The time required to reach (40%) consolidation is (5 min.) for a sample of (3 cm) thickness, the sample was tested in the laboratory using standard consolidometer device. How long will it take in months for the same soil in the field to reach (80 %) consolidation if its thickness is (3.0 m) and drained through one side only?

The time required to reach (40%) consolidation is (5 min.) for a sample of (3 cm) thickness, the sample was tested in the laboratory using standard consolidometer device. How long will it take in months for the same soil in the field to reach (80 %) consolidation if its thickness is (3.0 m) and drained through one side only?

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter11: Ground Improvement

Section: Chapter Questions

Problem 11.8P

See similar textbooks

Similar questions

the given data shows a sieve analysis of a soil sample. clarrify the soil using aashto method. a.A-3(0) b. A-1-a(0) c. A-2-5(0) d. A-2-4(0) e. A-1-b(0)
An oedometer test is performed on a 2 cm thick clay sample. After 5 minutes, 50% consolidation is reached. After how long a time in no. of days would the same degree of consolidation be achieved in the field where the clay layer is 3.70 m thick? Assume the sample and the clay layer have the same drainage boundary conditions (double drainage). a.17.15 b.234 c.564.3 d.119 With Free Body Diagram
Please i need help to solve this question.. A sample of the soil was taken for oedometer test and the initial thickness of the sample was 19 mm for astress increment of 100 kPa, calculate coefficient of permeability(k), coefficient of compressibility (mv) andcoefficient of consolidation (cv) from the data obtained as following: (hint: use the root time method). Thank you
A clay specimen with an initial height of 22 mm has been tested in an oedometer in the lab, allowing double-way drainage to occur. The clay specimen reached 80% of final consolidation after 25 min. How long would it take in days for the same clay with a thickness of 8 m in the field to reach 80% of its final consolidation if there are three permeable levels of sand, one sand layer overlying the clay, a second thin sand layer in the middle of the clay, and a third sand layer immediately below the clay? (Acceptable tolerance = 2%)
An oedometer test is performed on a 2 cm thick clay sample. After 5 minutes, 50% consolidation is reached. After how long a time in no. of days would the same degree of consolidation be achieved in the field where the clay layer is 3.70 m thick? Assume the sample and the clay layer have the same drainage boundary conditions (double drainage).Show Diagram a.234 b.119 c.564.3 d.17.15
A clay layer in the field is 4.6 m and is drained at the top only. Under a given surcharge, the estimated max consolidation settlements 310 mm. What is the average degree of consolidation for the clay layer when the settlement is 76 mm? A.) 24.5% B.) 35.38% C.) 18.72% D.) 29.65% Pls answer asap
Laboratory tests performed on a saturated alluvial subgrade soil gave the following information: In situ water content = 11.9%, Specific gravity = 2.65, Soil size distribution: D100 = 51 mm, D75 = 30 mm, D60 = 20 mm, D45 = 15 mm, D30 = 8 mm, D10 = 4.76 mm, D8 = 2 mm, D4 = 0.08 mm, < 2 m = 4% a. Is this soil well graded? Classify it by the AASHTO and Unified systems b. Using the sieve analysis soil data and the classification systems, estimate for a total of 100% the approximate percentages of coarse aggregate (gravel), fine aggregate (sand), silts, and clays?
FUNDAMENTALS OF GEOTECHNICAL ANALYSIS A constant head permeability test is performed on soil that is 2 cm x 2 cm square, and 2.5cm long. The head difference applied during the test is 20 cm and 7 cm3 is collected over a time of 100 sec. Provide step by step solution. a) Compute the permeability based on these test conditions and results. b) A falling head test is conducted on the same soil specimen at the same time (t1 – t2 = 100 sec), and the standpipe diameter is 0.8 cm. If the average head during the test should be 18 cm, what are h1 and h2 values?
An odometer test is carried out on a sample of clay 20 mm thick assumed to be fully saturated. The time to reach 90 percent consolidation is 10.5 min. Estimate the following: (a) Time to reach 50 percent consolidation in odometer test (b) Time for a 9-m-thick layer of this clay to reach 90 percent consolidation assuming the same drainage conditions apply and it is subject to the same load increment as in the odometer test.
8.5 m compacted fill is to be placed over the soil profile. Consolidation tests are done on samples from point A and point B and produce the following results. Compute the ultimate consolidation settlement due to the weight of this fill in INCHES.
A large oil storage tank 90 meters in diameter is to be constructed on the soil profile shown in the figure below. The average depth of the oil in the tank is 18 meters, and the specific gravity of the oil is 0.92. Consolidation test showed that the clay is normally consolidated with Ccε = 0.154, Crε = 0.0112, and σ'p = 260 kPa. Estimate the total consolidation settlement of the tank. Neglect any settlements in the sand (ρd,sand = 1.71 Mg / m3). Perform this estimation by: a. Assuming conditions at the mid-depth of the clay are typical of the entire clay layer. b. Dividing the clay layer into four thinner layers with a thickness of 5 meters each, computing the settlement of each thin layer, and summing up using the included equation for sc. Assume that σ'p = σ'vo when σ'vo > σ'p. Hint: the load applied by the tank is given by qo = ϒoilhoil
A permeability test is inducted with a sample of soil that is 60 mm in diameter and 120 mm long . The head is kept constant at 225 mm. The flow is 1.5 mL in 6.5 min. What is the coefficient of permeability?