The reading taken in a room from sling psychrometer gave a dry and wet bulb temperature of 25°C and 19.7°C respectively. Using psychrometric equation and psychrometric chart, determine: a. specific humidity b. relative humidity c. dew point temperature d. specific volume

The reading taken in a room from sling psychrometer gave a dry and wet bulb temperature of 25°C and 19.7°C respectively. Using psychrometric equation and psychrometric chart, determine: a. specific humidity b. relative humidity c. dew point temperature d. specific volume

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter35: Comfort And Psychrometrics

Section: Chapter Questions

Problem 3RQ: Lower room temperatures can be offset in winter by A. lowering the relative humidity. B. being very...

See similar textbooks

Related questions

Q: ᴡʜᴀᴛ ꜰᴏʀᴄᴇ ɪɴ ᴋɴ ɪꜱ ɴᴇᴄᴇꜱꜱᴀʀʏ ᴛᴏ ᴘᴜɴᴄʜ 4 ꜱɪᴍᴜʟᴛᴀɴᴇᴏᴜꜱ ꜱQᴜᴀʀᴇ ʜᴏʟᴇꜱ, 30 ᴍᴍ x 30 ᴍᴍ, ɪɴ ᴏɴᴇ ꜱᴛʀᴏᴋᴇ…

A: Given data: Number of holes = 4 Dimension of square hole = 30 mm x 30 mm Thickness of plate = 7 mm…

Q: The 43-kg cylinder is suspended from a clamping collar at C which can be positioned at any…

A: (a) Draw the free-body diagram of point C. Write the angles α and β.…

Q: Consider the hollow pipe supported and loaded as shown below. Which of the following represents the…

Q: 2m В A -500 N 45° -2m- C

A: Given,

Q: in 1 2 A block of mass m slides on a horizontal surface that has been lubricated with heavy oil so…

Q: The beam is to be hoisted using two chains. Determine the magnitude of force FA in order to develop…

Q: 4) A large aircraft having a volume of 80,000 m³ contains helium under standard atmospheric…

Q: A train travels along a circular track having a radiusof 2000 ft. If the speed of the train is…

A: Given:- A train travelling along a circular track Radius of track (R) = 2000 ft Initial velocity…

Q: Characteristics of Two Collisions of Pucks on an Air Table Collision I A stationary puck, Puck I, is…

A: Here I'm going to answer the question which is related to impulse theory.

Q: Two rods A and B are subjected to different external axial loads. If rod A carries an internal load…

A: Given: Two rods A and B where load on rod A = P kN load on rod B = 4P kN To find: the relationship…

Q: Gut the initial temperature (T1) in :( o C) is A piston-cylinder device contains water of quality…

Q: 3. Four pulleys are attached to the 50-mm-diameter aluminum shaft. If torques are applied to the…

Q: the power output (W out.) in (MW) is Adiabatic steam turbine has inlet of 6 kg/s at 5 MPa, 600 oC.…

A: Given that: P1 = 5 MPa, T1 = 600 oC Mass flow rate of steam is 6 kg/s P2 = 100 kPa, x = 100 % It is…

Q: Four people are attempting to move a stage platform across the floor. If they exert the horizontal…

Q: Highlight the concise difference between sensible cooling and cooling-dehumidifying process?

A: A psychrometric procedure that involves raising or lowering the air's temperature without altering…

Q: Q1/ Choose the correct answer (True or False) False O True AutoCAD provides nine ways to draw an arc…

Q: B- A6-mm-diameter electrical transmission line carries an electric current of 50 A and has a…

A: Given Diameter, d = 6 mm Current, I = 50 A Velocity, v = 40 km/h = 11.11 m/s Find Surface…

Q: The resultant of three concurrent forces A, B, and C is 10N with directions ?? = 60°, ?? = 60°, ?? =…

Q: The guy wires AB and AC are attached to the top of the transmission tower. The tension in cable AB…

Q: F. ssume F-470 N, 0 = 24° nswers: F Mi i Ꮎ F i+ N N j) N

Q: is fired down words. initial speed of into 27 m/s. If it experiences a deceleration of a = (-6t)…

A: given; initial speed(u)=27m/sdeceleration(a)=-6t m/s2where;t =time in seconddistance(s)=?final…

Q: Q3/ For the figure below: a) The total area is: 2 6"

A: Given: To determine the total area and the centroid of the given composite figure.

