The smooth particle has a mass of 90 g. It is attached to an elastic cord extending from O to P and due to the slotted arm guide moves along the horizontal circular path r= (0.4sine) m. If the cord has a stiffness k= 40 N/m and an unstretched length of 0.25 m. If the guide has a constant angular velocity e = 5 rad/s take ( a, = - 16.32m /s², a, = 10 m/s²). The normal force of the guide on the particle when 0 = 60°, is :-

The smooth particle has a mass of 90 g. It is attached to an elastic cord extending from O to P and due to the slotted arm guide moves along the horizontal circular path r= (0.4sine) m. If the cord has a stiffness k= 40 N/m and an unstretched length of 0.25 m. If the guide has a constant angular velocity e = 5 rad/s take ( a, = - 16.32m /s², a, = 10 m/s²). The normal force of the guide on the particle when 0 = 60°, is :-

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Determine the product of inertia for the cross-sectional area of themember shown, about the x and y centroidal axes.
The 100-kg disk rests on a surface for which μB = 0.2.Determine the smallest vertical force P that can be applied tangentially to the disk which will cause motion to impend.
Bar AB of figure has a uniform cross section, a mass of 25 kg, and a length of 1 m. Determine the angle ? for equilibrium.
A jet having a diameter of 60 mm and a velocity of 13 m/s is deflected through an angle of 60 degrees by a fixed curved vane. Determine the horizontal and vertical components of the force exerted by the jet on the vane. Neglect friction.
A tangential force of 0.004 K N affected the upper surface of a rectangle 5 mm high, 3 cm long and 5 cm wide, on its top surface. Not the shear modulus of elasticity of the body material is 3.33 * 10 N/ m Find (1) shearing stress (2) shearing strain (3) the resulting displacement in the direction of the force?
Determine the slope and vertical displacement of point A on the beam shown in the accompanyingillustration. Use Conjugate Beam Method. E = 200,000 MPa.
The uniform disk fits loosely over a fixed shaft having a diameter of 40 mm. If the coefficient of static friction between the disk and the shaft is μs = 0.15,determine the smallest vertical force P, acting on the rim, which must be applied to the disk to cause it to slip on the shaft. The disk has a mass of 20 kg.
Determine the ybar in meters centroid of the figure shown. Where r2=12 m and r1=4 m
2. The cross section of a rectangular hollow beam is as shown in figure. Determine polar moment of inertia of the section about centroidal axes. [Izz= 1,54,45334 mm4]
A rectangular bar is subjected to tensile forces of 2230 kN. Use E = 110 GPa and ν = 0.34. Determine the change in the dimension of its cross-section along X and Z directions. Also, calculate the change in the volume of the bar.
A block of mass M = 4 kg is pulled by a force F = 100 N forming an angle of 60 degrees with themhorizontal plane with friction coefficient 0.3. Determine the work of force F, friction force and normal force.
please solve ASAP, Will drop like