The power supplied by the two current sources in the following circuit is:100R, 3A)602ASelect one:O a 37.5 WO b.-56.25 WOc-18.75 WO d-37.5 WO e. 93.75 VWO f. 18.75 WO g 56.25 VWO h. -93.75 W

Answered: Image /qna-images/answer/ec53e25b-c7b9-42b4-b802-242f3247ef1a.jpg

Answered: The power supplied by the two current…

The power supplied by the two current sources in the following circuit is: 100ER, 3A 6AR Select one: O a 37.5 W O b-56.25 w Oc-18.75 W O d-37.5 W O . 93.75 W O f 18.75 W Og 56.25 W O h. -93.75 W

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter23: Resistive-inductive-capacitive Series Circuits

Section: Chapter Questions

Problem 9RQ: What is the power factor of the circuit in Question 6?

See similar textbooks

Related questions

Q: 1. Determine the output voltage Vo for the following circuits (a) 5k2 1k2 2Vo- Vo O Vo | 1.…

A: Given, a) inverting amplifier b)non inverting amplifier, To determine output voltage for both…

Q: Determine the voltage V, in the circuit in the figure. 12V Vo 3 20 21 O -3.28V O 4.14V O-6.43V O…

A: Given,

Q: 2Ω O5V Ε 20 V 3Ω 4Ω 52-54. The voltage v across the current source in the circuit is: 20 V 15 V 10 V…

Q: + Vx - + 4V 2A 1(A

Q: Find the voltage in resistance (5 Q) using superposition theorem in figure (4). 18A 30v

A: Superposition Theorem When more than one source (Voltage/current sources) are present in the…

Q: Q4. Find the inverse DFT x(n) for the X(k)-[0 1.5-jo.866 1.5+j0.866]

Q: PRO6. #3. FIND THE INDICATED bTdE BY VOLTAGE DIVIDER VAC Vc RI=50e XL=902 Tlee mmー R2=20-2 DIS0/30…

A: In this question we need to find a voltage VAB and Vc by using voltage division method.

Q: If V1=7 V and V2=3 V in the below circuit, then the output voltage (V.) is equal to +15V Vo Vz -15V

Q: Find the voltage gains Aus=V/V; and Au=V/Vi R$ Ro IMN + ImV ui R 2Mn 10ʻu RL

A: Given parameters are: VS=1mV, RS=1MΩ Ri=2MΩ, Auoc=104, RO=2Ω RL=8Ω.

Q: For the circuit show. The value of the current in the secondary side 12 is.A. * 1H F 80

A: The solution can be achieved as follows.

Q: When the input voltages to this circuit are Vi1 = 0.15 V and Vi2 = 0.7 V, the output is 10 ΚΩ 5 ΚΩ…

A: given here a op amp based circuit and asked to find the output voltage V0 . here nothing is…

Q: calculate in superPosition VRi, VR2, UR3 IR. IRe, IR3 RI R2 = 680r E, E lov

A: For superposition Theorem, only one independent source is active at time. If voltage source is…

Q: Perform the addition (-160)10 and (-130)10 using 2’s and 9’s complement form. note: question must…

A: To perform the addition (-160)10 and (-130)10 using 2’s and 9’s complement form.

Q: Q/ for the two circuits shawn below, Deter hine the a) D, current and the voltonge drof ackoss l.xK…

A: Diode- It is the minimum forward voltage across diode after which diode start conduction. Diode is…

Q: Yuis tion de termin the Power obsorbed bs each of shown in figure The in circuit resis tance 42 さ62…

Q: Sketch the output voltage (V.) for the circuit and the input voltage (V.) shown in figure (3). R Vị…

Q: ) In circuit below find the total current la Ia lash lOvO $452 R

Q: Solve the Circuit in given in Figure to: 20 (a) Find all the Voltages using voltage divider rule.…

Q: Cells are connected in parallel to increase the current output. In the figure below, if the three…

A: When voltage sources of unequal magnitude are connected in parallel and these given sources have not…

Q: The values of duty cycle (D) lies between O a. 1D>-1 O d. 0<D<1

A: In this question , we have to write range of duty cycle...

Q: Identify the nodes in the following circuit. How many nodes are there in total? 470 uF 470 uF 1000…

A: Node is a junction/point in the circuit where two or more than two branches are connected. if 2…

Q: Determine power balance by applying superposition a = 8Ω b = 8Ω

Q: find current i0 and voltage v0 in the circuit shown 0.5io 3A + Vo •

A: Given circuit,

Q: 6. What is the difference between (P=I*V) and (P=1² * R)?

A: In this solution let's discuss the basic difference between both the given formulae and when to use…

Q: A 7 Voltage Source -j 4

A: According to the question we have to find the value of I1 and I2.

Q: In the following circuit we have to transfer maximum power to the load RL, Determine the appropriate…

A: In this question , we will find load resistance value for maximum power transfer...

