Total number of stages of computation required to find 1024 point circular convolution using DFT method assuming that DFT is computed using DIT-FFT algorithm and also the length of the circular convolution is doubled is

Total number of stages of computation required to find 1024 point circular convolution using DFT method assuming that DFT is computed using DIT-FFT algorithm and also the length of the circular convolution is doubled is

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter6: Power Flows

Section: Chapter Questions

Problem 6.22P

See similar textbooks

Related questions

Q: Q5(a) Explain the Hebbian's Law. (b) Depict a diagram of a Hebbian learning in a neural network.

Q: 100 GLS)=- (S+1)(s+10) (s+50) PM=? GM =? Static Error Constant = ? %3D %3D

A: Given data: Gs=100s+1s+10s+50

Q: Using your knowledge of SSBSC, explain the advantage DSBSC has over conventional AM.

A: Sideband is the band of frequencies, which contains power, having higher and lower frequencies of…

Q: What are the methods used to reduce systematic errors? Explain them briefly

A: Systematic error - Systematic errors are errors that are not caused by chance but are caused by a…

Q: Consider the generalized block diagram of an PLL. For any two stages of the block diagram ,consider…

A: A phase locked loop (PLL) generates an output signal whose phase is related to the phase of an…

Q: Using the nonlinear programming (steepest decent) method, we want to estimate the parameters of an…

A: The solution to the above question has been provided with a proper explanation. By taking the…

Q: using convolution theorem determine the response of the mass spring system model

A: According to question: r(t)=1;0<t<2r(t)=0;otherwise∴r(t)=u(t)-u(t-2) First impulse response is…

Q: GLS)=- 100 (S+1)(s+10) (S+50 PM=? GM =? Static Error constant = %3D

A: According to question: a) The phase margin of the given system is calculated as…

Q: Represent the binary equivalent of 22 and 32 using by a creating 64-QAM constellation and pointing…

Q: 7. A communications system consists of n components, each of which will, independently. netion with…

A: Here it is asked to find out the probablity p with the informations given. Here binomial probablity…

Q: Q.2) What is the method of arbitration of the PCI bus? Modify the following diagram arbitration,…

A: In order to attenuate the latency of access, PCI's arbitration mechanism relies on access instead of…

Q: Which of the following comes under methods of multiple access techniques? * FDMA & TDMA SCPC & CDMA…

A: Choose the correct options Which of the following comes under method of multiple access technique.

Q: Q3. Consider, Multiplication problem of the contents of two arrays of size NxN using the a dual-core…

A: The content of two NXN arrays is to be multiplied, this can be thought of as multiplication of two…

Q: Answer the following questions i. What is address depletion problem in IP v4 ? ii. Due to what…

A: Answer are as follows

Q: Use ideal approximation

A: The solution can be achieved as follows.

Q: MMF method is called optimistic method as the regulation obtained is more than the actual value.…

A: To calculate the voltage regulation in synchronous machine without actual loading, we have many…

Q: Consider ROP APP which deals with all traffic and individual citizen and expat details and…

Q: Re-design the circuit of one of the LED segments of the 7-segment display that you designed…

Q: the differential length dl, find the length of each of

A: We can convert the cylindrical co-ordinate and spherical co-ordinates into Cartesian co-ordinate…

Q: With a neat block diagram representations discuss Cassade decomposition.

Q: Using whatever reference you have, find an application of a diac and explain the network behavior.…

Q: A.) McMurray commutation is superior compared to parallel capacitor commutation in respect of(a)…

A: Dear student as per our guidelines we are supposed to solve only one question.kindly repost other…

Q: Which of these use Capacitors and Latches from SRAM and DRAM for storage purpose? How long both can…

A: According to question:

Q: The expression of C1 for Schering bridge is given by

Q: ngineer (i) Sketch Nyquist plot for K(s+1) s2(s + 10) KG(s) %3D (ii) Determine stability range of K…

A: Solve the problem

Q: Ql) Fill in the blanks: 1- The acronym VHDL stands for, 2- FPGA consists of a matrix of…

A: fill in the blanks questions may have multiple answers The best suited answer need to be choosen…

Q: ERP is constructed with Moore's Law. Is Moore's Law still relevant today? A 6 What consequences do…

A: In 1965, about the time when the first commercial microprocessors hit the market, Gordon Moore…

Q: MMF method is called optimistic method as the regulation obtained is less than the actual value.…

A: MMF method us called as optimistic method as obtained regulation is less than actual value.

