To measure the mass flow rate of water flowing in a pipe, an orifice is used and a water-mercury differential manometer is attached to the pipe. Data are as follows. What is the volumetric flow rate of water in m3/hour ... Diameter of orifice = 3.19 cm %3D Diameter of the pipe = 12 cm h = 107 cm %3D %3D Temperature of water = 20°C Use coefficient of discharge = 0.62 %3D Sp. Gravity of mercury = 13.6 In 2 decimal values

Q: A gas stream contains 40 mol% isopropanoi III al 240 gmol/min, 70°C, and 1 atm. You are to use a con...

A: Given that, The mole fraction of isopropanol in the feed gas stream y1,f = 0.4 The mole fraction of ...

Q: The reactions of hydrocarbons are often studied in the petroleum industry. One such reaction is 2C3H...

A:

Q: 2.87mole of a diatomic gas is heated at constant volume from 26C to 188C. Calculate the change in en...

A:

Q: . A saturated solution of Na2SO4 at 30°C is cooled in a crystallizer to a saturated solution at 15°C...

A:

Q: Problem 1 A vapor mixture containing 65% benzene and 35% toluene is cooled from 150°C to 90°C at a p...

A: Given that: Vapor mixture has following composition Benzene = 65%  Toluene =35%  Initial temperatu...

Q: 1. What is the net force acting on a car cruising at a constant velocity of 70 km/h (a) on a level r...

A: Given that  constant velocity = 70 km/h  we have to find the net force acting on a car cruising on a...

Q: A gas phase reaction 2A + 4B → 2C which is first order in A and first order in B is to be carried ou...

A:

Q: Starting with the following equation, Pa(s) + F2(g) → PF3(g) calculate the moles of F2 that will be ...

A: The reaction taking place is between phosphorus and Fluorine. The balanced equation is P4(s)+6F2(g)→...

Q: EXTRACTION If a feed component is not soluble in the solvent, where does it exit? a. Raffinate Str...

A: In extraction  A Feed component is insoluble in solvent  Find -Where will be that component after ex...

Q: In 298K, Cp of water = 74.8 J/mol-K. Find Cy of water at 298K.- (a =2. 1*10*(K), B =4. 94*10* (atm")...

A: Given that :   Cp of water = 74.8 J/mol kα = 2.1 x 10-4 K-1β = 4.94 x 10-5 atm-1Molar volume of wate...

Q: A paper mill shifts to a Texas distributor 12, 208 kg of paper. A sample carefully taken at the mill...

A: Givenweight of paper before shipment=12208 kgMoisture content of paper before shipment=4.28%Moisture...

Q: In a plastic manufacturing concern, air is used to dry plastic sheets in which acetone is used as so...

A: gas flow rate =1000kgmole/hr mole fraction(acetone) at inlet in gas stream=0.04 mole fraction(aceton...

Q: Estimate the change in enthalpy and entropy when liquid chocolate at 450 K is compressed from 250 kP...

A: Given that 450 K is compressed from 250 kPa to1500 kPa. For liquid chocolate at 450 K, v = 1.02 ×10−...

Q: Given SG of mercury at 20°C is 13.546. Calculate the density and volume occupied by 200 kg of mercur...

A: Given that SG of mercurry = 13.546 T = 20 Cm = 200 kg

Q: (a) PbS(s) + 2(g) → PbO(s) + SO2{g) AH = – 415.4 kJ The oxide is then reduced to metal with carbon (...

A: Given that  There are two reaction are given and its enthalpy change is also given  we have to find ...

Q: Find the time required for a cylindrical tank of radius 8 ft and height 10 ft to empty through a rou...

A: Given that: Radius of cylindrical tank, R = 8 ft Height of tank, H = 10 ft Radius of round hole, r =...

Q: ndicate which chemical reactor is the most suitable considering the smallest possible volume require...

A: Given that :conversion = 85 % zero order ,n =0 

Q: 250 m^3 of 30°api gas oil is blended with 1000m^3 of 15°api fuel oil . what is the density of the re...

A:

Q: 1. Please determine K-C,H., and 50 C and 150 kPa via (a) the DePriester Charts and (b) Raoult's Law ...

A:

Q: 3. Complete the table and show all the pertinent solution. Standard Metal Reading 1, Reading 2, Read...

A: Disclaimer: Since you have asked multiple question, we will solve the first question for you. If yo...

Q: 3. Water at 20°C is pumped at a constant rate of 9 m'/h from a large reservoir resting on the floor ...

A: The density of water at 20oC is ρ = 998 kg/m3 The volumetric flow rate of water is, Q = 9 m3/h = 9/3...

Q: Which of the following feed operation for multiple-effect evaporators is preferred when the concentr...

A: Question: Answer: given that; The feed operation which is required for the High viscous fluid in the...

Q: Calculate the percent recovery using the given data: Feed Weight = 500 g Feed Grade= 3.8 grams per t...

