Choose the st graph for the particle.The v -t graph for a particle moving through an electricfield from one plate to another has the shape shown in(Figure 1), where t' = 0.2 s and vmax = 10 m/s. Whent =t'/2 the particle is at s = 0.5 m.s(m)1.0O 0.5-((s)0.10.2s(m)0.50.1-t(s)0.2s(m)Figure< 1 of 1 >0.5Smax- (s)Umax0.10.2t'/2t's(m) Part BChoose the a -t graph for the particle.a(m/s?)500.10.2-(s)a(m/s*)100-t(s)0.10.2a(m/s*)1000,10.2-100

Answered: Image /qna-images/answer/6a36c67f-3f10-471e-832b-6210932559bf.jpg

The v -t graph for a particle moving through an electric field from one plate to another has the shape shown in (Figure 1). where ť = 0.2 s and vmax= 10 m/s. When t =t'/2 the particle is at s = 0.5 m.

The v -t graph for a particle moving through an electric field from one plate to another has the shape shown in (Figure 1). where ť = 0.2 s and vmax= 10 m/s. When t =t'/2 the particle is at s = 0.5 m.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: A block of mass 10 kg rests on a horizontal floor. The acceleration due to gravity is 9.81 m/s?. The…

Q: Activity 2. In the figure, the coefficients of friction are as follows: 0.25 between blocks, 0.20 at…

A: Given :- Coefficient of friction between blocks = 0.25 Coefficient of friction at the floor = 0.20…

Q: The particles position along a rectilinear path with an acceleration given by the equation below…

Q: 14. In the figure, fluid A has a specific gravity of 0.90 and fluid B has a specific gravity of…

A: Given data Specific gravity of fluid A (GA) = 0.9 Specific gravity of fluid B (GB) = 3 Specific…

Q: SITUATION. On a frictionless, horizontal air track, a glider oscillates at the end of an ideal…

A: Answer We can write down the given data from the acceleration graph Maximum acceleration amax = 12…

Q: Define the friction losses in pipes, what are the parameters that effect on friction in the pipe?…

Q: Figure shows a container filled with light oil and heavy oil. The masses of two types of oil are the…

Q: 22 Three identical balls whose mass are 1.074 kg are adjacent to each other, as shown in the figure.…

A: Weight of Ball B= mg = 1.074 x 9.81 =…

Q: In the figure, the three perfectly vertical rods are attached to a rigid beam. Assuming small…

Q: In the figure, the two spheres shown impinge against each other along their line of centers. If…

Q: Situation 4: For the given section shown in the figure, determine the following: 20 mm 120 mm 20 mm…

Q: A particle moves along the x-axis with an initial velocity v = 50 m/s at the origin when t = 0. For…

A: Particle speed changes the speed of a car or particle while it is moving fast. therefore it…

Q: 11. Hydro-graph is a graph that shows, a) Load curve b) Energy curve c) Mass curve d) Volume curve

A: It is a graph that shows mass curve. hence, the option correct is (c).

Q: The figure shows a laterally loaded beam which is supported by two rollers and in equilibrium. Find…

Q: The rotor of an electric motor has an angular velocity of 4500 rpm when the load and power are cut…

A: Given data: when θ=0angular velocity of the electric motor=4500 rpmweight of the rotor…

Q: 2.16. A horizontal drum, a cross-section of which is shown below, is being filled with benzene…

A: a} Consider the given data V=Lr2cos-1r-hr-r-hr2-r-h2at h=0V=Lr2cos-1r-0r-r-0r2-r-02…

Q: A very small quantity of a liquid having a surface tension o forms a circular spot of diameter D…

Q: Determine the magnitude of Q if the particle is in equilibrium and if e =12.1°, P = 240 , a=2, and…

Q: The collar of 5 kg mass shown in the figure moves on a parabolic bar on a horizontal plane. The…

A: Introduction : Friction is the force that prevents solid surfaces, fluid layers, and material…

