Q3Choose correct answer To measure a very high resistance (above50M2), we should useWattemeterO ohmmeterO MeggerO Wheatstone bridge

Megger is used for measurement of high resistance.

Answered: To measure a very high resistance…

Engineering

Electrical Engineering

To measure a very high resistance (above50Mn), we should use Wattemeter O ohmmeter O Megger O Wheatstone bridge

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter5: Resistors

Section: Chapter Questions

Problem 8RQ: A 10,000- resistor has a tolerance of 5%. What are the minimum and maximum values of this resistor?

See similar textbooks

Related questions

Q: Determine the total resistance of network in Figure 300 N 200 N

A: The solution can be achieved as follows.

Q: 3. Find the open-circuit voltage and current i flowing in 6-ohm resistor. 2i 10Ω a 20 v(: Voc 60

A: Given: Consider the circuit: To find: Find the open-circuit voltage and current i flowing in a…

Q: 2. Determine the total resistance. 2kn Rt 2kn I kn

A: RT= 0.727272 (Kilo Ohms)

Q: A voltmeter has a resistance of 100 ohm what will be it's reading when it is connected across a cell…

A: Given, A voltmeter has a resistance of 100 ohm. It is connected across a cell of emf 2 V and…

Q: O By using the experiment of Ohm's law: I-Draw the theoretical circuit 2- Take the resistance 5KN,…

A: The Ohm's law states that the voltage across the two points is directly proportional to a current…

Q: A D'Arsonval galvanometer, 1 mA, 50 ohm is What is to be converted to a 5 Amp-ammeter. the value of…

A: Given data, Rating of galvanometer, Im=1 mA, Rm=100 A Maximum value of current I=5 A

Q: When connected to a 4-ohm resistor, a battery has a terminal voltage of 6.5V. If the open-circuit…

A: A broken continuity caused by an obstruction in the current flow channel is known as an open…

Q: 20 Determine the voltage at resistor R1 if the Zener voltage is 3V. * D1 R1 1K LI 5V

A: In the given circuit zener diode connected in series with resistance R1 Zener diode has voltage…

Q: Vz = 13V Pz(max) = 340 mW If the resistance RL ranges from 420 ohms to 3200 ohms, what is the…

A: Given: By the clear observation of the question we come to know that here the given circuit is a…

Q: Solve for the equivalent resistance if R = 14 Ohms R ww ww a c ww ww bo ww ww ww

A: Here wheatstone bridge forming Whenever bridge is balance then current flowing in the the…

Q: From what portion in Multisim should you get an ammeter and a voltmeter? Answer:

A: In Multisim we get an Ammeter and a voltmeter from measurement Toolbar.

Q: (b) Given two resistors with a 5 k and a 1 Mn Determine their conductance values . How does the…

Q: 3.3 k2 5.1 k2 7 V 2 k2 8 V

Q: Determine the equivalent resistance between terminals a and b. ww 10 ohms 10 ohms 10 ohms ww 10 ohms…

Q: Determine the equivalent resistance between terminals a and b. ww 10 ohms

Q: A battery with an internal resistance of r and an emf of 10.00 V is connected to a resistor. What is…

A: The circuit when only the battery with an internal resistance is present. For this circuit the…

Q: Given that the total resistance is 15 Ohms and the Voltage Source is 30 V: (1) Determine the…

Q: A D'Arsonval galvanometer, 1 mA, 50 ohm is to be converted to a 5 Amp-ammeter. What is the value of…

Q: Find equivalent resistance of the network across terminal ab. 60 ww 20 ww 62 ww 1 ww

A: Star-delta transformation- Star-delta transformation is the method to solving the circuit easily.…

Q: Find the Equivalent Resistance of the following R₁ = 5 kn www R₂ = 10 k ww R 10 k

Q: Which terminal has the largest equivalent resistance? 1. AB 2. AC 3. BC 4. each terminal has the…

A: If two resistors are connected in series then its equivalent resistance is sum of the individual…

Q: Find the equivalent resistance at terminals A and B if each resistor is rated 1k-ohm. A B c-M- M- D…

A: consider the given question;

Q: 5.) When a resistance of 3 ohms is placed across the terminals of battery, the current is 2A. When…

Q: Q/ By using the experiment of Ohm's law: 1-Draw the theoretical circuit il all i jilal pau 2- Take…

Q: Compute for the value of resistor R. * R 5V o 2V, 20mA 2V, 20mA

Q: Determine the equivalent resistance, Req if X=9 b) Determine current i, if "R" is 20 ohms.

A: The solution can be achieved as follows.