Q: Q6. Using Nodal analysis method, what is the value of v, in the figure? 5A a. 3 V b. 4.8 V 2Ω 8Ω ww…

A: 6) to find the value of vo using nodal analysis

Q: 6- Find I and Vab in the following circuit 10 V 30 ww Va BV 30 V

A: The solution can be achieved as follows.

Q: 4. Determine the total complex power of the load in the circuit below. Time saver: same circuit as…

A: In this question we need to find a total complex power of the given circuit.

Q: 25 V Determine the voltage V4. O -6V + O a O -8V 20 V -10V O -4V V. Determine the voltage across…

Q: Q-) Find dium. power, instantaneous power, active pow. ane and reactive power. 5)16 these three…

Q: W Fimd The voltaye for (2) Fnd the current for R, Re, Re Ru Ro

A: Redrawing the circuit by marking the current as shown below:

Q: Multiply each current and voltage by 4 then determine the power on the 4A current source in the…

A: Given circuit, Multiply each current and voltage by 4

Q: In the circuit in Figure 12.77, the switch has been in position 1 for all t 0). Find and sketch…

Q: Q2/ Calculate Vo for a ladder R-2R DAC with Vref= 5V, R=1k0 and the i/p digital word was [011]

Q: In the L-C-R circuit shown below, the voltmeter and ammeter readings are : 400 V 400 V O moo L R =…

A: Current in inductive circuit lag voltage by 90 degree Current in capacitive circuit lead voltage by…

Q: A 6A current source drives a load consisting a parallel combination of R1 = 60 0 and R2 = 10 0.…

Q: Two resistors 5 kN and 20 k2 are at 27°C. total noise voltage for the parallel combination? what is…

Q: Dw B. B ninim ods o

Q: Given that R=2.42 and that each R dissipates a maximum power of 36w without being spoiled what is…

Q: R1 R2 20 I = 2AZ30

Q: olp f the cct. if vVz V2) Vi what the Per The Cir Cuit below Re Ri Vie Rz V20 dlo

Q: For the circuit shown below calculate VB in V when IDSS=12mA VP=-6V and B=120

Q: For the below circuit find the power dissipated in the 60 resistor. 1.6 2 10 A 162 Select one: O a.…

Q: : Determine the maximum power transfer to the load resistor RL. lokN 30N 4ar 22KN 50N RL 40kh Vo…

A: Maximum power transferred to load RL can be obtained by realizing Thevenin's equivalent across the…

Q: Using the current sivider rule fin She current through each impedance R x2 = 44 XC 622 3x²32

Q: ompute for the following. a. Ib b. Ic c. le d. Vce e. Draw the re model f. Zin g. Zout h. Ai i. Av…

Question

The power supplied by the two current sources in the following circuit is:
100R, 3A)
60
2A
Select one:
O a 37.5 W
O b.-56.25 W
Oc-18.75 W
O d-37.5 W
O e. 93.75 VW
O f. 18.75 W
O g 56.25 VW
O h. -93.75 W

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 5 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Initially: RL= 100 oms, CL= 0.011 uF then: a) If the frequency of the source is doubled, what changes should be done to maintain maximum power transfer to the load? b) How does this change affect the value of the maximum power?
Do the DC Analysis of the circuit below and find out the DC voltage R1=30kΩΩ=610Ω
A three phase transformer, 11000 / 381 V, has D/Y connected and takes 12A from supply. The line current on the secondary side is * 1-0.24 A 2-600.08 A 3-200 A 4-346.45 A
3. Find i using superposition. 4. Find the value of alpha for maximum power to be received by the load.
An electic heater, 1- iS A from V= 115V Sowrce; 2 Canducter Con necting is La43 m long, the total ge dvop a long the Gbles is net to exceed V=12, Determine thedliameler (D), fP172aoam
Determine the open circuit voltage, in mV to the left of terminals a and b. R1 = 65 kohmsR2 = 76 kohms
For the network in the figure: a. Determine re. b. Find Av = Vo / Vi. C. Calculate Zi. and Zo.
With an AC voltage source of 5.4V and an f = 32000Hz. a) Calculate the Voltage and Current over 8100ohm. b) Calculate the Voltage and Current over 6µF. (Using the node voltage method)
two resistor in series connection, 20k ohms and 50 ohms respectively are at ambient temperature generates 2.16uV noise voltage, calculate the equivalent noise voltage if these two resistor are to be connected in series a. 987.82uV b. 975.79nV c. 952.16nV d. 440.82nV if the answer is not in the choices write it
If a transformer ratio is 4:1 and is connected to a 480v source, what is the secondary voltage of the source voltage is decreased by 7.5v
6 A transformer has 689 primary turns connected to a 1668 V supply. Choose the number of secondary turns for a 254 V Load voltage. a. 105 Turns b. 4525 Turns c. 689 Turns d. 615 Turns
A device has been tested under different load conditions and load currents have been recorded. Using appropriate techniques, combine the following recorded currents into one single wave i. I1= 0.866SinƟ+0.5CosƟii. I2= 0.574SinƟ-0.819CosƟiii. I3= 0.866CosƟ-0.5SinƟ