Answered: The range of frequencies a channel can…

The range of frequencies a channel can pass is called bandwidth in a. Bits per second b. Hertz c. Kilogram d. Nanosecond

Fundamentals of Information Systems

9th Edition

ISBN:9781337097536

Author:Ralph Stair, George Reynolds

Publisher:Ralph Stair, George Reynolds

Chapter4: Networks And Cloud Computing

Section: Chapter Questions

Problem 4RQ

See similar textbooks

Related questions

Q: 6) You are trying to calculate what the theoretical maximum throughput is on a given communication…

A: A music signal is characterized by a rms voltage of 2 V and a bandwidth B of 15 kHz. A noise process…

Q: A channel has a bit rate of 4 kbps and a propaga- tion delay of 20 msec. For what range of frame…

A: The Answer is

Q: III. The figure below shows synchronous TDM, the data rate for each input connection is 1 Mbps. If 1…

A: Given :- The figure below shows synchronous TDM, the data rate for each input connection is I Mops.…

Q: Q.1: A binary symmetric channel with error probability of 0.3 and marginal entropy H(y)= 0.97095…

A: For answer (i) Attached image below:

Q: In a digital transmission, the receiver clock is 0.1 percent faster than the sender clock. How many…

A: Given: In a digital transmission, the receiver clock is 0.1 percent faster than the sender clock.…

Q: The frequency ranges of some channels are given below- Identify which of them is a LOW PASS channel…

A: Low pass channel bandwidth starts from 0.

Q: What will be the frequency of the carrier for an AM wave, if its highest frequency is 850 Hz and the…

A: Upper frequency =850 HzBandwidth =50 HzTherefore lower Frequency =850−50=800 HzCarrier Frequency…

Q: Assume that a voice channel occupies a bandwidth of 8 kHz. We need to multiplex 10 voice channels…

A: Given: Channel bandwidth = 8kHz Guard bands = 1000Hz = 1kHz Number of channels = 10 to find:…

Q: Ten signals, each requiring 4000 Hz, are multiplexed onto a single channel using FDM. What is the…

A: The answer is

Q: Explain Difference between Circuit Switching, and Packet Switching. And also what are the advantages…

A: I have provided the answer in step 2.

Q: 25 noise ratio? Include in your answer what happens when the signal goes up or down and the same for…

Q: A 5 kHz channel transmits a signal experiencing SNR of 31. What is the maximum Bit Rate of the…

A: Here is the solution:

Q: Which transmission characteristic is never fully achieved? a. Latency b. Throughput c. Bit rate d.…

A: Answer: The correct option is (d) Bandwidth

Q: Your answer includes number only, thousands should be separated by a For example: 1,000 or 1,000,000…

A: GIVEN : Distance( satellite ,earth) = 36,000 km [As , 1 km = 103 meters] Distance between…

Q: For a ______ channel, the Nyquist bit rate formula defines the theoretical maximum bit rate. a.…

A: Answer :- ( b ). noiseless

Q: source encoding is 101 and the r is 2. what is the channel encoding?

A: Code for the source: A feed encoder turns electrical wavelengths to bits, while a receiver reverses…

Q: Assume that a voice channel occupies a bandwidth of 4 kHz. We need to multiplex 10 voice channels…

A: In go-back-n protocol, given the size of the sequence number field is 8. then the sequence number is…

Q: Exercise (1): A line has a Signal-to-Noise ratio 35dB and a bandwidth of 4000HZ, what is the maximum…

A: Data rate governs the speed of data transmission. A very important consideration in data…

Q: Assume having a low-pass channel that spans from a Frequency of 0Hz to 110Hz, to attain a bit-rate…

A: please upvote for my efforts ! answer: shannon's channel capacity formula: bit rate = bandwidth *…

Q: III. The figure below shows synchronous TDM, the data rate for each input connection is 1 Mbps. If 1…

Q: Find the new durations for a) the input bit duration, b) the output bit duration, c bit rate, and d)…

A: When there are four channels then each frame will carry 2 bytes from each Channel A)Therefore 2byte…

Q: Q1/ find the channel redundancy of the BSC shown below, if I(x1) = 3 bits? 0.7 X1 y1 0.3 0.3 X2 y2…

A: Input Data : X1 = 3 bits Probability of transferring bits from X1 to y1 = 0.7 Probability of…

Q: The physical layer is responsible for a. line coding b. channel coding c. modulation d. all of the…

A: The physical layer is one of the layers in the OSI network model that mainly deals with the physical…

Q: The actual bandwidth of a digital signal is infinite, the effective band width would be a. Finite b.…

A: Answer :- ( a ). Finite

Q: 2. (a) Suppose a radio channel occupies a bandwidth of 11 kHz. We need to multiplex 14 radio…

A: a) Bandwidth occupied by radio channel =11 KHzNeed to multiplex 14 radio channels with guard binds…

Q: A frame size 10 million bytes is being sent on a link with with bandwidth of 8 Mbps. The total…

A: Hi Dear!! Please give positive feedback!! Frame of size = 10 million bits = 10 × bytes = 10000000…

Q: Exercise (3): The Bandwidth of a voice signal is 3000HZ, what is bit rate required to send this…

A: I have answered the question in step 2. bandwidth w = symbol rate= bit rate / divided by the number…

Q: Q2.a) Suppose, the sender has 2Gb high quality videos to send to a receiver. But the sender does not…

A: 10 mins = 60*10 = 600s 2 Gb = 2*1024Mb = 2048Mb.

