Q7B/ Answer on 'One' or 'Two'One - If an electrical network has three energy-storage elements, is it possibleto have a state-space representation with more than three state variables.Explain.Two- Explain what is the difference and commonality between the transferfunction and the state space.

This question is related to control systems

Answered: Two- Explain what is the difference and…

Engineering

Electrical Engineering

Two- Explain what is the difference and commonality between the transfer function and the state space.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: List and briefly explain the three (3) control strategies used in AC variable speed motors

A: There are various through which we can control speed of AC can be achieved. The speed adjustment…

Q: Refer to the given circuit below. Determine the Thevenin Equivalent EMF if R3 is to be analyzed.

A: To determine the Thevenin's equivalent EMF considering R3 as load element

Q: 1. For the common-base network, determine the following: (a) Rc (b) Is (c) Ig (d) VBC (e) VCE 14 V…

Q: Write the logical equation of the CMOS circuit shown below: * +2.5 V 3 PMOS switch network Y 2 BOMB…

A: Given

Q: Solve the collector-emitter voltage of a fixed-bias circuit with Vcc = 10V, RB-310kohms,…

Q: - A 5-bit DAC has a current output. For a digital input of 101000, an output current of 10mA is…

Q: Q2/ Find the state-space representation of the electrical network shown in Figure 3.8. The output is…

Q: 1- A 1-phase transformer has 400 primary and 1000 secondary turns. The net cross- sectional area of…

Q: Consider the system whose closed-loop transfer function is K(T₁s + 1) G(s) = = T₂s +1 Obtain the…

Q: 1. If the load of wye connected transformer are: IA = 10 cis(-30°) IB = 12 cis (215°) Ic= 15 cis…

A: Positive components are symmetrical components. The phase sequence is same in balanced 3-phase…

Q: Question2): Find the current and voltage for each element in the fig. (2) Sketch the vand i curves.…

A: First we will calculate the impedance and then current by using current and impedance relationship…

Q: 2. A 3-phase, 11kV, star-connected alternator has armature resistance of 1 2/phase and a synchronous…

A: Given data, Here Terminal voltage(V)= 11 kV The load value = 1500kW The resistance value = 1Ω The…

Q: For transistor with W/L = 20/1, what is the value of Kn? Assume that K'n=50uA/V2

Q: The cutoff frequencies of a series resonant circuit are 5400 Hz and 6000 Hz. a) Find the bandwidth…

A: NOTE- As per the rules we can answer only 3 sub-parts, please post the remaining sub-parts as the…

Q: 5. A 5 hp, 220 V, 60 Hz, four-pole three-phase induction motor operatesat 1740 r/min when fully…

A: Given information about a three-phase induction motor is, Number of poles P=4. Supply frequency f=60…

Q: DRAW CIRCUIT OF ANALOG TO DIGITAL CONVERTER CIRCUIT. AND EXPLAIN HOW IT WORKS

A: Analog to digital converter:- This converter is used to convert the analog quantity to digital…

Q: Question 01: a) Determine a solution for x and y if: (x + j4) + (3X + jy) − j7 = 16/0° b) Determine…

A: (a) To determine a solution for x and y x+j4+3x+jy-j7=16∠0°4x+jy-3=16cos0°+j16sin0°4x+jy-3=16+j0 On…

Q: Q2: A JFET has parameters of Vp=-6V and lpss=3mA. Plot the transconductance curve for the devi Using…

A: JFET Features Voltage controlled Device Fast switching device High input impedence Smaller size…

Q: A material whose conductivity lies somewhere between those of metals and insulators is called:…

Q: A 4 pole dc generator with duplex wave winding has 72 slots, 4 conductors per slot. The flux per…

A: DC generator: This is an electromagnetic machine that works on the electromagnetic inductor…

Q: 1. If the load of wye connected transformer are: IA = 10 cis(-30°) IB = 12 cis (215°) Ic = 15 cis…

A: (1) It is given that: IA=10 cis-30°=10∠-30°IB=12 cis215°=12∠215°IC=10 cis82°=10∠82°

Q: In A/D converter, the maximum amount of error can be computed by dividing the voltage range over…

A: Given An analog to digital converter No of bits =10 Voltage range =0 to 6 volts We need to find…

Q: YES START START BUTTON MOTOR ON CONVEYER-ON IS THERE ANY BOTTLES UNDER Motor =off Conveyer=off…

A: To draw logic circuit means ladder logic

Q: 1. Using Thevenin's theorem, find the current through load Resistor (RL=22002) for the circuit shown…

Q: A power system has 2 buses with bus1 as slack bus and bus 2 as PQ bus and bus voltages as V1=1 20°…

A: Real Power: The actual power that is delivered to the load, such as a transformer, induction motors,…

Q: In what circumstances are radioactivity logs preferred to electrical logs?

A: Types of Logs Geochemical logs Nuclear logging Carbon oxygen logs Gamma rays logs Neutron logs

Q: Q1/ For the below system, if you know that the input is (t) = A sin(wt), explain and draw the…

Q: A 200 – kVA transformer with impedance of 5 percent and the power factor of the load is 85 percent.…

A: Given, A transformer with KVA rating, S=200 kVA Impedance, Z=5% Power factor, cosϕ=85%=0.85 Primary…

Q: Find the Laplace transform of each function.

