thermometer having a time constant of 0.2 min is placed in a temperature bath, and after the thermometer comes to equilibrium with the bath, the temperature of the bath is increased linearly with time at a rate of 1/min. Find the difference between the indicated temperature and the bath temperature. (a) 0.1 min after the change in temperature begins (b) 1.0 min after the change in temperature begins (c) What is the maximum deviation between indicated temperature and bath temperature. and when does it occur?

Q: Under appropriate conditions A decomposes as follows: k=0.1/min A kz=0.1/min R is to be produced…

A: A series reaction is carried in CSTR and PFR.

Q: 7. 2.500 grams of metal X (molar mass = 65.39 g/mole) was reacted with 100.0 mL of a 1.500 M HCI…

A:

Q: When 10 mL of liquid water and 10 mL of liquid ethanol are mixed, the resulting solution has a…

A:

Q: Propose/design the process scheme for (fermentation and recovery of glutamic acid from palm waste…

A: Fermentation and recovery of glutamic acid from palm waste hydrolysate by ion exchange resin column.

Q: The irreversible gas phase reaction 2A + B →C + D is first order in A and first order in B. the…

A:

Q: What is the equivalent value of T= 50°C in degrees Fahrenheit, Rankine, and Kelvin?

A:

Q: An incompressible fluid is confined between two infinite, parallel horizontal plates separated by a…

A: Note: as per our guidelines, we are supposed to solve only 3 subparts of a question. please send the…

Q: Determine the required number of theoretical plates needed if there are 13 theoretical stages after…

A: Given that  13 theoretical stages by using  McCabe Thiele method which contain a partial condenser…

Q: 1. Given that A Gmix = RT(xni02 + n¡ Inɖ1 + n2 Ino2). Show that µi - µ1° = RT{In(1- p2) + (1-1/x)) 2…

A: Given Where Prove that

Q: Figure Of the Steam power palnt QH T=500°c Boiler

A:

Q: A tank containing pure water. A saline solution containing 2 Ib/gal salt is put into the tank at a…

A:

Q: In the energy exchange between water (CP-4177 J/kg.K) and light lubricating oil (CP=2090 J/kg.K), a…

A: Given, Cp of water = 4177 J/Kg.K Cp of oil = 2090 J/Kg.K

Q: A lg sample of a group 2 alkaline metal chloride reacted with excess silver nitrate. The cl2…

A: Given Group2 alkaline metal chloride(1g)+excess silver nitrate Cl2 recovered-All AgCl Find Which…

Q: An acetal polymer block is fixed to the rigid plates at its top and bottom surfaces. If the top…

A: Materials elastic shear stiffness measurement is the shear modulus. This is the ratio between shear…

Q: A binary mixture is in vapor-liquid equilibrium with 1 mol of liquid and 1 mol of vapor. The liquid…

A: We are asked to conclude that if the pressure decreases than what will be the effect of fugacity of…

Q: which group of data is represented by the x and y -axis in a boiling-point composition diagram of a…

A:

Q: The pressure difference between two air tanks A and B is measured by a U - tube |manometer, with…

A:

Q: 4.3. Steam flows steadily through an adiabatic turbine. The inlet conditions of the steam are 4 MPa,…

A:

Q: In a sugar-processing plant, a centrifugal pump transports cane juice from the bottom of a juice…

A: Given Juice is transport juice from tank1 bottom to tank2 bottom Difference in level of liquid in…

Q: | The following empirical equation was proposed to estimate the rate of heat loss from the walls of…

A:

Q: Based on the figure below, what is most likely the modulus of elasticity of the material? (MPa) 500…

A: correct answer is  a) 200 GPa

Q: 13. An orifice meter is used to measure the rate of flow of a fluid in pipes. The flow rateis…

A:

Q: Select the case with the highest diffusion coefficient!   a. Diffusion of acetone in air at 0°, 1…

A:

Q: 2.18 The Antoine equation predicts the effect of temperature on vapour pressure by the relation: B…

