TRY SOLVING THIS! A cable 5 km long has an inner core diameter of 1.25 cm an impregnated paper insulation of thickness 1.25 cm having a relative permittivity of 3.8. Find the capacitance of the cable. ANSWER: 0.962 microfarad

TRY SOLVING THIS! A cable 5 km long has an inner core diameter of 1.25 cm an impregnated paper insulation of thickness 1.25 cm having a relative permittivity of 3.8. Find the capacitance of the cable. ANSWER: 0.962 microfarad

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter19: Capacitors

Section: Chapter Questions

Problem 1PP: Fill in all the missing values. Refer to the formulas that follow. Resistance Capacitance Time...

See similar textbooks

Related questions

Q: 10.8 오

A: Given, We have a network with resistances. We have to find the equivalent resistance across node b a...

Q: IV Si GaAs 1 k2

A: Circuit diagram is given as,

Q: 4. Draw a circuit using a NAND gate of the following function: A) F = (x'yz' + x'z) (xz' + xyz) (x +...

A: Given two Boolean functions.we need to implement them using nand gates.

Q: 47 V 2 k 3 kl A- For the shown network determine the voltages: (1 a) Va, Vb, b) Vc, Vd, c) Vab, Vdc,...

A: In this question, We need to find the voltage as per given question? We know using the ohms law vo...

Q: 2. Use superposition to find vo.

Q: -d etermine Th voltage aPleRring acress trminals -2ifdic Voltage loovis applied aiross X-Yterminals!...

Q: 2. Single-phase 10 kVA, 480 V/120 V to supply a 120 V load from a 600 V source conventional transfor...

A: In this question, Single-phase 10 kVA, 480 V/120 V . It's convert into 600/120V transformer. We n...

Q: For what values of K is the DC gain of the closed-loop system less than 0.9 seconds? R(s) E(s) U(s) ...

Q: A 3-phase, controlled midpoint converter connected to 380 V rms line-to-line, 50 Hz ac source is ope...

Q: e diffusion coefficient (including units) for:

A: We know. Semiconductor- The materials which are not very conductive as conductor but not very poor c...

Q: 30 V R, ŽR10 R, R12 FR13 FR,4 Fig. 3.1 Table 3.5 Resistances of Fig. 3.1 25 Q R8 R9 50 Q R1 R2 50 Q ...

Q: For the following confinuous-time signal x(t) 2A + n(t - 3) a) Sketch and label the signal x(t) b) F...

Q: V1-Vs 4 V1 V1 = 0 Z3+Z4+Z5 Z1 Z2 V½-0.77 -j1.0067 V1 V1 1.5 x 103 -j4.9274+j128.1770+830

Q: Refer to the given circuit below. Determine the equivalent resistance across terminals a and d if R1...

A: The solution is given below

Q: X = 6 N Xc = 10 N ll + UL %3D R = 20 t UC + UR e = 70.7 sin 377t ZT

Q: voltage v(t) = 141.4 sin (314t+ 10°) is applied to a circuit and a steady current given by i(t)=14.4...

Q: Using the Schokley's equation a. Determine the thermal voltage for a diode at a temperature of 20°C...

A: a) Given data : Temperature T=200C Temperature in Kelvin will be equal to, T=20+273=303 K

Q: Two point charges of equal mass m, charge Q are suspended at a common point by two threads of neglig...

Q: Calculate the total charge present within the region -8 < p <7, -1.6n < p < 1.2t, -5 < z < 10, given...

Q: What is the net current

Q: 6. D CLR En

A: The T Flipflop is a toggle flipflop and its output toggles if the input is 1 else the output will no...

Q: Determine the capacitor voltage in Volts (V), power in milliwatts (mW), and stored energy in microjo...

A: In this question, At time t= 0 switch is open. Find the voltage across the capacitor and power and...

Q: 6. Draw a NAND circuit to implement the complement of the following function F(w,x,y,z) = E (0,1,2,3...