Q: Link AB, of width b =50 mm and thickness t = 6 mm, is used to support the end of a horizontal beam.…

A: Given Width = 50 mm Thickness = 6 mm Allowable normal stress = 2140 MPa Allowable shear shear stress…

Q: The maximum temperature in the cycle :in ( o C) is A steam power plant operating on ideal Rankine…

A: Given, Pressure of steam at the inlet of turbine (high pressure) = P1 = 2000 kPa Pressure of steam…

Q: A couple of magnitude M-54 lb.in. and the three forces show are applied to an angle bracket. (a)…

A: GivenM=54lb

Q: 2.( , The blank for the spool shown in the figure below is to be sand cast out of A-319, an aluminum…

Q: The block in the figure has a weight of 400 lb and an applied force of 600 lb to the right. There is…

A: Given Weight, W = 400 lb Force, F = 600 lb Find Magnitude P and R

Q: The shown 4-bar mechanism has the following dimensions for its links: AB=8, BC =32, DC= 16, DE = 12,…

A: Given: To find: θ3,θ4,RED

Q: 224 lb 200 lb 60° 30° 12 390 Ib 300 lb X

Q: The guy wires AB and AC are attached to the top of the transmission tower. The tension in cable AB…

Q: The maximum temperature in : the cycle (in degree Kelvin) is Otto cycle has a compression ratio of…

A: 1) The Maximum cycle temprature =2676.470k OPTION 3 - BETWEEN 2500-2750K 2) The Exhaust temperature…

Q: Consider 2 kg of air has a decrease of internal energy of 25 kJ during a reversible non flow…

A: Given that: m = mass of air = 2 kg decrease in internal energy is -25 kJ. The process follows…

Q: P4. Two solid circular rods are welded together at B as shown. Determine the normal stress at the…

Q: For the structure shown in Fig.(2), determine the tension in cable ABD and the reaction at C when…

Q: Problem 3 Oil with S.G. = 0.86 is being transported in a pipe. Calculate the pressure if a U- tube…

Q: give two example and explanation of thermal energy transformation at constant volume, pressure and…

A: Given Thermal energy transformation To find Constant volume Constant pressure Constant heat

Q: Calculate the moment Mg of the 625-N force about the bolt at B. Simplify your work by first…

Q: Parameters of the following transfer function is given as: k=6, a=3.1, b=3.4, and c=2.8, determine…

Q: What is the injection duration (deg) needed for fuel injection in a single cylinder dieselengine…

A: Given Data The power engine produced is:P=50 kW The engine operating speed is:N=1500 rpm The break…

Q: briefly discuss ways of protecting a mental from corrosion

Q: 6. A hydraulic lift (see below) of the type commonly used for greasing automobil 280.00 mm diameter…

A: Given data as per questionDiameter of ram, d=280 mmDiameter of cylinder, D=280.18 mmOil film…

Q: How far cooling process should be to attain cooling-dehumidifying process?

A: Cooling and dehumidification is the process in which working fluid is cooled and dehumidification…

Q: The stagnation density after the shock (px= 55 kPa, Tx= 335 K, vx= 525 ms- ‚1) 0.26 kgm-3 O 0.77…

Q: Problem 4 A triangular gate is in the form of a right triangle with legs 1.8 m and 2.4 m. The 1.8 m…

Q: Find the 50 kPa, 5.27 m³/kg temperature in Celcius for water at

Q: Explain why do we need to know about the hydrostatic forces acting on plane surfaces in hydraulic…

Q: peed ahead and the other full speed in reverse. What thrust P must each tug exert on the ship to…

Q: OTTO CYCLE 3. A spark ignition engine operates on an Otto Cycle with a compression ratio of 9 and…

A: Given:- A spark ignition engine operating on Otto Cycle Compression ratio (r) = 9 Minimum…

Q: When a fluid flows through a sharp bend, low pressures may develop in localized regions of the bend.…

A: Given: Fluid is water at temperature 80 oF.

