Topic: Electromagnet Required: • history and discovery • what is its connection with interpoles? • uses and/or examples • definition

Q: The differential equation x2y "-y "sinx + (y) 2+y (Inx)=e* is not linear because A because of the…

A: Given,The differential equation is given as,x2y'''-y''sinx+y'2+ylnx =ex

Q: Using the circuit in the figure, design an amplifier that has a total voltage gain Av=vo/vi=193. It…

A:

Q: Any time an electric current flows through what component is a magnetic field created around the…

A: We need to select correct option for given statement

Q: How do we increase or decrease the generated voltage output in the operation of afactory finished…

A: It is asked to explain briefly that how to increase or decrease the generated voltage output in the…

Q: switch in Fig. 1 has been closed for long time. It opens at t=0. Please refer to the Fig. 1 for the…

A: time constant =inductance (L)equivalent resistance from inductor terminals(Req). first draw the…

Q: For the network shown below, determine the transfer function, G(s) = V(s)/V¡(s). Show the details of…

A:

Q: The parameters of a certain transmission line operating at ω = 6×108 rad/s are L = 0.35μH/m, C = 40…

A:

Q: =Use G (s) = CO R(a) 11 to find the response, c(t) to an input, r(t) = u(t), a unit step, assuming…

A:

Q: Please give the correct solution For the series-parallel arrangement shown in Figure, determine…

A: Given: Circuit diagram,

Q: A 10-pole 3-phase induction motor supplied from a 380V, 50 Hz supply. If slip is 4% calculate: The…

A: Given a 3-phase induction motor with, Total number of pole, P=10. Supplied voltage, V=380 V.…

Q: 21V Μ 4Ω Ο v = -0.6 V i = 3.2 A Ο v = -0.8 V i = 4.2 A Ο v = -0.8 Vi-3.2 A Ο v = -0.6 Vi=42A 3 Ω…

A:

Q: How 2/ For the circuit shown, determine the feet back topology and determine Avf Rif. Rof- Vcc ferso…

A: According to the questions we need to prove the given data in questions.

Q: Hello expert, I only need the output Id Is 102//1.2 +0.05 102 1/1·2+0.05+1.1 = 3

A: Given ratio of two currents Asked to simplify and provide final answer

Q: Q7) The current i(t) of Fig. 4 can be found as (mA): a) 12.5cos(500t - 0.107°) d) 12.5 cos(500t +…

A: Given, The circuit shown in figure 4 is shown below,

Q: Q8) The current through the-j10 2 can be found as (Arms) 8.752-19.65* c) 10.25290* f) 20253.26…

A: The required parameters can be calculated by using mesh analysis. The mesh equation can be obtained…

Q: QUESTION 7 What is the output "Q" if input A is False(0), B is False(0), and C is False(0)? A B C D…

A: Given logic circuit, TRUE→1.FALSE→0. A=0.B=0.C=0.

Q: Solve for lc of Figure 411 if RB 317 kohms, Rc-2.1 kohms and Vcc=16V. The answer should be in mA.…

A: We need to find out collector current for given circuit

Q: A resistor of 25 ohm is connected in series with a capacitor of 45μF. Calculate the impedance, and…

A:

Q: 9120° V V |A 5Ω ΤΩ 1.65 Ω j1.02 02 V 18 4Ω -15Ω

A:

Q: 1) If the switch is closed and the inductor acts as a short circuit, what will the new circuit look…

A:

Q: 9120° V V |A 5Ω ΤΩ 1.65 Ω j1.02 02 να 18 4Ω -15Ω

A:

Q: The product of (3 +4j)(1-2j) in polar form is

A: Given : Equation in rectangular form, F=3+j41-j2

Q: Q3/Chose the correct answer for the output Q3 of the following circuit ( Assume that A=…

A: Given: A = 001100 B = 111100 C = 001111 D = 000011 And a sequential circuit using SR, D and J-K flip…

Q: Calculate the area of the surface using the differential surface area dS: z = 4,2 <r < 5,0 << 90°…

A:

Q: A simple tuning circuit consists of a 100 µH inductance, a 200 pF capacitance, and a 20 Ω resistance…

A:

Q: Q4) By applying KCL to the node v/(t), the value of the voltage labeled v/(t) is (V): a) 2.86…

A: Solution 4.