Q: Given the following vector:

Q: Point charges of -15 μC, 2 μC, and -21 μC are located at (-9, 5, -5), (-5, -6, -7), and (7,-5,-5) re...

Q: 4. A two-port network is shown below. 10 10 Determine the hybrid-parameter (h-parameter) representat...

Q: Find the approximate collector current in the given transistor circuit. (B = 10 +V8B = 10 V +Vcc = 1...

Q: 02. Find the transfer function, C(s) R(s). for the signal-flow graph in Figure (2). Gys Gls) Hs) Gs)...

A: In this question, A control system is given. Find the transfer function using the signal flow grap...

Q: Make a Common Emitter Amplifier with Voltage Divider Bias with:

Q: I2> や、 Is Res"

Q: PROBLE M 4.I Consider the circuit containing a nonlinear element N as shown in Figure 4.54. The -i r...

Q: 1. Determine v1 and v2 in the following circut 82 ww ЗА 12 V 40 ww

Q: Find the rectangular components of the vector H = 20a, - 10a, + 3a, at P(x = 5, y = 2, z = 1). Match...

A: The solution is given below Hy=22.283 Hx=-1.857 Hz=3

Q: C1 5nF R1 R2 12ko 12ΚΩ AMP SIMP C2 5nF V1 1Vpk OHz-10kHz 0° RA 30KQ RB :112kΩ ..... . ... . .... .

Q: By which of the following command, you can draw a ?rectangle in AutoCAD

Q: total impedance [ZT] in polar form,

A: Given-E= 100∠0o VR= 8 ohmXL=6 ohm

Q: A point charge Q1 = 46 nC is located at P1(1,-4, -5) while a charge Q2= 31 nC is located at P2(9, -5...

A: In this question, A point charge Q1 = 46 nC is located at P1(1,-4, -5) while a charge Q2= 31 nC is l...

Q: The characteristic equation of a control system is given as 1 + KG (s) H (s) = s +8s2 + 10s + K = 0,...

A: Given: Characterstic equation:1+KG(s)H(s)=s3+8s2+10s+K=0

Q: 11.30. A Y-connected load, with Z, = 10/-60° 2, Z, = 10/0° 2, and Z = 10/60° Q, is connected to a th...

A: In this question 11.30, Unbalanced Star connected load supplied from the balance three phase CBA sou...

Q: . When using superposition, what is the ideal internal resistance of a voltage source? The Thevenin ...

A: De activated sources can be replaced by their internal resistances in super position theorem.

Q: 3. If all initial conditions of the networks of Figure P1.3 are zero, find v(t), t 2 0. 12 8 10 (a) ...

Q: A 50 Hz, 250 V single phase power line has the following loads placed across it in parallel; 4 kW at...

A: Given Single phase 50 Hz,250 v power line Three parallel loadsLoad-1P1=4 kwPF1=0.8 laggingLoad-...

Q: What is the value of the resistor that must be linked in parallel with the 6 k resistor? To limit th...

Q: By which of the following command, you can draw a ?rectangle in AutoCAD POL O ARC

A: AutoCAD is a software which is used to design different circuits it is used in designing of electric...

Q: Give three common electrical devices at home. For each device, give three important safety precautio...

A: Nowadays,with evolution of power electronic and Integrated circuits, The use of electrical devices i...

Q: A cylinder whose radius is 2cm and altitude of 100cm is uniformly wound with 2500 turns of wires in ...

A: The solution is given below

Q: Given the following delta-connected resistances: Rab = 10 Ω, Rbc = 9 Ω, and Rca = 4 Ω, calculate the...

Q: A 120 V shunt motor has an armature equivalent of 0.5 ohm and a field resistance of 60 ohm. At full ...

A: Given data, Armature resistance Ra=0.5 Ω Field resistance Rf=60 Ω Terminal voltage V = 120 V Load cu...