Q: The following are the correct sign conventions for analyzing circuits using Kirchhoff's Laws EXCEPT:

A: The direction of current travelling in a circuit can be given as the positive potential as the…

Q: 6. Convert these powers into Watts: P₁=100 dBm; P₂=1000 dB?

Q: Q1. Choose the correct answer Which of the following is the نقطة واحدة ?main advantage of Self bias…

A: We are authorized to answer only 1 question at a time isnce you have not mentioned which question…

Q: Solve for the overall h-parameters in the attached network

A: The given circuit is as shown below,

Q: six-pole, 30-slot dc commutator generator has a lap wound Armature winding. The armature constant,…

A: In this question , we will find back emfb, required armature current and voltage supply to this…

Q: VGSQ = -2.2V. (VDD = 12V, RD=4.1kohms,

A: JFET (Junction field-effect transistor)- It is a type if transistor in which fabrication is done by…

Q: Adjustment resistance in rotor system will --------when three phase load .decrease Increase O not…

A: Adjustment resistance is also known as external resistance. Purpose of adding external resiistance…

Q: A 50 HP, 440 V, 3 Phase, 60 Hz, 6 Pole squirrel cage induction motor is operating at full load and…

Q: Draw the logic diagram of F=(a+b+c+d) (a'+b+c'+d) ( a'+b'+c+d) ( a' + b' + c + d')

A: Given F=(a+b+c+d) (a'+b+c'+d) ( a'+b'+c+d) ( a' + b' + c + d')

Q: The drain-to-source voltage at the pinch-off point of a particular JFET is 7 V. If the…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: 4.4ΚΩ Μ Vin 800mv 30kΩ Μ => Rx Μ 55ΚΩ + +12V -12V -Vout δε 140

Q: 2. Find the transfer function of the following figures using block diagram reduction and Mansion…

Q: Q4/ Evaluate the state space expression for the below circuit if the output is the current through…

Q: Refer to the Figure below. VDD D Hov S Rs Cs Compute for Av= (without load) if VDD=20V, RG-159Mohms,…

A: Brief description : For the given MOSFET we need to calculate the value of voltage gain without…

Q: 501az A Determine the total current in a wire of radius 1.6 mm if J = P m² Select your answer. 5.026…

A: In this question we need to choose a correct option

Q: The power input to a synchronous motor is measured by two wattmeters both of whic √3 indicate 50 kW.…

Q: ital Electronics HW: Sketch the voltage transfer characteristics (Vo1/Vin and Vo2/Nin). +4V Rc2 136…

Q: HW: Determine the range of the oscillation frequency. 9V 555 1mA 4 50ΚΩ RQ ΙΚΩΣ 0.1μF: 7 62 8 555 21…

A: A periodic movement that repeats itself in an everyday cycle, which includes a sine wave with…

Q: geometric mean radius

A: Conductor in transmission line- The conducting wires set used for transmission of electrical power…

Q: Applying source transformation find i in the circuit. (Please solve by hand) 3Ω m i 5Ω. 18sin (200t…

A: Using source transformation calculation of current i in the circuit. First convert the circuit in…

Q: 2. A 3-phase, 11kV, star-connected alternator has armature resistance of 1 2/phase and a synchronous…

Question

Q7B/ Answer on 'One' or 'Two'
One - If an electrical network has three energy-storage elements, is it possible
to have a state-space representation with more than three state variables.
Explain.
Two- Explain what is the difference and commonality between the transfer
function and the state space.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Mathematical Modeling of Mechanical System

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Find a state model (A, B, C, D) for the system with transfer function
A comparator is an electronic circuit, which compares the two inputs that are applied to it and produces an output. The output value of the comparator indicates which of the inputs is greater, lesser or equal.Design a 3 bit comparator using behavioral model which also evaluates the number of times the inputs are equal.
Give an example of an application circuit that uses First Order LTI System and EXPLAIN IT ALL. Start with a problem and an objective. Example would be: Start with the problem Example: Noise corrupts the signal fed to the system. State the goal. Example: The goal is to filter out the noise on the output of the system.
A step in a space vehicle checkout depends on four sensors (A,B,C,D) . Every circuit is functioning if sensor A and at least two of the other 3 sensors are also 1s. Find the minimal SOP expression if the circuit is working properly . Output is designated as F
Design a digital circuit based off of the following truth table.
create and design a 4-bit subtractor.
Scilab coding convolution Represent as signal sequences of x[n]={3,1,2,2} and h[n]={3,3,7,3} from 0 ≤ n ≤ 3. i) Perform convolution on both signals and show the resultant signal graphically. ii) Proves by comparing the result in Scilab with showing the correct theoretical calculation by hand-writing.
Scilab coding convolution Represent as signal sequences of x[n]={3,1,2,2} and h[n]={3,3,7,3} from 0 ≤ n ≤ 3. Plot the x[n] signal graphically.
A step in a space vehicle checkout depends on four sensors (A,B,C,D) . Every circuit is functioning if sensor A and at least two of the other 3 sensors are also 1s. Find the minimal SOP expression if the circuit is working properly .
Explain the duality theorem with example. Digital electronics
a. Write an equation for the transfer function of a second-order system that meets the conditions for overdamped. Explain the selection of parameter values as a condition of each of these systems.
according the following truth table and using the boolean algebra theorem Find the transfer function as a sum of products, Find the transfer function as a product of sums and draw its diagram