Q: Binary 4-bit Asynchronous down Cc explain how it functions, find real li applications

A: The answer as given below:

Q: 10- It is not required to do a data validation before proceeding with the empirical modelling…

A: Control systems are represented by transfer function. This can be written in both time domain and…

Q: Explain G codes for Linear interpolation, circular interpolation, active plane selection, and work…

A: There are two G codes used to specify direction. G02/G03 codes are modal • They will cancel an…

Q: Q2 With suitable example, explain the difference between the three Verilog modelling styles which…

A: Verilog- Verilog is a language intended for hardware modelling, with an emphasis on describing…

Q: (a) Formulate the objective function for the hot dog mixture in 1000-pound batches to determine…

A: When the process necessitates changes to the experiment that a standard design cannot support,…

Q: O Why the Ip-VD is not linear at low VD regime? Is this an intrinsic or extrinsic property? Is…

A: Solution- ID -VD is not linear at low VD regime because of intrinstic property of semiconductor ,…

Q: Write the VHDL code that will implement this function. Please respect the VHDL syntax and upload…

Q: 1 and (ii) generic loss where ii = 0 and Aij= A,. Will th %3D %3D

A: Look around to view all of the options- Reject the ones that are ascending. This is because taking…

Q: Total number of stages of computation required to find 64-point DFT using DIT-FFT algorithm assuming…

Q: Question 6: Which of these use Capacitors and Latches from SRAM and DRAM for storage purpose? How…

A: Explanation: SRAM makes use of transistor latches to keep the statistics. No refresh is required. It…

Q: Ql) Fill in the blanks: 1- The acronym VHDL stands for 2- FPGA consists of a matrix of…

A: 1. VHDL stands for Very High-Speed Integration Circuit HDL (Hardware Description Language) VHDL is…

Q: Quèstion 6 For the following circuit and using ideal model, if V, is logic0 and V, is logic 0, then…

A: For the following circuit Find the output voltage Vo Assume diode is zero.

Q: Explain load flow analysis of Radial distribution system by artificial neural networks with neat…

A: The load flow of distribution system is different from that of transmission system because it is…

Q: Evaluate and sketch the block diagram representation of the Direct Form I and II for the following…

A: Brief description: In the above given question they have mentioned a difference equation. For the…

Q: ۱۰ تعليقات ل لفئة Re-design the circuit of one of the LED segments of the 7-segment display that you…

Q: 2. Design an excess-3-to-BCD code converter with efficient implementation.

A: 2. The excess 3 to BCD code converter is found below: The logic diagram:

Q: Given the values of Routh hurwitz table find value of K when system is 1) stable range , 2)…

A: given here a RH table and asked to find the value of k for stable and instable and marginally…

Q: How to linearize a state-space representation

A: For the linearization of the state space representation, the linear equation can be written at first…

Q: Write a possible scenario that could be used to help design tests for the MHC-PMS case. Then create…

A: A possible scenario that could be used to help the design test for the MHC-PMS case for the given…

Q: The MLP must always be fully connected. Select one: True False

A: The MLP must always be fully connected This statement is true or false?

Concept explainers

Maximum power transfer theorem

A resistive load will consume maximum power from a network when the load resistance is equal to the resistance of the network as viewed from the open-circuit terminals, with all energy sources removed leaving only the internal resistances. Physicist Moritz von Jacobi introduced the maximum power transfer theorem in 1940. Therefore, this theorem is also known as Jacobi's law.

Question

Digital signal process subject , need quick amd correctly

Total number of stages of computation required to find 1024 point circular convolution using DFT
method assuming that DFT is computed using DIT-FFT algorithm and also the length of the
circular convolution is doubled is

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Explain the difference between cumulative- and differential-compounded connections.
Total number of stages of computation required to find 64-point DFT using DIT-FFT algorithm assuming that the length of DFT is doubled is.
For system 3, which graph shows the best linearity, time variance, and/or memoryless. Explain why. Graphs can be chosen more than once.
Show how we get the provided answers.
For the circuit (See image), complete the attached temporary diagram (Use the image). Explain your solution.Consider that the propagation times are negligible and that the setup and hold times are zero, so that the signals that change on the edge take the values defined immediately before the edge.
using convolution theorem determine the response of the mass spring system model
solve in less than 50 min pls, Notes ; pls solve by computer lines and should be clear.
Depict the result of this model structure solved on a block diagram.
In this chapter we have designed three different neural networks to distinguish between apples and oranges, based on three sensor measurements (shape, texture and weight). Suppose that we want to distinguish between bananas and pineapples:
How to linearize a state-space representation
The DRAM memory cell is a capacitor. If the cell area is 1μm2, with a 4 nm oxide as the capacitor dielectric, and the operating voltage is 2 V, calculate the number of electrons stored in the memory cell. .
Suppose we have 15 graphics cards and 4 servers. The graphics cards are all identical, but the servers are not and are numbered 1, 2, 3, 4. How many different ways can we allocate graphics cards to servers? Assume that a server can make use of any number of graphics cards, including 0.(Note: since servers are distinct but graphics cards are indistinguishable, moving a graphics card from server 1 to server 2 creates a new assignment, but swapping a graphics card in a given server with another identical graphics card doesn't.)