True or False 1. The point of connection of a motor for its electrical supply is called junction box. 2. The bearing placed in the shaft of the generator is included as stator part. 3. Basically, not all generators are AC generator at first, even DC generator 4. DC generator can be used as an emergency generator. 5. Circuit breakers are used in a motor circuit protection rather than fuses (safety switch).

True or False 1. The point of connection of a motor for its electrical supply is called junction box. 2. The bearing placed in the shaft of the generator is included as stator part. 3. Basically, not all generators are AC generator at first, even DC generator 4. DC generator can be used as an emergency generator. 5. Circuit breakers are used in a motor circuit protection rather than fuses (safety switch).

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter27: Service-entrance Equipment

Section: Chapter Questions

Problem 19R

See similar textbooks

Similar questions

What is the reason why the cable trays must be connected to the grounding sytem and all metal parts in power plant operation. Can you please expalain why it is cable trays ,ust be electrically and mechanically connected to the grounding system.
What is the 277-volt–single-phase–60-hertz system used for? Select one: A. RECEPTACLE BRANCH CIRCUITS B. LIGHTING BRANCH CIRCUITS C. MOTOR BRANCH CIRCUITS D. RESIDENTIAL BRANCH CIRCUITS
2. When working on a high - voltage system , it is best to keep anyone who is not part of the ser vice away from you and the car by creating a buffer zone around the car . Technician A makes sure the outside edges of the zone are at least one foot away from the car . Technician B places B orange cones to define the outer boundaries of the zone. Who is correct ?
What special tools, not ordinarily carried by an electrician, are required to align a directly coupled, motor-generator set
explain substation earthing with diagram
Conduits or raceways through which moisture may contact live parts shall be ---- at either or both ends (a)sealed (b)bushed ( c)a or b (d)plugged
The NEC requires that a ____________ means be provided for standby power systems. In the case of portable gen sets, this might be as simple as pulling out the plug on the extension cord that is plugged into the receptacle on the gen set. For permanently installed standby power generators, this might be on the gen set and/or separately provided inside or outside of the home.
4. Why are the outer metal parts of electrical appliances grounded?
Which of the following must be notified prior to equipment shutdown for repair? a. Director of facilities b. Electrical department c. Affected employees d. Environmental, Health and Safety Office
Draw the power circuit and control circuit of a Direct On Line Motor Starter fo a three-phase motor. Add 4 pilot lights (PL) in the control circuit; red PL for running forward, orange PL for running in reverse, green for not running and yellow for overload.1. List the components used. 2. Procedures.
All answers should be written in complete sentences. Calculations should be shown in detail, and Codereferences should be cited when appropriate. Unless otherwise stated, all conductors are copper type THHN, and the supply is AC. 1. What is the minimum conductor ampacity, overload protection, and dual-element fuserating for a circuit supplying a 560-volt, 3-phase, code J, 40°C, 125-horsepower motorwith a nameplate full-load current of 115 amperes?
Refer to the National Electrical Code or the working drawings when necessary. Whereapplicable, responses should be written in complete sentences.A 300-kilovolt-ampere transformer bank consisting of three 100-kilovolt-amperetransformers has a 3-phase, 480-volt delta primary and a 120/240-volt, 3-phase, 4-wiredelta-connected secondary.For problems 1 through 4 show calculations and/or source of information. 1. What is the proper rating of the fuses to install for overcurrent protection of thesecondary?2. What is the kilovolt-ampere of the bank if one of the transformers is removed?