TIME (minutes) CUMULATIVE (mm) PROBLEM 4 10 6.2 In a storm of 90 minutes 20 8.5 duration, the incremental rainfall 30 14.5 at various time intervals is given 40 21.7 below. Draw the hyetograph of 50 27.9 the storm: 60 33.0 70 35.1 80 36.2 90 37.0

TIME (minutes) CUMULATIVE (mm) PROBLEM 4 10 6.2 In a storm of 90 minutes 20 8.5 duration, the incremental rainfall 30 14.5 at various time intervals is given 40 21.7 below. Draw the hyetograph of 50 27.9 the storm: 60 33.0 70 35.1 80 36.2 90 37.0

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: a the cap will be 116,000 cubic yards. The borrow material h oisture content of 18%, and is 100% sat...

A: According to given data A clay borrow material will be used in the construction of a landfill cap. ...

Q: Diameter = 100m Bench Height = 10m Bench Width = 5m Bench Slope Angle = 45° a. What is the volumetri...

A: Given data, Bench height h = 10 m Bench width b = 5 m Slope angle = 45o Diameter of top deposit (was...

Q: 42 GROUP A e LATERALLY BRACED AT ENDS & MID PT. Is the beam adequate for Bending? span L = 20' Pu (F...

A: Solution: Step 1: Calculate the factored design loads, Which is already given; Pu = 20 kips Wu = 2 ...

Q: A propped cantilever beam of a length 2L isloaded by a uniformly distributed load with intensity q.T...

Q: A confined aquifer underlies an unconfined aquifer as shown in the illustration below. Given the fol...

Q: 3m 3m 1m 1m 1m 4m

A: Unit weight of concrete, γc =24KNm3No hydrostatic lift it means no upward seepageUnit weight of wate...

Q: 2. Draw the shear and moment diagram. 2 kN/m 6 kN-m 2 m

A: Answer: Need to draw the shear force and bending moment diagram, of the above beam.

Q: Find the force P needed to hold the 10-m-long cylindrical object in position as shown in figure. Wat...

Q: 3. A W300 x 67 has two lines of 20mm diameter bolts in each flange (three bolts in each line) which ...

Q: what can you conclude form the fineness of cement experiment if the percent weigh residue is 3.38%? ...

A: Fineness of cement experiment if the percent weigh residue is 3.38% The conclusion for this residue ...

Q: peam (negative number in kip-ft to one decimal). Mg -Mg Mg Me + M +

Q: Situation 3 (CE Nov 1999) 8 m The frame shown in the figure is to be analyzed using the cantilever m...

Q: 1. Draw the shear and moment diagram and find the location of the maximum moment. 15KN 10KN/m 5KN.m ...

Q: What is the difference between hazard and risks. Provide an example

A: Safety engineering is a branch of engineering that ensures that designed systems meet accepted safet...

Q: Determine the average velocity for the stream given the following data.

Q: Determine the direct runoff, the D-index, and the excess rainfall hyetograph for the storm given bel...

A: DRH=Direct runoff hydrograph we have to determine ϕ-index here and excess rainfall for the hyetograp...

Q: A 3 DEGREE CURVE HAS AN ANGLE OF INTERSECTION OF 24°. WHHAT S THE LENGTH OF THE LONG CHORD IN METERS...

Q: A truss is loaded as shown in the figure. The cross- sectional area of each member is 500 mm^2. Hint...

Q: Draw Free Body Diagram Determine support reactions Draw the shear and moment diagrams Determine the ...

Q: A beam having a width of 300 mm and a depth of 600 mm carries a dead load of 24 kn/m (including its ...

Q: The correct length of a 100 m tape, weighing 24 N, when a pull of 200 N is applied at the ends freel...

A: The given question is related with surveying . In this question we are provided with value of length...

Q: Determine the additional longitudinal reinforcements (mm?) due to torsion of a rectangular beam with...

