Answered: The resistance is proportional to…

The resistance is proportional to length and inversely proportional to of the material given. O type of material used cross sectional area voltage resistivity

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: The length and diameter of a copper wire are found to be 100 and 0.002 m, respectively. Consider…

A: In this question , we have to find out resistnace of copper wire..Given length, diameter and…

Q: Answer the two following questions: A. Compute the resistivity of the given material whose…

Q: .A copper wire of unknown length has a diameter of 0.25 in. and a resistance of 0.28 ohm. By several…

A: This question belongs to basic electrical . It is based on the concept of formula of resistance .…

Q: A wire with length of 2000 meters have a diameter of 0.041 cm has a resistance of 3.5 ohms is drawn…

A: Here, we have given a wire with a length of 2000 meters. And the diameter and the resistance of the…

Q: 1. A l-m length of wire is found to have a resistance of 25 ohms. If the diameter of the wire is I…

A: As per the guidelines, we supposed to answer one question at a time so please ask other questions…

Q: Qʻ: Fill in the following blanks with suitable words : 1. Conductivity of a material depends on: and…

Q: A 1000 ft length copper wire has a resistance of 0.628 ohm at 20∘ C. Determine the resistance of the…

A: The volume of the wire remains constant even if it is stretched to on third of its cross section.…

Q: 1. Give what is ask A. The resistance of the wire increases from 40 Q at 10°C to 48.25 Q at 60°C.…

A: According to the given question, it is required ti determine the answer of the below given…

Q: A metallic wire is stretched from original length of 2 m to 5 m. If the original cross-sectional…

A: To determine the new resistance value of the metallic wire

Q: 3. What is the resistance of a piece of material whose length is 2 cm, area is 4 cm² and resistivity…

A: Given a piece of material with, Length, l = 2 cm Area, A = 4 cm2 Resistivity, ρ=60×10-5 Ω-m

Q: Using Ohm’s Law, what is the relationship of current, voltage, and resistance ? Explain and use…

Q: 1- In your own words, describe the classification of materials according to conductivity, with…

A: Note : According to the company guidelines we can answer first question. Here they are interested…

Q: Determine the resistance of a copper wire that has a cross-sectional area as 8.4 mm2. The length and…

A: Resistance of the wire R? Cross sectional area A= 8.4 mm2 Wire length l= 78.6m Resistivity =…

Q: What is electroplating? Discuss how impressed current can prevent the corrosion of metals

Q: A 1m length of wire is found to have a resistance of 25Ω. If the diameter of the wire is 1mm,…

A: From the relation of the resistance, resistivity length and area we can calculate the value of…

Q: A. What is the area in circular mills of an aluminum conductor that is 80 ft long with a resistance…

A: Given values are =

Q: The length and diameter of a copper wire are found to be 100 and 0.002 m, respectively, Consider…

Q: Find the conductance of a 500 ft long #12AWG wire made up of copper

A: Given data: Length of the wire l=500 ft The material of the wire: Copper The wire is of type #12…

Q: Problem 5. Calculate the cross-sectional area, in mm², of a piece of copper wire, 40 m in length and…

A: Given: A piece of copper wire having resistance, R=0.25 Ω Length, l = 40 m Resistivity, ρ=0.02×10-6…

Q: A wire of length L and of circular cross section of radius r has a resistance of R ohms. Another…

Q: A metallic wire is stretched from original length of 2 m to 5 m. If the original cross-sectional…

Q: A wire 50 m in length and 2 mm? in cross section has a resistance of 0.56 2. A 100-m length of wire…

Q: Find out which of the following statements is/are ALWAYS TRUE for the resistivity and conductivity…

A: To find correct statements

Q: A copper wire of unknown length has a diameter of 0.31 inch and a resistance of 0.38 ohms. By…

A: Volume of the wire will remain unchanged after stretching. Let L1 meter be the initial length of the…

Q: Determine the resistance of a bus bar of copper if the length is 75 feet long and the diameter is…

A: In this question, Determine the resistance of a bus bar of copper if the length is 75 feet long and…

Q: A copper wire has a length of 3500 ft and having an area of 144 cm squared. Find the resistance of…

Q: A brass wire, that has a cross sectional area of 0. 12m² and its resistance is 80µ ohms. Find the…

Q: The resistance is proportional to length and inversely proportional to material given. of the O…

A: Considering the formula for resistance of wire, R=ρLA Where, R is resistance, ρ is the resistivity…

Q: A metallic wire is stretched from original length of 1 m to 5 m. If the original cross-sectional…

Q: A wire with a length of 200 meters has a diameter of 0.052 cm is drawn so that its new diameter is…

A: Given:d1=0.052 cmd2=0.041 cmConductivity of the wire is 1.724 µΩ-cm at 20oCl1=200 m…

Q: The resistivity of a material depend on its length and its cross section area.? True False

A: Given statement: The resistivity of a material depend on its length and its cross section area.

Q: The length and diameter of a copper wire are found to be 100 and 0.002 m, respectively. Consider…

A: Given: l=100 m d=0.002 m resistivity=1.72 x 10^-4 ohm -m Formula used: ζ=π.D.D.R4.l

Q: Assuming constant temperature, what happens to the resistance of a material when the cross-sectional…

A: Cross sectional area- The cross sectional area is the area of a circle. Thus the cross section of…

Q: Which of the following materials are used in PV cells ? a. Paper b. None of these c. Semiconductors…

A: PV cell is used to convert solar energy into electricity.

