The rear window of an automobile is defogged by passing warm air over its inner surface. If the warm air is at T∞,i=40°C and the corresponding convection coefficient is hi=30 W/m2·K, what are the inner and outer surface temperatures, in °C, of 4-mm-thick window glass, if the outside ambient air temperature is T∞,o= -27.5°C and the associated convection coefficient is ho=65 W/m2·K? Evaluate the properties of the glass at 300 K. a. what is Ts, i in °C? b. what is Ts, o in °C?

The rear window of an automobile is defogged by passing warm air over its inner surface. If the warm air is at T∞,i=40°C and the corresponding convection coefficient is hi=30 W/m2·K, what are the inner and outer surface temperatures, in °C, of 4-mm-thick window glass, if the outside ambient air temperature is T∞,o= -27.5°C and the associated convection coefficient is ho=65 W/m2·K? Evaluate the properties of the glass at 300 K. a. what is Ts, i in °C? b. what is Ts, o in °C?

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter6: Forced Convection Over Exterior Surfaces

Section: Chapter Questions

Problem 6.36P

See similar textbooks

Similar questions

An electrical transmission line of 1.2-cm diameter carries a current of 200 amps and has a resistance of 310-4 ohm per meter of length. If the air around this line is at v, determine the surface temperature on a windy day, assuming a wind blows across the line at 33 km/h.
The air-conditioning system in a Chevrolet van for use in desert climates is to be sized. The system is to maintain an interior temperature of 20C when the van travels at 100 km/h through dry air at 30C at night. If the top of the van is idealized as a flat plate 6 m long and 2 m wide and the sides as flat plates 3 m tall and 6 m long, estimate the rate at which heat must be removed from the interior to maintain the specified
Clothing made of several thin layers of fabric with trapped air in between, often called ski clothing, is commonly used in cold climates because it is light, fashionable, and a very effective thermal insulator. So it is no surprise that such clothing has largely replaced thick and heavy old-fashioned coats. Consider a jacket made of five layers of 0.1-mm-thick synthetic fabric (k = 0.13 W/m·K) with 1.5-mm-thick air space (k = 0.026 W/m·K) between the layers. Assuming the inner surface temperature of the jacket to be 28°C and the surface area to be 1.25 m2, determine the rate of heat loss through the jacket when the temperature of the outdoors is 0°C and the heat transfer coefficient at the outer surface is 25 W/m2·K. What would your response be if the jacket is made of a single layer of 0.5-mm-thick synthetic fabric? What should be the thickness of a wool fabric (k = 0.035 W/m·K) if the person is to achieve the same level of thermal comfort wearing a thick wool coat instead of a…
1. (a) Consider a room with a 1.8-m-high and 2.0-m-wide double-pane window consisting of two 4-mm-thick layers of glass separated by a 10-mm-wide stagnant air space. The convection heat transfer coefficients on the inner and outer surfaces of the window are 12 W/m2 K and 25 W/m2 K, respectively, while the average thermal conductivity of glass is 0.78 W/m K; and the air, 0.026 W/m K. If the room is maintained at 22 oC, the outside temperature is -4 oC and heat transfer due to radiation can be neglected, determine: (i) Draw the sketch and thermal resistance network; (ii) the total thermal resistance; (iii) the steady rate of heat transfer through this double-pane window; (iv) the temperature of the inner surface of the window.…
Steam at a temperature of 723 K is flowing through a pipe with an outer diameter of 100 mm. The pipe is insulated with 30-mm thick mineral wool, the average thermal conductivity of which is 0.065 W/m.K. Determine the outside surface temperature of mineral wool if the ambient air temperature is 300 Assume the hot-surface temperature of the mineral wool is the same as that of the flowing steam and the value of the surface coefficient of the insulating material is 33 W/m2.K.
A house has a composite wall of wood, fiberglass insulation, and plaster board, as indicated in the sketch. On a cold winter day the convection heat transfer coefficients are ho 60 W/m2 K and hi 30 W/m2 K. The total wall surface area is 350 m2. (a)Determine the total heat loss through the wall. (b) If the wind were blowing violently, raising ho to 300 W/m2 K, determine the percentage increase in the heat loss.
Partially-frozen ice cream is being placed in a package before completion of the freezing process. The package has dimensions of 8 cm by 10 cm by 20 cm and is placed in air- blast freezing with convective heat coefficient of 50 W/(m2 K) for freezing. The product temperature is -5°C when placed in the package, and the air temperature is -25°C. The product density is 700 kg/m3, the thermal conductivity (frozen) is 1.2 W/(m K), and the specific heat of the frozen product is 1.9 kJ/(kg K). If the latent heat to be removed during blast freezing is 100 kJ/kg, estimate the freezing time.
A long stainless-steel (AISI 316) steam pipe, with an inside diameter of 6.00 cm and an outside diameter of 8.00 cm, is covered with a layer of asbestos insulation (k = 0.150 W/m-K) 1.00 cm thick, which in turn is covered with foam insulation (k = 0.044 W/m-K) 6.00 cm thick. The inside surface temperature of the stainless-steel steam pipe is measured to be 250.0°C, while the outside surface of the foam is exposed to convection, T_inf = 25.0°C, h_inf = 15.0 W/m^2-K. • Draw and label a sketch of this system. Include dimensions, known temperatures, etc. • Draw and completely label the corresponding 1-D steady-state conduction resistor diagram. • Determine the heat transfer rate through the pipe per unit length. • Calculate the temperature at the asbestos/foam interface.
As seen in the attached figure, a 5-mm-diameter spherical ball (k = 15 W/m·K, Cp=480 J/kg·K) at 50°C is exposed to a medium at 15°C, with a combined convection and radiation heat transfer coefficient of 20 W/m2·K (to be used for option a and b) a) If the ball is covered by a 1-mm-thick plastic insulation (k = 0.13 W/m·K), determine whether the plastic insulation on the ball will help or hurt heat transfer from the ball. b) Assume that the ball is initially at uniform temperature of 50 °C. Determine how long it will take for the center of the ball to drop to 20 °C.
A spherical object with a temperature of 700 oC, made of carbon steel with a diameter of 3 cm, will be cooled to 370 oC by an air flow with a temperature of 35 oC and a heat convection coefficient of 90 W/m2K. Calculate the time (s) required to cool the body, ignoring the temperature gradient inside the body and making any other assumptions you deem necessary. The heat transmission coefficient of carbon steel can be 45 W/mK, its density is 7800 kg/m3 and its specific heat is 480 J/kgK.
A glass window of width W = 1 m and height H = 2 m is 5 mm thick and has a thermal conductivity of kg =1.4 W/m.K. If the inner and outer surface temperatures of the glass are 15 oC and -20 oC, respectively, on a cold winter day, what is the rate of heat loss through the glass? To reduce heat loss through windows, it is customary to use a double pane construction in which adjoining panes are separated by an air space. If the spacing is 10 mm and the glass surfaces in contact with the air have temperatures of 9oC and -15 oC, what is the rate of heat loss from a 1 m x 2 m window? The thermal conductivity of air is ka = 0.024 W/m.K.
Question 1: A glass window of width W = 1 m and height H = 2 m is 5 mm thick and has a thermal conductivity of kg =1.4 W/m.K. If the inner and outer surface temperatures of the glass are 15 oC and -20 oC, respectively, on a cold winter day, what is the rate of heat loss through the glass? To reduce heat loss through windows, it is customary to use a double pane construction in which adjoining panes are separated by an air space. If the spacing is 10 mm and the glass surfaces in contact with the air have temperatures of 20 oC and -15 oC, what is the rate of heat loss from a 1 m x 2 m window? The thermal conductivity of air is ka = 0.024 W/m.K.