Two Alternators are operating in parallel supplying a common load of 4250KW at 85% power factor lagging. Alternator A contributes 600KVAR at 92% power factor lagging, determine the : a. KVA and power factor of the load b. KVA and power factor of alternator B.

Two Alternators are operating in parallel supplying a common load of 4250KW at 85% power factor lagging. Alternator A contributes 600KVAR at 92% power factor lagging, determine the : a. KVA and power factor of the load b. KVA and power factor of alternator B.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.26P: A small manufacturing plant is located 2 km down a transmission line, which has a series reactance...

See similar textbooks

Related questions

Q: 1. Calculate the voltage output by the secondary winding of a transformer if the primary voltage is ...

Q: A module consisting of 2 parallel strings of 20 series-connected squared solar cells (cell length 12...

A: Since you have posted a question with multiple sub-parts, we will solve the first three subparts for...

Q: 0,(s) 1. Find the transfer G(s) = T(s) for the rotational mechanical system shown below 1000 N-m-s/r...

Q: 4Ω J5 Ω =-j2 Q Find the total power factor.

A: We need to find out the power factor for the given circuit

Q: Problem 4. Find the total current IT. 1.5k2 IT 2.5k2 2k2 120V 1.2k2 1kQ 1kN 2k2

A: We have given the following problem

Q: Find the value of vo in the circuit below 5 ΚΩ 4 k2 2 k2 Do 3 V(+ 9 V+ 6 k2 4 k2

Q: . For a signal x(n)=[2,4,6,8,10,12,14,16] defined for n=0to7, evaluate the Fast Fourier Transform us...

A: given signal xn=2,4,6,8,10,12,14,16for n=0 to 7

Q: For the three stage system with an input power Pin = -20 dbm and a power gains of the three stages a...

Q: +15V R4 560 Q R1 1ka R3 9100 VZR: 3V R2 3 2ka - 8V

A: The solution is given below.

Q: A tuned circuits of the oscillator in an AM transmitter used a 50 micro Henry coil and a 1 nano Fara...

A: We are authorized to answer one question at a time since you have not mentioned which question you a...

Q: 2) The following circuit has a problem. Switch #1 is able to control lamp #1, but lamp #2 never come...

A: Given: Lamp 1 in series with switch 1 and Lamp 2 with in series with switch 2.

Q: If the measured frequency response of an unknown system is constant (40 dB) for all frequencies out ...

A: Given that frequency response has constant magnitude of 40dB for all frequencies greater than 200 ra...

Q: The circuit in the figure below has been connected for a long time. Let R, = 8.80 Q and R, = 3.80 Q....

Q: 2 kn +) 6 V 1 kn 2 mA 4 mA 12 V 2 kN 31 kN 1 kn 31 kn Vo ww

A: The solution is given below

Q: aplace transform of the initial and final values of the current i0(t) in the circuit in Figure 2. ...

A: Solution- For t = 0-, For this condition, the system is for long time with supply of 4A only. Ca...

Q: R3 180kQ R1 R2 5.5kQ 10KQ R4 2kQ

Q: If the total resistance is Rt = 120.16 kilo Ohms in the given circuit then what is the value of resi...

Q: What is it that we need to understand about electrical engineering?

A: Engineering- Engineering is making nature/the physical world behave the way you want it to behave by...

Q: 1. For the network of Figure below: a. Calculate 57 (Here, 7 = time constant of RC circuit = RC) b. ...

A: The given circuit is shown below:

Q: а. Consider signal: : x, (+) .. -10 (a) Suppose that the signal #1(t) is the input to an LTI system ...

A: As per our guidelines we are supposed to answer only first question. Kindly repost the other questio...

Q: V R1 R2 R3 1kO 5k2 3k0 5.0V

Q: 20. Eight holiday lights are connected in parallel as shown in Fig. 6.89. a. If the set is connected...

A: Note: As per the rules we can answer only 3 sub-parts, please post the remaining sub-parts as the se...

Q: 3. Find the following in the circuit below; a. Total Resistance b. Total Current c. Total Power d. C...

Q: The reactance of 10 mH inductor and a 0.2 uF capacitor are equal when the frequency is: 21 kHz 7.12 ...

A: Given: Inductor, L=10 mH Capacitor, C=0.2 μF Reactance of inductor and capacitor are equal.

Q: Si Ge 3. Vp and In E 10V 2.4KO VR (a)

A: In this question, determine the current and voltage Vd . Assume forward bias voltage of Si type = ...

Q: reee Vict) QH 1 Find te sansfer funciun V(S) using Vics) nodal method.

Q: How do you know if a single stage and a second stage amplifer is considered to be an IF amplifier ju...

A: Single stage In Single stage IF amplifier There is only one transistor. there is only one L and C ...

Q: Rf 120 K2 Rin Vin 20 K2 out Figure 1: inverting op-amp

Q: Given A= (3x +y³)a_ + (x – y*)a,, find V · A.

Q: A 15Kz music signal is applied to an AM modulator of the SSB (Single Side Band) type, so the bandwid...

A: SSB modulation, or single sideband modulation, is a derivation of amplitude modulation, or AM. It is...

Q: Assume you want to decode the binary number 0011 with an active high output decoder. The missing gac...

A: Given circuit, Input is 0011 A3=0A2=0A1=1A0=1

Q: A moving iron voltmeter of 100 V is intended for 50 Hz and it has a resistance of 4 kN. Find the ser...

Q: 11 R5 (A1) 5600 11 R2 R3 2200 3300 R4 4700 V1 R1 1000 12 13 -25V A2) A3 12 13

Q: 2. Evaluate *2) dx by Gauss three-point formula. o 1+(x+1)*

Q: In a pulse code modulation system, a message signal m(t) = 3.6cos(2n × 7.6 × 10°t) is sampled at Nyq...

A: Given, Message signal, mt=3.6 cos2π×7.6×103t Number of bit, N =7

Q: 1ka R1 560 a R2 E12 V Ge

Q: The temperature coefficient of resistivity of carbon is -0.0005/C°. If the resistor is made of graph...

Q: Based on your own understanding, differentiate the five (5) types of Magnetic Motor Starter in a min...

A: There are five main types of magnetic motor starters that are used based on the requirements of the...

Q: A 200 kVA transformer has a primary winding resistance of 0.292 and a secondary winding resistance o...

A: Given that Primary votage =2kV=2000vsecondary voltage=200vprimary resistance=0.292Ωsecondary resist...

Q: Please solve max in 20-30 minutes im very needed and no reject thank u If V1=105 V what is the valu...

Q: Given: Y (A,B,C,D) = B'D +A'D +BD. Write the simplified sum of minterm expression.

Q: If V, = 8 V and V2 = 13 V, determine the voltage Vx across the 1 A source. Express your answer in vo...

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source, eithe...

Q: R= 50 2 I= ??? V– 24V.

Q: List twenty farming operations requiring electrical power. Discuss the advantages and disadvantages ...

A: Electricity- Flow of electrons from region of high concentration (aka high potential or high voltage...

Q: What is the principle behind the working of a capacitance-based level sensor? Compare this type of s...

A: A level sensor is a device that monitors, maintains, and measures the level of liquid (and sometimes...

Q: >The band gap of Germanium is 7.32eV at room temperature. Find the maximum wavelength of excitation ...

A: We have given the following problem

Q: A lamp of 500cd is placed at the center of a room, 20m * 10m * 5m. Calculate the illumination oon ea...

A: Illumination: It is the process of making it brighter or clear. It is the ratio of flux per area.

Q: Design a Half adder, Full adder, Half Subtractor and Full Subtractor.

Q: Consider three resistors in the figure: R1 = 29.270, R2 = 33.090, R3 = 42.972 and R4 = 3.60. What is...

A: The solution is given below

Q: Rs Di Ish im ас DzA Rsh Rm Input Rectifier Type of Voltmeter

A: -The given circuit is half wave rectifier circuit. - the given meter is Ameter and it is converted t...

Concept explainers

Synchronous Generator

In comparison to an asynchronous generator, it is a machine where the rotor speed is equal to the rotating magnetic field produced by the stator, i.e., mechanical speed is equal to the electrical speed, thus called synchronous, and not asynchronous.

Salient Pole Rotor

Salient pole rotor includes a large number of exposed poles mounted on a magnetic wheel. The construction of a bright pole is as shown in the image on the left. The proposed poles are made of metal laminations. The rotor winding is provided on these poles and is supported by pole shoes.

Question

Two Alternators are operating in parallel supplying a common load of 4250KW at 85%
power factor lagging. Alternator A contributes 600KVAR at 92% power factor lagging,
determine the :
a. KVA and power factor of the load
b. KVA and power factor of alternator B.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step by step

Solved in 5 steps with 5 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

While the instantaneous electric power delivered by a single-phase generator under balanced steady-state conditions is a function of time havi ng two components of a constant and a double-frequency sinusoid, the total instantaneous electric power delivered by a three-phase generator under balanced steady-state conditions is a constant. (a) True (b) False
In the above figure, a single line model of a three-phase power system is given. Base power 50MVA, base voltage 13.8kV according to its value, a) Per-unit values of power system circuit elements according to the given base power and base voltage values. calculate. b) The perunit you calculate by drawing the equivalent impedance circuit for one phase of the power system given in the figure. show on the values.
A 6,600V, 1,200 kVA, 3-phase alternator is delivering full load at 0.80 power factor lagging. Its reactance is 25% and resistance is negligible. By changing its excitation, the emf is increased by 30%. At this load, determine the new current and power factor. Draw the single line diagram.
An a electric power system A 200 MW unit with 0.05 pu turbine operates in parallel with a 400 MW unit of identical turbine regulation. For a specified amount of power demand in crease, find the ratio of sharing of the Load by the units, system frequency is 50Hz .
Two generating stations A and B have the capacities 500MW and 800MW respectively are interconnected by a short line. The percentage speed regulations from no load to full load of the two stations are 2 and 3 respectively. Find the power generation at each station and power transfer through the line if the load on bus of each station in 200MW.
n 3-phase alternator, the change of terminal voltage from no load to full load is more in case of leading power factor as compared to unity power factor. Select one: True False
The annual load duration curve of a power supply system may be considered as straight line from 40 MW to 8 MW. The load factor of the system is ?
A single phase, unity power factor load takes 90 Amps at 10 kV. Using a base voltage of 65 kV and base kilovolt amperes of 4475 kVA. Find the base current, base impedance, base power, per unit current and per unit voltage of the load.
An 11 kV, three-phase, star-connected alternator has a synchronous impedance of10∟80° Ω/phase and operates at unity power factor on infinite bus bars. It supplies acurrent of 300 A by using a general load diagram. Determine: the full-load current for normal excitation ( motor mode), the current and power factor for 100% excitation on 25% overload (generatormode), the maximum power that the machine can develop in the generator mode for50% excitation
A generating station has a maximum demand of 20MW,a load factor of 60%, a plant capacity factor of 48%, and a plant use factor of 80%. Determine the reserve capacity of the plant.
Power Transmission and Distribution Discuss the advantages and disadvantages of single-phase and three-phase system
Two alternators rated 400 MW and 600 MW are operating in parallel. The droopcharacteristics of their governors are 3% and 4% respectively from no loadto full load. Assuming that the alternators are operating at 50 Hz at noload, how would a load of 1000 MW be shared between them? What will be thesystem frequency at this load?