A: Given that, The weight of feed F = 500 g The weight fraction of solute in the feed xF = 3.8 grams pe...

Q: Fresh feed containing 20% by weight KNO3 (K) in H2O (W) is combined with a recycle stream and fed to...

A:

Q: Ethylene oxide is produced by the catalytic oxidation of ethylene: 2C2H4 + O2 → 2C2H4O An undesired ...

A: Given that, 2C2H4 + O2 → 2C2H4OC2H4 + 3O2 → 2CO2 + 2H2O The feed to the reactor contains 3 moles of ...

Q: C. Consider a chemical reaction. At a temperature T1 = 300. K and an external pressure P, the enthal...

A: To estimate the temperature, where the forward reaction is feasible : T1 = 300 K∆rH(T1,P) = 400 J∆rG...

Q: A helium-toluene mixture contains 30 mole% toluene and 70 mole% helium at 100°C and 752 mmHg. (MW: t...

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part ...

Q: The amount of water to be removed from 2000 kg/hr of feed to be dried from 110% (db.) to 5% (w.b.) i...

A: The feed given is F = 2000 kg/h, The concentration of a particular solid in feed is given as 110% on...

Q: A current of 200A is passed through a stainless steel wire having a thermal conductivity K=19W/mK, d...

A: Given that, Current I = 200 A Thermal conductivity of wire K = 19 W/m.K Diameter d = 3 mm = 0.003 m ...

Q: A gas containing 80% CH, and 20% He is sent through a quartz diffusion tube (see Figure P8.8) to rec...

A: Given that, The mole fraction of CH4 in the feed gas xCH4,F = 0.8 The mole fraction of He in the fee...

Q: 100 g of water is sealed into a t-t container at 25°6. The container aiso contains air at t atm. The...

A: Given data: Mass of water = 100 g Volume of container = 1 L Temperature of water = 25 0C Pressure of...

Q: a. Determine whether energy as heat is evolved or required in the following process at constant pres...

A: Disclaimer: Since you have asked multiple question, we will solve the first question for you. If you...

Q: 3. Given the following block diagram of a system: X(s) s3 - 2s2 –s+ 2 G(s) Y(s) s2 – s -6 Find the I...

A: Given that Output ,Y(s)  =S2 -S  -6Input ,X(S) = S3 -2S2 -S +2

Q: If the reaction aA + bB → cC + dD were carried out in a batch reactor, write down the stoichiometric...

A: A reaction is carious out in a batch reactor.

Q: If you start at the triple point labelled B what actions must you take in oder to produce liquid sul...

A:

Q: Calculate the frictional pressure drop for a 50 % solution of glycerol with a density of 1.1273 g/cc...

A: The glycerol is flowing through the rectangular duct of dimension having 0.8 m wide, 0.3 m height an...

Q: Who are the customers of the occupational safety function?

A: Introduction Occupational health, also known as occupational safety and health (OSH), is a multidisc...

Q: The molar volume of a van der Waals gas at 100oC and 100 atm given that a = 1.345 atm-L2/mole2 and b...

A:

Q: 100 kg/hr of palay is dried from 70% moisture content to a final product containing 15% moisture. Dr...

A: Given data: Mass flow of palay = 100 kg/h Initial composition of palay is as follows: Moisture = 70 ...

Q: 200 moles of ethane (C2H6) are sent to a reactor and react to form ethylene (C2H4) and hydrogen gas ...

A: The number of moles of ethane fed to the reactor nC2H6,f = 200 mol The fractional conversion of etha...

Q: Q4: 0.5-kg water that is initially at 1 MPa and 10 percent quality occupies a spring-loaded piston- ...

A: In thermodynamics when we talk about heat and work there will be two possibility for each which defi...

Q: P9.21 A solution is made up of 199.0 g of ethanol and 116.7 g of H2O. If the volume of the solution ...

A: The partial molar property is a thermodynamic property that describes the variation of an extensive ...

Q: Wastewater flow in a sewer can be estimated by adding a known amount of tracer such as salt solution...

A:

Q: Typical data on the ultimate analysis of the combustible components in residential MSW Percent by we...

A:

Q: Estimate the volume of a compound in vapor phase using below methods. Fluid is at a state  with T = ...

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part ...

Q: An equimolar mixture of substances A, B and C is fed to a reactor to produce product D by the reacti...

A:

Q: Draw a flowchart of the process, labeling the two feed streams (beans and solvent) and the leaving s...

A: Flow rate of feed = 750 kg/h Feed composition, Oil=14.5% (by weight) Insoluble solids=85.5% (by weig...

Q: Calculate the equilibrium conversion for the following liquid-phase reaction and express the reactio...

A:

Q: Q2: A piston-cylinder device with a set of stops initially contains 0.3 kg of steam at 1.0 MPa and 4...

A:

Q: 1. A large-particle composite consisting of tungsten particles within a copper matrix is to be prepa...

A: