Answered: The term that refers to the phase…

The term that refers to the phase continues through the boundary of two signal elements is a. non coherent BFSK b. coherent BFSK c. Binary ASK d. Multilevel ASK

Systems Architecture

7th Edition

ISBN:9781305080195

Author:Stephen D. Burd

Publisher:Stephen D. Burd

Chapter8: Data And Network Communication Technology

Section: Chapter Questions

Problem 30VE

See similar textbooks

Related questions

Q: Plot the following signals. Label x-axis with time(s) for continuous time signals, and 'n' for…

A: Required: on matlab

Q: What should be the theoretical minimum sampling frequency for the signal to be reconstructed in the…

A: Theoretical Value of sampling frequency is always equal to 2 times the signal frequency. Hence Ns…

Q: 8- A binary source sending x1 and x2 over BSC, if the probability of x1 is 0.4 and probability of…

Q: 28. ___________ is a type of transmission impairment in which the SIgnal looses strength due to The…

A: GIVEN: 28. ___________ is a type of transmission impairment in which the SIgnal looses strength…

Q: If the channel is band limited to 6 kHz and signal to noise ratio is 16, what would be the capacity…

A: Introduction :Given , a channel band limited to 6 KHz SNR is 16 We have to calculate the capacity of…

Q: For Sin wave signal, which one is not correct? O a. It is aperiodic signal. O b. It is continuous…

A: For The Sin wave signal, which one is not correct? a) it is a periodic signal. b)it is a continuous…

Q: A signal travels from point A to point B. At point A, the signal power is 300 W. At point B, the…

A: Given, Signal power at point A = 300W Signal power at point B = 280W It means, Transmitted or input…

Q: Q1. A non-periodic composite signal contains frequencies from 15 to 50 KHz. The peak amplitude is 20…

A: The Answer is in given below steps

Q: gnal is 16 hertz. Choose the best sampling rate of the signal in Pulse code modulation, so that the…

A: The highest frequency in a composite analog signal is 16 hertz. Choose the best sampling rate of…

Q: For composite signals, if the high frequency content of the signal is removed, what happens to the…

A: Here is the solution

Q: Q1: Where we can combined the well- known signals as modulated signal which represents the video…

A: The ask is to name the procedure which combine the modulated signal and the driving signal.

Q: Decomposing periodic analog signal into two sine waves having a phase shift equivalent to 1/6 and…

Q: a) Draw the graph of the NRZ-I, Manchester & differential Manchester using data stream 01010101,…

A: The following things need to be kept in mind while drawing the data stream:- NRZ-I- Change the…

Q: Computer Science Build an optimized format for a frame that uses a little-endian format. It is used…

A: Answer: I have given answered in the brief explanation

Q: Plot the following discrete-time signals over the range -10 sns 10: i. 6[n-3] ii. u[n-3] iii. r[n-3]…

A: Requirements :- I HAD SOLVED 4 AS YOUR REQUIREMENT . Solution :- please see the matlab code below…

Q: In ________, the amplitude of the carrier signal is varied to create signal elements. Both frequency…

A: Let's see all the options : Option (a) : ASK ASK stands for Amplitude Shift Keying in which…

Q: write the numricals of queying delay transmission delay and propagation??

A: Delays, means time required for processing of the packet. There are following types of delays:-…

Q: Plot the following signals. Label x-axis with time(s) for continuous time signals, and 'n' for…

A: Required:

Q: Consider a composite analog signal set) where its freques Amplitude (Vetaer) 3. 2. 1 x4 x2 Answer…

A: Answer:

Q: Draw the constellation diagram of 2*4 QAM signal then show the output amplitudes and phases

A: EXPLANATION Below is the answer for the given question. Hope you understand it well. If you have any…

Q: 1) A low pass signal is sampled using PAM with a bandwidth of 3 kHz., the sampling rate is…

A: To execute a program written in high level language must be translated into machine understandable…

Q: Q4: Draw the constellation diagram of 2*4 QAM signal then show the output amplitudes and phases of…

Q: 2. For the given signal, x(t)= 5 + sin(6t) + 2cos(8t), perform the following basic operations on it:…

A: PART 1. OUTPUT:

Q: Q2. A signal travels from point A to point B through a link. It was found that at point B, the…

A: We are given the following data : Signal at point A : 98 W Signal at point B : 65 W We need to…

Q: In ________, the amplitude of the carrier signal is varied to create signal elements. Both frequency…

A: Amplitude Shift Keying The amplitude of the resultant output depends upon the input data whether it…

Q: 1. Complete Q 3 from Week-2 work: Plot the following discrete-time signals over the range -10 sns…

A: Requirements :- Solution :- Please see the matlab code with output in step-2

Q: FSK.pdf > title ('Carrier 2 Wave ') m=amp.*square (2*pi*fp*t) +amp; &For Generating Square wave…

A: The code for frequency shift keying in matlab is given by data= [0 1 0 1 1 1 0]; n = length(data);…

Q: Give an example of a synchronous connection as well as an example of an isochronous connection, and…

A: Asynchronous connections occur when the sender and receiver utilize different clocks.The clock is a…

Q: Digital- to analog conversion is the process of changing one of the characteristics of signal…

A: Analog signal is produced my devices in forms of varying voltage, electric or electromagnetic…

Q: Your challenge is to use MATLAB to plot a received signal at a base station in a multipath channel…

A: It is defined as a script, which contains a set of commands exactly as you would type them at the…

Q: Describe Transmission Delay in Different Topologies.

Q: If transmission time is 5ms and propagation delay is 12ms then draw the complete ‘Stop-and-Wait Flow…

A: SUMMARY: - Hence we discussed all the points.

Q: Number of locally generated carriers needed for the coherent demodulation of FSK signals is a. no…

A: FSK is the digital modulation technique in which the frequency of the carrier signal varies…

Q: Q7) 1 GHz carrier is frequency modulated by a 10 kHz sinusoid, so that the peak frequency deviation…

A: 1 GHz carrier is frequency modulated by a 10 kHz sinusoid, so that the peak frequency deviation is1…

Q: Both an isochronous connection and a synchronous connection may be understood better by examining…

A: Connection that takes place at its own pace: Data is sent from one end of a communication system to…

Q: Plot the following signals. Label x-axis with time(s) for continuous time signals, and 'n' for…

A: Matlab code: clc; clear all; % clear all the registers close all; % it will close all the previous…

Q: Plot the following signals. Label x-axis with time(s) for continuous time signals, and 'n' for…

A: Matlab code: clc; clear all; % clear all the registers we have close all; % it will closes all the…

Q: ________ is a type of transmission impairment in which the signal loses strength due to the…

A: Given that: ________ is a type of transmission impairment in which the signal loses strength…

Q: Assume we want to find the best match between an EEG signal and a sinusoidal waveform. EEG sample…

A: The mоst соmmоn wаy оsсillаtiоns аre used tо сhаrасterize brаin асtivity is by using…

Q: QUESTION 3 What is the phase angle between the following two signals s1(t) = -25 sin(wt - 35°) s2(t)…

A: - We need to calculate the phase angle between the two signals given. - The signals provided :-…

Q: ________ is a type of transmission impairment in which the signal loses strength due to the…

A: Given: ________ is a type of transmission impairment in which the signal loses strength due to…

Q: 8. Show using diagram the contents of the six output frames for a synchronous TDM multiplexer that…

A: In the Synchronous Time Division Multiplexing (STDM), the multiplexer assigns an equal time slot to…

Q: Discuss the following outdoor propagation Longley-rice model Okumura model Hata model

A: Outdoor propagation models involve estimation of propagation loss over irregular terrains such as…

Q: in the frequency domain, the following modulated signal has its carrier in the mentioned domain: A…

A: It is defined as analytic space in which mathematical functions or signals are conveyed in terms of…

Q: composite analog signal is 16 hertz. Choose the best sampling rate of the signal in Pulse code…

A: The highest frequency in a composite analog signal is 16 hertz. Choose the best sampling rate of…

Q: onal matrix. For the channel model shown: 0.2 Y2 X2 0.8 Find: DrWaleed -Source Entropy rate ,if t =…

A: The average rate of amount of information produced per second . The channel sends the information…

Q: An analog signal in sine form is intended to be transmitted to the receiver by pulse code…

A: 1) - Theoretical Value of sampling frequency is always equal to 2 times the signal frequency. Hence…

Concept explainers

Fast Fourier Transform Concepts

The algorithm used to convert a sequence to its Discrete Fourier transform (DFT) is known as the Fast Fourier transform. It can be used for both DFT and IDFT (Inverse DFT) transformation.

Question

157.	The term that refers to the phase continues through the boundary of two signal elements is
a.	non coherent BFSK
b.	coherent BFSK
c.	Binary ASK
d.	Multilevel ASK

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.

Similar questions

In ________, the amplitude of the carrier signal is varied to create signal elements. Both frequency and phase remain constant. a. ASK b. PSK c. FSK d. QAM
Which quantization level results in a more faithful reproduction of the signal?
Now suppose you have a composite signal (composed of many frequencies). If the frequencies range from 50 Hz to 600 Hz, what is the (analog) bandwidth?
A method for representing digital data analog signals by changing the phase of the analog carrier to represent the digital information is known as PSK explain?
which of the following should be done in order to convert a continuous-time signal to a discrete-time signal ? a.sampling b.differentiating c.integrating d.none of the mentioned
in the 6B3Q ,the number of signal levels used for the line-coding process equal?
Both coherent and noncoherent psk demodulators demodulate signals differently.
Implement MATLAB program that plots channel capacity vs signal to noise ratio for 2-PSK,4-PSK,8-PSK modulations
For composite signals, if the high frequency content of the signal is removed, what happens to the signal in the time domain? On the other hand, if the low frequency content of the signal isremoved, what happens to the signal in the time domain?
Three networks are cascaded with the following gains, noise factors, and input power respectively (image attached below):1. Express the input power in dBm. 2. Express the input power in dBu. 3. Express the individual noise factors into noise figures. 4. Express the individual gains into absolute values. 5. Obtain the total noise factor of the system.6. Obtain the equivalent noise temperature of the entire system. 7. If the input noise is 0.1 uW, determine the input SNR. 8. Obtain the output SNR. Present your solitions in a complete and systematic manner. Box your final answer. Use 4 deciual places.
Signals are demodulated in different ways using coherent and non-coherent psk demodulators.
which is trefers to time shifting of discrete time signal: a.x(n) = z(n-k) b.x(n) = z(-n-k) c.x(n) =-z(n-k) d.x(n) = z(n+k)