Answered: The technique of temporarily delaying…

The technique of temporarily delaying outgoing acknowledgements so that they can be hooked onto the next outgoing data frame is known as a. Bit stuffing b. Piggy backing c. Pipelining d. Broadcasting

A+ Guide To It Technical Support

10th Edition

ISBN:9780357108291

Author:ANDREWS, Jean.

Publisher:ANDREWS, Jean.

Chapter9: Supporting Mobile Devices

Section: Chapter Questions

Problem 15TC

See similar textbooks

Related questions

Q: We are using the selective repeat ARQ for sending the file from point A to point B. The file size is…

A: Introduction :Given , Selective repeat ARQ implementation file size = 500 KB frame size = 20 B…

Q: Q3: A / Draw a diagram showing the PDU messages exchange of writing a file of 950 bytes to the…

Q: Based on the given block data below, answer the following questions. Hint: First do Google search…

A: Below is the answer to above question. I hope this will be helpful or you..

Q: A wireless LAN uses polling to provide communications between 10 stations and a central base…

A: Answer :- (e) 39.96 Mbps

Q: Suppose that R = 1 Gbps and Rc is 300 Mbps and Rs is 200 Mbps. Assuming that the servers are…

A: EXPLANATION: As per the information given in the question, it can be said that: R = 1GBPS = 1024…

Q: Suppose that a digitized TV picture is to be transmitted from a source that uses a matrix of 720x480…

A: Because there are 32 intensity levels and each pixel can have one of these levels .So each pixel…

Q: Which of the OSI layers handles each of the following: a. provides synchronization between the tasks…

A: Seven layers of OSI network model: Physical layer Data link layer Network layer Transport layer…

Q: Which of the OSI layers is responsible for each of the following: a. allows the tasks to be…

A: Intro Seven layers of OSI network model: Physical layer Data link layer Network layer Transport…

Q: This is Networking subject, Binary to Decimal conversion and subnet mask. What should I put in the…

A: In the above question we need to represent the given decimal format IP address into Binary.

Q: Consider a full-duplex 256 Kbps satellite link with a 240 millisecond end-to-end delay.

A: Propagation delay Given as 240 ms Transmission delay is 256/12000 = 0.021 = 21 ms Putting in formula…

Q: Compute the fraction of the bandwidth that is wasted on overhead (headers and retransmissions) for…

A: selective repeat protocol,and 8 bits sequence numberwe know that ,sender window…

Q: What is/are the advantages and disadvantages of adding more redundancy bit in a message?

A: Lets see the solution in the next steps

Q: Compute the fraction of the bandwidth that is wasted on overhead (headers and retransmi- ssions) for…

A: The Answer is

Q: Computer Science Fill in each blank with one word. Separate your answer using commas. No space in…

A: ne of the biggest costs of congestion and buffering are wasted for packet lost blanks are filled in…

Q: 6. If CS= 1A2FH and IP= CB3AH, show: and Calculate: The logical address, The offset address, The…

A: Option A and D are correct answer Sice both are same

Q: Sender A sends the word A+ to Receiver B. By using Cyclic Redundancy Check (CRC), with divisor 1010,…

A: CRC cyclic redundancy check is performed in the data link layer for detecting damaged frames which…

Q: onsider the data pipelining process in the writing of a HDFS block. Suppose the data packet size is…

A: below we find how many packet needed? =========================================================…

Q: A Go-Back-N (GBN) ARQ scheme has been designed with window-size W = 10 such that it is fully…

A: Given that, In Go-Back-N ARQ scheme, Window size w= 10 Frame size= 20,000 bits There are no errors…

Q: SO/OSI Reference Model would be responsible for encryption or compression during a communication…

A: SUMMARY OSI Reference ModelSession- The fifth layer of the OSI model, which is responsible for the…

Q: Compute the fraction of the bandwidth that is wasted on overhead (headers and retransmissions) for…

Q: QUESTION 9: Assume the usage of Go-Back-7 (N = 7) ARQ sliding window protocol for flow and error…

A: Here in this multiple question we have given a sliding window (GB7) .and we have asked to find no of…

Q: What is/are the advantages and disadvantages of adding more redundancy bit in a message?

