Three phase SHP,408 volt 50Hz induction motor is working at an efficiency of 74 % at 0.83 power factor lagging Calculate the line current pint Output Power-5735W) Write answer correct to two decimal places. DO NOT WRITE UNIT

Q: A positive-sequence, balanced A-connected source supplies a balanced A-connected load. If the…

A: Given Line current for delta connected system Ia =9.609 ∠35° A per phase impedance ZAB =18+j  12 Ω

Q: Α Vs = 2420°V 50Hz 2.2ΚΩ V

A:

Q: 2. Implement an asynchronous up-counter with counting sequence 0-8 by positive edge- triggered D…

A:

Q: A full-wave bridge rectifier is operated from a 50 Hz, 220 V rms line. It has a 100 µF filter…

A:

Q: A three-phase transformer has a core shown below. There are three coils, and the number of turns are…

A:

Q: In the ideal transformer circuit of Fig. 13.38, find V, and the complex power supplied by the…

A: it is asked to find the voltage Vo and complex power supplied by source

Q: operational amplifier given below, calculate Vo -R₂ (i) the voltage gain in dB, (ii) input…

A: Given : Resistance R1=4.7 kΩ, Resistance R2=220 kΩ.

Q: ē 4. A D flip-flop with connected to input D is shown in the figure (i). A truth table for D…

A:

Q: 1. If a point source of radio waves transmits 1 watt, what is the power density 20,000 meters from…

A: Since you have posted multiple questions, we will provide the solution  only to the first five…

Q: Q5. The commonest insulating liquids are: A. Petroleum oils B. Askarels C. Fluorocarbons Q6.…

A: The insulating liquids is used to prevent the transformer. Suspended solid particle mechanism is…

Q: Example 1. The switch in Figure 2 has been closed for a long time. It is open at t=0. Find: a.…

A: The required parameters can be obtained by analysing the circuit at time t less than 0 and greater…

Q: The Thevenin voltage for the circuit is A) 5.0 V B) 10 V C) 6.67 V D) 8.33 V

A: Given data, Circuit diagram is given as,

Q: The transistor shown in Figure B2 has parameters VTN = 0.4 V, K₂ = 0.4 mA/V², and λ = 0. The…

A: Since you have posted the questions with multiple subpart and so we are supposed to answer 3…

Q: A 3-phase transmission line has conductors 1.4 cm in diameter spaced 1 m apart in an equilateral…

A: Given data Conductor's diameter, d=1.4 cm Spacing between the conductor, D=1 m Line current, Iline=9…

Q: 39. (a) Find both wattmeter readings in Fig. 12.39 if VA = 100/0° V rms, VB = 50/90° V rms, ZA =…

A: The most popular method for measuring three-phase power is the two-wattmeter approach.The two…

Q: Example 2. The switch in Figure 3 was open for a long time but closed at t=0. Find: a. i(0*), v(0*)…

A: In a series circuit, a switch is used to make it simple to open or close the electrical circuit. A…

Q: (i) Determine the unknown true power, P2 and reactive power Q3. (ii) Draw the power triangle and…

A: We have to do the following (i) Determine the unknown true power, P2 and reactive power Q3. (ii)…

Q: A continuous time LTI system is described by the differential equati dx(t) d²y(t) dt² dy(t) +4…

A:

Q: 4. Determine the node voltages, V₁ and using nodal analysis. GA 102 M

A: Circuit is given as:

Q: Q2.11 : For the integrator circuit shown in Fig (Q₂.11), a sine wave signal is applied to its input.…

A: Types of op-amp Inverting Op-amp Non-inverting Op-amp  The Ideal operational amplifier is an…

Q: 5. Calculate the maximum voltage drop at the given radial network. All required parameters have been…

A:

Q: Question 6 Find the resistance of load which takes a power of 10kW from a shunt generator whose…

A: Given- Power P=10 kW, To Find- The resistance of load (RL).

Q: 1. Draw a schematic diagram for electrical networks from generators to the consumers with their…

A:

Q: Q. 19. The lightning stroke that hits a transmission line may be thought to be a current source with…

A: Lightning stroke generated due to the charges stored in clouds.

