The scale of the photograph is 10cm = 100m. The photograph size is 23 cm x 23 cm determine the number of photographs required to cover an area of 15km x 10 km, if the longitudinal overlap is (Your Registration Number) % and side overlap is (Your Registration Number x-) %.

The scale of the photograph is 10cm = 100m. The photograph size is 23 cm x 23 cm determine the number of photographs required to cover an area of 15km x 10 km, if the longitudinal overlap is (Your Registration Number) % and side overlap is (Your Registration Number x-) %.

Traffic and Highway Engineering

5th Edition

ISBN:9781305156241

Author:Garber, Nicholas J.

Publisher:Garber, Nicholas J.

Chapter14: Highway Surveys And Location

Section: Chapter Questions

Problem 10P

See similar textbooks

Related questions

Q: 1. Compute Heights of Instrument and Elevations. 2. Check the accuracy of the arithmetical…

A: Take Elevation of BMa = 100 HI of any station = Elevation of that station + B.S HI of BMa = 100 +…

Q: The accompanying table below shows the observed data of a traverse in which the lengths of the two…

A: Given:- Course Length (m) Azimuth AB l1 57o55' BC 373.06 320o00' CD 952.75 256o46' DE…

Q: Choose the right answer for the following:

A: option a.) grazing is incorrect because grazing angle is less than the incident angle option b.)…

Q: An aerial photograph is taken from a flight at a height of 3.5 km above mean sea level, using a…

A: Given data- Flight height H=3.5 km=3500 mfocal length f=152 mm=0.152 maverage elevation havg=460 mTo…

Q: A camera with a focal length of 20 cm fitted in an aircraft is used for taking vertical aerial…

A: Given data: Focal length, f = 20 cm Average elevation of terrain, h = 1200 m Scale, S = 1:8000…

Q: Find the length of a road if the ground coordinates at its beginning are ( 1000m, 2000m) and the…

A: Scale S=fH-hWhere S=Scale=Photo CoordinatesActual Coordinates at Groundf=Focal Length=140mmH=Flying…

Q: The elevation of points O and a is 267ft, that of point is B and C is 52 4ft and that of D is 820ft…

A: The scale is defined as the ratio of the distance on the map to the distance on the ground. Scale…

Q: A distance ab on a vertical photograph is 65.0 mm, and the corresponding ground distance AB is 1153…

A: Given data, Photo distance = 65 mm Ground distance = 1153 m Camera focal length = 153.19 mm Flying…

Q: of measuring horizontal angles about a 2. The process point is termed a) transiting b) indexing c)…

A: Process of measuring horizontal angle about a point is termed?

Q: Object snap tracking works in combination with object snaps to enable you to temporarily acquire and…

A: The precise location of the object can be traced with help of object snaps. The vertical and…

Q: An upright aerial photograph is taken using a camera focal length of 150.7 mm, where there are 2…

Q: An average photo scale of 1:15000 is required of vertical photos. a) What airbase is required in…

A: we have formula:end lap:R=G-BG×100G=ground distanceB=Air baseR=end lap=65%so,

Q: B- What the deference between particle imaging velocimetry and laser doppler velocimetry with…

Q: A vertical aerial photograph was taken from a flying height of 3200 meters above datum with a camera…

Q: An area of 150 km × 110 km is to be surveyed using photogrammetry. From the data given below,…

Q: Two inaccessible` objects A and B are each viewed from two transit stations C and D, on one side of…

Q: To run a straight line between two points, when both ends are inter visible. We establish…

Q: K 258°34'22" 364.55 ft 60°21'26" 292.94 ft M 309°05'38" ---- 347.00 ft 128°04'44" ------- - - 472.74…

A: We can adjust the Lattitude and departures of a Traverse by 2 methods. 1) Compass rule. 2) Transit…

Q: A vertical photograph was taken at an altitude of 1500 m above mean sea level. If the focal length…

Q: An offset is 15 m long and the scale of plotting is 1 cm 30 m. If the accuracy in linear measurement…

A: Solution:- We know that limiting error is:

Q: 03: the straight length of a track measured to be 2.5 mm and you know that the real ground distance…

A: To find the scale of photo-

Q: On AutoCAD, what are the two important data to be input or specify in creating a circle?