Q: how much length must be cut off from the wire in order to reduce its resistance to 12.5 ohms.

A: Given, Resistance of a wire is 17.5 ohm, if its length is 560 m. Let, to reduce the resistance of…

Q: DETERMINE THE RESISTANCE OF 600 FT LENGTH OF #10 AWG COPPER WIRE

A: Given, Length of copper wire, l=600 ft=600×304.8 mm=182880 mm For 10 AWG, diameter d=2.59 mm

Q: The resistance of a long piece of copper wire is 48 2 at 20°C. a. What would the resistance be at…

A: Given: Resistance of a long copper wire = 48Ω at 200C To do: a) we have to determine the resistance…

Q: Q3: Is it preferable to have an insulating material with a high tand or a low tand use in :(1) Low…

A: As the loss tangent increases, the system's power factor will increase and losses in the system will…

Q: A wire of length L and of circular cross section of radius r has a resistance of R ohms. Another…

A: Given, For first wire Length l1=L Circular cross-section radius r1=r Resistance, R1=R For second…

Q: A coil of copper wire has a resistance of 62 ohms at room temperature of 24°C, (a) what will be its…

A: The solution can be achieved as follows.

Q: The length and diameter of a copper wire are found to be 100 and 0.002 m, respectively. Consider…

Q: What is ohm's law and what its connection to between voltage, current, and resistance?

Q: 3. Calculate the cross-sectional area, in mm^2, of a piece of copper wire, 40 m length and having a…

Q: Using the idea of energy bands in solid materials, explain the characteristics of the following…

A: The useful way to see the difference between Conductor, Insulator and Semiconductor is to plot the…

Q: A wire of 59 in length and 4 mm2 has a resistance of 0.94 ohms. A 110-m length of wire of the same…

Q: A 1-m length of wire is found to have a resistance of 25 ohms. If the diameter of the wire is 1 mm,…

Q: Determine the resistance of a bus bar made of aluminum at 50°C if the length is 15 meters long and…

A: to determine the resistance of a bus bar made of aluminum at 50°C if the length is 15 meters long…

Concept explainers

HVDC

HVDC stands for high voltage direct current in the electric power transmission system. The high voltage direct current system uses direct current (DC) for the transmission of electrical power through transmission lines in contrast with the alternating current that is the AC system. The HVDC is used to transmit bulk power point-to-point through long distances transmission lines. Power is rapidly transferred because the efficiency of transmission lines is greatly increased over long distances due to HVDC lines.

Question

The resistance is proportional to length and
inversely proportional to
of
the material given.
O type of material used
O cross sectional area
voltage
resistivity

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1 Analyzing the question

VIEW

Step 2 Answer of the question

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Compute for the resistance of (i) silver, (ii) copper, and (iii) aluminum wire using these Equations in the given. For the three wires, the length is 2 meters, the diameter is 1 millimeter, and the temperature is at 27◦C.
Design a 1500-meter-long electrical transmission line with a cross-section size of 0.00199 cm2 that can carry a 50-amp current with a power loss of no more than 5 x105 W. Table 1 shows the electrical conductivity of a variety of materials. What kind of material could be a good candidate?
An electric wire having a mass of 0.5 kg/m along the horizontal is suspended between supports of the same elevation which is 50m apart. If the maximum tension in the wire is 800N, find a. the minimum tension b. the sag c. the length cable
The number n of free electrons per m3 in the current carrying cable is iBL/VHeA. (A is the crosssectional area of it.) Where n is obtained from? a. The current density J’s expression b. Ohm’s Law c. The resistivity’s expression E/J d. Faraday’s Law.
A copper wire at 20 degrees C, and 164 cmil, has a K value of 10.4 ohms per mi-foot. If the distance to the load is 600 feet (183 m) calculate the resistance of the loop.
In a design task, a wire of 2000 m requires to exhibit a voltage drop of 2.5 Vwhen 3.2 A of current passes though it. Based on the Table Q1 (b) below, inyour opinion, which of the wire is the most suitable for aviation when the fuelsaving is another factor to be considered as well.
Find total charge enclosed in a cube of volume 10(m3) located at (5,4,6) is- Equation of D is given.
Determine the resistance of a bus bar made of aluminum at 50°C if the length is 15 meters long and cross section is 9cm2 Note: DRAW THE DIAGRAM
Determine the resistance of a bus bar made of aluminum at 50°C if the length is 15 meters long and cross section is 9cm2
Based on the definition of ∆V and current density J⃗ = σE⃗ , discuss the consequence of having a pinched wire running current to some device like the light in the last problem. (By pinched, expect that the cross section is decreased at one spot.)
Compute the resistivity of the given material whose resistance is 2 Ω; area of cross-section and length are 25cm2 and 15 cm respectively?
Find the total current flowing (in ampere) in a cylindrical conductor (solid wire) 1 meter long and a diameter of 1mm. Given also that its charge density (De) is 1029 carriers/m3 and its carrier velocity (u) is 19.9x10-6 m/s.