Q: 1 MO з мо 600 0 5 kn 100 kQ

Q: 7. What will be the value of the voltmeter in this circuit and why? Explain. RESISTOR1 1k Voltmeter…

A: Zener diode- Zener diode is highly doped diode 1:105. It is always fabricated with Si. Because…

Q: Find the conductance of a resistor of resistance (a) 10Ω (b) 2kΩ (c) 2mΩ

A: Let us calculate the conductance of the given resistors one by one as shown below. The conductance…

Q: A D'Arsonval galvanometer, 1 mA, 50 ohm is to be converted to a 5 Amp-ammeter. the value of the…

A: Given data, Rating of galvanometer Im=1 mA Resistance rating Rm=50 Ω Galvanometer to be converted as…

Q: Calculate the power dissipated by the voltmeter and by resistor R given figure when (a) R = 250 ohm…

Q: ww 1 ohm A 4 ohm 2 ohm ww 3 ohm

A: According to the question we have to find the value of equivalent resistance between A and B.

Q: Determine the Norton equivalent current IN and resistance RN between terminals a-b. RΩ oa V V IN RN

Q: Resistances can be measured with the help of a O voltmeter O ammeter wattmeter ohmmeter

A: Voltmeter is used to measure the voltage between two node. Ammeter is used to measure current flow…

Q: the voltage , v, equal to _______ in a 30 a of current in a 120-kohms resistor.

A: Given data: Current I = 30A Resistance R= 120 k ohm The relationship between voltage (V), current…

Q: Determine the equivalent resistance between terminals b and d. a ww m www 5 ohms 10 ohms O 8.1688…

Q: 3.3 k2 5.1 k2 + 7 V 2 kN 8 V

A: Given Circuit:

Q: For a given wire gauge, the longer the wire the greater the resistence. A copper wire 750ft long has…

A: Given: Length of copper wire, l=750 ft And resistance of 750 ft. long wire, R=1.89 Ω For the same…

Q: Calalate ta Rey. in

Q: 122 122 D2 MM 1252

Q: 1. A dynamometer voltmeter draws a current of 1 mA for full scale value of 100V. If it draws a…

Q: D1 好 R1 500

Q: Find the equivalent resistance between A and B. 11 ohm 10 ohm 10 ohm 32 ohm 29 ohm 30 ohm O 31 ohm

Q: A very small resistance 100 m ohm is measured using kelvin double bridge. The standard resistor is…

A: The unknown resistance can be measured using various bridges and kelvin double bridge is one of…

Q: A metal resistor has resistance of 10 ohm at 0°C and 11 ohms at 160°C, the temperature coefficient

A: Temperature coefficient: The resistance-change factor per degree Celsius of…

Q: 6. Consider the circuit below. ,60 12V (a) What will be the reading of a voltmeter connected across…

A: We will use nodal analysis and ohms law to determine voltage across AB terminals. For calculating…

Question

Q3 Choose correct answer

To measure a very high resistance (above50M2), we should use
Wattemeter
O ohmmeter
O Megger
O Wheatstone bridge

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A solar cell can produce a voltage of 0.5 V and has a current capacity of 0.1 A. How many cells should be connected in series and parallel to produce an output of 6 V at 0.3 A?
A 10,000- resistor has a tolerance of 5%. What are the minimum and maximum values of this resistor?
5. A digital voltmeter indicates a voltage of 2.5 V when 10 of current flow through a resistor. What is the resistance of the resistor?
A voltmeter with resistance ‘RV ’ is connected in parallel with resistance of 100 ohms. The applied voltage V= 100V. Determine the error (E) & percentage error (%E) in the measurement of voltage (V) due to loading effect of voltmeter when RV =1M Ω
voltmeter with resistance 'RV' is connected in parallel with resistance R=100 ohms. applied voltage V= 100V, Determine the error (E) & percentage error (% E) in the measurement of voltage (V) due to loading effect of voltmeter when- (i) RV=1M (Ohms) (ii) RV = 100K (Ohms).
Determine the equivalent R eq resistance of the following resistor arrangement:
A thermistor has a resistance of 16.33k ohms at 0.0 degrees C, and it drops to 6.247k ohms at 20.0 degrees C. This thermistor is used in a simple voltage divider circuit. Vs = supply voltage = 5.0 Vdc, Rs = supply resistance = 10k ohms.
Design an ohmmeter with Voltage, V = 6 V, If Rs can change from 0 Ω to 1500 Ω, galvanometer(ammeter) full scale current is 1mA. What is the minimum and maximum resistance that we can measure? (N.B.: write your answer like Rmin-Rmax. For examle 100 Ω -1000 Ω )
Breadboard Projects Propose a SIMPLE PROJECT with the use of Basic Electronic Components and Define why you’ve chosen/decided to propose that project? What is itsimportance? Requirements :Title of the Project:Its Importance:List of Components:Breadboard Layout:
1. Find the equivalent resistance of the following circuits, represent each step clearly: A) Assume the value of each 1KM resistor. Figure A B) Figure B
A galvanometer has a resistance in Rg = 40 Ω, carrying a maximum current of 4 mA. Determine the size of the resistors R₁, R₂ and R3 if the galvanometer is to be used as an ammeter capable of measuring potential differences of 0.2 A, 2 A and 20 A
A galvanometer coil has a resistance of 2.5 ohms and deflects full scale on 50 mV. Determine the resistance of a multiplier if the instrument is used as a 150-volt voltmeter.