The sinusoidal voltage source in the circuit seen in(Figure 1) is operating at a frequency of 46 krad/s. Thecoefficient of coupling is adjusted until the peak amplitudeof 1 is maximum.Figure2002100 Q5 mH37502 300 £2ww20 mH1 of 140 nFPart AWhat is the value of k?Express your answer using three significant figures.k = .085SubmitPart BVAΣ vecX Incorrect; Try Again; 28 attempts remainingi₁ =SubmitPrevious Answers Request AnswerWhat is the peak amplitude of 1 if Ug = 399 cos(4.6 x 10¹) V?Express your answer to three significant figures and include the appropriate units.Provide FeedbackμAValueRequest AnswerUnits??

supply voltage Vg(t) =399 cos(4.6×104t) V to find the value of K at maximum peal amperes of i1…

The sinusoidal voltage source in the circuit seen in (Figure 1) is operating at a frequency of 46 krad/s. The coefficient of coupling is adjusted until the peak amplitude of ₁ is maximum. Figure 2002 100 Ω 5 mH3 75 Ω 300 £2 mm 320 mH 1 of 1 40 nF Part A What is the value of k? Express your answer using three significant figures. k= .085 Submit Previous Answers Request Answer X Incorrect; Try Again; 28 attempts remaining Part B Avec i₁ = What is the peak amplitude of 21 if Ug = 399 cos(4.6 x 10¹) V? Express your answer to three significant figures and include the appropriate units. Submit Provide Feedback μÀ Value Request Answer Units ? ?

The sinusoidal voltage source in the circuit seen in (Figure 1) is operating at a frequency of 46 krad/s. The coefficient of coupling is adjusted until the peak amplitude of ₁ is maximum. Figure 2002 100 Ω 5 mH3 75 Ω 300 £2 mm 320 mH 1 of 1 40 nF Part A What is the value of k? Express your answer using three significant figures. k= .085 Submit Previous Answers Request Answer X Incorrect; Try Again; 28 attempts remaining Part B Avec i₁ = What is the peak amplitude of 21 if Ug = 399 cos(4.6 x 10¹) V? Express your answer to three significant figures and include the appropriate units. Submit Provide Feedback μÀ Value Request Answer Units ? ?

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.7P: Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor,...

See similar textbooks

Similar questions

An industrial load consisting of a bank of induction motors consumes 50 kW at a power factor of 0.8 lagging from a 220-V,60-Hz, single-phase source. By placing a bank of capacitors in parallel with the load, the resultant power factor is to be raised to 0.95 lagging. Find the net capacitance of the capacitor bank in F that is required.
Convert the following instantaneous currents to phasors, using cos(t) as the reference. Give your answers in both rectangular and polar form. (a) i(t)=5002cos(t30) (b) i(t)=4sin(t+30) (c) i(t)=5cos(t15)+42sin(t+30)
The rms value of v(t)=Vmaxcos(t+) is given by a. Vmax b. Vmax/2 c. 2Vmax d. 2Vmax
A coil with an iron core absorbs a current of 0.5 A when a sinusoidal voltage of 220 V rms is applied to its terminals. If the power absorbed was 30 W, deduce the equivalent circuit of the coil. Ans: RFe = 1,617.64 Ω and Xμ = 457.38 Ω. (I need the procedure)
Two alternating voltages are given by v1 = 15sinωt volts and v2 = 25 sin (ωt – π/6) volts. Plot both functions on the same axes and hence determine a sinusoidal expression for the resultant vr = v1 + v2. Check your answer using an analytical method. Your manager has asked you to analyse the variation in in results between the two methods
Read A 70-Vac source has the following waveform. Determine:a. Vpkb. Vpk-pkc. Vrmsd. Periode. Frequencyf. Angular Velocityg. Phase Angleh. equation of the waveform (in time domain)i. the instantaneous voltage when t = 120 msj. the angle (1st occurrence) after t = 0 when the voltage is +80 Vk. the time (2nd occurrence) after t = 0 when the voltage is –10 VAnswers:a. 98.9949 Vb. 197.9899 Vc. 70 Vd. 100 mse. 10 Hzf. 20π rad/secg. 125.0876°h. v(t) = 98.9949sin(20πt + 125.0876°)i. -29.0880 Vj. 0.99959°k. 63.643 ms Give the solution for J and K ONLY ans (0.99959 degrees and 63.643 ms respectively)
Determine the rms values of each of the following (a) v(t) = 100 sin(ωt) V Vrms = 70.7V (b) i(t) = 8 sin(377t) A Irms = 5.656V(c) v(t) = 40 sin(ωt + 40o) V Vrms = 28.28V (d) i(t) = 120 cos(ωt) mA Irms = 84.84A Can you check if my answer is correct?
Assume you are working on sinusoidal ac supply voltage which is in the form of 150 sin 220 t. So apply this voltage find out following parameters. Analyze the average value of voltage. Options: A)89.85volt B)90.75volt C)86.45volt D)95.55volt
1 RMS value of sinusoidal voltage is given by Vrms= 5 V, Calculate the value of peak voltage Vm? a. 7.07 V b. 5 V c. 1.4142 V d. 3.535 V
The sinusoidal voltage source in the circuit seen in (Figure 1) is operating at a frequency of 54 krad/skrad/s. The coefficient of coupling is adjusted until the peak amplitude of i1 is maximum. What is the peak amplitude of i1 if vg=429cos(5.4×104t)V?
The average value of a sinusoidal current is 300A. What is it’s rms value? Group of answer choices 444 A 202 A 333 A 101A
The equation of alternating voltage isgiven by ν = 325.22 ???314?.Find (i) RMS value (ii) Frequency (iii)Average value.