Twelve-hectares farm is to be planted with rice by broadcasting. The owner of the farm wishes that his farm could be finished within one day (8 hrs per day). How many people would be required to do the job?

Twelve-hectares farm is to be planted with rice by broadcasting. The owner of the farm wishes that his farm could be finished within one day (8 hrs per day). How many people would be required to do the job?

Fundamentals Of Construction Estimating

4th Edition

ISBN:9781337399395

Author:Pratt, David J.

Publisher:Pratt, David J.

Chapter14: Pricing General Expenses

Section: Chapter Questions

Problem 3RQ

See similar textbooks

Related questions

Q: Determine the maximum upward reaction at E in kN a= 45 kN (concentrated load) b= 50 kN/m (uniformly…

A: Given data: wL=50 kN/mwd=23 kN/mP=45 kN

Q: 2. On a map with a scale of 1 cm = 290 m, the measured length of a concrete fence is 0.33 m.…

Q: what is the change in the pipe pressure (kPa)

A: ###Determination of change in pressure in pipe ###

Q: For the concrete dam shown, calculate the factor of safety against overturning and sliding. Use…

Q: Compute both the design strength for LRFD and the allowable strength for ASD. 1. L = 15 ft 2. L = 20…

Q: Illustrate and calculate the shear and moment diagram of the frame. 5m B A 10 kN/m 6m 3m A 25kN

Q: Hi, i was wonderwing why with the normal stress at B the moment Mx * Cy is minus. can you explain…

A: From figure given below it is clear that the direction of moment about x-axis (Mx) and y-axis (My)…

Q: given in Time 1-h Unit Hydrograph (h) 1.00 2.00 3.00 4.00 For the derived unit hydrograph, determine…

A: As per guidelines we need to answer only first 3 subparts of questions so please repost rest…

Q: 60cm Waw A 23cm 6- 16cm SG=08 20cm 20cm SG= 13.6 SG=136 Given heights: 60cm, 23cm, 16cm, h, 20cm, 20…

Q: Illustrate and calculate the shear and moment diagram of the beam. Indicate values at all change of…

Q: Streamlines 1Q. A flow field is defined by V = {8y i +6x j} m/s, where x and y are in meters.…

Q: Compute the maximum moment of the beam. a. 690 kN.m b. 860 kN.m c. 960 kN.m d. 890 kN.m

A: Given: w = 1500 N/m Required: Maximum moment in the beam

Q: 3Q. As a fluid flows through the fixed curved conduit in the figure shown, the velocity of particles…

A: Given: V = 0.4 S² e-0.04t to find: Acceleration magnitude if S =0.6m,t=1s, r = 0.5 m

Q: II. Determine the external reactions in the following determinate structures: Problem 1: 215.36 N…

Q: From the frame loaded as shown. Solve the following if P = 15 P kN/m D 2P kN/m -8 m B H E 3P kN/m…

Q: 1. A 10-cm-diameter siphon tube is used to empty the reservoir and discharge it into the air (Figure…

A: A tube of diameter 10 cm and length of 20m is used to empty a reservoir. Head loss from intake to…

Q: Describe mathematically how the rate of change of the canopy storage of water may be estimated.

A: Solution Net rainfall reaching the ground surface after the interception losses plays an important…

Q: What is the support reaction VG from the following figure?

A: Brief introduction : The given question is related with solid mechanics . In this question we have…

Q: i) What is the height of the concrete stress block if the area of steel is 3 in², concrete strength…

Q: P = 10 Utilize Portl method 1.5P KN PKN-> 1.5 m, GH -3 m E 1.5 m, IC B 2 m 6 m

A: To find force in member EF

Q: Problem no. 2. Compute MD 1m 15 kN/m 4.2m B 5m 6m 3m 6 kN/m

A: Given: A simply supported beam Required: Moment diagram

Q: Consider the beam shown in (Figure 1). Suppose that 12 kN/m. Figure B ܝܐ 60⁰ 6 m W 1 of 1 60 kN-m

Q: A circular raft foundation of 20 m diameter and 1.6m thick is provided for a tank that applies a…

A: Given- Diameter of raft d=B=20 m, Thickness t=1.6 m, Bearing pressure q=110 kPa, Young modulus E=30…

Q: Determine the pressure difference ?????? ?????−???? ?????= ?(kPa) between the two pipelines.

Q: Utilize Portl method 1.5P KN F PKN-> A 1.5 m, GH -3 m E 1.5 m IC

A: To find moment about point A

Q: A carpenter holds a 11-lb 2-in. by 4-in. board as shown. If he exerts vertical forces on the board,…

A: A carpenter holds a board as shown in the figure and it has been asked in the question to determine…

Q: PROBLEM 2: An L-shape bracket shown on Figure SRB 002 is fixed at point O with an applied force of…

Q: change in the sides?

Q: A gallon of water weighs 8.34 pounds. The Stean family has a round, 12-foot diameter, above -ground…

Q: The volume of irrigation water is usually expressed in acre-feet. One acre-foot is a volume of water…

A: Given: Storage capacity = 3.54 x 106 acre feet 640 acre = 1 mi2 1 acre = 43560 ft2

Q: At two points '1' and '2' in a pipeline, the velocities of fluid are v and 3v respectively. Both…

A: Bernoulli's theorem : According to Bernoulli's theorem, if the fluid flows horizontally with no…

Q: The distance scaled on a 1:9,500 map between two adjacent contours is 37mm. Determine the slope of…

Q: zero error and reading error in relation to measuremen

A: One scale reading's estimated inaccuracy can be calculated as being equal to half of the scale's…

Q: An expansion in horizontal rectangular Fakes place from a width of 2m to 3m. Depth of flow 7.2…

A: Answer We are given inlet width b1 = 2 m outlet width b2 = 3m Discharge Q = 7.2 m3/sec inlet depth…

Q: Compute and draw the Shear and Moment Diagram. Compute the maximum moment.

Q: How much total reinforced concrete weight does Beam A support considering its self-weight and the…

Q: AIR WATER M₂₂ OIL 2 2 MERCURY

Q: An effective rainfall of 2 hour duration produced a flood hydrograph peak of 200 m³/s. The flood…

Q: 4) For the given body with a couple acting on it, determine the couple moment using the following…

Q: Given the following data: Typical Classroom. Dimensions: 24 x 30 x 12ft. Required footcandles = 70.…

A: Room dimensions 24 *30*12 ft Working plane = 30 in = 2.5ft To determine room cavity ratio.

Q: Solve the following and submit with the same format of this module, A4 size: 1. Determine the…

A: For W 10x 33 The radius of gyration, r = 1.94 in Gross area, Ag = 9.71 in2 For A992 steel Minimum…

Q: Define Ultimate Strength Design Method (APA citation). Discuss how USD helps the computation for a…

A: The ultimate strength design Method explains how to analyze a structure's design while taking its…

Q: Find the cross section of concrete and area of steel required for a simply supported rectangular…

A: Design of beam is done as per ACI code

Q: A circular raft foundation of 20 m diameter and 1.6m thick is provided for a tank that applies a…

A: Calculate the elastic settlement of foundation??

Q: Note: Read the question carefully and give me BOTH right solutions with clear calculations.…

A: Given data: Arrival rate λ(t) 7 AM to 8 AM = 5 vehicles per minute Service rate (7:15 AM to 7:45…

Q: 30. Determine the available strength of an L6x4×3/4 attached through the long leg to a gusset plate…

Q: Problem. 2, A soil has void ratio = 0.72, moisture content = 12% and G₂= 2.72. its Determine

Q: A 6-hour Unit Hydrograph (UH) of a catchment is triangular in shape with a total time base of 36…

Q: Problem 3: 4 kips/ft Determine the following: a. The reaction at support A, R = b. The reaction at…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Solve this urgently..
Need by 1 hour
A person travels to work in the morning and returns home in the evening. How many productionsand attractions are generated in the work and residence zones?
A ventilating system is to be installed in a building. It will require 400 hours ofwork to install it. Each worker takes a total of 1⁄2 hour to get tools out in themorning and put them away at night. Each worker also takes a total of 1⁄4 hourto get to the workplace and back again each day. Workers are also given a1⁄4-hour break in the morning and another in the afternoon. a. For an 8-hour workday, how much time is actually spent installing theventilating system?
43. Taxpayers with an office in their home may deduct a percentage of their home-related expenses. This percentage is based on the ratio of the office’s area to the area of the home. A taxpayer with a 2200-square-foot home maintains a 22-foot by 24-foot office. If the yearly electricity bills for the home come to 4010, how much of this is deductible? Express your answer in 2 decimal places.
At 7.8%, a bridge cost P220M with a life of 18 years. The bridge must be partially rebuilt at a cost if P90M at the end of each 18 years. Calculate the capitalized cost if an annual maintenance of P590,000 is required.
For the project in Problem 10.7,sketch the $/cy vs, trucks curve(±2truck) if each excavator operates at $110/hr and each truck operates at＄70/hr.For example, if you select 6 trucks, develop data points and acurve for 4,5,6,7,and 8 trucks
You have a run of overhead irrigation pipe that has 20 sprinkler heads in a 600-foot row (oneevery 30’). The effective wetting width of the run is 40 feet. If each sprinkler delivers 3 gallonsper minute, approximately how many minutes will it take to apply ½ inch of water to theirrigated area?a. 125 minutesb. 250 minutesc. 374 minutesd. 500 minutes
How economic development can impact trip generation? Sketch the relationship between them
Hand written plzzzzz asap..i'll give you more votes if you solve 30-40 mins...
In a 200-hectare corn project, the field has to be tilled in 30 days. What size of heavyduty offset-disk harrow should be selected if the tractor to be used operates at 5 kph. Assume a 75% field efficiency and an 8-hour working day Do not round off during computation, do not round your final answer, write all the decimals. Use 745.7 ?/ ℎ? and G = 9.806 ?/?2
Calculate diameter in m. of a cylindrical water tank for a subdivision that has 500 lots if fully occupied. Assume 6 persons per household and water consumption rate of 250 lpcd. Add water volume for fire demand which is 25% of the average day demand. The height of the cylindrical water tank to is 10 meters.