Q: A 1500KVA, 11KV, 50Hz, Star connected synchronous generator is tested by operating it as a…

A: Given information about a star connected synchronous motor is written below. The percentage loading…

Q: 3. Suppose the voltage on a load terminals is equal to v(t) = 311.12cos (wt +30) and the current is…

A: As per our company guidelines we are supposed to answer only first three subparts kindly repost the…

Q: ) Calculate the lighting levels in a corridor where the minimum light level is 30 lux at floor…

A: To calculate the lighting levels in the corridor, we need to consider the amount of light that is…

Q: 2. In the following two-machine system, the voltages of sending and receiving ends are V₁ = 104/10°…

A: Let sending end voltage is Vs∠α and receiving end voltage is Vr∠β . Transmission line reactance is X…

Q: What are the different types of core?

A:

Q: Ammeter (02) G D S 10 V 1 kn Figure 3. A 10 V www (3) ΚΩ In the circuit in Figure 3, the current…

A: Given: When switch open, Current reading is 4mA, and When switch closed, Current reading is 3mA,…

Q: Describe how the starting torque and current can be improved in induction machines, both wound…

A: Describe how the starting torque and current can be improved in induction machines, both wound rotor…

Q: the voltages across 2K2 and 4K7 resistors.

A: Given : is the given circuit diagram.

Q: Q2.12 : Design an op-amp integrator with a time constant (RC) of one second. For a dc Voltage of…

A: Note: The operational amplifier is an important voltage amplification electronic circuit with very…

Q: The circuit has an RMS secondary voltage of 18.06 volts. One of the diodes is broken. Considering…

A: The amount of AC voltage that appears on a DC voltage is known as ripple voltage. The converter…

Q: A 3-phase industrial load is supplied from a 33kV feeder. The load is consuming 500kVA at 33kV at…

A:

Q: How Can you Measure the basing Value of op-AMP (+Vcc, -Vcc)

A: We have to explain how to you Measure the basing value of op-amp (+ Vcc, - Vcc)

Q: A unity negative feedback system has an open loop transfer function k G₂ s(s+ 10) for the system to…

A: Given data, Open loop transfer function Gs=kss+10. Unity feedback system Hs=1. Damping ratio ζ=0.25.

Q: Q. 31. A 4 kV, 110 Hz Schering bridge with a grounded detector as shown in fig. 4 has Cs-100 PF. In…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Transformer 1 2 Np 1000 80 Ns 8 00 Vp 120 20 Vs 12 2 Jp 0.4 Is 2 2.5 Based on the above table, if…

A:

Q: Question: A three-phase induction motor is running at 5 percent slip with certain load. If at this…

A: Given- A three-phase induction motor with. % slip, s = 5 % = 0.05. Power input to the rotor,…

Q: Q1: Find the value of v,in following the circuit assuming the op-amp is ideal (10 Pts) 9V 8 ΚΩ 5 V 6…

A:

Q: Find the Thevenin equivalent circuit for the portion of the network external to the elements between…

A:

Q: 14) What does the following function return for a given binary tree? struct TNode (int data; TNode…

A: What does the following function return for a given binary tree? struct TNode { Int data; TNode…

Q: 208/0° V, 17. Assume the system shown in Fig. 12.34 is balanced, Rw = 0, Van and a positive phase…

A: As the given system is balanced, we can use calculate the values of a single phase,i.e. on per phase…

Q: What range of output voltage is developed in the circuit of figure below if the I₁=0.066 mA, I₂ =…

A:

Q: Consider the amplifier circuit shown in Figure Q1.a with parameters: Rs = 0.5 kn, RB 10 k, Rc = 6.8…

A:

Q: G/ Determin the efficiency of transformer when in Pout Power 500w, iron losses-40 W Copper losses-60…

A:

Q: 3. Design a common-source amplifier with a total power budget of 10 mW (the bias current should be…

A: Given data Power budget, P=10 mW VDD=5 V VTH=0.6 V μnCox=250 μA/V2 Rsig=50 Ω RS=100 Ω RL=500 Ω We…

Q: Q2. A step down chopper has a resistive load of 2002 and input voltage VS = 220V. When chopper is…

A:

Q: Problem IV. Find the solution of the following LTI homogeneous system. X(t) = [¹²]X(t) . -4 X(0) =

A: it is asked to find the solution for given state space representation

Stator and Rotor Magnetic Field

The stator and rotor magnetic field is the resulting magnetic field generated by a system of coils that are symmetrically aligned. They are supplied with polyphase currents. The magnetic field is generated by poly-phase (two or more phases) current or single-phase current. In the latter case, two field stator windings are supplied and two resulting electromagnetic fields are generated beyond the stage.