A: To find : Additional reinforcement in mm2

Q: Calculate the weight ratios of three beams with the same length, material, maximum bending moment, a...

Q: Given the following principal stresses and principal direction: ơx = 27 MPa, oy = 15 MPa, txy = 6 MP...

Q: Calculate the magnitude of a uniformly distributed load (in addition to the beam's) which will cause...

A: Given : Width of web, Bw = 250 mm Width of bottom, Bb = 500 mm Width of flange, Bf = 750 mm Heigh...

Q: The soil is uniform if the coefficient of uniformity Cu close to: O 1.2.0 O 2.1.5 O 3.0.1 O 4.1.0 QU...

Q: QUESTION 2 Which of the following is NOT a strategy for improving intersection safety? Oa. Adding tu...

Q: An open cylindrical tank 30 cm. in diam. änd 80 cm, high partially filled with water is rotated abou...

Q: Determine the following using Slope Deflection Method. W1 P W2 A B X1 X2 X3 X4 Given: X1 = 4 X2 = X3...

Q: ever beam shown and num absolute value of ng moment. Indicate th You may use the meth od or both

Q: A bar ABCD has a circular cross section of 75 mm diameter over half its length and 50 mm diameter ov...

A: Torsion is the twisting of an item caused by an applied torque in solid mechanics. Torsion is measur...

Q: Lean Six Sigma Give the DMAIC and DMADV model of a Mining Industry.

A: Lean Six Sigma is an approach for quality management that concentrates on removing waste and reducin...

Q: A small project has 12 activities - N, P, Q, R, S, T, U, V, W, X, Y and Z. The relationship among th...

Q: A rectangular beam has a width of 375mm and has an effective depth of 450 mm. f'c = 25 MPa, Fy = 300...

Q: Determine the following using Slope Deflection Method. W1 P W2 A B X1 X2 X3 X4 Given: X1 = 4 X2 = X3...

Q: Problem 2 A composite beam made of steel and concrete has the dimensions and layout shown below. Det...

Q: to resist tipping and slipping, considering parameter values geon geotechnical according to the tabl...

Q: Given data : Work done=20 Joule Displacement=5 m Calcualte force applied

A: This question is related with mechanics . In this question we are provided with value of work done a...

Q: The rigid bar AC in shown in the figure A is to lift a weight W at C and is supported by pin at A an...

A: Load W = 2.4 kN Dimensions: L1 = L2 = H = 1.2 m

Q: The column consists of a wooded post and a concrete footing. Determine the normal stress developed i...

Q: A)Convert the "basis weight" of 38 of a facing into the "ream weight" . There is no more extra data ...

A: Given- Basis weight =38 To Find- Ream weight

Q: At a development site in Cebu City, a plate-load test was conducted on soil whose properties resembl...

Q: R=0.956 m 6.97 %3D R = =0.956 %3D P. b+2/2d %3D7.29-2.828d

Q: Write the equivalent fraction for x2 – 3 - 6x(x + 1) that has a denominator of 6æ2 (x + 1)(x – 5). a...

A: Multiplying the numerator and denominator with (x2 - 5x) we will get desired denominator 6x2(x+1)(x-...

Q: A tube well of 15 cm diameter penetrates fully an artesian aquifer 27 m thick. Determine the permeab...

Q: A column with a rectangular cross section area is subjected to an axial force as shown in the figure...

Q: onsider the tension member shown below. The channel iIs made of ASTM A572 (Fy = 50 ksi; Fu = 65 ksi)...

Q: What are the two principal steps needed to convert an igneous rock into a sedimentary rock?

A: Igneous rocks are formed when the magma cools and solidifies either at the surface of earth or insid...

Q: S LINEAR ERROR OF CLOSURE Problem 2: For the given data of a transit-tape survey. R 1. Determine the...

A: GIVEN Length of line, L Bearing of line, θ To Determine 1. Determine the latitudes and departures of...