A: According to the information given:- We have to define the advantages and disadvantages of adding…

Q: MCQ 2712: The technique of temporarily delaying outgoing acknowledgements so that they can be hooked…

A: the answer is given below:-

Q: Consider a full-duplex 256 Kbps satellite link with a 240 millisecond end-to-end delay. The data…

A: Given: Goal: We have to find the effective throughput using stop and wait protocol and using…

Q: Consider a message 11100011 and a divisor 110011, then use mod 2 binary division method to…

A: Cyclic redundancy check:- CRC is an error detection algorithm which appends the remainder in the…

Q: uppose frames are limited to 1,500 bytes (excluding the 18 bytes of the header and the trailer)…

A: Summary: -Hence, we discussed all the points.

Q: 28. In stop-and-wait transmission, suppose that both sender and receiver retransmit their last frame…

Q: Compute the fraction of the bandwidth that is wasted on overhead (headers and retransmissions) for…

A: The answer is....

Q: What is/are the advantages and disadvantages of adding more redundancy bit in a message?

A: Advantages By adding redundancy bit decreases the bit error rate. Requirements of the backchannel…

Q: The message to be sent from source to destination is 4000B. The link MTU's from source to…

A: Given information: - The message sent from source to destination is 4000B. The link MTU’s from…

Q: [Q2 ]: The following data streams ( 100010010101101, 110110111101100 , - 101101111011011,…

A: Introduction to error detection and correction technique As per our guidelines we are suppose to…

Q: iefly explain your answer to each of the following questions. When the window widths of both the…

A: Introduction: Below briefly explain When the window widths of both the transmitter and receiver are…

Q: tal data over a multiplexed line as shown in the Figure below. A). Show how the messages are…

A: Four computers are sending the digital data over a multiplexed line as shown in the Figure below.…

Q: A 3400-byte datagram needs to cross a network with an MTU of 800 bytes. i. How many fragments are…

A: Given: 3400-byte datagram needs to cross a network with an MTU of 800 bytes. So, how many…

Q: The next 4 questions are based on the following description: In all following calculations, assume K…

Q: compute the fraction of the bandwidth that is wasted on overhead (headers and retransmissions) for…

A: The answer is..

Q: 1.5.1 Show the sequence of start, data, and stop bits that are generated during asynchronous…

A: 1.5.1 Show the sequence of start, data, and stop bits that are generated during asynchronous…

Q: A pure ALOHA network transmits 200-bit frames on a shared channel of 200 kbps. What is the…

A: Explanation: Average frame transmission time is given below,Tfr = 200 bits/200 kbps or 1 ms

Q: Compute the fraction of the bandwidth that is wasted on overhead (headers and retransmissions) for…

A: The Answer is

Q: Compare and contrast the following four mechanisms for breaking up a bitstream into frames (make…

A: 1. Byte count This method uses a field in the header for specifying the number of bytes contained in…

Q: Question 20 Consider the intermediary symbol coding table below: Intermediary symbol Binary code…

A: It is defined as a code that can directly be translated into its target machine code, then why at…

Q: Choose the scenario below where the receiving device would drop the frame. O a. If the frame is more…

A: Dear Student, A frame is dropped by the recieving device if the transmitted frame is less than the…

Q: 1. Suppose, there are two channels to multiplex, one bits from each source and use TDM with 180Kbps…

A: Here we have given the answers for the above asked question. You can find the solution in step 2.

Q: Based on the given block data below, answer the following questions. Hint: First do Google search…

A: Q1. (Layer 4) Protocol is:Based on the above input data block result, the Protocol used in layer 4…

Q: (b) Consider a simple framing protocol with the following features: . frames are delimited by flag…

A: Bit stuffing is insertion of a non-informational bit into data stream framing. In bit stuffing a…

Q: ng delimiter) and apply bit stuffing approach at layer 2. b) Apply Polar (RZ or NRZ) signaling/

A: SUBJECT:- NETWORKING NOTE:- TAKE X = 1149 QUESTION# 1:- A bit stream X is being transmitted, where;…

Q: 2) Will the following message-passing code cause communication deadlock if 2) implemented in a…

A: MESSAGE PASSING: As standard implementation of the parallel computing "message passing" model, MPI…

Concept explainers

Types Of Protocols

A network protocol is a collection of rules that governs the exchange of data between devices connected to the same network. In other words, network protocols are rules that specify how devices communicate or transfer data over a network. The sender and receiver systems must obey the standards to facilitate communication between them.

