Three pure resistances of value 200Ω each are connected to 3 phase 440V, 50Hz supply. Calculate the line and phase values of current and voltage in both star and delta connection.

Q: Notes Convert 100 watts of power into dBW? Show all steps Done

A:

Q: R A=A mmeter V= Vo Itmeter R= Resistor B- Battery K= Key wwww Rh = Rheostat Rh 3. The above circuit…

A: You have asked for two questions both have been answered below.

Q: From the circuit diagram of power measurement using two wattmeter for delta connected load in…

A: In the question, Fill the blank  Instrument is used to measure the current?

Q: A heater coil rated at 1000 W, 220 V is connected to 110 V line. Power consumed is?

A:

Q: 23. In the circuit shown, the voltmeter, ammeter, and wattmeter read as follows: 230V, 1.9A, 345W.…

A: Given data, Input current = 1.9 A. Input voltage = 230 V. Input power = 345 W.

Q: A 425 V, 3 phase, delta connected system supplies three resistive loads of 30 ohms each. The current…

A:

Q: A voltmeter connected line to ground reads 66 volts. What is the transmission line voltage of the PT…

A:

Q: 12. A 5-kW electric heating unit is connected to a 240-V. line. What is the current flow in the…

A:

Q: 1. In the network shown, 25 Volts is applied to terminals AB. Determine (a) resistance between…

A:

Q: For the network of figure 3 determine beta, Vcc, RB, IC, IE

A: Here, we will perform DC analysis. And we know that for DC analysis all the capacitors becomes open…

Q: Use the mesh-current method to analyze the following circuit. What are the magnitudes of the mesh…

A:

Q: Considering the resistor network below RI 2200 2200 15V 220 Vio 470 Calculate all answers to 2…

A: Given circuit,

Q: ComputationA house has the following specifications for a circuit determine the size of the circuit…

A: Here it is asked to determine the size of circuit breaker, size of wire and pipe for each circuit…

Q: For the circuit shown below Use using resistor combination, current division, or voltage division,…

A: In this question we need to find a voltage v shown in the given circuit.

Q: Derive the proper equations for all branch currents and voltages in terms of ov. 12v. 560, 820 & 680…

A: Kirchhoff's circuit laws can be used to find nodal voltages and mesh currents. There are two laws -…

Q: A fluorescent lighting fixture has a compact ballast with a nameplate rating of 180w, 120 V.…

A:

Q: ii) By using mesh analysis method determine the value of current and voltage across the 102…

A:

Q: Using a circuit analysis technique of your choosing, calculate the mesh currents and power balance…

A:

Q: 5. Three resistors connected in parallel with values 10, 5, 20 ohms respectively. Find the total…

A:

Q: Use the mesh-current method to analyze the following circuit. What are the magnitudes of the mesh…

A: Here  circuit is given and we have to find the unknown voltage and power dissipated in 15 ohm so…

Q: If the appliances is rated 7 HP and the available voltage source is equal to 220 v. What is the size…

A:

Q: A 5-kW electric heating unit is connected to a 120-V. line. What is the current flow in the circuit?

A: P=5 kW V=120 V

Q: A work area at bench level is to be illuminated to a value of 300 lux, using 85W single fluorescent…

A: Dear student as per our guidelines we are supposed to solve only one question in which it should…

Q: If the conductor is needed to be strung with a sag of 11.4 ft the tension would be: 2000 Ibs OA.…

A:

Q: 3. Using Kirchhoff's Law, calculate the current through the 4 ohms resistor of the circuit shown. 10…

A: Given circuit, Kirchhoff's current law states that the algebraic sum of  the currents entering a…

Q: Calculate the line and phase current drawn bythe load

A: In this question,  We need to calculate the line and phase current drawn by the load.  Current I=…

Q: 31. There are 20 discs in the string of insulators of a 3-phase, 400kV transmission line. String…

A: We need to calculate maximum voltage across any disc from given details .

Q: Given a current at the 8 ohm Resistor equals to 3A. Determine V2, Line current 1 and Total Voltage…

A:

Q: Using Thévenin's or Norton's theorem, calculate the value of the current source IX such that the…

A:

Q: verify the equivalence between the delta and star connections? (Compare the voltage and the currents…

A:

Q: An incandescent lamp, rated at 100 W, gives a certain amount of light when placed across the 120 V…

A: As per the guidelines, we supposed to answer one question at a time so please ask other questions…

Q: 1- Find the dissipated power in each resistor in the following circuits using nodal analysis. lease…

A:

Q: Calculate the current through the 2 ohm resistor using the Norton equivalent method.

A: We need to find out current through 2 ohm resistor by Norton equivalent.

Q: Sketch Vo for the network of Figure below and determine the de voltage available. 14 Meal Dide Meal…

A: To analysis, the circuit containing more than one diode, check the diode state on/off states in each…

Q: 3. Three coils each having resistance 11 and inductance L H are connected in star type to a 424…

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: 22 SV 10 lov 15V

A:

Q: Calculate the current in the 2-ohm resistor of the network shown below.

A: The solution can be achieved as follows.

Q: 2. To distribute the power at 415V over 3 phase 3 wire line, _____________ substation is used.

A:

Q: Use the mesh-current method to analyze the following circuit. What are the magnitudes of the mesh…

A:

Q: The PT of a 220kV transmission line has a ratio of 100kV: 300V. A voltmeter connected line to ground…

A:

Q: 9. Where branch circuit panelboards for normal and essential power serve the same patient care…

A: The explanation is as follows.

Q: 2. A circuit consisting of three resistors rated 75 2, 48 m2 and 650 µN are connected in wye. What…

A: Given: 'Y' connectedR1=75ΩR2=48 mΩ or 48×10-3ΩR2=.048 ΩR3=650 μΩ or 650×10-6ΩR3=.000650 Ω

Q: Use the mesh-current method to analyze the following circuit. What are the magnitudes of the mesh…

A:

Q: A 415 V, 3 phase, 4 wire star connected system supplies three resistive loads of 40 ohms each. The…

A: Given: A 3 phase, 4 wire star connected system VL=415 VRL=40 Ω each

Q: Determine the node voltages. 40 ww 81 ww ЗА 21,

A:

Q: From the circuit diagram of power measurement using two wattmeter for delta connected load in…

A: In Wattmeter method,  Instrument to measure the current is called?

Q: ) A circuit consisting of three resistors rated: 10-ohms, 15-ohms and 20-ohms are connected in…

A:

Q: What is the smallest value of resistance that can be used across a 100 Vdc source if the power…

A: Given: Voltage source V=100 V Maximum allowed power dissipation Pmax=50 W

Q: What is the voltage drop across the 5 ohm resistance in the given circuit below? 20 40 12 V 50 10…

A: Option A.  2.86 volts Using KCL will give results fast and easy

Q: A 410 V, 3 phase, delta connected system supplies three resistive loads of 25 ohms each. The current…

A: Given, 3-phase Delta connected system

Single Phase AC Circuit

Alternating Current (AC) is a type of electric power in which the electric current changes, both in magnitude and direction, at regular intervals. This AC Circuits can deliver power in either a Single Phase system or a Three Phase system.