Q: Example A particle moves in the X-Y plane with a constant acceleration of 1.5 m/s² in the direction…

A: Given- constant acceleration a=1.5 m/s2angle=37oat t=0; velocity u=8.0 m/sVelocity and position of…

Q: A

Q: -1 A string is wrapped on a wheel of moment of inertia 0.2 kg/m² and radius 10 cm and goes through a…

A: Given- Moment of inertia I=0.2 kg/m2radius=10 cm=0.10 mmass of block m=2 kg

Q: Determine the following for the figure shown, a. Centroidal Moment of Inertia about the x-axis b.…

A: To find 1. a. Centroidal Moment of inertia about x-axis. b. Moment of Inertia about y-axis.

Q: The figure represents three-quarters of a disk rotating around an axis that passes perpendicular to…

A: Given a figure of three-quarters of a disk rotating around an axis that passes perpendicular to its…

Q: AK 30⁰ 4 m 60⁰ Consider the smooth uniform bar shown in (Figure 1), which has a mass of 27 kg.…

Q: As shown in the figure, the block of mass m is placed on a horizontal plane a attached to an ideal…

A: Solution Given Data Stiffness K= 30N/m Velocity= 6 m/s

Q: A venturi meter is a device that is used for measuring the flow rate of a fluid within a pipe. Gas…

Q: C. The normal acceleration of the particle on the rim of a pulley 15 ft in the diameter is constant…

Q: Situation 2: As shown in the figure, two blocks are connected by a light, flexible cord passing over…

Q: 1. A 15-lb block A rests on a 35-lb wedge B as shown in the figure. Determine the acceleration of…

A: Solution Given That Mass of Block A= 15 lb Mass of Block B= 35 lb

Q: Water flows over a dam as illustrated in Figure Q6. Assume that the flowrate, q, per unit length…

Q: Activity 1. A particle moves along a straight line so that: s = 3r – 4r Where "s" is in meters and…

Q: A water jet with velocity V jet impinges normal to a moving flat plate with velocity V plate Such…

A: Given data: Calculate the relative velocity:

Q: WA particle (m- 225 g) is guided along the cireular guide as shown in the figure. The angular…

Q: uestion 4: The tank in a water tower has the geometry shown in the figure (the lower part is a…

Q: A particle starts from rest and travels along a straight line with acceleration a = (40 – 0.3v)…

A: Physics:

Q: Determine the magnitude of Q if the particle is in equilibrium and if 6 =27.7°, P = 515 , a=7, and…

A: Using lami's theorem

Q: For Example 6.6 part (a), if the units of d, P, L , and A are given in in., lbf , inches, and in2,…

A: The units of d, P, L, and A are given in in., lbf, inches, and in.2 respectively.

Q: A free-body diagram of a particle subjected to the action of four forces is shown in the figure.…

Q: A 4 cm diameter water jet with a velocity of 40 m/s impinges tangentially onto a fixed vane…

Q: The figure shows a laterally loaded beam which is supported by two rollers and in equilibrium. Find…

Q: Consider the geometry shown in the figure. The cube center is level with the surface of the liquid.…

A: According the given data in the questionThe density of the cube will be 733 kg/m^3Calculation is…

Q: An air–fuel mixture is compressed by a piston in a cylinder of an internal combustion engine. The…

A: The given figure is shown below:

Q: The water in a tank is pressurized by air, and the pressure is measured by a multifluid manometer as…

Q: If the particle starts from rest, what is its velocity, m/s, at t = 4 s? a (m/s) 10 t(S) 4

A: Given:- A particle starts from the rest A graph is given between variation of acceleration (a) with…

Q: Kim Jisoo discovered an element (1.43 kN/m3) that flows through a 100 mm (diameter) pipe at a mean…

A: given - density of element= 1.43KN/m3 it flows through pipe pipe diameter D = 100mm = 0.1m mean…

Q: In the figure, the two spheres shown impinge against each other along their line of centers. If the…

Q: 5. The 1.5m diameter solid cylinder shown is 7m long perpendicular to the figure and rests in static…

A: Bouyancy vertical force is equal to weight of cylinder.

