair Readings Bearings Remarks B.M P +10° 00’ 1.050, 1.103, 1.156 40° R.L of B.M =1958.500 ft Q -15° 00’ 0.952, 1.055, 1.158 140° The constant of instrument (f/i) = 100, Height of instrument = 5.15 ft Compute: The horizontal distance between P and Q Reduced Levels of P and Q Grade between P and Q