The resistance of tunsgten filament at 1750c° is 4ohm. Find the resistance of the filament at 20c°[take the temperature coefficient of resistance of tunsgten as 6×10^-3k^-1]

Q: An alternator has been dismantled and the rotor slip rings are blackened with carbon deposits. Techn...

A: The brush are used to make a contact between the rotor conductor and the external circuit. Brush res...

Q: 4 Using Loop Method, find the currents at R1, R4, and R5. (Non-anonymous questionO) * (20 Points) R,...

A:

Q: An impedance coil is connected in series with a fixed resistor, and a 120-V, 50-cycle Source is then...

A:

Q: Qu/Determinathe response of the Sys given-as whosa isp Kin)and honlae follows; else where -2 Sn S2 e...

A:

Q: Q1/ A piece of resistance wire, 15.6 m long and of cross-sectional area 12 mm at temperature of 0°C,...

A: Given  A piece of wire,Length l=15.6 mArea a=12 mm2Current I=7.9 ADC supply V=240 vThe temperture ri...

Q: 6) State the three types of instruments. 7) State the three-classified instrument based on their fun...

A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: 2l Find the inVerse trans formf (Fs) Fess=( 55+4 25-18

A: Given F(s)=(5s+4s3-2s-18s2+9)

Q: Find the value of the following Wilkinson's Factor: 8.

A: Brief description : In the above given question they want to know the value of Wilkinson's Factor. H...

Q: Q3/ Using nodal analysis, find the branch currents in circuit below. V3 12 8. A B R1 R3 R5 10 +. V1 ...

A: By Nodal Analysis,KCL at node A,VA-1212+VA6+VA+10-VB4=0⇒0.5VA-0.25VB=-1.5 ....... 1By KCL at node B,...

Q: Determine the color codes required if you need the following resistors for a project: a. 1.2 kΩ ± 20...

A:

Q: Four charges form an isosceles trapezoid: Q1 = +2C is located at vertex X; Q2 = -3C is located at ve...

A: I am attaching detailed solution image of this question.

Q: 3. 15SL /82 252 gov E 25V Solve for the branch currents and show the actual current directions.

A: Solve the first question, unless the student has asked for a specific question to be solved, subject...

Q: 4) What is the function of measurement system?

A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: A battery has an open circuit voltage of 12V. When it is connected across two 80 ohm bulbs connected...

A: GivenBattery open circuit voltage=12vcurrent=290 mA

Q: In an Amplitude Modulator, the carrier is ve = 10 sin[2n (1 x 10°t)l, the frequency spectrum of the ...

A:

Q: An LTI system can be described by the equation (D² + 6D+5)y(t) =(D+1)x(t). (a) Find the characterist...

A: Here we have given the LTI system(D2+6D+5)y(t)=(D+1)x(t)(a). the characteristics equation of the sys...

Q: Please provide a Karnaugh map for image shown. Groupings must be clearly shown.

A: Brief description: The given Boolean variables in the question bare P,D & W. Quadrants will redu...

Q: The transition matrix of a channel is given by: p(Y/X) = 10.1 0.3 l0.2 0.25 0.55 0.6 If p(x,) = 0.4,...

A: Given: The transition matrix of a channel is: pYX=0.10.30.60.20.250.55 if px1=0.4 To find: a) noise ...

Q: A 3-phase, delta-connected alternator supplies a wye connected load, each phase of which has a resis...

A: I am attaching detailed solution image of this question.

Q: Branch circuits in a house wiring system in Figure 2 are parallel circuits. A toaster, a coffee make...

A:

Q: a 3.2 52 b 502 1002 Wr 3.23 20 d e W- 252 7503 - f

A:

Q: JFET, the VGS is -2.3V at ID equal to a quarter of IDSS. Determine the value of VGSoff in V.

A:

Q: VR(S) 1: Please create transfer function, , of the RLC network V(s)

A: The transfer function can be obtained by converting the circuit into S-domain and by using the volta...

Q: A 100-mH inductor is connected in parallel ta

A:

Q: The following system of equations was generated by applying the mesh current law to the circuit in t...

A:

Q: Find the two elements in a series circuit (i.e., R and L, or R and C, or L and C), given that 1(t) 2...