Q: Determine the torque applied to the shaft of a car that transmits 450 hp and rotates at a rate of…

A: Given:Power transmitted by the car, P=450 hpSpeed of the shaft, N=300 rpm

Question

The reading taken in a room from sling psychrometer gave a dry and wet bulb
temperature of 25°C and 19.7°C respectively. Using psychrometric equation and
psychrometric chart, determine:
a. specific humidity
b. relative humidity
c. dew point temperature
d. specific volume
e. enthalpy

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The relative humidity in heated homes is generally the _____in the winter season. A. highest B. lowest
During performances, a theatre experiences a sensible heat load of 500,000 Btu/hr and moisture load of 175 lb/hr. Air enters the theatre at 65°F and 55% relative humidity and is removed when it reaches 75°F or 60% relative humidity, whichever comes first. What is the ventilation rate in mass of air per hour?
Example 1: Moist air at 32C db, 24C wb. Determine: - Relative humidity RH, Dew temperature, Specific humidity .
1. 1.5 kg of air is compressed at a pressure of 7 barg(gauge pressure). The isentropic index is 1.2 and the air intake is at 1 bar, 20 degrees Celcius & Relative Humidity =65%. Determine:(i) the amount of work required to compressed the air. (ii) the temperature at the end of compression.
1. 1.5 kg of air is compressed at a pressure of 7 barg(gauge pressure). The isentropic index is 1.2 and the air intake is at 1 bar, 20 degrees Celcius & Relative Humidity =65%. Determine:(i) the amount of work required to compressed the air.
Pls. Answer this...Thank you! During an air-conditioning process, 910 ft3 /min of conditioned air at 64 F and 33 percent relative humidity is mixed adiabatically with 305 ft3 /min of outside air at 80 F and 92 percent relative humidity at a pressure of 1 atm. Determine (a) the temperature, (b) the specific humidity,(c) the relative humidity of the mixture
For each of the given initial state parameters, select the appropriate enthalpy value: Note: Tdb - dry bulb temperature, F h -enthalpy, Btu/lbair RH - relative humidity, %
During humidification process, __________ increases. (A) Wet bulb temperature (B) Relative humidity (C) Dry bulb temperature (D) Specific humidity
A horizontal move to the right on the psychrometric chart corresponds to which of the following? Select all that apply. A) A decrease in specific B) An increase in enthalpy. C) A decrease in D) A decrease in humidity ratio. E) A decrease in relative F) Which of the following equations is correct to calculate heat flow by water? A) Q = 500 * GPM * AT B) Q = 4.5 * CFM * AH C) Q = 1.1 * CFM * AT D) 8) Identify which of these equations should be used for the following load estimates:…
Last Oct. 4th, the temperature in Quezon City was 77°F, the barometric pressure was 29.8 in, and the relative humidity was 95%. Estimate the folloa) mole fraction of water in the air (4 decimal places)b) dew point (°C) (4 decimal places)c) molal humidity (4 decimal places)d) absolute humidity (4 decimal places)©) percentage humidity (4 decimal places).
At a climate station, air pressure is measured as 100 kPa, air temperature as 24°C, and the wet-bulb or dew point temperature as 19°C. Calculate the corresponding relative humidity in percent.
The Accuweather App listed for a certain data indicated a temperature of 28°C. Barometer pressure is 100 kPa and relative humidity is 75%. Determine Percent Saturation? [Psat @ 28°C = 3.782kPa]