Two cylindrical specimens A and B of the same soil, of 50 and 75 mm diameter, respectively, are subjected to a constant head flow in an experimental setup shown in Fig. Water flowing through the specimens was collected in a bucket for measuring the flow rate, where 340 g of water was collected in 10 min. Find the hydraulic conductivity of the soil specimens.

Two cylindrical specimens A and B of the same soil, of 50 and 75 mm diameter, respectively, are subjected to a constant head flow in an experimental setup shown in Fig. Water flowing through the specimens was collected in a bucket for measuring the flow rate, where 340 g of water was collected in 10 min. Find the hydraulic conductivity of the soil specimens.

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter6: Hydraulic Conductivity

Section: Chapter Questions

Problem 6.6P

See similar textbooks

Similar questions

A sample of sand, 5 cm in diameter and 15 cm long, was prepared at a porosity of 60% in a constant-head apparatus. The total head was kept constant at 30 cm and the amount of water collected in 5 seconds was 40 cm^3. The test temperature was 20 deg C. Calculate the hydraulic conductivity. Provide a diagram a.5.0 x 10^-2 b.3.47 x 10^-2 c.2.0 x 10^-1 d.6.7 x 10^-1
3.) A SAMPLE IN A VARIABLE HEAD PERMEAMETER IS 8CM IN DIAMETERAND 100K HIGH. THE PERMEABILITY OF THE SAMPLE IS ESTIMATED TO BE 10X10 4 CM/S. IP IT IS DESIRED THAT THE HEAD IN THE STAND PIPE SHOULD FALL FROM 2,4cm To SRE OF THE SIZE OF THE STANDPIPE IN mm 12 cm IN 3min., DETERMINE THE
The lab apparatus shown in the figure maintains a constant head in both the upper and lower reservoirs. The soil sample is a silty sand, placed in a 200mm diameter container, having a specific gravity of 2.70 with a hydraulic conductivity k-0.1945 cm/sec. The moisture content of soil is 18.5% and the degree of saturation is 100%. The relationship between the specific gravity. moisture content, degree of saturation, and void ratio is given below: SGw- Se The level of water from the datum in the inlet and outlet portion is 460mm and 240mm respectively. Calculate for the discharge of wwater in cubic cm per sec if distance d is 100mm and distance Lis 220mm NLET OUTLET of red water DATUM Sol Sample
The permeameter in a perrneability test setup involves a soil sample 200 mm diameter and a length of 30 mm. The height of water is kept constant at 400 mm. In a duration of 4 min, water was collected in the graduated flask having a volume of 420 cu. cm. Determine the following. Flow Rate Hydraulic gradient Hydraulic conductivity
A sample in a variable head permeameter is 8 cm in diameter and 10 cm high.The permeability of the sample is estimated to be 10 × 10^–4 cm/s. If it is desired that the headin the stand pipe should fall from 24 cm to 12 cm in 3 min., determine the size of the standpipe in cm which should be used. a.1.29 b.5.43 c.3.67 d.4.19
A cylindrical soil sample 50 mm in diameter and 200 mm in height is used as thepermeameter in a falling head permeability test setup. In one minute of observation, thehydraulic head in the 10 mm diameter standpipe through which test water went reducedfrom 900mm to 500 mm. During that time, 1.5 liters of water were collected in the graduate. Calculate the soil sample's permeability coefficient in cm/s.
A constant-head test was conducted on a sample of soil 15 cm long and 60 cm^2 in cross-sectional area. The quantity of water collected was 50 cm^3 in 20 seconds under a head difference of 24 cm. Calculate the hydraulic conductivity in cm/s. a.1.0 x 10^-1 b.4.3 x 10^-3 c.2.6 x 10^-6 d.3.47 x 10^-2
In a constant head permeability test, a sample of soil 12cm long and 6cm in diameter discharged 1.8 x10^-3m^3 of water in 15 minutes. The head difference in two piezometers A and B located at 1cm and 11cm, respectively, from the bottom of the sample is 2cm A.Determune the hydraulic conductivity of the soil in cm/s Choices: 0.32,0.40,0.35,0.34 B.Calculate the discharge velocity in mm/s Choices: 0.79,0.68,0.71,0.64 C. How long will it take in minutes for the test to collect 3L of water Choices: 22.29,25,26.15,27.69
In a constant-head permeability test, a 60 cm3 of water was collected in 25 seconds with a head difference of “H” cm in a soil sample that has a diameter of 8 cm and length of 12 cm. Calculate the hydraulic conductivity. If the sample has a porosity of 60%, determine the average velocity and seepage velocity. Estimate the coefficient of permeability of a soil similar to the sample with a porosity of 45% from the results of this test.
A constant-head test was conducted on a sample of soil 15 cm long and 60 cm^2 in cross-sectional area. The quantity of water collected was 50 cm^3 in 20 seconds under a head difference of 24 cm. Calculate the hydraulic conductivity in cm/s. a.1.0 x 10^-1 b.4.3 x 10^-3 c.2.6 x 10^-6 d.3.47 x 10^-2 WITH FBD
Two cylindrical specimens A and B of the same soil, of 50 mm and 75 mm diameter respectively, are subjected to a constant head flow in an experimental setup shown in Fig. Q1-a. Water flowing through the specimens was collected in a bucket for measuring the flow rate, where 340 g of water was collected in 10 minutes. Find the permeability of the soil specimens. 50 A 100 150 B All dimensions in mm 150
A constant head permeameter, 85 mm in diameter containing fine sand sample 450 mm long, allowed water to flow at a rate of 184 mL/min under steady flow conditions. Given the difference in head between two points 240 mm apart was 375 mm, determine the coefficient of permeability in mm/s. When the same sample size is tested in a falling head apparatus using a stand-pipe of 32.5 mm diameter, calculate the time required for the water in the stand-pipe to drop from 1750 mm to 1000 mm above the outflow level.