A: Answer : Two Important data for creating a circle are Center of circle and radius.

Q: TY There are two types of scales in aerial photographs, mention and explain them briefly the…

Q: A photogrammetric survey uses photographs taken with specially designed cameras from where? O a.…

A: There are different type of surveying based of instrument, area to be considered etc.…

Q: Using Transit Rule, adjust the traverse. (solution and tables for corrected latitude and departure…

A: A closed traverse ABCDE is given with its all values of latitude and departure. It has been asked in…

Q: A line AB on the photograph measures 10.24 cm for which focal length was 15 cm, the corresponding…

Q: The elevation of points L is 260ft, that of point is k is 300ft and point M is 800ft, that of point…

Q: A camera with a focal length of 20 cm fitted in an aircraft is used for taking vertical aerial…

A: Given Data: Scale S = 1:8000 Focal length of the camera = 20 cm. The average elevation of the…

Q: A camera equipped with a 152 mm focal length lens is used to take a vertical photograph from a…

A: Given data- focal length f==152 mmFlying height H=2789 melevation h=500 mTo Find-The scale of the…

Q: In GPS, "Multipath" is: A. The collective term for the routes taken by the rovers used in RTK…

A: Multipath is propagation phenomenon in which radio signals reaches the receiving antenna by more…

Q: The scale of a photograph of size 30 cm x 30 cm is 1 cm = 125 m. How many photographs will be…

A: Given, Scale =1cm:125m Area = 337.5km²

Q: a) Using the given set of balanced latitudes and departures, calculate the areas of the traverses…

A: To Determine Using the given set of balanced latitudes and departures, a) calculate the areas of the…

Q: The scale of the photograph is 10cm = 100m. The photograph size is 23cmx23cm determine the number of…

A: Given: The scale of the photograph is 10 cm = 100 m. The photograph size is 23 cm x 23 cm. The…

Q: A computational method used to calculate the enclosed area in a loop traverse when the coordinates…

A: A computational method used to calculate the enclosed area in a loop traverse when the coordinates…

Q: A near-vertical aerial photograph taken with a 152.916-mm-focal-length camera contains images of…

A: A curve, without sharp turns, is a continuous and smooth line. The radius of curvature of the normal…

Q: Work out included angles from following data Sr. No. Line F.B. AB 40° BC 120° CD 240° 60 DA 340°…

Q: Which method should a topographer use to measure distance using the method in the image ? A B k k C…

A: Brief concept- The distance can be measured by different methods of surveying. One method is shown…

Q: Q3) Suppose that highest terrain h1 average terrain havg' and lowest terrain h2 are 610, 460, and…

Q: Triangulation Stations A, B, C, and D have the following observation angles. Angle Values ACB 50°…

Q: Plane surveying is that type of surveying in which the earth is considered to be a flat surface.…

A: In plane survey curvature of the earth is not considered.Plane survey is done for area less than 250…

Q: 1. The interior angles X, Y, and Z of a triangular traverse were measured with the same precision.…

A: Given, Interior angle at station, X = 41o and number of measurements = 3Interior angle at station, Y…

Q: c) A camera with focal length 152mm was used to take photos in 3 locations of the county. At…

A: Given, focal length of the camera=f=152 mm At location A, Flying height= H= 2280 m At location B,…

Q: INSTRUCTIONS: Given in the accompanying tabulation are the observed data for a closed traverse…

A: Sign convention: N-E : Both positive S-E: Latitude negative and Departure positive N-W: Departure…

Q: C) A 20-mile strip of terrain is to be photographed for highway mapping. The aerial camera to be…

A: Given values: Length of terrain, L = 20 mile =105600 ft Focal length of camera, f= 12 in Photograph…

Q: Two points A and B located along the perimeter of a circular track has a distance of 20 m measured…

A: Using formula for arc length

Q: Reconnaissance survey is carried out with the help of Topography Maps Photographs Aerial…

A: The objective of the Reconnaissance survey is to get a brief survey of the area that has to be…

Q: Relative precision of traverse is A absolute value of the difference between total distance and…

A: Relative precision of traverse is Option (D) ratio of linear error of closure to the perimeter of…

Q: A vertical photo was obtained by using an aerial camera with a 200mm focal length. From an altitude…

A: Using formula to find scale of photograph

Concept explainers

Unit Conversion

Standard units are also called SI units. SI units are used for measuring a physical quantity satisfying certain conditions. There are two types of units: fundamental units and derived units. Fundamental units are physical quantities that are independent, that is, they do not depend on other quantities like mass, length, or time. There are plenty of quantities in our lives which need to be measured and compared. Measuring is the comparison of a particular physical quantity with its reference value. A unit is a measure of a fixed physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.