Q: What can you say about the topic: PHILIPPINE ELECTRICAL CODE 1

A:

Q: C(0) Use G (8) = R(a) to find the response, c(t) to an input, r(t) = u(t), a unit step, assuming…

A: We need to find out response for given system

Q: Select the block diagram that correctly converts a Fahrenheit temperature to a Celsius one a.…

A:

Q: If D = (2y² + z)a¸ + 4xya, + xa₂ C/m², find (a) The volume charge density at (−1,0,3) (b) The flux…

A: The density of the charges at a certain location is referred to as the charge density. Charge per…

Q: PRACTICE EXERCISE 4.9 A charge distribution in free space has Pv otherwise. Determine E at r = 2 m…

A: Please comment if you need any clarification. If you find my answer useful please put thumbs up.…

Q: Combine three resistors 50, 4.5 and 30 in such a way that the total resistance of this combination…

A: Given: Three resistor value: R1=5 Ω.R2=4.5 Ω.R3=3 Ω.

Q: Q6/ prove that the olp of LT I Sys whose ip and unit Sample off response are given as follows: xinh…

A: Given data: xn=bnunhn=anun Formula of convolution sum. yn=∑k=-∞∞xkhn-k

Q: A lossless transmission line is 50 cm in length and operates at a frequency of 100 MHz. The line…

A:

Q: 12. A long-shunt, compound generator delivers a load current of 50 A at 500 V and the resistances of…

A: We need to find out the current and voltage for given generator

Q: A 40-km, 220-kV, 60-Hz three-phase overhead transmission line has a per-phase resistance of 0.15…

A: Transmission lines are essentially a component of an electrical system that transport electrical…

Q: Use G (s) = R(a) to find the response, c(t) to an input, r(t) = u(t), a unit step, assuming zero…

A: Given- Gs=CsRs=1s+5 Input , r(t) =u(t) Initial condition= zero To find response, c(t) =?

Q: A zero to 300 V voltmeter has an error of ±2% of the full-scale deflection. If the true voltage is…

A:

Q: Problem 5 For the following circuit, find the Thevenin equivalent resistance RTH looking into…

A: In the given circuit, there is a dependent source so the thevenin's equivalent resistance can be…

Q: 12 A 4.8 (2 m 1.92 (2 161, 80 15/02A 402 130 wwmm 20 -1452 Fig. 6 Fig.7 Q10) The average power…

A:

Q: Q1/To Design parallel adder to add 5 numbers (4-bit) must using 2(4-bit parallel adder)+ 2 (8-bit…

A: Parallel adder: The addition of two one-bit values plus an input carry is handled by a single…

Q: Using Ohm's Law and KCL, find the currents 11 through 15 for the circuit of Figure 1. V1 10V 15 R1…

A:

Q: 6. An integrated circuit has in one chip a NAND gate, a flip flop, a counter, and a shift register.…

A:

Q: A dc motor coupled to a large grinder develops 120 hp at aconstant speed of 700 r/min. The moment of…

A:

Q: A 3-phase star connected 1000 V alternator supplies power to 500 kW delta- connected induction…

A: It had been given that the alternator is star connected and the motor is delta connected. Line to…

Q: 4- If the signals x₁(t) = sin3t u(t), and x₂(t) = u(t), then the Laplace transform of [ 2 x₁(t)-0.7…

A: We need to find find out Laplace transform and Fourier transform of given signal

Q: A discrete-time signal x(n) is shown in Fig. Sketch and label carefully each of the following…

A: As per the policy of bartleby the provisions is to solve only 3 subparts of questions now I am…

Q: of Fig. 12 for the following questions (Q20 d) 15 V e) 24 V Q20) (0) can be found as: a)30 V b) 12.5…

A: We need to find out the voltage across capacitor

Q: The electrostatic field intensity E is derivable as the negative gradient of a scalar potential V.…

A:

Q: (2) Determine the power delivered to the amplifier. (a) 40 W (b) 60 W (c) 20 W (d) 50 W R www 15 V +…

A: Given:

Distribution System

The final stage in the delivery of the electric power is the electric power distribution system. From the transmission system to the individual customers it carries electricity. The distribution system is connected with the transmission system and is used to lower the voltage of the transmission to medium voltage in the range of 2 kV to 35 kV with the help of transformers. This medium voltage to the distribution transformers located near the customer's premises is carried by the primary distribution system lines. These distribution transformers in turn lower the voltage to utilization voltage used in lightings, household appliances, industrial equipments etc. Through secondary distribution lines often several customers are supplied from one transformer. It is through service drops, the commercial and residential customers are connected to the secondary distribution system lines. Customers who demand a larger amount of power can be connected directly to the primary distribution system level or the sub-transmission level.