The tower is held in place by three cables. If the force of each cable acting on the tower is shown, determine the magnitude and coordinate direction angles a B and yof the resultant force. Take x - 20 m, y=5 m 600 N S00 N 400 N 24 m 16 m 4m 6 m 18 m X---------

Q: Replace the loading by a single resultant force, specify the location of force measured from point…

A: Note that, the center of mass of a uniformly varying loading (UVL) acts at the position of two-third…

Q: 2) Replace the force system acting on the post by a resultant force, and specify where its line of…

A: We have to determine the line of action interests the post AB form point A

Q: The boat is to be pulled onto the shore using two ropes. If the resultant force is to be 400N,…

A: For the force P to be minimum, the forces P and T should be perpendicular to each other.

Q: Determine the magnitude of the resultant force at A. F=840 N 6 m Fe 420 N 3 m B. 2 m 3 m 2 m E

A:

Q: Q5: The two forces act at point A of the bent F1 = 15 kN bar. Determine: 1. The resultant of the…

A:

Q: Ql:Determine the resultant R of the three forces acting on the simple truss. Specify the points on…

A:

Q: D FDA= 3.5 kN 9 m FDB= 2.5 kN FDc= 3.0 kN B 4.5 m 3 m 3 m 3 m A 30°

A: Write the coordinates of point D.   0, 0, 9   Write the coordinates of point A.   3sin30°, 3cos30°,…

Q: The beam is to be hoisted using two chains. If the resultant force is to be 600 N directed along the…

A:

Q: The tower is held in place by three cables. If the force of each cable acting on the tower is shown,…

A: Since you have asked multiple questions in a single request, we would be answering only the first…

Q: The beam is to be hoisted using two chains. If the resultant force is to be 600 N directed along the…

A: Resultant Force = 600 N Find the magnitude of force Fa and Fb and angle

Q: Find the Resultant Force for the Forces shown by resolving the Forces into their X& Y components.…

A:

Q: The distributed load acts on the beam as shown. Determine the magnitude of the equivalent resultant…

A: w= -2x2 + 4x + 16 x= 0 to 4 ft

Q: The two forces shown act at point A of the bent bar. Determine the direction R .of the two forces F₁…

A:

Q: The eyebolt supports the four forces shown. If the resultant force on the bolt is 3 kN in the +x-…

A: given:

Q: D FDA= 3.5 kN, 9 m FDB= 2.5 kN FDc= 3.0 kN B 4.5 m 3 m 3 m 3 m A - 30°

A: Given data: The value of force in the cable DC is, FDC=3 kN. The value of force in the cable DA is,…

Q: The tower is held in place by three cables. If the force of each cable acting on the tower is shown,…

A:

Q: Determine the resultant R (single equivalent force) of the three forces acting on the simple truss.…

A:

Q: Q3/ Replace the two forces acting on the bent pipe by a single equivalent force R. Specify the…

A:

Q: ituation 2. If the resultant force acting on the support is to be directed horizontally to the…

A: Solution;

Q: Q9/ If FB = 3 kN and its angle e = 45°, determine the magnitude of the resultant force of the two…

A: Given dataForce in tug A FA = 2kNForce in tug B FB = 3kNAngle of force A with respect to x axis θA =…

Q: Q1: Determin the magnitude and direction of the force F so that the resultant has force is directed…

A:

Q: H.W 3: Determine the angle of for connecting member A to the plate so that the resultant force of FA…

A:

Q: Replace the loading on the frame by a single resultant force. Specify where its line of action…

A: Let the resultant force F is acting at a distance of x from the point A in member AB, whose…

Q: F= 600 N HW06-1 Determine the magnitude of the projection of force F = 600 N along the u axis. 4 m…

A:

Q: The rectangular concrete slab is subjected to four column loadings, all acting on downwards (hence…

A: The given forces and their coordinates are written in the table below. Force (x,y) 20 kN (0…

Q: F-7kN Q1: The plate is subjected to the two forces at (A ) and (B) as shown. Determine the magnitude…

A: Mechanical Equilibrium: A body is said to be in mechanical equilibrium if it satisfies the following…

Q: Q/ Determine the magnitude of the resultant forces acting on the screw eye and its direction…

A: Resolve the forces into its components as shown in the figure. Now, ∑Fx=2cos45°-6cos60°=-1.586 kN…

Q: Determine the magnitude of the resultant force if the load at E is increased by 29

A:

Q: Q1: The 650 N tension force in cable AB is required to prevent the CA bar from rotating clockwise.…

A:

Q: B: The plate shown below is affected by the forces FA and Fs, by assuming the value of 0, calculate…

A:

Q: The turnbuckle is tightened until the tension in the cable AB equals 2.4 kN. Determine the vector…

A:

Q: If the resultant force is required to act at the center of the slab, determine the magnitude of the…

A:

Q: B. 4.5 m 2 m Fc A 4 m 25 m FD 6 m y

A:

Q: 3. If F1 -8 kN and F2 = 9kN, represent the force system acting on the corbels by a resultant force,…

A:

Q: The beam is to be hoisted using two chains. If the resultant force is to be 600 N directed along the…

A: To find the value of the resultant we need to resolve the forces along vertical and horizontal…

Q: Determine the angle for connecting member A to the plate so that the resultant force of F sub A and…

A: If two or more forces operate on an object, it is possible to find the resulting force by adding up…

Q: Q5/ 120 N- 80 mm Replace the two forces acting on the bent pipe by a single equivalent force R.…

A:

Q: Q3/ Replace the two forces acting on the bent pipe by a single equivalent force R. Specify the…

A:

Q: B: The plate shown below is affected by the forces FA and FB, by assuming the value of 0, calculate…

A:

Q: Determine the magnitude of the resultant force acting on the bracket and its direction measured…

A:

Q: Replace the force system acting on the post by a resultant force, and specify where its line of…

A: Given: Replace the force system acting on post by resultant force, measured form A Consider an…

Q: Replace the force system acting on a plate by a single force and determine where the line of action…

A:

Q: 3. Determine the resultant of the three forces acting on the dam and locate its intersection with…

A:

Q: If the magnitude of the resultant force is to be 9 kN directed along the positive x axis, determine…

A:

Q: Q/ Determine the magnitude of the resultant forces acting on the screw eye and its direction…

A:

Q: Determine the magnitude of the resultant force (R) acting on the plate and its direction (e)…

A: Answer: (a)The magnitude of the resultant force is 730.92 N. (b) It's direction measured from…

Q: Q1: The 700 N tension force in cable AB is required to prevent the CA bar from rotating clockwise.…

A: Solution: The force can be resolved as Fx and Fy as shown in the figure (Fx and Fy are…

Q: Determine the resultant R of the two forces applied to the bracket. Write R in terms of unit vectors…

A:

Q: The bent rod is supported at points A, B and C by smooth journal bearings, and is subjected to force…

A: Moment is known as the bending action of force which is product of magnitude of force to the…

Q: 2) Replace the force system acting on the post by a resultant force, and specify where its line of…

A: Apply the equilibrium of forces in the x-direction. Apply the equilibrium of forces in the…