Question

10.	The technique of temporarily delaying outgoing acknowledgements so that they can be hooked onto the next outgoing data frame is known as
a.	Bit stuffing
b.	Piggy backing
c.	Pipelining
d.	Broadcasting

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.

Similar questions

44. What does the reciever use to extract frames from the bit stream?a. reverse lookupb.character stuffingc. MAC paddingd. Big endian
profile-image Time remaining: 00 : 09 : 15 Computer Science 8. In multimedia applications, buffers are very important to deal with jitter, what is the best buffer size (B) 1. the size of 1 packet 2. equal the maximum jitter 3. the same size as the streamed video 4. Zero (no buffer is needed) - In streaming multimedia using UDP, the video source generates frames at the rate of 30 frames per second, what is the transmission rate (send rate ) 1. we cannot use UDP with video streaming 19- Wirless networks have higher packet loss/delay due to bit-errors (discarded packets, delays for link-layer retransmissions), and handover loss True false 2. 30 frame per second 3. variable rate 4. 1 frame per second
a- Explain the Stop-and-Wait protocol b- Draw the Collision of the first bits in CSMA/CD? e- What is the protocol that responsible for video streaming such as YouTube videos?
This is what my professor said: Items are 4 bytes, pages are 2k, so ~512 items fit on a page. Even if we start in the beginning of a page, the first access will be a miss followed by ~200 hits, then a TLB miss followed by ~500 hits, so the hit rate is ~100%5. Page size 512 means 9 bits of offset and 7 bits of VPN. The offset is just the decimal version of 1 0111 0111 [unsigned] which is 375The offset is 0011 100 which is 28. Is he correct?
_________ is a supplementary protocol that allows non-ASCII data to be sent through email. a. JPEG b. MPEG c. MIME d. none of the above
In today's standard conversations, "save and forward" is no longer used. Investigate the workings.
MCQ 2712: The technique of temporarily delaying outgoing acknowledgements so that they can be hooked onto the next outgoing data frame is known as a. Bit stuffing b. Piggy backing
Common gateway interface is used to A. generate executable files from web content by web server B. generate web pages C. stream videos D. download media files
89. A ________ bridge can forward and filter frames and automatically build its forwarding table. a. simple b. dual c. transparent d. none of the above
Dear Writer this is my calculation solution.could you please double check it and let me know it if it soccrect or should i proceed with your solution: Please provide justification if correction is need and correct answer.Thank you in advance. a) The transmission time of a frame can be calculated as follows: Propagation delay (Tp) = distance/speed = 5km / 200000 km/s = 0.0025ms Transmission time (Tt) = frame size/bandwidth = 10000 * 8bits / (1Mbps * 10 ^ 6) = 0.008sec = 8ms Total time for transmission = 2 * Tp + Tt(since the frame has to travel from A to D and then D to A) = 2 * 0.0025ms + 8ms = 0.005ms + 8ms = 8.005ms The transmission time of the frame from A to D is 8.005 ms. b) The efficiency of the CSMA/CD protocol is given by the formula: Tt is the transmission time of a frame C is the number of collisions, Tp is the propagation time of a signal from one end of the segment to the other. Efficiency = Tt / (C * 2 * Tp + Tt + Tp) Assuming that there are no other…
COM. 1. Which algorithm detect less errors and can have more false positive or negative ? Checksum Professor CRC Single bit parity 2. Which one belongs to Random Access Protocol ? SNMP TOKEN RING CSMA / CD FDMA
17. The two types of real time streaming are : a. live & on demand streaming b. dead & static streaming c. static & on demand streaming d. on demand streaming