Question

hello

put 58 in registration number

The scale of the photograph is 10cm = 100m. The photograph size is 23 cm x 23 cm
determine the number of photographs required to cover an area of 15km x 10 km, if
the longitudinal overlap is (Your Registration Number) % and side overlap is (Your
Registration Number x-) %.
O No 0? (10 Marks)
C2-PLO 1

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Reg.no : 5395 Use the following given information; Photographic scale is 1 in=(Last three digits of your registration number with two 00 (e.g 19PWCIV5203 , 20300)) ft, lens focal length=6.022 in, elevation of mean datum=520ft, calculate the flying height and altitude in an aerial survey.
The scale of the photograph is 10cm = 100m. The photograph size is 23cmx23cm determine the number of photographs required to cover an area of 15kmx10 km, if the longitudinal overlap is 60% and side overlap is 720%.
The elevation of points L is 260ft, that of point is k is 300ft and point M is 800ft, that of point is N is 520ft the flying height above sea level is 1769ft and the focal length of the camera is 8.23 inch determine the scale of the photograph along the line ao along the be and at point d, expressing each scale as a number of feetcorres ponding to 1 inch,
Given the following data from a balanced traverse, find the area of the traverse by DMD method. LINE ADJ. DEP. ADJ. LAT 1-2 +3.14 -18.55 2-3 -55.05 +9.45 3-4 -3.53 +19.51 4-1 +55.44 -10.41
Determine the horizontal distance between two points A and B whose elevations above datum are hA = 1840 ft and hB = 1425 ft and whose images a and b on a vertical photograph have photo coordinates xa = 2.95 in., ya = 2.32 in., xb = -1.64 in., and yb = -2.66 in. The camera focal length was 152.4 mm and the flying height above datum 7900 ft . Express your answer in feet to four significant figures.
SURVEYING Discrepancy formula: |length1-length2|
c=4 x=254 y=25 DO NOT ROUND OFF
An upright aerial photograph is taken using a camera focal length of 150.7 mm, where there are 2 points, namely a and b, whose photo coordinates have been calculated with the results as in the following.Xa = 18.4 mm ; Yes = -61.4 mmXb = 110.1 mm ; Yb = -21.2 mmFurthermore, the height of the two points is calculated in the field, namely point A (437.5 m) and point B (444.9 m). If the distance between points A and B is 585.1 meters, what is the flying height of the plane when shooting?
Subject: GE135 - Fundamentals of Surveying and Mapping
Please answer the problem attached image. Thank you very much. Use NSCP 2015. Hint: the answer Pr = 530 kNPc = 717.96 kNMrx (w/ amplification factor) = 20 kNmMry (w/ amplification factor) = 5.05 kNmMcx = 117.72 kNmMcy = 49.85 kNmInteraction Value = 0.98 < 1.0 safe - adequate section
1. Compute Heights of Instrument and Elevations. 2. Check the accuracy of the arithmetical computations, add all backsights as well as all the foresights. The difference between these two sums must be equal to the difference in elevation between BM1 and BM2.Please refer to image and data provided.
vertical aerial photo is exposed at 3910 ft above mean sea level using a camera having an 88.9 mm focal length. A triangular parcel of land that lies at elevation 850 ft above sea level appears on the photo, and its sides measure 39.5 mm, 28.9 mm, and 27.7 mm, respectively. What is the approximately area of this parcel in acres? 3. On a vertical photograph, image a and b of ground points A and B have photographic coordinates X = -12.68 mm, Ya = 70.24 mm, Xo = 89.07 mm, and yo = 92.41 mm. The horizontal distance between A and B is 1317 m, and the elevation of A and B are 382 m and 431 m above datum, respectively. Calculate the flying height above datum if the camera had a 152.5 mm focal length?