A: Given, The Antoine equation of water is lnPs = A - BT-ClnPs = 16.26205 - 3799.887T-46.854…

Q: . First draw a line representing the behavior of water on the axes below. Then, relative 1) to your…

A:

Q: . steam enters a group of convergent-divergent nozzles at a oressure of 2.2MPA and with a…

A:

Q: A binary hydrocarbon liquid mixture of A and B (K = 1.5) containing 60 mole percent A is flash…

A:

Q: A 5m x 5m x 3m room contains air at 25°C and 100kPa at a relative humidity of 75%. Determine: i. The…

A:

Q: The entropy of a closed system only depends on the initial and

A:

Q: Choose the true statement from the following regarding batch distillation: a) The exact…

A:

Q: 5 moles of air are allowed to expand isothermally at T= 300 K from 20 L to 50 L. If air obeys the…

A:

Q: Initially, a fixed-volume tank contains n-octane vapor mixture, as shown by the black dot on the…

A: Given  Final mole fraction of hexane =0.5  And volume is constant  Initially tank contain only n -…

Q: Classify the method in disposing clinical and non-clinical waste

A: Introduction Of the total amount of waste generated by health-care activities, about 85% is…

Q: = 0.06624 bar): %3D

A:

Q: Determine the rate of formation of HBr considering the mechanism of chain reaction, i.e.: (a)…

A: Reaction are Initiation is Propagation of the chain Termination Find Rate of formation of HBr by…

Q: Consider the two reaction and their equilibrium constants: K1 = 1000 A +B → C A +D → 3E K2 = 78…

A:

Q: Type TRUE if the statement is correct. If the statement is wrong, type a short explanation as to why…

A: Wrong. Explanations- A reversible process represents a limit to the performance of actual processes.

Q: ived

A: TRUE . EXPLANATION- For an ideal gas Change in entropy= (mass*specific heat capacity at constant…

Q: Determine the order and degree of the differential equation: 2r + 5z () dy + 522 ry = 0 da O fourth…

A: Given , The differential equation We know that, Order is the highest derivative of Differential…

Q: Q3. The surface temperature of a very long ród 8 millt ill diameter is exposed to ambient air at…

A:

Q: Consider the block flow diagram of an ammonia (NH3) production plant shown below. The fresh feed to…

A: The limiting reactant is determined in the system. The moles of hydrogen consumed and remained is…

Q: Estimate the change in enthalpy and entropy when liquid ammonia at 270 K is compressed from its…

A:

Q: 3.2. For liquid water the isothermal compressibility is given by: K= V(P+b) where c and b are…

A:

Q: The vapor-phase molar volume of a particular compound is reported as 23,000 cm3.mol–1 at 300 K and 1…

A: Given that At 300 k and P1 = 1 bar ν1 = 23000 cm3mol=23000 x 10-6  m3molT2=300 kP2 = 5 bar = 5 x 105…

Q: 1 mole of ideal gas at 40 degrees 150 KPa is subjected to the following processes, respectively. a)…

A:

Q: How many grams of barium sulfate will form when 35 mL of 0.160 M barium chloride reacts with excess…

A:

Q: "Principles of mobility control applicable to the development of enhanced-oil-recovery (OR)…

A: Enhanced oil recovery, also known as tertiary recovery, is the process of extracting crude oil from…

Q: A gasoline engine is burning 2 liters of fuel per hour. The energy of combustion of this fuel is…

A: As per our guidelines, we are supposed to solve only 3 subparts of the question. kindly send the…

Q: Question: A Furnace Burns Natural Gas With A Volumetric Analysis As Follows: Methane (CH4)= 75%,…

A: Composition of natural gas is, CH4 = 75 % C2H6 = 13 % C3H8 = 12 % % excess air = 35 %

Q: A Pollution Control Officer is asked to design a system to drain the sugar central's wastewater.…

A: Given Details: for a Pipe, Flow rate through pipe, Q =171.5 kg/s Available head, h =4.57 m of H2O…