A: We need to find out circuit elements for given current and voltage

Q: Design at a logic circuit that will output excess 2 of its input from 0-10

A:

Q: When an impedance coil is connected to a 100 V, 60-Hz, ac supply, the circuit current is 1.325 A. Wh...

A:

Q: An impedance coil is connected in series with a capacitor across a 220 V, 60 Hz ac supply. The circu...

A: In this question,  Determine the apparent power?  We know apparent S= VI*   I* is conjugate of the c...

Q: 3 When an impedance coil is connected to a 100 V, 60-Hz, ac supply, the circuit current 1.325 A. Whe...

A:

Q: Alfredo deDarke sleeps with a 7.5-Watt night light bulb on. He turns it on before getting in bed and...

A:

Q: Find the equivalent inductive reactance if the frequency is 65 Hz

A: This question belongs to circuit theory . It is about calculation of equivalent inductive reactance ...

Q: A load is supplied the complex power S = 60 + j80 VA by a voltage source of 50 cos 377t V. Find the ...

A:

Q: Sensor Circuit Light Source Control Alarm Photodiode Circuit Circuit 9. Which may not be used as an ...

A: Given, Alarm circuit is  LED source ---> Photo Diode ----> Control Circuit ----> Alarm circ...

Q: Find the two elements in a series circuit (i.e., R and L, or R and C, or L and C), given that ste) =...

A:

Q: Given the following circuit: FIAB.C.D C- D

A: The circuit diagram is shown below,

Q: Solve for the total impedance of a three-branch parallel circuit with the following data: Branch 1:...

A: Given:3 branch parallel circuit.Branch 1: 50Ω resistor in series with a 20µF capacitor  Branch 2: 30...

Q: 15. At which cycle will the 16. At what exact value of voltage waveform be cut from the diagram will...

A: I am attaching detailed solution images of this question.

Q: Determine the currents 1, 12, and ID2 for the network. RI 3.3k2 Si Di 20 V Si D2 12 R2 5.6 ka

A:

Q: Figure P13.16 25 2 be 1= 0 80 N 100 0 a 80 µF +. 275 V 100 V 240 N vo 16 mH

A:

Q: 100 V Ideal diodes 2.2 k2 -100 V

A:

Q: 20 j 62 HE -j20 j20 10 I -j20 j42 24 Vac -j20 all HE

A: This is a complex network as it has both capacitors and inductor with it Note that the voltages at s...

Q: What is the value of v in volts before t = 0? What is the value of i in amperes before t = 0? What i...

A:

Q: An impedance coil is connected in series with a fixed resistor, and a 120-V, 50-cycle Source is then...

A: The solution is given below 

Q: Find the two elements in a series circuit (i.e., R and L, or R and C, or L and C), given that = 2/2 ...

A:

Q: Find the transfer function of the given circuit. RESISTANCE R INDUCTANCE CAPACITANCE i(t)

A:

Q: For the circuit below, find the current I. j62 ll He -j22 j20 10 -j22 j42 24 Vac -j20 ll HE

A:

Q: ed is a silicon diode, determine the currents ID1, ID2 and current rough R2. Finalize answers as fol...

A:

Q: A three stage amplifier is to have an overall noise temperature no greater than 70 K. The overall ga...

A: For a three-stage amplifier - TT=70KAT=45dBFor stage 2,A2=20dBNF2=3dBFor stage 3,A3=15dBNF3=6dB

Q: Assume diodes are ideal.  Determine the label current and voltage

A: This question belongs to analog electronics . It is based on the concept of diode analysis in the ci...

Types of Thyristors

With four layers of alternating P- and N- materials, a thyristor is a solid-state semiconductor device. It acts as a type of bi-stable switch and it conducts when the gate receives a current trigger and continues to conduct until the voltage is reverse biased across the device or by some means until the voltage is removed. The silicon-controlled rectifier is considered synonymous with thyristors by some sources. Thyristors are defined as more complex by other sources as it contains at least four-layer of alternating N-type and P-type substrate. They find large applications in the control of electrical power supplies, electric motor speed control, and ranging of light dimmers because thyristors can control large amounts of power supplies and voltage with a small device. The circuit symbol of the thyristor is given below.