Q: 1- The bandwidth of the SSB signal is compared to DSB signal A. Triple B. Double C. Same D. Half E.…

A: DSB is double sideband suppressed carrier modulation and SSB is single sideband suppressed carrier…

Q: Telephone lines are considered as channels. a. band pass b. low pass O c. band reject O d. high pass

A: here have to determine correct option for telephone lines.

Q: 5. Assume that there are five 1 kbps connections to be multiplexed together. A unit is 1 bit. Find…

A: Ques 5). Before Solving the question we need to know that "what is multiplexing?". "It is the set…

Q: Mutual information of the channel can never be negative.

A: the ans is false

Q: Question 5 In the transmission, the channel capacity is shared by both communicating devices at all…

A: Given: In the ______ transmission , the channel capacity is shared by both communicating devices at…

Q: Baseband transmission of a digital signal is possible only if we have a ____ channel. a. low-pass b.…

A: Baseband Transmission of a digital signal is a type of signaling technology that sends digital…

Q: An RF frequency has 30-36 MHz as its lower andhigher frequencies. It has a current channel capacity…

Q: sume that data rate for each input connection in figure above is 5 Mbps. A unit is 1 bit. nd the new…

A: 6c Frame rate = Data rate from each Channel x byte carried by each frame = 50 x 2 =100 frame /…

Q: ESTION 7 How many signal levels are needed to achieve a theoretical data rate of 32Mbps if the…

A: Nyquist formula: The Nyquist formula describes the link between data transmission rate, bandwidth,…

Q: What is meant by "asynchronous" in the topic of Asynchronous Communications? O No clock is…

A: 1) Serial data transfer can be grouped into two types: Synchronous: Both the sender and receiver…

Q: A channel has a 1-MHz bandwidth. The SNR for this channel is 63. What is the appropriate bit rate?…

A: Here shannon formula is used to find the upper limit C = B log2 (1 + SNR) = 106 log2(1+ 63) = 106…

Q: What is the channel capacity for a communication channel with a bandwidth of 1 MHz, 1 W transmitted…

A: Find the required answer with calculation given as below :

Q: The physical layer is concerned with the movement of over the physical medium. Select one: a.…

A: For question 1 The physical layer is concerned with the movement of Bits over the physical medium.…

Q: 93. ................. is a measure of how much the strength of the signal is reduced in passing…

A: It is very obvious that when signal travels through various communication medium then it’s power…

Q: The range of frequencies a channel can pass is called bandwidth in Hertz why?

A: A range of frequencies within a continuous set of frequencies is referred to as bandwidth. Hertz is…

Q: 4b. A Television channel is 6 MHz wide. How many bits/sec can be sent if 8 level digital signals are…

A: Answer: 36 Mbps

Q: Given the main frequency of the wideband channel to be 250MHZ with a bandwidth of 200MHZ, what will…

A: Given Data : Main frequency = 250 MHz Bandwidth = 200 MHz Number of subchannels = 4

Q: The physical layer is responsible for

A: The physical layer is responsible for

Q: 6) You are trying to calculate what the theoretical maximum throughput is on a given communication…

A: Given Bandwidth (B) = 15kHz = 15000 Hz Number of signal levels (M) = 2 Theoretical Maximum…

Concept explainers

Types Of Protocols

A network protocol is a collection of rules that governs the exchange of data between devices connected to the same network. In other words, network protocols are rules that specify how devices communicate or transfer data over a network. The sender and receiver systems must obey the standards to facilitate communication between them.

Question

The range of frequencies a channel can pass is called bandwidth in
a.	Bits per second
b.	Hertz
c.	Kilogram
d.	Nanosecond

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2: Correct Option

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.

Similar questions

Computer Science Suppose that you had more than 4GByte of data to send and could only afford one memory stick but you had plenty of pigeons available (Winston’s extended family). You reason that you can send the data stick back, load it with the next 4GByte of data. What would the throughput of this channel be now?
Two channels, one with a bit rate of 100 kbps and another with a bit rate of 200 kbps, are to be multiplexed: a) How this can be achieved? b) What is the frame duration? e What is the frame rate? What is the bit rate of the link? And Please be clear, couldn't understand a bit from the last two answered
In digital communications, what term is used to descirbed the relationship of the message bits and the encoder output bits? A. Code rate B. Transmission rate C. Efficiency rate D. Error rate
Transcribed Image Text:This is about radiated media communication, microwave communication vs satellite communication. Under what circumstances would you use satellite communication circuit a rather than a microwave communication circuit?
Assume we need to download text documents at the rate of 500 pages per second (each page is 24 lines with 80 characters per line (8 bits per character)). What is the required bit rate of the channel?
Is it true that a narrowband channel transfers data slowly? Why?
Sharing a medium and its link by two or more devices is called Select one: A. Modulation b. error handling c. digital coding d. multiplexing
118. In _______, the peak amplitude of one signal level is 0; the other is the same as the amplitude of the carrier frequency. a. PSK b. OOK c. FSK d. none of the above