Q: A W14x68 is used as a beam having a simple span of 6m. Properties of WF section. d=356.62mm bf=254.8...

A: Since Lp<Lb<Lr, nominal strength will control the inelastic lateral torsional buckling limit s...

Concept explainers

Storm Sewers and Detention

The storm drains system transports rainwater or stormwater and other runoff from roads, parking lots, and roof downpipes directly to nearby creeks, rivers, or the sea without any treatment.

Question

TIME (minutes)
CUMULATIVE
(mm)
PROBLEM 4
10
6.2
In a storm of 90 minutes
20
8.5
duration, the incremental rainfall
30
14.5
at various time intervals is given
40
21.7
below. Draw the hyetograph of
50
27.9
the storm:
60
33.0
70
35.1
80
36.2
90
37.0

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

During the dumpy level test, the observations are as follows:Staff reading stationAInstrument placedB2.2353.545AB1.6052.564Distance between A and B is 250 m and R.L of A is 435.062 m, Find the R.L of B.
Follow directions and box your answers. ANSWER: (a) 1.0 (b) 5/8, - 3/8 (c) 15/8 1. (a) 4, -1 (b) 2.5, -1.5 (c) 7.5 kN.m, -5 kN.m 2. (a) 3,200 N (b) 1450 N, -450 N (c) 6000 N.m, -1000 N.m
A surveying student had recorded the following afterrepeated pacing:First distance = 200 m.No. of paces: 222.00, 231.10, 230.50, 210.20, 215.20, 211.80,221.00, 230.20, 220.90, 218.10, 211.50, 218.50, 212.20, 216.00and 215.80Determine the second distance if the no. of paces are: 570.10,572.20, 575.00, 571.20, 572.30, 570.00, 578.10, 569.90, 569.50,571.20, 573.30, 573.50, 570.40, 575.20 and 593.80. SEND SOLUTIONS
A stone is dropped down a well with a velocity of 3.28 ft/s and 16.30seconds later thesound of the splash is heard. If the velocity of sound is 1130 feet per seconds. What isthe depth of the well?
HELP ASAP!!! a = 5.4 m , b= 3.8 m, c= 1.9 m
An engineer’s transit was set up at a central station O. Four surrounding points A, B, C and D were observed. Angle AOB 63°25’, BOC 55°45’, COD, 29°15’ and DOA 31°10’. What is the most probable value (MPV) of angle BOC?a. 55°51’15” b. 49°30’ c. 100°38’45” d. 10°51’15” What is the MPV of COD? a. 29°08’45” b. 15°38’45’ c. 74°08’45” d. 29°21’15”
Bearing or Azimuth of Line AB: ____________________ Sta Occ Sta Obs Dist (m) Mean Dist Observed Interior Angle Corr Adjusted Interior Angle Direct Reversed Mean A E 11.55 102°57 B 13.20 B A 13.20 C 17.42 C B 17.42 D 10.00 D C 10.00 E 13.90 E D 13.90 A 11.55
Convert 224 Psf to N/m2 * 72,102.51 25,304.80 10,721.51 17,528.42 Convert 726,000 lbs to MN * 7.21 3.23 3,230,000 5,480.000 Convert 903 joules/sec to Watts * 0.903 903 9,030.00 90,300, Convert 400 N-m/sec to HP * 298,280 0.000894 0.53640 5.3640 Convert 6,543.21 Pa to MN/m2 .065 .0065 654,321.00 65,432.10
A square island have 3 installed rainfall station on each of the corner with these records: A=1350mm, B=1850mm, and C=2450mm. What is the areal precipitation in mm using distance weighting method?
Question: Use the Thiessen polygon method to find the mean areal precipitation for the area composed of a square and an equilateral triangular plot of side 2.5 km. Rainfall values (in cm) at the stations are as indicated.
solve problem 29 and 30
Select one: a. 1.54 m b. 1.73 m c. 1.39 m d. 1.01 m