Q: Q4: A 7-cm diameter solid aluminum ball balance nicely when submerged in a fluid as shown in figure.…

A: Given: Dal = 7cm, S.Gal = 2.7, SGbr = 8.5

Question

Choose the s
t graph for the particle.
The v -t graph for a particle moving through an electric
field from one plate to another has the shape shown in
(Figure 1), where t' = 0.2 s and vmax = 10 m/s. When
t =t'/2 the particle is at s = 0.5 m.
s(m)
1.0
O 0.5
-((s)
0.1
0.2
s(m)
0.5
0.1
-t(s)
0.2
s(m)
Figure
< 1 of 1 >
0.5
Smax
- (s)
Umax
0.1
0.2
t'/2
t'
s(m)

Part B
Choose the a -t graph for the particle.
a(m/s?)
50
0.1
0.2
-(s)
a(m/s*)
100
-t(s)
0.1
0.2
a(m/s*)
100
0,1
0.2
-100

Expert Solution

Step 1

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Plss help ASAP A)resulting acceleration in (m/s^2) B)estimate resulting pressure at the bottom of the tank in kilopascal
Determine the diameter of an orifice that permits a tank of horizontal crosssection 1.5m2 to have its liquid surface draw down at the rate of 160 mm/sfor a 3.35-m head on the orifice. Use C=0.63.
The object W1 in the figure is at an angle of 45 to the horizontal It is based on its frictionless surface at point B. Point A is articulated (fixed support) and ground friction Since (μ = 0.3) body W2 is a surface What should be the weight of W1 that will cause it to start? W2= 26 [kN]sin45=cos45=0.7
The object W1 in the figure is at an angle of 45 to the horizontalIt is based on its frictionless surface at point B.Point A is articulated (fixed support) and ground frictionSince (μ = 0.3) body W2 is a surfaceWhat should be the weight of W1 that will cause it to start? W2= 38 [kN]sin45=cos45=0.7
Show complete and detailed solution. Show FBD of the figure. What is the smallest mass of B to make the system in equilibrium while neglecting the friction between the string and the ramp? Mass of Block A = 45kg Coefficient of Block A, Block B, and Ramp C = 0.10
Knowing that at the instant shown assembly A has a velocity of 9 in./s and an acceleration of 15 in./s2both directed downward, determine (a) the velocity of block B, (b) the acceleration of block B
The 2.4kg particle moves in the horizontal x-y plane and has the velocity shown at time t=0. If theforce F = 2+3t^2/4 N, where t is time in seconds, is applied in the particle in the y-direction beginning attime t = 0, determine the velocity of the particle 4s after F is applied and specify the corresponding anglemeasured counter clockwise from the x-axis to the direction of the velocity
A particle moving along a straight line such that when (t = 0), the position (S = 8 m) and the velocity (u = 6 m/sec), then the particle subjected to deceleration a = -3u m/sec?. Determine the velocity and the position when(t = 5 sec.).
21. Obtain the volume of flow in L/s that will pass through a 200 mm pipe with a head loss of 3.78 m per kilometer. The pipe has a friction factor of 0.02569.8 L/s83.7 L/s24.2 L/s45.6 L/s
a circular cone s(0.99) floats vertically as shown in the figure, determine if it is stable or unstable, for that position R=0.75m and h=1.50m
A cylindrical tank has a diameter of 1.4 m. and a total height of 1.8 m. It contains water to a depth 2/3 of its total height. What will be the required angular velocity (in rad/s) such that half of its content will be spilled out? A. 9.80 rad/s B. 10.40 rad/s C. 14.00 rad/s D. 8.09 rad/s
The velocity of a particle is v = { 3i + (6 - 2t)j} m/s where t is in seconds. If r = 0 when t = 0, determine the magnitude of the displacement In meters of the particle during the time interval t = 1 s to t = 3 s.