There are 90 slots in the armature of a 3-phase, 50 Hz., 6 pole, star connected alternator. Winding is of double layer type and there are 20 conductors in each slot. Coil span is 2 slots less than the pole pitch. Calculate the flux per pole if the line voltage of 3300 V is required. Assume the emf to be sinusoidal.

There are 90 slots in the armature of a 3-phase, 50 Hz., 6 pole, star connected alternator. Winding is of double layer type and there are 20 conductors in each slot. Coil span is 2 slots less than the pole pitch. Calculate the flux per pole if the line voltage of 3300 V is required. Assume the emf to be sinusoidal.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Find the terminal voltage (in volts) on open circuit for a star-connected 6-Pole alternator having a flux per pole of 50mWb with 4 slots per pole per phase with 4 conductors per slot and a coil span of 130° and running at 1250rpm.
For an alternator that underwent the typical tests, connected in a star, voltage and current data were obtained when an equal field current was circulated in each case, yielding data: VLL = 480 Volts, IL = 120.4 Amperes, ¿ What will its synchronous impedance be?
A 20-pole, Y-connected, three-phase, 400-Hz alternator has 3 coils per phase group. Each coil has 2 turns and the flux per pole is 23 mWb. The coils are connected in two parallel groups. Determine (a) the rotor speed, (b) the number of slots in the armature, (c) the winding factor, (d) the per-phase voltage, and (e) the line voltage.
Two 50-MVA, 3-phase alternators operate in parallel. The settings of the governors are such that the rise in speed from full-load to no-load is 2 percent in one machine and 3 percent in the other, the characteristics being straight lines in both cases. If each machine is fully loaded when the total load is 100 MW, what would be the load on each machine when the total load is 60 MW? (Req'd) Draw an appropriate diagram.
Determine the flux per pole for 6 pole dc machine having 240 wave connected conductors, which generates an open circuit voltage of 500 volt, which is running at 1000 rpm.
A 20-pole, star-connected, three-phase alternator rotates at 300 r.p.m. The armature has 360 slots and 6 conductors per slot. The width of the coils is 5/6 of the pole pitch. If the maximum flux per pole, with a sinusoidal distribution, is 0.086 Wb, what will be the values of the emfs? phase and line? I need the procedure to get to that answer. Thank you
A 1200 kVA, 6600 volts, 3-phase Y connected alternator, has an effective resistance of 0.4 ohms and a reactance of 6 ohms per phase. It delivers full load current at 0.8 lagging power factor at rated voltage. What will be the terminal voltage for the same excitation and load current, if the power factor is 0.8 leading? Ans.: 4560.22 volts per phase show circuit diagram
4 DECIMAL PLACES. The stator of a 3-phase, 16-pole alternator has 144 slots and there are 4 conductors per slot connected in 2 layers and the conductors of each phase are connected in series. If the speed of the alternator is 397 rpm, calculate (a) kc, (b) kd, and (c) the emf inducted per phase. The resultant flux in the air-gap is 5 x 10-2 webers per pole sinusoidally distributed. Assume the coil span as 150° electrical.
3-phase,50 Hz, delta connected generator, its stator winding having 12 slots per pole pair and 6 conductors in each, if the total air gap flux is 160mwb. Find the terminal voltage. The prime mover speed is 750rpm.
A short shunt compound DC generator supplies a load of 10A at a voltage of 10 volts. If the resistances of Armature, shunt field and series field windings are 0.01 ohm, 1 ohm and 0.00 ohm respectively. c) write down the factors to improve the generated voltage. Generated Voltage is 10.2 V
The effective resistance of a 2200 V, 50 Hz, 440 KVA, 1 -phase alternator is 0.5 ohm. On short-circuit, a field current of 40 A gives the full load current of 200 AS. The electromotive force on open-circuits with same field excitation is 1160 V. Then the synchronous impedance and reactance is _______ ohm and _______ ohm respectively.
1- 1-Nose point in the PV Curve of an alternator gives you the information about a.Intersection of load line and generator characteristics b.Characteristics load line c.Maximum Real Power it can deliver d.Good voltage profile