Q: QUESTION 8 • A simple Zener diode voltage regulator is under design. De design constraints are: Supp...

A: Brief description : In the above given question they want to know the designing of a regulator resis...

Q: One branch A of a parallel circuit consists of a 60-µF capacitor. The other branch B consists of a 3...

A: Kirchoff's law and ohms law are the two important tools to analyze the electrical circuits. Accordin...

Question

100%

Please answer it in 30 mins.

Show soln neat and complete. Thank you

Capacitance

TRY SOLVING THIS!
A cable 5 km long has an inner core diameter of 1.25
cm an impregnated paper insulation of thickness 1.25
cm having a relative permittivity of 3.8. Find the
capacitance of the cable.
ANSWER: 0.962 microfarad

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
Inductive Circuits Fill in all the missing values. Refer to the following formulas: XL=2fLL=XL2ff=XL2L Inductance (H) Frequency (Hz) Inductive Reactance ( ) 1.2 60 0.085 213.628 1000 4712.389 0.65 600 3.6 678.584 25 411.459 0.5 60 0.85 6408.849 20 201.062 0.45 400 4.8 2412.743 1000 40.841
Find the numerical value of the capacitance per unit length of two long parallel wires (both parallel to the x axis in the xy plane), each with radius 1 mm, with their centers separated by 4 mm. Express your answer in picofarads per meter. You may assume the wires are perfect conductors.
A cylinder whose radius is 2cm and altitude of 100cm is uniformly wound with 2500 turns of wires in a single layer. A second layer of 100 turns and of much finer wires is wound over the first near its center. Calculate the mutual inductance of the coils.
a) Compute the capacitance of a parallel-plate capacitor with plates 10 cm by 20 cm and separation of 5 mm if the dielectric are (i) an air dielectric, (ii) a ceramic dielectric with permittivity of 7500
Two coaxial conducting cylinders of radius 2 cm and 8 cm have a length of 1.42m. The region between the cylinders contains a layer of dielectric from ρ = 3 to ρ = 7 with εR = 14. Find the capacitance in pF.
A parallel plate capacitor has a plate separation of 1 mm and a capacitance of 1.5 microF. Find the area of the plates. Also calculate the area if there was a dielectric insulator inserted between the plates with a dielectric constant of k = 2.
A ceramic capacitor is to be constructed to have a capacitance of 0.01µF and to have a steady working potential of 2.5 kV maximum. Allowing a safe value of field stress of 10 MV/m, determine (a) the required thickness of the ceramic dielectric, (b) the area of plate required if the relative permittivity of the ceramic is 10, and (c) the maximum energy stored by the capacitor.
A large capacitance of 1.58 mF is needed for a certain application. (a) Calculate the area the parallel plates of such a capacitor must have if they are separated by 4.19 µm of Teflon, which has a dielectric constant of 2.1. (b) What is the maximum voltage that can be applied if the dielectric strength for Teflon is 60 ✕ 106 V/m (c) Find the maximum charge that can be stored. (d) Calculate the volume of Teflon alone in the capacitor. (units: m^3)
A current of 2 uA is discharged on a capacitor with a plate area of 100 cm² and a capacitance of 1x10-^7F at t=0, and find the displacement current intensity (uA) between the plates at t=0.
The distance between the plates of a capacitor, which consists of a square plate with a side length of 3 cm, is 2mm. The dielectric coefficient of the insulator is 2. If the maximum electric field that the air can withstand is 2.10 ⁶ V / m, find the maximum load the capacitor can carry.
1. A parallel plate capacitor has the following characteristics:the dielectric is air, k = 1spacing between plates d = 1.50cmPlate area A = 25cm2potential between plates V = 250V.The capacitor is immersed in distilled water. Assume that the liquid is a dielectric.(a) Determine the load on the plates before and after the dive.(b) Determine the capacitance and the potential difference after immersion.(c) What is the change in energy?